2AVLK-CHARGE-W2MRAM Wireless Charger

This wireless charger pad is super slim design. Qi2 15W fast charging for iPhone series and fast charging for Airpods absolutely security charging gurantee Provide power to the charger through 5V/3A,QC2.0 9V/2.22A PD2.0 5-15V/2A adapters                              
         ­ €  ‚ FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance, could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. FCC RF exposure statement: The equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance between 20cm the radiator your body.

Local Representative Letter For Certification Service in the USA Federal Communications Commission Equipment Authorization Division, Application Processing Branch 7435 Oakland Mills Road Columbia, MD 21048 To whom it may concern Pursuant to Section 2.911(d)(7), of the Commission’s Rules (47 C.F.R.) we attest as follows for the product listed below: FCC ID Model name 2AVLK-CHARGE-W2M RAM-GDS-CHARGE-W2M, RAM-GDS- CHARGE-W2M-1 We hereby acknowledge as follows: i. both signees confirm that the point of contact accepts responsibility to act as a US- American Representative on behalf of the applicant ii. the point of contact provides the physical U.S. address and email as listed below iii. both parties maintain the requirements of this agreement for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. iv. An expiration date for this letter does not exist. In case the U.S. agent changes, the grantee is obligated to notify the FCC within 30 days via the granting TCB. US-American Point of Contact Applicant/Approval Holder Signature Date: 2025-12-29 Signature Date: 2025-12-29 Company Name: GLOCERTS TECHNOLOGY INC National Products, Inc FRN: 0036339737 0029109345 Contact Name: Huiying Fan SCOTT ANDERSON Address: 19784 SUNKISSED RIDGE DR, RIVERSIDE, CA 92507 8410 DALLAS AVE SOUTH SEATTLE, WA 98108 United States Phone: (626) 588-8039 001-512-796-5400 Email: [email protected] [email protected]

Page 1 of 3 FCC ID:2AVLK-CHARGE-W2M External photos Page 2 of 3 FCC ID:2AVLK-CHARGE-W2M Page 3 of 3 FCC ID:2AVLK-CHARGE-W2M

Label size : 37*23mm FCC ID:2AVLK-CHARGE-W2M

Page 1 of 2 FCC ID:2AVLK-CHARGE-W2M Internal photos Phone Coil Page 2 of 2 FCC ID:2AVLK-CHARGE-W2M

Page 1 of 11 Report No.:AiTSZ-251204001FW2 Note: This device has been tested and found to comply with the standard(s) listed, this test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. This report shall not be reproduced except in full, without the written approval of Dongguan Yaxu (AiT) Technology Limited. If there is a need to alter or revise this document, the right belongs to Dongguan Yaxu (AiT) Technology Limited, and it should give a prior written notice of the revision document. This test report must not be used by the client to claim product endorsement. Dongguan Yaxu (AiT) Technology Limited No.22, Jinqianling 3rd Street, Jitigang, Huangjiang, Dongguan, Guangdong, China. TEST REPORT Product Name : RAM Wireless Charger Brand Name : RAM® Model : RAM-GDS-CHARGE-W2M Series Model : RAM-GDS-CHARGE-W2M-1 FCC ID : 2AVLK-CHARGE-W2M Applicant : National Products, Inc Address : 8410 Dallas Ave South, Seattle, WA 98108, USA Manufacturer : National Products, Inc Address : 8410 Dallas Ave South, Seattle, WA 98108, USA Standard(s) : FCC CFR 47 PART 1, § 1.1310 KDB 680106 D01 Wireless Power Transfer v04 Date of Receipt : Dec. 04, 2025 Date of Test : Dec. 05, 2025~ Dec. 23, 2025 Issued Date : Dec. 24, 2025 Issued By: Dongguan Yaxu (AiT) Technology Limited No.22, Jinqianling 3rd Street, Jitigang, Huangjiang, Dongguan, Guangdong, China Tel.: +86-769-8202 0499 Fax.: +86-769-8202 0495 Reviewed by: Approved by: Emiya Lin Simba Huang Page 2 of 11 Report No.: AiTSZ-251204001FW2 Report Revise Record Report Version Issued Date Notes M0 Dec. 24, 2025 Initial Release Page 3 of 11 Report No.: AiTSZ-251204001FW2 Contents 1 GENERAL INFORMATION ....................................................................................................................................... 4 1.1 ENVIRONMENTAL CONDITIONS ........................................................................................................................................ 4 1.2 GENERAL DESCRIPTION OF EUT ...................................................................................................................................... 4 1.3 TEST FACILITY .............................................................................................................................................................. 5 1.4 MEASUREMENT UNCERTAINTY ........................................................................................................................................ 5 1.5 DESCRIPTION OF THE TEST MODE ..................................................................................................................................... 6 1.6 SPECIAL ACCESSORIES ................................................................................................................................................... 6 1.7 EQUIPMENT LIST FOR THE TEST ....................................................................................................................................... 6 2 TEST CONDITIONS AND RESULTS ........................................................................................................................... 7 2.1 APPLICABLE STANDARD .................................................................................................................................................. 7 2.2 LIMIT ......................................................................................................................................................................... 7 2.3 TEST SETUP ................................................................................................................................................................. 7 2.4 MEASUREMENT PROCEDURE .......................................................................................................................................... 8 2.5 TEST RESULT OF E AND H FIELD STRENGTH ........................................................................................................................ 8 2.6 CONCLUSION ............................................................................................................................................................... 9 3 TEST SETUP PHOTOGRAPHS OF EUT .................................................................................................................... 10 Page 4 of 11 Report No.: AiTSZ-251204001FW2 1 GENERAL INFORMATION 1.1 Environmental conditions During the measurement the environmental conditions were within the listed ranges: Normal Temperature: 25°C Relative Humidity: 55 % Air Pressure: 101 kPa 1.2 General Description of EUT Product Name: RAM Wireless Charger Model/Type reference: RAM-GDS-CHARGE-W2M Serial Model: RAM-GDS-CHARGE-W2M-1 Model difference: All models are the same except for the model name Power Supply: Input: USB 5V/3A QC2.0 9V/2.22A USB PD2.0 5-15V/2A Output:5W/7.5W/15W Hardware Version: N/A Software Version: N/A Sample(s) Status: AiTSZ-251204001-1(Normal sample) AiTSZ-251204001-2(Engineer sample) Wireless Charger: Operation frequency: 110kHz-205kHz, 360KHz Modulation Technology: ASK Antenna Type: Loop coil Antenna Antenna gain: 0dBi Remark: The above DUT's information was declared by manufacturer. For more detailed features description, please refer to the manufacturer’s specifications or the User's Manual. Page 5 of 11 Report No.: AiTSZ-251204001FW2 1.3 Test Facility Test Laboratory: Dongguan Yaxu (AiT) Technology Limited No.22, Jinqianling 3rd Street, Jitigang, Huangjiang, Dongguan, Guangdong, China The test facility is recognized, certified or accredited by the following organizations: CNAS-Registration No: L6177 Dongguan Yaxu (AiT) technology Limited is accredited to ISO/IEC 17025:2017 general Requirements for the competence of testing and calibration laboratories (CNAS-CL01 Accreditation Criteria for the competence of testing and calibration laboratories) on…

Text truncated - open the document above for the full version.

Page 1 of 28 Report No.: AiTSZ-251204001FW1 Note: This device has been tested and found to comply with the standard(s) listed, this test report merely corresponds to the test sample. It is not permitted to copy extracts of these test result without the written permission of the test laboratory. This report shall not be reproduced except in full, without the written approval of Dongguan Yaxu (AiT) Technology Limited. If there is a need to alter or revise this document, the right belongs to Dongguan Yaxu (AiT) Technology Limited, and it should give a prior written notice of the revision document. This test report must not be used by the client to claim product endorsement. Dongguan Yaxu (AiT) Technology Limited No.22, Jinqianling 3rd Street, Jitigang, Huangjiang, Dongguan, Guangdong, China. TEST REPORT Product Name : RAM Wireless Charger Brand Name : RAM® Model : RAM-GDS-CHARGE-W2M Series Model : RAM-GDS-CHARGE-W2M-1 FCC ID : 2AVLK-CHARGE-W2M Applicant : National Products, Inc Address : 8410 Dallas Ave South, Seattle, WA 98108, USA Manufacturer : National Products, Inc Address : 8410 Dallas Ave South, Seattle, WA 98108, USA Standard(s) : FCC CFR Title 47 Part 15 Subpart C Date of Receipt : Dec. 04, 2025 Date of Test : Dec. 05, 2025~ Dec. 23, 2025 Issued Date : Dec. 24, 2025 Issued By: Dongguan Yaxu (AiT) Technology Limited No.22, Jinqianling 3rd Street, Jitigang, Huangjiang, Dongguan, Guangdong, China Tel.: +86-769-8202 0499 Fax.: +86-769-8202 0495 Reviewed by: Approved by: Emiya Lin Simba Huang Page 2 of 28 Report No.: AiTSZ-251204001FW1 Report Revise Record Report Version Issued Date Notes M0 Dec. 24, 2025 Initial Release Page 3 of 28 Report No.: AiTSZ-251204001FW1 Contents 1 TEST SUMMARY .................................................................................................................................................... 4 1.1 TEST STANDARDS ......................................................................................................................................................... 4 1.2 TEST SUMMARY ........................................................................................................................................................... 4 1.3 TEST FACILITY .............................................................................................................................................................. 5 1.4 MEASUREMENT UNCERTAINTY ........................................................................................................................................ 5 2 GENERAL INFORMATION ....................................................................................................................................... 6 2.1 ENVIRONMENTAL CONDITIONS ........................................................................................................................................ 6 2.2 GENERAL DESCRIPTION OF EUT ...................................................................................................................................... 6 2.3 DESCRIPTION OF THE TEST MODE ..................................................................................................................................... 7 2.4 SPECIAL ACCESSORIES ................................................................................................................................................... 7 2.5 EQUIPMENT LIST FOR THE TEST ....................................................................................................................................... 8 3 TEST CONDITIONS AND RESULTS ........................................................................................................................... 9 3.1 CONDUCTED EMISSIONS TEST ......................................................................................................................................... 9 3.2 RADIATED EMISSIONS .................................................................................................................................................. 12 3.3 20DB BANDWIDTH ..................................................................................................................................................... 20 3.4 ANTENNA REQUIREMENT ............................................................................................................................................. 22 4 TEST SETUP PHOTOGRAPHS OF EUT .................................................................................................................... 23 5 PHOTOS OF THE EUT ........................................................................................................................................... 24 Page 4 of 28 Report No.: AiTSZ-251204001FW1 1 TEST SUMMARY 1.1 Test Standards The tests were performed according to following standards: FCC Rules Part 15.207,15.209, 15.215(c) ANSI C63.10: 2020: American National Standard for Testing Unlicensed Wireless Devices 1.2 Test Summary Test Item Section in 47 CFR Test Result Electric Field Radiated Emissions FCC Part 15 C (Section15.209) PASS 20dB Bandwidth/99% Bandwidth FCC Part 15 C (Section15.215(c)) PASS AC Power Line Conducted Emission FCC Part 15 C (Section15.207) PASS Antenna Requirement FCC Part 15 C (Section15.203 PASS Page 5 of 28 Report No.: AiTSZ-251204001FW1 1.3 Test Facility Test Laboratory: Dongguan Yaxu (AiT) Technology Limited No.22, Jinqianling 3rd Street, Jitigang, Huangjiang, Dongguan, Guangdong, China The test facility is recognized, certified or accredited by the following organizations: CNAS-Registration No: L6177 Dongguan Yaxu (AiT) technology Limited is accredited to ISO/IEC 17025:2017 general Requirements for the competence of testing and calibration laboratories (CNAS-CL01 Accreditation Criteria for the competence of testing and calibration laboratories) on April 18, 2022 FCC-Registration No.: 703111 Designation Number: CN1313 Dongguan Yaxu (AiT) Technology Limited has been register…

Text truncated - open the document above for the full version.

Address:No. 2, Xisha Road, Shijie Town, Dongguan City, Guangdong Province,China Operation Frequency 100-500KHz Antenna Type Loop coil antenna Antenna gain: 0dBi We statement that All measurements were performed radiated and therefore additional antenna gain documentation is not required.

Page 1 of 1 FCC ID:2AVLK-CHARGE-W2M