A25-TX005RFan Remote Controler

MODEL:TX005 TX005-R OPERATION INSTRUCTION Learning Code -With the main power on, press the HI & LOW button on the transmitter at the same time and hold for 5 seconds could achieve the learning code. ● Remote Functions: ● ● Light Source Auto-recognition Technique :Be able to recognize incandescent and CFL automatically. Switch Off Memory - when power is off and back again, resume the status of both light and fan before switch off. 12V Front Back 1 2 3 12V 4 Back TX005 TX005-R : , ◎ ◎ : . 1.Fan speed control button To control the ceiling fan speed HIGH MEDIUM,LOW. 2.FAN/OFF button:Turn off the fan; Press and hold for 5 seconds to enter Light Delay Off mode. 3.LIGHT ON/OFF/DIMMER button To control light on,off and dimmer Note:Install the 12-volt battery(not included) to the remote control. : , ◎ ◎ : . :. 1.Fan speed control button To control the ceiling fan speed HIGH MEDIUM,LOW. 2.FAN/OFF button:Turn off the fan; Press and hold for 5 seconds to enter Light Delay Off mode. 3.LIGHT ON/OFF/DIMMER button To control light on,off and dimmer Reverse function button To control fan direction4. OPERATION INSTRUCTION ●Products shall be subject to any changes without additional notices due to DawnSun will keep innovation and optimization on the products. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference This device must accept any interference received including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment . . ,(2) NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and use in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1.Reorient or relocate the receiving antenna. 2.Increase the separation between the equipment and receiver. 3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4.Consult the dealer or an experienced radio/TV technician for help. ,

SchDiagram Transmitter Circuit Reference Oscillation Source (315MHz) Button/Coding Indicating Circuit MCU Battery/Power Supply Circuit

General Appearance of the EUT

FCC ID Label FCC ID:A25-TX005R This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This devices may not cause harmful interference, (2)This device must accept any interference received,including interference that may cause undesired operation. 28 30 MODEL:TX005 TX005-R

Internal Photo

Operation Description All are “OOK” modulation transmitter circuit, transmission frequency is 315Mz, consists of Power Supply Circuit (12V), Master Control MCU, Transmitter Circuit (315Mz), Reference Oscillation Source, Keyboard Scanning Circuit and Indicating Circuit.

11 22 33 44 D D C C B B A A Title Number Revision Size A4 Date: 2011/11/25 Sheet of File: E:\ 产品开发管理 \..\TX001.SchDoc Drawn By: S4HI/3S3 MED/2 +12V 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 10 10 11 11 12 12 13 13 14 14 15 15 16 16 IC1TI1106-3D7A LED1RED S2LOW/1S1 FAN-OFF/0 C10104 GND GND S5DIM/ON/OFF R72.7K C1104 VCC R14.7M R24.7M Q1 2SK3018 GND 2 31 S6NC VSS R6200 R510K~180K C936PC79P SAW1 315MHZ R468~240 Ω C4221 R310 1 2 L1 Φ 1.2*5.75T （线径 Φ 0.42 ） C87P C32P C624P C530P C22.2P GND GND GND GND 1 23 Q2 R25 TX001/-RTX004/-RTX005/-R S6TX001-R √ TX004-R √ TX005-R √

REPORT NO.: FTS11GR-056E FCC ID: A25-TX005R DATE: 11/25/2011 Page 1 of 22 ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT INTENTIONAL RADIATOR CERTIFICATION TO FCC PART 15 SUBPART C REQUIREMENT OF FAN REMOTE CONTROLLER MODEL No.: TX001,TX001-R,TX004,TX004-R,TX005, TX005-R FCC ID: A25-TX005R REPORT NO: FTS11GR-056E ISSUE DATE: Nov. 25, 2011 Prepared for DawnSun Electronic Technology.Co.,Ltd.ZhongShan NO.8 NANYI STREET ,XINGGONG RD SHAXI TOWN ZHONGSHAN,GUANGDONG 528471 CHINA Prepared by Future Test Services (Zhongshan)Co., Ltd. 2/F,NO.33 Xiangfeng South Road, Xiaolan Town, Zhongshan City, Guangdong Province, China. Tel : +86-760-22582758 Fax: +86-760-22582768 REPORT NO.: FTS11GR-056E FCC ID: A25-TX005R DATE: 11/25/2011 Page 2 of 22 VERIFICATION OF COMPLIANCE Applicant: DawnSun Electronic Technology.Co.,Ltd.ZhongShan NO.8 NANYI STREET ,XINGGONG RD SHAXI TOWN ZHONGSHAN, GUANGDONG 528471 CHINA Manufacturer DawnSun Electronic Technology.Co.,Ltd.ZhongShan NO.8 NANYI STREET ,XINGGONG RD SHAXI TOWN ZHONGSHAN, GUANGDONG 528471 CHINA Product Description: FAN REMOTE CONTROLLER Integral PCB antenna 0dBi Pulse train modulation OOK Model Number: Basic Model: TX005-R Additional Model: TX001,TX001-R,TX004,TX004-R,TX005, TX005-R Serial Number: N/A File Number: FTS11GR-056E Date of Test: Nov.16, 2011 to Nov.25 2011 We hereby certify that: The above equipment was tested by DONGGUAN EMTEK Co., Ltd. The test data, data evaluation, test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4 (2009) and the energy emitted by the sample EUT tested as described in this report is in compliance with conducted and radiated emission limits of FCC 15 Paragraph 15.205, Paragraph 15.209, Paragraph 15.231,Paragraph 15.31, Paragraph 15.33, Paragraph 15.35. The test results of this report relate only to the tested sample identified in this report. Approved By Henry Wang / Manager Future Test Services (Zhongshan)Co., Ltd. REPORT NO.: FTS11GR-056E FCC ID: A25-TX005R DATE: 11/25/2011 Page 3 of 22 Ta b l e o f C o n t e n t s 1. GENERAL INFORMATION ................................................................................................. 4 1.1 PRODUCT DESCRIPTION........................................................................................................................... 4 1.2 RELATED SUBMITTAL(S) / GRANT (S) ..................................................................................................... 4 1.3 TEST METHODOLOGY.............................................................................................................................. 4 1.4 SPECIAL ACCESSORIES............................................................................................................................ 4 1.5 EQUIPMENT MODIFICATIONS.................................................................................................................. 4 1.6 TEST FACILITY........................................................................................................................................ 5 2. SYSTEM TEST CONFIGURATION .................................................................................... 6 2.1 EUT CONFIGURATION............................................................................................................................. 6 2.2 EUT EXERCISE........................................................................................................................................ 6 2.3 TEST PROCEDURE.................................................................................................................................... 6 2.4 LIMITATION............................................................................................................................................. 7 2.5 CONFIGURATION OF TESTED SYSTEM..................................................................................................... 8 3. SUMMARY OF TEST RESULTS ......................................................................................... 9 4. DESCRIPTION OF TEST MODES ...................................................................................... 9 5. CONDUCTED EMISSIONS TEST (NOT APPLICABLE IN THIS REPORT).......... 10 5.1 MEASUREMENT PROCEDURE:................................................................................................................ 10 5.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ....................................................................... 10 5.3 MEASUREMENT EQUIPMENT USED: ...................................................................................................... 10 5.4 MEASUREMENT RESULT:....................................................................................................................... 10 5.5 CONDUCTED MEASUREMENT PHOTOS: ...................................................................................................... 10 6. RADIATED EMISSION TEST ............................................................................................ 11 6.1 MEASUREMENT PROCEDURE................................................................................................................. 11 6.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION) ....................................................................... 12 6.3 MEASUREMENT EQUIPMENT USED: ...................................................................................................... 13 6.4 MEASUREMENT RESULT........................................................................................................................ 14 7. DEACTIVATION TESTING ............................................................................................... 16 7.1 REQUIREMENT....................................................................................................................................... 16 7.2 TEST SET-UP ..................................................................…

Text truncated - open the document above for the full version.

Setup Photos