A95-TURNON00Remote Control

12 VOLT AUTOMOTIVE CONTROL SYSTEM Thank you for purchasing the 2KOOL automotive 12-volt control system. This is the most advanced program- mable control system available today. This system can control interior and exterior neon, strobe, and LED lights, EL Logos, and customized functions. With an optional relay even more demanding applications such as trunk lids, shaved door handles and linear actuators can be controlled. Consult with a professional installer when high current applications are planned. THE 2KOOL SYSTEM The 2KOOL System has two components a Keypad, used to send the activation command, and the Receiver which responds to the commands turning the application on and off. KEYPAD The Keypad has nine buttons, eight of which can be used to send the on/off commands, and one which sends an off command to all trained Receivers. RECEIVER The Receiver when trained is used to turn your applications on and off. After training, the receiver will only respond to the button press you select. Each receiver has a different code so you don’t have to worry about interfering with another 2KOOL control system. CAUTION Please follow manufacturer’s installation recommendations when adding accessory items, particularly auxiliary lighting. Lights installed with a 2Kool controller may be intended for off-road or show use only. Check with your light manufacturer and local authorities before street use. Installation of any merchandise shall be the sole and absolute responsibility of the purchaser. See our web site at www.2kooltech.com or call 1-800-555-0000 complete details. SPECIFICATIONS KEYPAD 9 control buttons 8 for on/off and 1 for all off Self contained battery RECEIVER User programmable for the desired Keypad button Power input + 12 Volts and ground * Power output + 12 Volts and ground max current is 1 Amp* * The wire with the white stripe is + 12Volts Receiver Training Perform the following steps after the Receiver has been wired to a light or set of lights and 12 Volt power. 1. Remove the cover from the Receiver housing 2. Locate the small jumper block shown in the figure below. 3. Place the block over both pins on the Receiver circuit board. 4.Press the keypad button you wish to use several times. (You will see the light turn on and off) 5.Replace the jumper so that it only covers one pin. 6.Replace the cover on the Receiver. The Receiver will now respond to the key you pressed. Note: When the jumper covers both pins (training mode) the Receiver will respond to any key you press. The Receiver only remembers the last key you press as its assigned key. NOTE The range of the Keypad can be affected by where you put the receiver in the car. If you are having trouble activating the receiver with the Keypad move the receiver to another location. See the FAQ section of the 2KOOL website for more information. 2KOOL Technologies St. Charles, IL 60174 www.2kooltech.com Compliance Statement ( Part 15.19 ) This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation. Warning ( Part 15.21 ) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. CONNECTION Select the physical location of your application such as neon lights. Install the lights in accordance with the manufacturer recommendations. Connect the wire from the lights to the Receiver wire, this is the wire on the right hand side. The wire with the white stripe is the ( + ) wire the other wire is the ground wire. For power connect the wire coming from the left hand side of the receiver to a 12 V source and ground. The wire with the white stripe is +12 Volts, the other wire is connected to ground.

F C C CONFIDENTIALITY Date: 12/17/03 To: FEDERAL COMMUNICATIONS COMMISSION 7435 Oakland Mills Road Columbia, MD 21046 Subject: Request for Non disclosure for FCC ID: A95-TurnOn00 To Whom It May Concern: Pursuant to 47 CFR Section 0.459, Dukane Corporation hereby requests non disclosure and confidential treatment of the following materials submitted in support of FCC certification application for FCC ID # A95-TurnOn00 a. Schematic Diagrams b. Operational Description c. Block Diagram Above materials contain trade secrets, proprietary and technical information which would customarily be guarded from competitors under 47 CFR section 0.457(d)(2). Disclosure or publication of any portion of this company confidential material to other parties could cause substantial competitive harm and provide unjustified benefits for competitors. Dukane Corporation understands that pursuant to 47 CFR section 0.457(d)(1)(ii) disclosure of the applicant and all accompanying documentation will not be made before the date of the grant. Sincerely yours, Kenneth D. Neltnor / Director of Engineering Dukane Corporation Seacom Dukane Corporation Seacom Division 2900 Dukane Drive St. Charles, IL 60174 TEL: (630) 762-4050 FAX: (630) 762-4049 WEB: www.dukcorp.com/sc E-mail: [email protected]

Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo One – External Top View of Transmitter – Label / Keypad provides 9 Keys Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo Two – External Back View of Transmitter – FCC ID Label Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo Three – External Back View of Transmitter – FCC ID Label Close-up

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID : A95-TURNON00 Canada ID: 2333A-TURNON00 MODEL : Turn On Patent Pending Made in USA www.2kooltech.com

Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo One – Internal Open for Inspection Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo Two – Internal Battery Holders and Bottom of PCB Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo Three – Internal Component Side of PCB with RF Section Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo Four – Internal PCB Antenna and RF Section Dukane Corporation 2KOOL Automotive Control System UHF Transmitter FCC ID#: A95-TURNON00 Photo Five – Internal RF Section

Test Report #: 303485 TX c Page 1 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. L.S. Compliance, Inc. W66 N220 Commerce Court Cedarburg, WI 53012 262.375.4400 FAX: 262.375.4248 Compliance Testing of: “Turn On” Transmitter Prepared For: Dukane Corporation Attn.: Mr. Dan Kramer 2900 Dukane Drive St. Charles, IL 60174 Test Report Number: 303485 TX c Test Dates: January 12 th – 21 st and March 5 th , 2004 All results of this report relate only to the items that were tested. This report may not be reproduced, except in full, without written approval of L.S. Compliance, Inc. Test Report #: 303485 TX c Page 2 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. Table of Contents Section Description Page Index 2 1 L.S. Compliance in Review 3 2 A2LA Certificate of Accreditation 4 3 A2LA Scope of Accreditation 5 4 Validation Letter-U.S. Competent Body for EMC Directive 89/336/EEC 6 5 Signatures 7 6 Product and General Information 8 7 Introduction 8 8 Purpose 8 9 Product Description 9 10 Test Requirements 9 11 Summary of Test Report 9 12 Radiated Emissions Test 10-22 Appendices A Calculations 23 B Duty Cycle Correction 24-25 C Test Equipment List 26-27 Test Report #: 303485 TX c Page 3 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 1. L.S. Compliance in Review Brief Review of L.S. Compliance Accreditations and Listing’s As an EMC Testing Laboratory, our Accreditation and Assessments are recognized through the following: A2LA – American Association for Laboratory Accreditation Accreditation based on ISO/IEC 17025 : 1999 with Electrical (EMC) Scope of Accreditation A2LA Certificate Number: 1255.01 Federal Communications Commission (FCC) – USA Listing of 3 Meter Semi-Anechoic Chamber based on Title 47 CFR – Part 2.948 FCC Registration Number: 90756 Listing of 3 and 10 meter OATS based on Title 47CFR – Part 2.948 FCC Registration Number: 90757 Industry Canada On file, 3 Meter Semi-Anechoic Chamber based on RSS-212 – Issue 1 File Number: IC 3088-A On file, 3 and 10 Meter OATS based on RSS-212 – Issue 1 File Number: IC 3088 U. S. Conformity Assessment Body (CAB) Validation Validated by the European Commission as a U. S. Competent Body operating under the U. S. /EU, Mutual Recognition Agreement (MRA) operating under the European Union Electromagnetic Compatibility –Council Directive 89/336/EEC, Article 10.2. Date of Validation: January 16, 2001 Validated by the European Commission as a U.S. Notified Body operating under the U.S./EU, Mutual Recognition Agreement (MRA) operating under the European Union Telecommunication Equipment – Council Directive 99/5/EC, Annex V. Date of Validation: November 20, 2002 Notified Body Identification Number: 1243 Test Report #: 303485 TX c Page 4 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 2. A2LA Certificate of Accreditation Test Report #: 303485 TX c Page 5 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 3. A2LA Scope of Accreditation Test Report #: 303485 TX c Page 6 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 4. Validation Letter – U. S. Competent Body for EMC Directive 89/336/EEC Test Report #: 303485 TX c Page 7 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 5. Signatures Prepared By: April 2, 2004 Teresa A. White, Document Coordinator Date Tested By: April 2, 2004 Abtin Spantman, EMC Engineer Date Approved By: April 2, 2004 Kenneth L. Boston, EMC Lab Manager Date PE # 31926 Licensed Professional Engineer Registered in the State of Wisconsin, United States Test Report #: 303485 TX c Page 8 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 6. Product and General Information Manufacturer: Dukane Corporation Model No.: Turn On Serial No.: 04 Test Frequency & Voltage: 6 VDC, 433.92 MHz Environmental Conditions in the Test Lab : Temperature: 20-25° C Atmospheric Pressure: 86 kPa - 106 kPa Humidity: 30-60% 7. Introduction On January 12 th through 21 st and March 5 th , 2004 a series of Radiated Emissions tests were performed on one sample of the Dukane Corporation “Turn On” Transmitter, Serial Number 04, here forth referred to as the “Equipment Under Test” or “EUT”. This product operates at a frequency of 433.92 MHz, by means of amplitude-shift-keying (ASK) of binary encoded data. These tests were performed using the test procedure outlined in ANSI C63.4, 2001 for intentional radiators, and in accordance with the limits set forth in FCC Part 15.231 for a periodic operation of a low power transmitter. 8. Purpose The tests were performed in order to determine the compliance of the EUT with limits contained in various provisions of Title 47CFR, FCC Part 15, including: 15.35, 15.205, 15.209 and 15.231(b). All Radiated Emission tests were performed to measure the emissions in the frequency bands described later in this report, and to determine whether said emissions are below the limits established by the aforementioned standards. These tests were performed in accordance with the procedures described in the American National Standard for methods of measurements of Radio-Noise Emissions from Low- Voltage Electrical and Electronic Equipment in the Range of 9 kHz to 40 GHz (ANSI C63.4, 2001). Also used as a reference for the EMI Receiver specification is the International Special Committee on Radio Interference – CISPR 16-1, 2002. Test Report #: 303485 TX c Page 9 of 27 Prepared For: Dukane Corporation Prepared By: L.S. Compliance, Inc. 9. Product Description This is a system for controlling a device on a vehicle with an onboard battery, such as an automobile. The system consists of a portable transmitter and a receiver. A portable wireless remote control unit sends a coded message to a receiving unit. The receiving unit, upon detecting a valid signal, provides onboard battery voltage to a remote location. This voltage is toggled on or off, when the receiving unit detects …

Text truncated - open the document above for the full version.

Photo(s) of Radiated Emission Test Setup View of the EUT in Horizontal Orientation This Orientation had the Highest Fundamental Emissions Measured. View of the EUT in the Side Orientation Photo(s) of Radiated Emission Test Setup (continued) View of the EUT in the Vertical Orientation