2AX5B-FR2005ELECTRIC KIDS BUMPER CAR

Remote Controller of Electric Ride-on Car Features -Supply Voltage：2 X 1.5V -Frequency： 2402-2480MHz Button Description -Forward: Direct the ride-on car to move forward -Backward: Direct the ride-on car to move backward -Paring: Pair the ride-on car with a remote controller -Left: Direct the ride-on car to turn left -Right: Direct the ride-on car to turn right -Speed: Adjust the speed of the ride-on car’s movement as low, moderate or high -Brake: Immediately stop the ride-on car and render it immovable until unlocking Pairing Instruction 1.Turn on the power of the ride-on car, press and hold the pairing button until the speed indicator light switches on without flashing 2.Release the pairing button, and the speed indicator light will switch off 3.If the speed indicator light switches on again, then the pairing is successful; if not, please repeat steps 1 and 2 4.One successful pairing is all, and no more pairings are needed in later use Battery installation Open the back cover of the remote control with screwdriver and insert two triple A batteries (AAA 1.5V). Please pay attention to the polarity. Close the back cover and tighten the screws when the LED light is on, indicating battery installed properly. Battery needs to be replaced when the LED light dims or blinks. FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna . -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. RF Exposure Statement The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Flat River Group LLC Agent Authorization Letter (November 24, 2020) Eurofins MET Labs 914 West Patapsco Avenue Baltimore, MD 21230 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern: We, the undersigned, hereby authorize (Shenzhen Tongzhou Testing Co.,Ltd.) to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Mariah Carlson / Account Manager

Flat River Group LLC Long Term Confidentiality Request Letter (November 24, 2020) Eurofins MET Labs 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR (ELECTRIC KIDS BUMPER CAR / FR2005# 2AX5B-FR2005#) To Whom It May Concern: This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the - Block Diagram - Schematics - Operational Description - BOM required to be submitted with this application be permanently withheld from public review. The above-mentioned documents belong to internal documents, is our proprietary information, that could never get into the possession of our competition. Please contact me if there is any information you may need. Sincerely, Client’s name / title : Mariah Carlson / Account Manager Company Name: Flat River Group LLC Contact information / address: [email protected]/ 306 Reed St. , Belding, MI 48809

Short Term Confidentiality Request Letter (November 24, 2020) MET Laboratories, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Short Term Confidentiality Request For(ELECTRIC KIDS BUMPER CAR / FR2005# 2AX5B-FR2005#) To Whom It May Concern: In accordance with sections 0.457 and 0.459 of CFR 47, < Flat River Group LLC >. requests short-term Confidentiality of following sections of this application for a period of 45 days after grant is issued. Test setup photos External photos Internal photos User’s manual These documents contain detailed system and equipment descriptions and related information about the product, which < Flat River Group LLC > considers to be proprietary, confidential, and a custom design and otherwise, would not release to the general public. Since this design is a basis from which future technological products will evolve, < Flat River Group LLC > feels that this information would be of benefit to its competitors, and that the disclosure of the information in these documents would give our competitors an unfair advantage in the market. Please contact me if there is any information you may need. Sincerely, Name: Mariah Carlson Function: Account Manager Signature: Flat River Group LLC

Antenna Specification The Basic Technical Specification : Frequency band 2402MHz ~ 2480MHz Integrated Chipset LT660 OSC 12MHz Modulation GFSK Antenna type PCB Antenna Antenna 0dBi

Report No.: TZ201101789 Page 1 of 29 FCC TEST REPORT Test report On Behalf of Flat River Group LLC For ELECTRIC KIDS BUMPER CAR Model No.: FR2005 FCC ID: 2AX5B-FR2005 Prepared for : Flat River Group LLC 306 Reed St. , Belding, MI 48809 Prepared By : Shenzhen Tongzhou Testing Co.,Ltd 1th Floor, Building 1, Haomai High-tech Park, Huating Road 387, Dalang Street, Longhua, Shenzhen, China Date of Test: 2020/11/2 – 2020/11/14 Date of Report: 2020/11/16 Report Number: TZ201101789-EW1 The test report apply only to the specific sample(s) tested under stated test conditions It is not permitted to copy extracts of these test result without the written permission of the test laboratory. Report No.: TZ201101789 Page 2 of 29 TEST RESULT CERTIFICATION Applicant’s name ................. : Flat River Group LLC Address .................................. : 306 Reed St. , Belding, MI 48809 Manufacture's Name ............ : Flat River Group LLC Address .................................. : 306 Reed St. , Belding, MI 48809 Product description Trade Mark ............................. : N/A Product name ........................... : ELECTRIC KIDS BUMPER CAR Model and/or type reference .. : FR2005 Standards ............................. : FCC Rules and Regulations Part 15 Subpart C Section 15.249 ANSI C63.10: 2013 This publication may be reproduced in whole or in part for non-commercial purposes as long as the Shenzhen Tongzhou Testing Co.,Ltd is acknowledged as copyright owner and source of the material. Shenzhen Tongzhou Testing Co.,Ltd takes no responsibility for and will not assume liability for damages resulting from the reader's interpretation of the reproduced material due to its placement and context. Date of Test ........................................... : Date (s) of performance of tests ............. : 2020/11/2 – 2020/11/14 Date of Issue .......................................... : 2020/11/16 Test Result .............................................. : Pass Testing Engineer : (Nancy Li) Technical Manager : (Hugo Chen) Authorized Signatory : (Andy Zhang) Report No.: TZ201101789 Page 3 of 29 Revision History Revision Issue Date Revisions Revised By 000 2020/11/16 Initial Issue Andy Zhang Report No.: TZ201101789 Page 4 of 29 TABLE OF CONTENTS 1. GENERAL INFORMATION ................................................................................................................................... 5 1.1. DESCRIPTION OF DEVICE (EUT) ........................................................................................................................ 5 1.2. HOST SYSTEM CONFIGURATION LIST AND DETAILS .......................................................................................... 5 1.3 EUT CONFIGURATION .......................................................................................................................................... 6 1.4. EXTERNAL I/O CABLE ......................................................................................................................................... 6 1.5. DESCRIPTION OF TEST FACILITY ........................................................................................................................ 6 1.6. STATEMENT OF THE MEASUREMENT UNCERTAINTY .......................................................................................... 7 1.7. MEASUREMENT UNCERTAINTY ........................................................................................................................... 7 1.8. DESCRIPTION OF TEST MODES .......................................................................................................................... 7 1.9. FREQUENCY OF CHANNELS ................................................................................................................................ 8 2. TEST METHODOLOGY ......................................................................................................................................... 9 2.1. EUT CONFIGURATION......................................................................................................................................... 9 2.2. EUT EXERCISE ................................................................................................................................................... 9 2.3. GENERAL TEST PROCEDURES ........................................................................................................................... 9 2.4. TEST SAMPLE ...................................................................................................................................................... 9 3. SYSTEM TEST CONFIGURATION .................................................................................................................... 10 3.1. JUSTIFICATION................................................................................................................................................... 10 3.2. EUT EXERCISE SOFTWARE .............................................................................................................................. 10 3.3. SPECIAL ACCESSORIES .................................................................................................................................... 10 3.4. BLOCK DIAGRAM/SCHEMATICS......................................................................................................................... 10 3.5. EQUIPMENT MODIFICATIONS ............................................................................................................................ 10 3.6. TEST SETUP ...................................................................................................................................................... 10 4. SUMMARY OF TEST RESULTS ........................................................................................................................ 11 5. TEST RESULT .......................................................................................…

Text truncated - open the document above for the full version.