2AWEN-SY112Sound Bar

Effective distance: 10m Output power: 3Wx2 Charge voltage: DC 5V Frequency response: 120Hz - 16KHz Signal-To-Noise ration SNR: 70db Audio Input: Bluetooth, TF cards, LINE, USB Speaker unit: 4 Operational guidelines Portable Bluetooth Speaker SY112 Basic parameters Product charcteristics Bluetooth speaker phone call Smart Voice Tips TF card, USB disk play back, support MP 3 and other audio source formats Micro USB charging interface 1 1. Switch on/off Boot: dial“ON” Shut down: dial to“OFF” 2. Bluetooth connection a. Search by cell phone or other device after entering Bluetooth mode conduct “SY112”pairing connection, if you need to enter a pairing code of “0000”. after the pairing is successful, enter Bluetooth playback mode. b. After the device pairing is successful, the next time it enters Bluetooth mode, it will automatically return to 10S, and the backlink timeout will enter the pairing state. 3. Bluetooth call When you receive a call, press key Answer, Long press refuse, Talking process short press hang up. 4. TF cards, USB disks Insert TF card into TF card slot to automatically switch to card reading modde. Inserting a USB socket automatically switches to card reding mode. 5. Audio Input Will be 3. one end of the 5mm stereo audio cableplug is connected to the Bluetooth speaker AUX port, and the other end is linked to the 3.5mm audio output of multimedia audio source playback devices such as mobile/MP3/PC. The Bluetooth speaker automatically switches to line mode. 6. Charging Connect micro charging cable USB plug to USB charging port with DC 5V, micro charging head is connected to the machine plug in, You can charge and charge the red indicator light. Bluetooth Speaker 1 post Micro USB charging cable 1pcs Instruction 1 item 1. Please store and use this product at room temperature; 2. Do not expose this product to rain or wet conditions; 3. Do not drop, to avoid the fall of the product damage; 4. Do not dismantle and repair the product; 5. The product built-in lithium battery, do not casually discard or put in the fire, soas not to cause danger! 1. The device is often automatically turned off after along period of playing. The battery may not have enough power. please charge and try again. 2. Bluetooth music appears, Caden. Whether it is beyond the effective connection distance of the speaker, or if there is an obstacle between the speaker and the Bluetooth device. 3. Matching failed a. Check that the speaker is in search or reboot. b. There are too many Bluetooth devices around, making it difficult to search and turning off other Bluetooth devices. Operational instructions Frequently Asked Problem Solutions Matters needing attention Packing list 23 FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits ar e designed to pr ovide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a par t icular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: ‐‐ Reorient or relocate the r eceiving an tenna. ‐‐ Increase the separation between the equipment and receiver. ‐‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ‐‐ Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Opera tion is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RF Exposure Statement To maintain compliance with FCC's RF Exposure guidelines, This equipment should be installed and operated with minimum distance of 20 cm the radiator your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter.

Co m Ad d Pr o Mo d SY1 Pr o We act We an d issu our Sig Na m Title Com mpany: DO dress: Build oduct Name del Numbe 119 oduct Desc authorize M on our beha declare tha d certificatio ues concern behalf shal nature: me: e: mpany: DON ONGGUAN M ding B, no. 68 e: Sound Ba er(s): SY112 ription: Sou MiCOM Lab alf on all ma at MiCOM L n of equipm ning the app ll have the s Wei Li Manager DONGGUA GGUAN M Agen MORITAKE IN 8, xixing third r 2, ISB11B, und Bar bs Inc., 575 atters conce Labs Inc. is ment to the r proval applic same effect AN MORITAK MORITAKE nt Auth NDUSTRIAL d street,chan IJSPSM01, Boulder Co erning the c allowed to f regulatory a cation. Any t as acts of KE INDUSTR E INDUSTR horizat CO.,LTD ngping town, SY113, SY ourt, Pleasa certification forward all i agencies as and all acts our own. RIAL CO.,LT RIAL CO.,L tion dongguan c 114, SY115 anton, Califo of above na information s required a s carried ou Date: TD LTD city, China , SY116, SY ornia 94566 amed equip related to t nd to discu ut by MiCOM May. 27, 20 Y117, SY118 6, USA, to pment. the approva ss any M Labs on 021 8, al

Office o Federa 7435 O Columb USA Subjec t FCC ID To Wh o Pursua are req u docume These d propriet might b It is ou r corresp docume authoriz Sincer e Signat u Name: Title: M of Engineeri l Communic Oakland Mills bia, MD 210 t; Request f D: 2AWEN- om It May C nt to the pro uesting the ents from pu documents tary informa be harmful to Schema Block D Parts Lis Operatio Tune-up r understand pondence du ents and thi zation is iss ely, ure: Wei Li Manager DONGG ing Techno cations Com s Road 046 for Confiden -SY112 Concern, ovisions of t Commissio ublic disclos contain det ation in ope o our comp atic Diagram iagram st onal Descri p Procedure ding that all uring the ce s informatio sued. GUAN MO logy mmission ntiality the Commis on to withho sure indefin tailed syste ration of th e any and wo m ption e l measurem ertification re on will be av RITAKE IN ssion’s rule old the follow nitely. m and equi e equipmen ould give co ment test rep eview proce vailable for NDUSTRIA s Title 47 S wing attach pment desc nt. The publ ompetitors a ports, FCC ess cannot public revi e AL CO.,LTD Sections §0. hment(s) as criptions an ic disclosu r an unfair ad ID label for be granted ew once the D Date: May. 457 and §0 confidentia d are consi re of these d vantage in mat and as confide n e grant of eq . 27, 2021 0.459, we al dered as documents the market . ntial quipment .

Model Difference Declaration To Whom It May Concern, We, DONGGUAN MORITAKE INDUSTRIAL CO.,LTD (Sound Bar) Trademark:Moritake; Model Number: SY112, ISB11B, IJSPSM01, SY113, SY114, SY115, SY116, SY117, SY118, SY119 All model’s the function, software and electric circuit are the same, only with a product color, appearance and model named different. Test sample model: SY112 Please contact me if you have any question. Name: Wei Li Date: May. 27, 2021 Title: Manager Signature of applicant:

Annex A External Photos Report No.: HK2105101405-E Page 1 of 4 Report No.: HK2105101405-E Page 2 of 4 Report No.: HK2105101405-E Page 3 of 4 Report No.: HK2105101405-E Page 4 of 4

FCC ID LABEL: Label Location Width: 2cm Long: 4cm FCC ID: 2AWEN-SY112 Product name: Sound Bar Model No.: SY112 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation.

Annex B Internal Photo Report No.: HK2105101405-E Page 1 of 3 Antenna Report No.: HK2105101405-E Page 2 of 3 Report No.: HK2105101405-E Page 3 of 3

MPE ESTIMATION FCC ID: 2AWEN-SY112 1, Limit for General Population/ Uncontrolled Exposures Frequency Power density (mW/ cm 2 ) Averaging time(minutes) 300MHz----1.5GHz F/1500 30 1.5GHz---100GHz 1.0 30 2, Estimation Result For 2.4G WIFI: Mode Max PK Output power(dBm) Tune Up Power(dBm) Max Tune Up power(mW) Antenna Gain(dBi) Antenna Gain (linear) MPE (mW/cm²) BT -6.241 -6±1(-7) 0.2 0 1 0.00004 Note: Note: The estimation distance is 20cm Note: PK Output power= conducted power. Conducted power see the test report HK2105101405-E. Gantenna gain=0dBi when the minimum test separation distance is >20 cm, a distance of 20 cm is applied to determine RF Exposure test exclusion. The test exclusion threshold is 0.00004mW/cm² which is< 1.0mW/cm², RF Exposure testing is not required. -------The End-------

Page 1 of 45 Report No.: HK2105101405-E TEST REPORT FCC PART 15 SUBPART C 15.247 Test report On Behalf of DONGGUAN MORITAKE INDUSTRIAL CO.,LTD For Sound Bar Model No.: SY112, ISB11B, IJSPSM01, SY113, SY114, SY115, SY116, SY117, SY118, SY119 FCC ID: 2AWEN-SY112 Prepared for : DONGGUAN MORITAKE INDUSTRIAL CO.,LTD Building B, no. 68, xixing third street,changping town, dongguan city, China Prepared By : Shenzhen HUAK Testing Technology Co., Ltd. 1-2/F., Building B2, Junfeng Zhongcheng Zhizao Innovation Park, Heping, Fuhai Street, Bao’an District, Shenzhen, Guangdong, China Date of Test: May. 10, 2021 ~ May. 17, 2021 Date of Report: May. 17, 2021 Report Number: HK2105101405-E Page 2 of 45 Report No.: HK2105101405-E TEST RESULT CERTIFICATION Applicant’s name ................. : DONGGUAN MORITAKE INDUSTRIAL CO.,LTD Address ................................. : Building B, no. 68, xixing third street,changping town, donggu an city, China Manufacture's Name ............ : DONGGUAN MORITAKE INDUSTRIAL CO.,LTD Address ................................. : Building B, no. 68, xixing third street,changping town, dongguan city , China Product description Trade Mark: Moritake Product name ........................... : Sound Bar Model and/or type reference : SY112, ISB11B, IJSPSM01, SY113, SY114, SY115, SY11 6, SY 117, SY118, SY119 Standards ............................. : 47 CFR FCC Part 15 Subpart C 15.247 This publication may be reproduced in whole or in part for non-commercial purposes as long as the Shenzhen HUAK Testing Technology Co., Ltd. is acknowledged as copyright owner and source of the material. Shenzhen HUAK Testing Technology Co., Ltd. takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Date of Test ............................................ : Date (s) of performance of tests ............. : May. 10, 2021 ~ May. 17, 2021 Date of Issue ........................................... : May. 17, 2021 Test Result ............................................... : Pass Prepared by: Project Engineer Reviewed b y: Project Supervisor Approved by: T echnical Di rector Page 3 of 45 Report No.: HK2105101405-E Table of Contents Page 1. SUMMARY............................................................................................................................................................ 5 1.1. TEST STANDARDS ..................................................................................................................................................... 5 1.2. TEST DESCRIPTION ........................................................................................................................................................ 5 1.3. TEST FACILITY .............................................................................................................................................................. 6 1.4. STATEMENT OF THE MEASUREMENT UNCERTAINTY ............................................................................................................... 6 2. GENERAL INFORMATION ....................................................................................................................................... 7 2.1. ENVIRONMENTAL CONDITIONS ........................................................................................................................................ 7 2.2. GENERAL DESCRIPTION OF EUT ...................................................................................................................................... 7 2.3. DESCRIPTION OF TEST MODES AND TEST FREQUENCY .......................................................................................................... 8 2.4. EQUIPMENTS USED DURING THE TEST .............................................................................................................................. 9 2.5. RELATED SUBMITTAL(S) / GRANT (S) .............................................................................................................................. 10 2.6. MODIFICATIONS ......................................................................................................................................................... 10 2.7. DESCRIPTION OF TEST SETUP ................................................................................................................................ 10 3. TEST CONDITIONS AND RESULTS ......................................................................................................................... 11 3.1. CONDUCTED EMISSIONS TEST ....................................................................................................................................... 11 3.2. RADIATED EMISSIONS AND BAND EDGE .......................................................................................................................... 14 3.3. MAXIMUM PEAK CONDUCTED OUTPUT POWER ............................................................................................................... 25 3.4. 20DB BANDWIDTH ..................................................................................................................................................... 26 3.5. FREQUENCY SEPARATION ............................................................................................................................................. 29 3.6. NUMBER OF HOPPING FREQUENCY ................................................................................................................................. 31 3.7. TIME OF OCCUPANCY (DWELL TIME) .............................................................................................................................. 33 3.8. OUT‐OF‐BAND EMISSIONS ............................................................................................................................................ 36 3.9. PSEUDORANDOM FREQUENCY HOPPING SEQUENCE …

Text truncated - open the document above for the full version.

Test Model：SY112 Radiated Emission Conducted Emission