BY34339-49PPR/C VEHICLE

SIZE: 297MM X 210MM PN#65-5885-000-0100 BATTERY INSTALLATION (For maximum performance, use alkaline batteries) Remember to take out all batteries from vehicle and transmitter after playing. 1. Do not mix old and new batteries. 2. Do not mix alkaline, standard (Carbon-Zinc), or rechargeable batteries. ATTENTION PARENTS It is recommended that this toy and all accessories be periodically examined for potential hazards and that any potentially hazardous parts be repaired or replaced. HOW TO INSTALL BATTERY IN VEHICLE 1. Turn over the vehicle and push the ON/OFF to "OFF" position. (See Diagram #1) 2. Open the battery cover. (See Diagram #1) 3. Follow the "arrow" sign and insert the battery pack into the battery compartment. Make sure the (+) (–) polarity is correct. (See Diagram #2) 4. Replace the battery cover. HOW TO INSTALL BATTERY IN TRANSMITTER 1. Remove battery cover and install 2"AA" batteries by matching + and – poles as indicated in the battery compartment. (See Diagram #3) 2. Replace the battery cover. Note: Remove battery after you have finished using your vehicle. HOW TO PLAY START TO PLAY 1. Build up antenna by passing the cable through the antenna tube provided and plug into the vehicle tightly. Otherwise, the vehicle will not work. (See Diagram #4) 2. Push the ON/OFF switch to the "ON" position of the vehicle. (See Diagram #5) FORWARD RUNNING 3. Push the Driving Control Stick forward for forward running. (See Diagram #6). REVERSE RUNNING 4. Pull the Driving Control Stick backward for reverse running. (See Diagram #7) FRONT WHEELS STEERING ADJUSTMENT 5. If the vehicle does not run straight forward, adjust the lever for satisfactory alignment on the underside of the vehicle. (See Diagram #8) 6. If the vehicle runs towards left, turn "Steering Alignment Lever" towards "R". 7. If the vehicle runs towards right, turn "Steering Alignment Lever" towards "L". STEERING OPERATION 8. Turn the Steering Control Stick to the left or right while pushing the Driving Stick forward at the same time the car will turn left or right and run forward. (See Diagram #9) 9. Turn the Steering Control Stick to the left or right while pulling the Driving Stick backward at the same time the car will turn left or right and run backward. (See Diagram #10) STOP OPERATION 10. Release both Control Sticks, the vehicle will stop. (See Diagram #11) ENGLISH CAUTIONS 1. Do not charge battery pack that is hot, wet or shows leakage or corrosion. 2. May explode if disposed of in fire! 3 Do not disassemble the battery pack. 4. Non-rechargeable batteries are not to be recharged. 5. Rechargeable batteries are to be removed from the toy before being charged. 6. Rechargeable batteries are only to be charged under adult supervision. 7. Different types of batteries or new and used batteries are not to be mixed. 8. Only batteries of the same or equivalent type as recommended are to be used. 9. Batteries are to be inserted with the correct polarity. 10. Exhausted batteries are to be removed from the toy. 11. The supply terminals are not to be short-circuited. 12. The antenna wires are not to be inserted into socket outlet. FCC NOTE: THE ANTENNA PROVIDED IS A UNIQUE ANTENNA. BY INSTALLATION OF UNAUTHORIZED ANTENNA TO THIS EQUIPMENT. SUCH UNAUTHORIZED INSTALLATION COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. © 2015 SCIENTIFIC TOYS LTD. 1108, TOWER B, 14 SCIENCE MUSEUM ROAD, TSIMSHATSUI, HONG KONG. PRINTED IN CHINA O.I. NO.5885 (5) (6) DIAGRAM 3 DIAGRAM #5 DIAGRAM 1 DIAGRAM 4 (8) (7) DIAGRAM 10 (17) DIAGRAM 11 (18) DIAGRAM 7 (14) (13) DIAGRAM 6 (12) (10) (11) (16) DIAGRAM 9 DIAGRAM 8 DIAGRAM 2 OFFON (1) (4) (3)(2) OFFON (9) (15) (Diagram #1) <1> On/Off switch <2> Battery cover <3> Unscrew to open (Diagram #2) <4> 5 x AA Batteries (Diagram #3) <5> Back Panel of transmitter <6> 2 x AA Batteries (Diagram #4) <7> Cable <8> Antenna tube (Diagram #5) <9> On (Diagram #6) <10> Driving control stick <11> Forward <12> Forward w/ arrow (Diagram #7) <13> Backward <14> Reverse (Diagram #8) <15> Steering alignment lever (Diagram #9) <16> Steering Control Stick (Diagram #10) <17> Steering Control Stick (Diagram #11) <18> Stop

May 7, 2015

External Photos

Internal Photos

• The test results reported in this test report shall refer only to the sample actually tested and shall not refer or be deemed to refer to bulk from which such a sample may be said to have been obtained. • This report is for the exclusive use of Intertek's Client and is provided pursuant to the agreement between Intertek and its Client. Intertek's responsibility and liability are limited to the terms and conditions of the agreement. Intertek assumes no liability to any party, other than to the Client in accordance with the agreement, for any loss, expense or damage occasioned by the use of this report. Only the Client is authorized to copy or distribute this report. Any use of the Intertek name or one of its marks for the sale or advertisement of the tested material, product or service must first be approved in writing by Intertek. The observations and test results referenced from this report are relevant only to the sample tested. This report by itself does not imply that the material, product, or service is or has ever been under an Intertek certification program. • For Terms And Conditions of the services, it can be provided upon request. • The evaluation data of the report will be kept for 3 years from the date of issuance. TRF No.: FCC 15C_RX_b Intertek Testing Services Shenzhen Ltd. Kejiyuan Branch 6F, D Block, Huahan Building, Langshan Road, Nanshan District, Shenzhen, P. R. China Tel: (86 755) 8601 6288 Fax: (86 755) 8601 6751 SCIENTIFIC TOYS LTD. Application For Certification FCC ID: BY34339-49PP R/C VEHICLE Model: BY34339-49PP Additional Models: See page 1&2 Superregenerative Receiver Report No.: SZHH00964240-001 Prepared and Checked by: Approved by: Sign on file Terry Tang Engineer Andy Yan Senior Project Engineer Date: August 2, 2015 INTERTEK TESTING SERVICES Report No.: SZHH00964240-001 FCC ID: BY34339-49PP TRF No.: FCC 15C_RX_b i GENERAL INFORMATION SCIENTIFIC TOYS LTD. Model: BY34339-49PP FCC ID: BY34339-49PP Grantee: SCIENTIFIC TOYS LTD. Grantee Address: Rm. 1108, 11/F., Block B, New Mandarin Plaza 14 Science Museum Road, TST East Kowloon, Hong Kong Contact Person: Muk Shui Leung Tel: 852-25573202 Manufacturer: SCIENTIFIC TOYS LTD. Manufacturer Address: Rm. 1108, 11/F., Block B, New Mandarin Plaza 14 Science Museum Road, TST East Kowloon, Hong Kong Model: BY34339-49PP Type of EUT: Superregenerative Receiver Description of EUT: R/C VEHICLE Serial Number: N/A FCC ID : BY34339-49PP Date of Sample Submitted: May 29, 2015 Date of Test: June 29, 2015 Report No.: SZHH00964240-001 Report Date: August 2, 2015 Environmental Conidtions: Temperature: +10 to 40°C Humidity: 10 to 90% INTERTEK TESTING SERVICES Report No.: SZHH00964240-001 FCC ID: BY34339-49PP TRF No.: FCC 15C_RX_b ii SUMMARY OF TEST RESULT SCIENTIFIC TOYS LTD. Model: BY34339-49PP FCC ID: BY34339-49PP TEST SPECIFICATION REFERENCE RESULTS Maximum Peak Output Power 15.247(b), (c) / RSS-210 A8.4 N/A Hopping Channel Carrier Frequencies Separation (for 2.4GHz Digital) 15.247(e) / RSS-210 A8.1 N/A 20dB Bandwidth of the Hopping Channel 15.247(a) / RSS-210 A8.1 N/A Number of Hopping Frequencies 15.247(e) / RSS-210 A8.1 N/A Average Time of Occupancy of Hopping Frequency 15.247(e) / RSS-210 A8.1 N/A Anteann Conducted Spurious Emissions 15.247(d) / RSS-210 A8.5 N/A Radiated Spurious Emissions 15.247(d) / RSS-210 A8.5 N/A RF Exposure Compliance 15.247(i) / RSS-Gen 5.5 N/A Transmitter Power Line Conducted Emissions 15.207 / RSS-Gen 7.2.2 N/A Transmitter Field Strength (for 27MHz) 15.227 / RSS-310 3.8 N/A Transmitter Field Strength (for 40MHz) 15.229 / RSS-210 A2.7 N/A Transmitter Field Strength, Bandwidth and Timing Requirement 15.231(a) / RSS-210 A1.1.1 N/A Transmitter Field Strength, Bandwidth and Timing Requirement (for 433MHz) 15.231(e) / RSS-210 A1.1.5 N/A Transmitter Field Strength and Bandwidth Requirement(for 88-108MHz) 15.239 / RSS-210 A2.8 N/A Transmitter Field Strength and Bandwidth Requirement 15.249 / RSS-210 A2.9 N/A Transmitter Field Strength and Bandwidth Requirement (for 49MHz) 15.235 / RSS-310 3.9 N/A Receiver / Digital Device Radiated Eissions 15.109 / RSS-310 3.1 Pass Digital Device Conducted Emissions 15.107 / ICES-003 N/A INTERTEK TESTING SERVICES Report No.: SZHH00964240-001 FCC ID: BY34339-49PP TRF No.: FCC 15C_RX_b iii Table of Contents 1.0 General Description ............................................................................................... 1 1.1 Product Description ............................................................................................ 1 1.2 Related Submittal(s) Grants ............................................................................... 2 1.3 Test Methodology ............................................................................................... 2 1.4 Test Facility ........................................................................................................ 2 2.0 System Test Configuration .................................................................................... 3 2.2 EUT Exercising Software ................................................................................... 3 2.3 Special Accessories ........................................................................................... 3 2.4 Equipment Modification ...................................................................................... 3 2.5 Support Equipment List and Description ............................................................ 3 3.0 Emission Results ................................................................................................... 4 3.1 Field Strength Calculation .................................................................................. 4 3.2 Radiated Emission Configuration Photograph.................................................... 5 3.3 Radiated Emission Data ..................................................................................... 5 4.0 Equipment Photographs .....................................................…

Text truncated - open the document above for the full version.

Radiated Photos