ACJ96NKX-FPG391Facsimile with 5.8 GHz FHSS Cordless Telepone Base

EXHIBIT A STATEMENT OF SECURITY CODE This cordless telephone system has 1,099 billion digital security coding combinations that are provided by the following means: • Provided with 40 bits (1,099 billion) for security codes. • When shipped from the factory, the security code is decided by the manufacture. It is memorized in a memory IC. • Base and Handset knows each other’s security code information.

BASE UNIT POWER SUPPLY UNI T 5V 24V 24V 24V PG PG DG 8V G/A RESET KSCLK KTXD KRXD KLATCH KSTART +5V GND LCD MI CI N -5V C_ LI NEOUT F_ LI NEOUT LI NE_ SZ RLY SI DETONE_ CTL CI DI N LI NEI N BELL KEY +5VA DGAG 24V MI C CBUSY2 CBUSY1 CSO CSI CCLK S_ENB CRESET DG DG 5VD 5VA AG AG COM COM GND GND 5V TM STB1 STB2 THCLK THLAT THDAT RX_ MOTOR TX_ MOTOR MR( 3) COM MR( 2) MR( 1) MR( 0) MT( 3) COM MT( 2) MT( 1) MT( 0) CI S V_LED G_LED F1 +5V FTG GND SIG ANALOG BOARD DI GTAL BOARD CORDLESS BASE BOARD OPERATI ON BOARD THERMAL HEAD FPG391 Block Diagram L_ DCI N CLK AC ADAPTER PORTABLE HANDSET CHARGER FILM END PTOP REED LED 5V_DOWN SPMUTE RF BLOCK DSP ASI C MODEM ROM RAM MOTOR DRIVER MOTOR DRIVER

RF Unit for Base unit PLL2 2398-2483MHz 2nd Local delta-sigma Modulator PLL1 129.6MHz Mixer Crystal 13.824 MHz Discrimi nator Slicer Baseset 3359.67794MHz1st LO PLL IF=2MHz BW=900kHz IF=2MHz ANT 1 RXDATA DOWN CONVERTER 5.725-5.85GHz LC BPF PLL3 BLOCK LNA Power Amplifier IC701 5.725-5.85GHz LC BPF UP CONVERTER Power Amplifier LNA IC801 TXDATA IC891 ANT 2 ANT1 ANT2 Q871 IC851

EXHIBIT C KX-FPG391 EXHIBIT C Rear View

EXHIBIT B MARKINGS Base Unit: The base unit provides with the following markings, or equivalent. NOTE: Above markings are shown on rear of the base unit. Nameplate

EXHIBIT C Internal View EXHIBIT C TEL Circuit Board EXHIBIT C TEL Circuit Board (Another Side) EXHIBIT C Digital Board EXHIBIT C Digital Board (Another Side) EXHIBIT C RF Board EXHIBIT C RF Board (Metal Cover Open) EXHIBIT C RF Board (Another Side) EXHIBIT C Power Supply Board EXHIBIT C Power Supply Board (Another Side)

Facsimile with 5.8GHz FHSS Cordless Telephone MODEL: KX-FPG391(xx) FCC ID: ACJ96NKX-FPG391 Applicant: Matsushita Electric Industrial Co., Ltd. 1006 Oaza Kadoma Kadoma Osaka 571 Japan In Accordance With Federal Communications Commission (FCC) Part 15, Subpart C, Section 15.247 Frequency Hopping Spread Spectrum Transmitters Operating in the 5725 – 5850 MHz Band UltraTech's File No.: PAN-051F15C247 This Test report is Issued under the Authority of Tri M. Luu, Professional Engineer, Vice President of Engineering UltraTech Group of Labs Date: May 10, 2004 Report Prepared by: Dan Huynh Issued Date: May 10, 2004 Tested by: Mr. Hung Trinh, EMC/RFI Technician Test Dates: April 23 – May 4, 2004 ƒ The results in this Test Report apply only to the sample(s) tested, and the sample tested is randomly selected. ƒ This report must not be used by the client to claim product endorsement by NVLAP or any agency of the US Government. UltraTech 3000 Bristol Circle, Oakville, Ontario, Canada, L6H 6G4 Tel.: (905) 829-1570 Fax.: (905) 829-8050 Website: www.ultratech-labs.com , Email: [email protected], Email: [email protected] 2 31040/SIT C-1376 46390-2049 200093-0 SL2-IN-E-1119R 00-034 FCC Part 15, Subpart C, Section 15.247 - Frequency Hopping Spread Spectrum Transmitters Contents i Facsimile with 5.8GHz FHSS Cordless Telephone, Model No.: KX-FPG391(xx) FCC ID: ACJ96NKX-FPG391 ULTRATECH GROUP OF LABS File #: PAN-051F15C247 3000 Bristol Circle, Oakville, Ontario, Canada L6H 6G4 May 10, 2004 Tel. #: 905-829-1570, Fax. #: 905-829-8050, Email: [email protected], Website: http://www.ultratech-labs.com All test results contained in this engineering test report are traceable to National Institute of Standards and Technology (NIST) TABLE OF CONTENTS EXHIBIT 1. INTRODUCTION .......................................................................................................................................................... 1 1.1. SCOPE .......................................................................................................................................................................................... 1 1.2. RELATED SUBMITTAL(S)/GRANT(S)..................................................................................................................................... 1 1.3. NORMATIVE REFERENCES ..................................................................................................................................................... 1 EXHIBIT 2. PERFORMANCE ASSESSMENT ............................................................................................................................... 2 2.1. CLIENT INFORMATION ............................................................................................................................................................ 2 2.2. EQUIPMENT UNDER TEST (EUT) INFORMATION............................................................................................................... 2 2.3. EUT’S TECHNICAL SPECIFICATIONS.................................................................................................................................... 3 2.4. LIST OF EUT’S PORTS............................................................................................................................................................... 3 2.5. ANCILLARY EQUIPMENT ........................................................................................................................................................ 3 EXHIBIT 3. EUT OPERATING CONDITIONS AND CONFIGURATIONS DURING TESTS................................................. 4 3.1. CLIMATE TEST CONDITIONS ................................................................................................................................................. 4 3.2. OPERATIONAL TEST CONDITIONS & ARRANGEMENT FOR TESTS............................................................................... 4 EXHIBIT 4. SUMMARY OF TEST RESULTS................................................................................................................................ 5 4.1. LOCATION OF TESTS................................................................................................................................................................ 5 4.2. APPLICABILITY & SUMMARY OF EMC EMISSION TEST RESULTS ................................................................................ 5 4.3. MODIFICATIONS INCORPORATED IN THE EUT FOR COMPLIANCE PURPOSES.......................................................... 5 EXHIBIT 5. MEASUREMENTS, EXAMINATIONS & TEST DATA FOR EMC EMISSIONS ................................................ 6 5.1. TEST PROCEDURES .................................................................................................................................................................. 6 5.2. MEASUREMENT UNCERTAINTIES ........................................................................................................................................ 6 5.3. MEASUREMENT EQUIPMENT USED ..................................................................................................................................... 6 5.4. ESSENTIAL/PRIMARY FUNCTIONS AS DECLARED BY THE MANUACTURER............................................................. 6 5.5. COMPLIANCE WITH FCC PART 15 – GENERAL TECHNICAL REQUIREMENTS ............................................................ 7 5.6. AC POWER LINE CONDUCTED EMISSIONS [47 CFR §15.107(a)] ....................................................................................... 9 5.7. HOPPING CHANNEL CARRIER FREQUENCY CHARACTERISTICS [47 CFR §§ 15.247(a)(1) & (a)(1)(iii)] .................. 13 5.8. PEAK OUTPUT POWER & EQUIVALENT ISOTROPIC RADIATED POWER (EIRP) [47 CFR § 15.247(b)].................... 31 5.9. RF EXPOSURE REQUIRMENTS [47 CFR §§ 15.247(b)(5) & 1.1310] .............................................................................…

Text truncated - open the document above for the full version.

ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 1 Radiated Emissions at 3 M ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 2 Radiated Emissions at 3 M ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 3 Radiated Emissions at 3 M

ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 1 AC Power Line Conducted Emissions (Front View) ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 2 AC Power Line Conducted Emissions (Side View) ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 3 Radiated Emissions at 3 M ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 4 Radiated Emissions at 3 M ANNEX 1 - TEST SETUP PHOTOS Matsushita Electric Industrial Co., Ltd. Facsimile with 5.8GHz FHSS Cordless Telephone Model KX-FPG391(xx) A1 - 5 Radiated Emissions at 3 M