BTQ170495RF Transceiver module

Shenzhencoolwave communication Co,ltd CWMRF01-A 1 Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: z Reorient or relocate the receiving antenna. z Increase the separation between the equipment and receiver. z Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. z Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter. Module Device This device is intended only for OEM integrators under the following conditions: OEM integrator is still responsible for testing their end product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.). IMPORTANT NOTE : In the event that these conditions can not be met (for example certain laptop configurations or co-location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC authorization. Without Co-located The antenna(s) used for this transmitter must not be co-located or operating in conjunction Shenzhencoolwave communication Co,ltd CWMRF01-A 2 with any other antenna or transmitter. Modular OEM Integrator Notice End Product Labeling The final end product must be labeled in a visible area with the following: “Contains TX FCC ID: BTQ170495”. CWMDP01 UART WIRELESS TRANSCEIVER MODULE PRODUCT BRIEF CWMDP01 UART transparent wireless transceiver module is based on the chip of Semtech XE1201Amonophonic module, which operating frequency is 300 500MHz.This kind of module adopt the design of low transmission frequencyhigh Rx sensitivity, highly satisfies with European ETSIEN300-220-1 and EN301-439-3and FCC 15.231(a),complies with the demand of wireless controlno need to apply for frequency using license. Low consumptionRx current 12MA High integration Switching time is short No need to do second development .APPLICATIONS z RF security system z Process controlwireless sensing z Vehicle door control z keyless entrybuilding control KEY PRODUCTS SPECIFICATION Shenzhencoolwave communication Co,ltd CWMRF01-A 3 Item CWMDP01 Frequency 433.92MHz Voltage 5V Sensitivity -108dBm Modulation FSK Speed 25kbps Transmitting distance 20m Tx current 16mA Rx current 10mA Operating humidity 10%~90% relative humidity, no condensation Operating temperature -20~60

Confidential Letter Date: 2007/4/9 Federal Communications Commission Authorization and Evaluation Division FCC ID：BTQ170495 Permanent Confidentiality Request Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules, the Applicant Hereby requests confidential treatment of information accomparting this Application As outlined below: 1. Block Diagram 2. Circuit Diagram 3. Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. The Applicant understands that pursuant to Rule 0.457, disclosure of this Application and all accompanying documentation will not be made before the date of the Grant for this application Sincerely, Applicant’s company name : Model Rectifier Corporation Applicant’s company address : 80 Newfield Avenue Edison, New Jersey 08837 USA Signature : _________________________________ Job Title and Dept. : Steve Lin / Chief Enginer

Module Approval Request Letter Subject: Module Approval Date: Apr. 13, 2007 FCC ID: BTQ170495 Dear Reviewer, We, Sporton International Inc., are authorized by Model Rectifier Corporation to have their state-of-the-art RF transceiver module approved under module approval authorization. The application of this module is specified to portable host and mobile host equipment. The requirements regulated in Public Notice DA00-1407 have been fulfilled and clearly explained below. 1. The requirement of RF shielding: The shielding of the radio portion can be demonstrated in exhibition External Photo. 2. The requirement of buffered inputs: Buffered data inputs stage has been integrated in chip atmega 48. 3. The requirement of power supply regulation: The part number of the power regulator is 7805. 4. The requirements of section 15.203 and 15.204(C): The requirements of antenna connector and spurious emission have been fulfilled. Please reference the exhibition Test Report. 5. The requirement of stand-alone test configuration: Please reference exhibition Test Configuration Photo for the stand-alone test configuration. 6. The requirement of labeling: The instruction on the labeling rule of the end product has been stated in the users manual of this module. Please also see the exhibition Label Sample. 7. The requirement of compliance on specific rule or operating requirements: The required FCC rule has been fulfilled and all the instructions for maintaining compliance has been clearly stated in the Users Manual. 8. The requirement of RF exposure: Please refer exhibition RF Exposure for the compliance of MPE and SAR RF exposure rule. Please do not hesitate to contact me for any questions of this request letter. Thank you. Company name : Model Rectifier Corporation Company Address : 80 Newfield Avenue Edison, New Jersey 08837 USA Signature : Name : Steve Lin Job Title : Chief Enginer as (60/f GHz) mW for d < 2.5 cm in the TCB exclusion list

SPORTON International Inc. PAGE NUMBER : 1 OF 3 TEL : 886-2-2696-2468 ISSUED DATE : Apr. 09, 2007 FAX : 886-2-2696-2255 APPENDIX B. Photographs of EUT SPORTON International Inc. PAGE NUMBER : 2 OF 3 TEL : 886-2-2696-2468 ISSUED DATE : Apr. 09, 2007 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : 3 OF 3 TEL : 886-2-2696-2468 ISSUED DATE : Apr. 09, 2007 FAX : 886-2-2696-2255

SPORTON International Inc. PAGE NUMBER : 1 OF 3 TEL : 886-2-2696-2468 ISSUED DATE : Apr. 09, 2007 FAX : 886-2-2696-2255 APPENDIX B. Photographs of EUT SPORTON International Inc. PAGE NUMBER : 2 OF 3 TEL : 886-2-2696-2468 ISSUED DATE : Apr. 09, 2007 FAX : 886-2-2696-2255 SPORTON International Inc. PAGE NUMBER : 3 OF 3 TEL : 886-2-2696-2468 ISSUED DATE : Apr. 09, 2007 FAX : 886-2-2696-2255

FCC TEST REPORT Report No.: FR732717 SPORTON International Inc. Report Format Version: 2007-4-23-a FCC RADIO TEST REPORT according to 47 CFR FCC Part 15 Subpart C § 15.231 Equipment : RF transceiver module Model No. : CWMDP01 Brand Name : Model Rectifier Corp Filing Type : New Application Applicant : Model Rectifier Corp. 80 Newfield Avenue Edison, New Jersey 08837 USA FCC ID : BTQ170495 Manufacturer : Model Rectifier Corp. 80 Newfield Avenue Edison, New Jersey 08837 USA Received Date : Mar. 27, 2007 Test Date : Apr. 20, 2007 Statement The test result in this report refers exclusively to the presented test model / sample. Without written approval of SPORTON International Inc., the test report shall not be reproduced except in full. The measurements and test results shown in this test report were made in accordance with the procedures and found in compliance with the limit given in ANSI C63.4-2003 and 47 CFR FCC Part 15 Subpart C. The test equipment used to perform the test is calibrated and traceable to NML/ROC. SPORTON International Inc. 6F, No. 106, Sec. 1, Hsin Tai Wu Rd., Hsi Chih, Taipei Hsien, Taiwan, R.O.C. Lab Code: 200079-0 FCC TEST REPORT Report No.: FR732717 SPORTON International Inc. Page No. : i of ii TEL : 886-2-2696-2468 Issued Date : Apr. 23, 2007 FAX : 886-2-2696-2255 FCC ID : BTQ170495 Table of Contents 1. SUMMARY OF THE TEST RESULT ...................................................................................................................... 2 2. GENERAL INFORMATION..................................................................................................................................... 3 2.1. Product Details ........................................................................................................................................................................................ 3 2.2. Table for Test Modes .............................................................................................................................................................................. 3 2.3. Table for Testing Locations ..................................................................................................................................................................... 3 2.4. Table for Supporting Units....................................................................................................................................................................... 3 2.5. Test Configurations ................................................................................................................................................................................. 4 3. TEST RESULT ........................................................................................................................................................ 5 3.1. AC Power Line Conducted Emissions Measurement.............................................................................................................................. 5 3.2. Field Strength of Fundamental Emissions Measurement........................................................................................................................ 9 3.3. 20dB Spectrum Bandwidth Measurement............................................................................................................................................. 12 3.4. De-activating Time / Operation Restriction Measurement..................................................................................................................... 14 3.5. Radiated Emissions Measurement........................................................................................................................................................ 17 3.6. Antenna Requirements.......................................................................................................................................................................... 25 4. LIST OF MEASURING EQUIPMENTS ................................................................................................................. 26 5. TEST LOCATION.................................................................................................................................................. 27 6. NVLAP CERTIFICATE OF ACCREDITATION..................................................................................................... 28 APPENDIX A. TEST PHOTOS ........................................................................................................................ A1 ~ A7 APPENDIX B. PHOTOGRAPHS OF EUT ....................................................................................................... B1 ~ B3 FCC TEST REPORT Report No.: FR732717 SPORTON International Inc. Page No. : ii of ii TEL : 886-2-2696-2468 Issued Date : Apr. 23, 2007 FAX : 886-2-2696-2255 FCC ID : BTQ170495 History of This Test Report Original Issue Date: Apr. 23, 2007 Report No.: FR732717 No additional attachment. Additional attachment were issued as following record: Attachment No. Issue Date Description 15.205(a) 15.209(a) 15.231(a) 15.231(e) Further, this requirement does not apply to intentional radiators that must be professionally installed. FCC TEST REPORT Report No.: FR732717 SPORTON International Inc. Page No. : 2 of 28 TEL : 886-2-2696-2468 Issued Date : Apr. 23, 2007 FAX : 886-2-2696-2255 FCC ID : BTQ170495 1. SUMMARY OF THE TEST RESULT Applied Standard: 47 CFR FCC Part 15 Subpart C Part Rule Section Description of Test Result Under Limit 3.1 15.207 AC Power Line Conducted Emissions Complies 29.39 dB 3.2 15.231(b) Field Strength of Fundamental Emissions Complies 37.25 dB 3.3 15.231(c) 20dB Spectrum Bandwidth Complies - 3.4 15.231(a) De-activating Time / Operation Restriction Complies - 3.5 15.231(b) Radiated Emissions Complies 14.66 dB 3.6 15.203 Antenna Requirements Complies - Test Items Uncertainty Remark AC Power Line Conducted Emissions 2.3dB Confidence levels of 95% Field Strength of Fund…

Text truncated - open the document above for the full version.

FCC TEST REPORT Report No.: FR732717 Page No. : 1 of 7 FCC ID : BTQ170495 Appendix A. Test Photos FCC TEST REPORT Report No.: FR732717 Page No. : 2 of 7 FCC ID : BTQ170495 1. Photographs of Conducted Emissions Test Configuration FRONT VIEW REAR VIEW FCC TEST REPORT Report No.: FR732717 Page No. : 3 of 7 FCC ID : BTQ170495 SIDE VIEW FCC TEST REPORT Report No.: FR732717 Page No. : 4 of 7 FCC ID : BTQ170495 2. Photographs of Radiated Emissions Test Configuration For radiated emissions below 30MHz FRONT VIEW REAR VIEW FCC TEST REPORT Report No.: FR732717 Page No. : 5 of 7 FCC ID : BTQ170495 For radiated emissions above 30MHz FRONT VIEW REAR VIEW FCC TEST REPORT Report No.: FR732717 Page No. : 6 of 7 FCC ID : BTQ170495 Test Fixture FRONT VIEW FRONT VIEW FCC TEST REPORT Report No.: FR732717 Page No. : 7 of 7 FCC ID : BTQ170495 REAR VIEW