2AYGE-M2445Remote Control Transmitter

Remote Instructions Model: M2445 FCC ID: 2AYGE-M2445 IC: 26807-M2445 FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user’s authority to operate the equipment. IC WARNING This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

MeLaSen Electronics Co., Ltd. No.29 Industrial Road, Xiaolan Industrial Estate, Xiaolan Town, Zhongshan City, Guangdong Province, 528415 China Tel: +86 13532008828 Fax: +86 76022824830 FCC ID: 2AYGE-M2445 POWER OF ATTORNEY 2020/12/25 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern: We, the undersigned, hereby authorize ITL Co., Ltd. (MR. Pauler LI, Manager) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by ITL Co., Ltd. (MR. Pauler LI, Manager) on our behalf shall have the same effect as acts of our own. This authorization expires on 2021/06/25. This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, (MeLaSen Electronics Co., Ltd.), are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, (MeLaSen Electronics Co., Ltd.) <SIGNATURE> (RUI YE) (General Manager)

MeLaSen Electronics Co., Ltd. No.29 Industrial Road, Xiaolan Industrial Estate, Xiaolan Town, Zhongshan City, Guangdong Province, China 528415 Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Gentlemen: This letter is to comply with Sections 0.457 and 0.459 pertaining to confidential material. MeLaSen Electronics Co., Ltd. would like the following documents regarding this submission for FCC ID: 2AYGE-M2445 to be kept confidential. Type of Confidentiality Requested Exhibit Short Term Permanent Block Diagrams Short Term External Photos Short Term Permanent* 1 Internal Photos Short Term Permanent Operation Description/Theory of Operation Short Term Permanent Parts List & Placement/BOM Short Term Permanent Tune-Up Procedure Short Term Permanent Schematics Short Term Test Setup Photos Short Term Permanent* User’s Manual The above material contains trade secrets or technical data, which would customarily be guarded from competitors. We do not want these documents to be accessible to the general public. Pursuant to sections 0.457 and 0.459 of CFR 47 and to avoid premature release of sensitive information prior to marketing or release of the product to the public, the applicant requests the following documents contained in this certification application be temporarily withheld from public disclosure for an initial period of 180 days. Sincerely, By: __________________________ RUI YE (Signature) (Print name) Title: General Manager On behalf of: MeLaSen Electronics Co., Ltd. (Company Name) Telephone: +86 13532008828

Page 1 of 5 External PHOTO: Model: M2445 Page 2 of 5 Page 3 of 5 Page 4 of 5 Page 5 of 5

25*40MM Model: M2445 FCC ID: 2AYGE-M2445 IC ID: 26807-M2445 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference.(2)This device must accept any interference received. including interference that may cause undesired.

Label location

Page 1 of 2 Internal PHOTO: Model: M2445 Antenna Page 2 of 2

ITL Page 1 of 22 Report No.: D201210015 TEST REPORT Applicant: MeLaSen Electronics CO., LTD Address of Applicant: No.29 Industrial Road, Xiaolan Industrial Estate, Xiaolan Town, Zhongshan City, Guangdong Province, P.R.China Manufacturer: MeLaSen Electronics CO., LTD Address of Manufacturer: No.29 Industrial Road, Xiaolan Industrial Estate, Xiaolan Town, Zhongshan City, Guangdong Province, P.R.China Product name: Remote Model: M2445 Rating(s): 2 x AAA batteries, 3Vdc Trademark: / Standards: 47 CFR PART 15 Subpart C: section 15.231 FCC ID: 2AYGE-M2445 Data of Receipt: 2020-11-26 Date of Test: 2020-11-26~2020-12-10 Date of Issue: 2020-12-11 Test Result Pass* * In the configuration tested, the test item complied with the standards specified above. Authorized for issue by: Test by: Reviewed by: Dec.11, 2020 Eleven Liang Dec.11, 2020 Pauler Li Project Engineer Project Engineer Date Name/Position Signature DateName/Position Signature ITL Page 2 of 22 Report No.: D201210015 Possible test case verdicts: test case does not apply to the test object .. : N/A test object does meet the requirement ........ : P (Pass) test object does not meet the requirement .. : F (Fail) Testing Laboratory information: Testing Laboratory Name .......... : ITL Co., Ltd. Address : No.8, JinQianLing street 5, DongHuan Road, Huangjiang Town, Dongguan, China. Testing location : Same as above Tel : 0086-769-39001678 Fax : 0086-20-62824387 E-mail : [email protected] General remarks: The test results presented in this report relate only to the object tested. The results contained in this report reflect the results for this particular model and serial number. It is the responsibility of the manufacturer to ensure that all production models meet the intent of the requirements detailed within this report. This report would be invalid test report without all the signatures of testing technician and approver. This report shall not be reproduced, except in full, without the written approval of the Issuing testing laboratory. General product information: / ITL Page 3 of 22 Report No.: D201210015 1 Test Summary Test Test Requirement Test method Result Radiated Emission FCC PART 15 section 15.231(b) ANSI C 63.10: Clause 6.4, 6.5 and 6.6 PASS Occupied Bandwidth FCC PART 15 section 15.231(c) ANSI C 63.10 PASS Dwell Time FCC PART 15 section 15.231(a) FCC PART 15: Section 15.231(a) PASS Conducted Emission / / N/A Remark: N/A: because the device is battery operated. EUT: In this whole report EUT means Equipment Under Test. Tx: In this whole report Tx (or tx) means Transmitter. Rx: In this whole report Rx (or rx) means Receiver. RF: In this whole report RF means Radio Frequency. ANSI C63.10: the detail version is ANSI C63.10:2013 in the whole report. ITL Page 4 of 22 Report No.: D201210015 2 Contents TEST REPORT ....................................................................................................................................................................... 1 1 TEST SUMMARY ......................................................................................................................................................... 3 2 CONTENTS ................................................................................................................................................................... 4 3 GENERAL INFORMATION ........................................................................................................................................ 5 3.1 CLIENT INFORMATION ............................................................................................................................................ 5 3.2 GENERAL DESCRIPTION OF E.U.T. ....................................................................................................................... 5 3.3 DETAILS OF E.U.T. ................................................................................................................................................ 5 3.4 DESCRIPTION OF SUPPORT UNITS ........................................................................................................................ 5 3.5 TEST LOCATION ..................................................................................................................................................... 6 3.6 DEVIATION FROM STANDARDS .............................................................................................................................. 6 3.7 ABNORMALITIES FROM STANDARD CONDITIONS .................................................................................................. 6 3.8 OTHER INFORMATION REQUESTED BY THE CUSTOMER ....................................................................................... 6 3.9 TEST FACILITY ....................................................................................................................................................... 6 3.10 MEASUREMENT UNCERTAINTY .............................................................................................................................. 6 4 INSTRUMENTS USED DURING TEST .................................................................................................................... 7 5 TEST RESULTS ........................................................................................................................................................... 8 5.1 E.U.T. TEST CONDITIONS ...................................................................................................................................... 8 5.2 RADIATED EMISSIONS ........................................................................................................................................... 9 5.3 OCCUPIED BANDWIDTH ....................................................................................................................................... 18 5.4 DWELL TIME ..............................................................................................…

Text truncated - open the document above for the full version.

Page 1 of 2 TEST PHOTO: Page 2 of 2