2ASPONFC100ANFC/BLE

Introduction Wiring C ol or F uncti on N otes R ed P ower + B l ack G N D Ground G reen D0 Wi egand D0 Whi te D 1 B rown L E D G reen LE D li ght control Y el l ow B uz z er B uz z er control Wi egand D1 Installation 1 2 P a r a meter s A : B : A 1 : 1/8 “ : 1/8 “ 1/4 “ 1/4 “ 5/16 “ 1-5/8” C 1 : C : Wa ll A B 3-1/4 “ 3/8 “ 3/8 “ C S te p1 S te p2 S te p3 Model O perati ng V ol tage F requency C ard T y pe R eadi ng Di stance O utput Format Work i ng T emperature S tandby Current I ndex of Protecti on D i mension 918V DC～ H I D card 1 1/8 to 3 1/8 “ HID - 40 ̊F - 140 ̊F ≤25 mA I P 6 6 3 P a ck i ng Li st 1 Reader 1 Manual S crew D ri v er 2 Wal l F i x i ng P l ugs 2 S el f T appi ng Screws N a me Q ua nti ty 1 U ser Ma nua l Proximity Reader L4 3/4 x W 1 7/8 x H 7/8 “ L4 3/4 x W 3 x H 7/8 “ The Dolphin-NFC-BLE is a Wiegand Output Proximity Reader. 125KHz HID formats are compatible with these readers. These readers have the ability to read a HID format of 26 bits. These indoor and outdoor readers are waterproof and functions at extreme temperatures (-40F - 140F). The readers also have a built-in light sensor to signal when the keypad is being tampered. • Drill 2 holes (A,C) on the wall for the screws and one hole for the cable • Knock the wall xing plugs to holes A and C • Screw the back cover to the wall • Thread the cable through hole B • Attach the unit to the back cover 125 kHz EM 125 kHz HID 13.56 MHz NFC Type 2 Tag 13.56 MHZ Mifare, Type 2, and Type 4 2.4 GHz Bluetooth Low Energy 8-24 VDC Dolphin-NFC-BLE Dolphin-NFC-BLE BLE Read Range ~30 feet (10 meters) Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A External Photos Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 2 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 3 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 4 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 5 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 6 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 7 of 17

FCC ID: 2ASPONFC100A Contains FCC ID: SH6MDBT42Q

Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Internal Photos Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 8 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 9 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 10 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 11 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 12 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 13 of 17

of Applicant: Transmitter Solutions Address: 2480 South 3850 West, Suite B Salt Lake City, UT 84120 United States Tested and Prepared by Worldwide Testing Services (Taiwan) Co., Ltd. FCC Registration No.: TW1477, TW0020, TW1072 Industry Canada filed test laboratory Reg. No. 20037 A2LA Accredited No.: 2732.01 Report No.: W6M22005-19877-C-9 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E- mail: [email protected] 47 CFR PART 15 SUBPART C TEST REPORT for NFC/BLE Model No.: NFC-100 FCC ID: 2ASPONFC100A Registration number: W6M22005-19877-C-9 FCC ID: 2ASPONFC100A TABLE OF CONTENTS 1 General Information ............................................................................................................................ 2 1.1 NOTES .......................................................................................................................................... 2 1.2 TESTING LABORATORY ................................................................................................................ 3 1.2.1 Location .................................................................................................................................. 3 1.2.2 Details of accreditation status ................................................................................................. 3 1.3 DETAILS OF APPROVAL HOLDER ................................................................................................... 3 1.4 APPLICATION DETAILS ................................................................................................................. 3 1.5 GENERAL INFORMATION OF TEST ITEM ........................................................................................ 4 1.6 TEST STANDARDS ......................................................................................................................... 4 2 Technical test ...................................................................................................................................... 5 2.1 S UMMARY OF TEST RESULTS ........................................................................................................ 5 2.2 TEST ENVIRONMENT .................................................................................................................... 5 2.3 T EST EQUIPMENT LIST ................................................................................................................. 6 2.4 GENERAL TEST PROCEDURE ........................................................................................................ 9 3 Test results (enclosure) ..................................................................................................................... 10 3.1 PEAK OUTPUT POWER ............................................................................................................... 10 3.2 SPURIOUS EMISSIONS RADIATED – TRANSMITTER OPERATING ................................................... 13 3.3 OCCUPIED BANDWIDTH ............................................................................................................. 15 3.4 ANTENNA REQUIREMENT ........................................................................................................... 16 3.5 RADIATED EMISSIONS FROM RECEIVER SECTION OF RECEIVER PART ....................................... 17 3.6 POWER LINE CONDUCTED EMISSION ......................................................................................... 19 Appendix: Diagrams Worldwide Testing Services (Taiwan) Co., Ltd. Page 1 of 19 Registration number: W6M22005-19877-C-9 FCC ID: 2ASPONFC100A 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the Worldwide Testing Services(Taiwan) Co., Ltd. Tester: May 21, 2020 Leon Chueh Date WTS-Lab. Name Signature Technical responsibility for area of testing: May 21, 2020 Kevin Wang Date WTS Name Signature Worldwide Testing Services (Taiwan) Co., Ltd. Page 2 of 19 Registration number: W6M22005-19877-C-9 FCC ID: 2ASPONFC100A 1.2 Testing laboratory 1.2.1 Location OATS No.5-1, Shuang Sing Village, LiShuei Rd., Wanli Dist., New Taipei C ity 207, Taiwan (R.O.C.) Company Worldwide Testing Services(Taiwan) Co., Ltd. 6F, NO. 58, LANE 188, RUEY-KUANG RD. NEIHU, TAIPEI 114, TAIWAN R.O.C. Tel : 886-2- 66068877 Fax : 886-2- 66068879 1.2.2 Details of accreditation status Accredited testing laboratory A2LA accredited number: 2732.01 FCC filed test laboratory Reg. No. TW1477, TW0020, TW1072 Industry Canada filed test laboratory Reg. No. 20037 Test location, where different from Worldwide Testing Services (Taiwan) Co., Ltd. : Name: ./. Accredited number: ./. Street: ./. Town: ./. Country: ./. Telephone: ./. Fax: ./. 1.3 Details of approval holder Name: Transmitter Solutions Street: 2480 South 3850 West, Suite B Town: Salt Lake City, UT 84120 Country: United States Telephone: 866-975-0101 Fax: 866-975-0404 1.4 Application details Date of receipt of test item: May 07, 2020 Date of test: from May 08, 2020 to …

Text truncated - open the document above for the full version.

Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Set Up Photo of Radiated Emission 125kHz Below 30 MHz Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 14 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Above 30 MHz Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 15 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A 13.56 MHz Below 30 MHz Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 16 of 17 Registration number: W6M22005-19877-FCC FCC ID: 2ASPONFC100A Above 30 MHz Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 17 of 17