2BBCYUHY-01Multi-functional Amateur Radio

Multi Scan Mode Channel Scan / Prior Channel ScanCompandor Scrambler Whisper Foreword Thank you for choosing the FM two way radio. This product is de signed to meet the requirements of a radio that is easy to operate and give ex cellent perfor- mance.Please read this manual carefully before using the radio. The i nformation herein will help you to find the maximum performance, operating method and maintenance of your radio. PRODUCT INSPECTIONBefore using, you are recommended to inspect the products as fo llows. First check the shipping carton for any signs of damage. If any damage has occurred, ple ase contact your dealer immediately. Confirm the supplied product against the packing slip to accura cy. 265g 199 5.00/6.25/10.00/12.50/25.00KHz 7.4V Frequency Range Channel Capacity Frequency Spacing Working Voltage Operating Temperature Range -25 ~ 60 Dimension (L×W×H) 123.5mm×59mm×40mm Weight (including Antenna andBattery) TX:420-450MHz RX:400-480MHz GENERAL RECEIVER Receiving Sensitivity 0.18uV Audio Output Power 1W Audio Distortion ” TRANSMITTER Output power 2W/5W/10W Audio Distortion ” FEATURES 199 ChannelsCTCSS (50)DCS (214 )VOX / VOX Delay FunctionTime-out TimerRogerKeypad LockScan CTCSS / DCSChannel Scan / Prior Channel ScanAuto Power Off and Battery SavingEmergency CallChannels NamedThree Operation ModesMenu / Shortcut Key OperationFM RadioTail Tone EliminateCompandorScramblerWhisper High Output Power FM Two Way Radio High Output Power FM Two Way Radio WARNING MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and(2) this device must accept any interference including received interference th at may cause undesired operation. The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Suc h modifications could void the user’s authority to operate the eq uipment. Replacement of any transmitter component (crystal, semiconducto r, etc) not authorized by the FCC equipment authorization for this radi o could violate FCC rules. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:— Reorient or relocate the receiving antenna.— Increase the separation between the equipment and receiver.— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.— Consult the dealer or an experienced radio/TV technician for help. CONTENTPRODUCT INSPECTIONRADIO OVERVIEWSPREPARATIONBattery InformationAttachment Installing & RemovingBASIC OPERATIONSPower SwitchVolume AdjustmentSquelch AdjustmentChannel SelectionTransmitterReceiverFUNCTIONS OPERATIONSThe Shortcut KeyFunctions of MENU Functions of MENU Operations FM RADIO OPERATIONSFREQUENCY (MHz) LIST TABLECTCSS FREQUENCY CHARTDCS CODES TABLE 23-2425-26 2526 01 02-0304-0704-0606-0708-09 080808080909 10-2410-1112-1314-22 High Output Power FM Two Way Radio High Output Power FM Two Way Radio Charger AC Adaptor Hand Strap Belt Clip Screws User’s Man ual Antenna Li-poly Battery Main Unit RADIO OVERVIEWS (1) Antenna(5) Power & Volume Knob (9) PTT Key (2) Speaker(6) LED indicator(10) Lamp Key (3) MIC(7) LCD Display(11) Monitor Key (4) Channel Selector Knob(8) Keyboard(12) MIC/SPK Jack PRODUCT INSPECTIONPlease unpack the package box carefully and check that all item s shipped are received; report any missing or damaged items to your dealer. High Output Power FM Two Way Radio 01 High Output Power FM Two Way Radio 02 Belt C lip QTY. (pcs) Items Antenna Li-poly Battery Desk-top Charger AC Adaptor Belt Clip Screws of Belt Clip Hand Strap User’s Manual Main Unit Headset Headset Programming Cable Programming Cable 1 11 1 111 2 11 Screws g ra mming Ca LCD Display Keyboard Lockup IndicatorCTCSS Tones IndicatorDCS Tones IndicatorFrequency Shift Positive / Opposite Direction IndicatorIndicator When Frequency ReverseBattery Saver IndicatorBattery Capacity IndicatorScan Add IndicatorNarrow Bandwidth IndicatorVOX Function Enabled Signal Strength Indicator The more bars, the stronger signals. Low Output Power IndicatorHigh Output Power Indicator FM Radio Status Indicator PREPARATIONBattery InformationApplicable Battery PacksTo reduce the risk of injury, charge only the Ex-battery specif ied by the manufacturer. Unauthorized batteries could result in failure of Ex-protection and thus cause bodily injury and property damages.The average life of Ex-battery pack is 16 hours. Average times are calculated using 5% transmit, 5% receive and 90% standby. Caution: To avoid risk of personal injury, do not dispose of batteries i n fire! Dispose of batteries according to local regulations (e.g. recyc ling). Do not dispose as household waste.Never attempt to disassemble the battery. Battery Tips When charging your battery, keep it at a temperature among 5 - 40 . Temperature out of the limit may cause battery leakage or damage.When charging a battery attached to a radio, turn the radio off to ensure a full charge. Do not return fully charged batteries to a charger for an “extr a boost”. This action will significantly reduce battery …

Text truncated - open the document above for the full version.

Lisheng Communication Co., Ltd. 5#, Chongxiang St., Econ. & Tech. Area, Quanzhou, Fujian, China Agent Authorization Company: Lisheng Communications Co., Ltd. Address: 5#, Chongxiang St., Econ. & Tech. Area, Quanzhou, Fujian, China Product Name: Multi-functional Amateur Radio Model Number(s): UHY-01 Product Description: Multi-functional Amateur Radio We authorize MiCOM Labs Inc., 575 Boulder Court, Pleasanton, California 94566, USA, to act on our behalf on all matters concerning the certification of above named equipment. We declare that MiCOM Labs Inc. is allowed to forward all information related to the approval and certification of equipment to the regulatory agencies as required and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Signature: Date: 2023-06-21 Name: HanYang Qiu Company: Lisheng Communications Co., Ltd.

Lisheng Communication CO., LTD. 5#, Chongxiang St., Econ. & Tech. Area, Quanzhou, Fujian, China Date: 2023-06-20 Declaration Letter FEDERAL COMMUNICATIONS COMMISSION Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: Declaration of compliance to the requirements of §15.121 with FCC ID: 2BBCYUHY-01 Dear Sir/Madam, We declare that, this scanning receiver is incapable of operating (tuning), or readily being altered by the users to operate, within the frequency bands allocated to the Cellular Radiotelephone Service in part 22 of this chapter (cellular telephone bands). This device will not be able to receive transmissions in the cellular telephone bands by means of clipping the leads of, or installing, a simple component such as a diode, resistor or jumper wire; replacing a plug-in semiconductor chip; or programming a semiconductor chip using special access codes or an external device, such as a personal computer. This device is also incapable of converting digital cellular communication transmissions to analog voice audio. This device is designed so that the tuning, control and filtering circuitry is inaccessible. Any attempts to modify the equipment to receive transmissions from the Cellular Radiotelephone Service will render the receiver inoperable. This scanning receiver rejects any signals from the Cellular Radiotelephone Service frequency bands that are 38 dB or lower based upon a 12 dB SINAD measurement. We are aware that the modification of this device to receive transmissions from Cellular Radiotelephone Service frequency bands will be considered to constitute manufacture of such equipment. This includes any individual, individuals, entity or organization that modifies one or more scanners. Any modification to receive transmissions from the Cellular Radiotelephone Service frequency bands voids the certification of the scanning receiver, regardless of the date of manufacture of the original unit. Sincerely Yours, Signature: ___________________________ Contact person: HanYang Qiu

Report No.: AGC15733230602AP02 Page 1 of 4 EXTERNAL PHOTOS All VIEW OF EUT TOP VIEW OF EUT Antenna Report No.: AGC15733230602AP02 Page 2 of 4 BOTTOM VIEW OF EUT FRONT VIEW OF EUT Report No.: AGC15733230602AP02 Page 3 of 4 BACK VIEW OF EUT LEFT VIEW OF EUT Report No.: AGC15733230602AP02 Page 4 of 4 RIGHT VIEW OF EUT ****************************************End of Report*************************************

FCC ID Label Location 40mm&40mm FCC ID: 2BBCYUHY-01

Report No.: AGC15733230602AP02 Page 1 of 6 INTERNAL PHOTOS OPEN VIEW OF EUT (FIGURE 1) OPEN VIEW OF EUT (FIGURE 2) Report No.: AGC15733230602AP02 Page 2 of 6 OPEN VIEW OF EUT (FIGURE 3) INTERNAL VIEW OF EUT (FIGURE 1) Report No.: AGC15733230602AP02 Page 3 of 6 INTERNAL VIEW OF EUT (FIGURE 2) INTERNAL VIEW OF EUT (FIGURE 3) Report No.: AGC15733230602AP02 Page 4 of 6 INTERNAL VIEW OF EUT (FIGURE 4) INTERNAL VIEW OF EUT (FIGURE 5) Report No.: AGC15733230602AP02 Page 5 of 6 INTERNAL VIEW OF EUT (FIGURE 6) INTERNAL VIEW OF EUT (FIGURE 7) Report No.: AGC15733230602AP02 Page 6 of 6 INTERNAL VIEW OF EUT (FIGURE 8) ****************************************End of Report*************************************

Page 1 of 25 FCC Test Report Report No.: AGC15733230602FE08 FCC ID : 2BBCYUHY-01 APPLICATION PURPOSE : Original Equipment PRODUCT DESIGNATION : Multi-functional Amateur Radio BRAND NAME : MOHANTON MODEL NAME : UHY-01 APPLICANT : Lisheng Communications Co., Ltd. DATE OF ISSUE : Jun. 19, 2023 STANDARD(S) : FCC Part 15 Rules REPORT VERSION : V 1.0 Attestation of Global Compliance (Shenzhen) Co., Ltd Report No.: AGC15733230602FE08 Page 2 of 25 REPORT REVISE RECORD Report Version Revise Time Issued Date Valid Version Notes V1.0 / Jun. 19, 2023 Valid Initial Release Report No.: AGC15733230602FE08 Page 3 of 25 TABLE OF CONTENTS 1. VERIFICATION OF COMPLIANCE ................................................................................................................. 4 2. PRODUCT INFORMATION .............................................................................................................................. 5 3. IDENTIFICATION OF THE RESPONSIBLE TESTING LOCATION ............................................................... 6 4. SUPPORT EQUIPMENT LIST ......................................................................................................................... 7 5. SYSTEM DESCRIPTION .................................................................................................................................. 7 6. MEASUREMENT UNCERTAINTY ................................................................................................................... 8 7. SUMMARY OF TEST RESULTS ..................................................................................................................... 8 8. FCC RADIATED EMISSION TEST .................................................................................................................. 9 8.1 PROVISIONS APPLICABLE ................................................................................................................... 9 8.2 TEST SETUP BLOCK DIAGRAM ........................................................................................................... 9 8.3 TEST PROCEDURE .............................................................................................................................. 11 8.4 TEST RESULT ....................................................................................................................................... 12 9. FCC CONDUCTED EMISSION TEST ............................................................................................................ 16 9.1 PROVISIONS APPLICABLE ................................................................................................................. 16 9.2 TEST SETUP BLOCK DIAGRAM ......................................................................................................... 16 9.3 TEST PROCEDURE .............................................................................................................................. 17 9.4 TEST RESULT ....................................................................................................................................... 18 10. ANTENNA CONDUCTED POWER FOR RECEIVERS ............................................................................... 20 10.1 PROVISIONS APPLICABLE ............................................................................................................... 20 10.2 TEST SETUP BLOCK DIAGRAM ....................................................................................................... 20 10.3 TEST PROCEDURE ............................................................................................................................ 20 10.4 TEST RESULT ..................................................................................................................................... 21 11. SCANNING RECEIVERS AND FREQUENCY CONVERTERS USED WITH SCANNING RECEIVERS .. 23 11.1 PROVISIONS APPLICABLE ............................................................................................................... 23 11.2 TEST SETUP BLOCK DIAGRAM ....................................................................................................... 23 11.3 TEST PROCEDURE ............................................................................................................................ 23 11.4 TEST RESULT ..................................................................................................................................... 24 APPENDIX I PHOTOGRAPHS OF TEST SETUP ............................................................................................. 25 APPENDIX II: PHOTOGRAPHS OF TEST EUT................................................................................................ 25 Report No.: AGC15733230602FE08 Page 4 of 25 1. VERIFICATION OF COMPLIANCE Applicant Lisheng Communications Co., Ltd. Address 5#, Chongxiang St., Econ. & Tech. Area, Quanzhou, Fujian, China Manufacturer: Lisheng Communications Co., Ltd. Address 5#, Chongxiang St., Econ. & Tech. Area, Quanzhou, Fujian, China Factory Lisheng Communications Co., Ltd. Address 5#, Chongxiang St., Econ. & Tech. Area, Quanzhou, Fujian, China Product Designation Multi-functional Amateur Radio Brand Name MOHANTON Test Model UHY-01 Measurement Procedure ANSI C63.4: 2014 Deviation No any deviation from the test method. Date of receipt of test item Jun. 06, 2023 Date of Test Jun. 06, 2023~Jun. 19, 2023 Condition of Test Sample Normal Test Result Pass Report Template AGCRT-US-PTT/EMC The above equipment was tested by Attestation Of Global Compliance (Shenzhen) Co., Ltd. for compliance with the requirements set forth in the FCC Rules and Regulations Part 15, the measurement procedure according to ANSI C63.4:2014. This said equipment in the configuration described in this report shows the maximum emission levels emanating from equipment are within the compliance requirements. The test results of this report relate only to the tested sample identified in this report. …

Text truncated - open the document above for the full version.

Report No.: AGC15733230602AP01 Page 1 of 2 TEST SETUP PHOTOS RADIATED EMISSION TEST SETUP BELOW 1GHz RADIATED EMISSION TEST SETUP ABOVE 1GHz Report No.: AGC15733230602AP01 Page 2 of 2 AC POWER LINE CONDUCTED TEST SETUP ****************************************End of Report*************************************