DBZSSMC1Wireless Microphone Transmitter

SSM Micro Bodypack Transmitter INSTRUCTION MANUAL Rio Rancho, NM, USA www.lectrosonics.com Fill in for your records: Serial Number: Purchase Date: Quick Start Steps 1) Install a good battery and turn power on (see pages 5 and 9). 2) Set the compatibility mode to match the receiver (see page 8). 3) Connect the signal source and adjust input gain for optimum modulation level (see pages 10 and 11). 4) Set Step Size and frequency to match receiver. Also see receiver manual for scanning procedure to find a clear operating frequency. 5) Turn on the receiver and verify that solid RF and audio signals are present (see receiver manual). This device has not been authorized as required by the rules of the Federal Communications Commission. This device is not, and may not be, offered for sale or lease, or sold or leased, until authorization is obtained. SSM LECTROSONICS, INC. 2 Micro Body Pack Transmitter Rio Rancho, NM 3 Consumer Alert for US Users - FCC Order DA 10-92 Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this micro- phone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless mi- crophone systems, and these rules are subject to change. For more information, call the FCC at 1-888- CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC’s wireless microphone website at www.fcc.gov/cgb/wirelessmicrophones. To operate wireless microphone systems at power greater than 50mW, you must qualify as a Part 74 user and be licensed. If you qualify and wish to apply for a license go to: http://www.fcc.gov/Forms/Form601/601.html Table of Contents Introduction ..............................................................................4 Three Block Tuning Range .....................................................4 About Frequency Blocks ........................................................4 About Digital Hybrid Wireless ® ...............................................4 Battery Charging .....................................................................5 Battery Installation ..................................................................5 Controls and Functions ..........................................................6 Modulation LEDs ....................................................................6 LCD Screen ...........................................................................6 BATT LED ..............................................................................6 AUDIO Button ........................................................................6 FREQ Button ..........................................................................6 Power Button ..........................................................................6 UP and DOWN Arrow Buttons ...............................................6 Connectors and USB Port ......................................................7 Attaching and Removing the Microphone .............................7 Operating Instructions ............................................................8 Powering On in Operating Mode ............................................8 Powering On in Standby Mode ..............................................8 Powering Off ..........................................................................8 Setup Screens .......................................................................8 Screens Used in Normal Operation .......................................8 Setup Steps ...........................................................................8 Setup Screens ..........................................................................9 DOWN Button Menu ..............................................................9 UP Button Menu .....................................................................9 Adjusting the Input Gain .......................................................10 Input Jack Configuration ......................................................10 Locking the Controls .............................................................10 Remote Control ......................................................................10 IR (infrared) Sync ...................................................................11 Removable Belt Clip ..............................................................11 Accessories ...........................................................................12 Specifications ........................................................................13 Service and Repair ................................................................14 Returning Units for Repair ...................................................14 FCC Notices: For body worn operation, this transmitter model has been tested and meets the FCC RF exposure guidelines when used with the Lectrosonics accessories supplied or designated for this product. Use of other accessories may not ensure compliance with FCC RF exposure guidelines. Contact Lectrosonics if you have any questions or need more information about RF exposure using this product.. This device complies with FCC radiation exposure limits as set forth for an uncontrolled environment. This device should be installed and operated so that its antenna(s) are not co-located or operating in conjunction with any other antenna or transmitter. Industry Canada Notices: Per RSS-210 This device operates on a no-protection no-interference basis. Should the user seek to obtain protection from other radio services operating in the same TV bands, a radio licence is required. Please consult Industry Canada’s document CPC-2-1-28, Optional Licensing for Low-Power Radio Apparatus in the TV Bands, for details. Per RSS-Gen This device complies with Industry Canada’s le…

Text truncated - open the document above for the full version.

Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 35 of 38 FCC Part 74/ IC RSS-210 Test Report 12 Exhibit C- EUT Photos 12.1 EUT- Front View 12.2 EUT- Rear View Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 36 of 38 FCC Part 74/ IC RSS-210 Test Report 12.3 EUT – Top View 12.4 EUT – Bottom View

Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 37 of 38 FCC Part 74/ IC RSS-210 Test Report 12.5 PCB Board – Top View 12.6 PCB Board – Bottom View Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 38 of 38 FCC Part 74/ IC RSS-210 Test Report 12.7 EUT – Battery --- END OF REPORT ---

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by A2LA* or any agency of the Federal Government. * This report may contain data that are not covered by the A2LA accreditation and are marked with an asterisk “*” (Rev.3) p SAR EVALUATION REPORT For Lectrosonics, Inc. 581 Laser Road, Rio Rancho, NM 87124, USA FCC ID: DBZSSMC1 IC: 8024A-SSMC1 Report Type: Original Report Product Type: Wireless Microphone Transmitter Prepared By: Jerry Tong Test En gineer Report Number: R1502273-SAR Report Date: 2015-04-07 Reviewed By: Simon Ma Lead Engineer Bay Area Compliance Laboratories Corp. 1274 Anvilwood Avenue, Sunnyvale, CA 94089, USA Tel: (408) 732-9162 Fax: (408) 732 9164 Lectrosonics Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-SAR SAR Evaluation Report Page 2 of 62 Summary of Test Results Rule Part(s): FCC §2.1093 IC RSS-102, Issue 5 Test Procedure(s): FCC KDB 447498 D01; RSS-102 Device Category: Exposure Category: General Population/Uncontrolled Exposure Device Type: Portable Device Modulation Type: FM TX Frequency Range: 614.4 - 691.175 MHz Maximum Conducted Power Tested: 16.73 dBm Antenna Type(s) Tested: Integral Antenna Body-Worn Accessories: Microphone Face-Head Accessories: None Battery Type (s) Tested: Lithium –ion 3.7V 800mAH DLF40 battery pack Max. SAR Level (s) Measured: Operating Channel Position Level (W/Kg) High CH Back Side Touch 0.584 Lectrosonics Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-SAR SAR Evaluation Report Page 3 of 62 TABLE OF CONTENTS 1 GENERAL DESCRIPTION ................................................................................................................................ 6 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ........................................................................ 6 1.2 EUT TECHNICAL SPECIFICATION .................................................................................................................... 6 2 TEST FACILITY .................................................................................................................................................. 7 3 REFERENCE, STANDARDS AND GUIDELINES .......................................................................................... 8 3.1 SAR LIMITS .................................................................................................................................................... 9 4 EQUIPMENT LIST AND CALIBRATION ..................................................................................................... 10 4.1 EQUIPMENT’S LIST & CALIBRATION INFO .................................................................................................... 10 5 SAR MEASUREMENT SYSTEM VERIFICATION ..................................................................................... 11 5.1 SYSTEM ACCURACY VERIFICATION .............................................................................................................. 11 5.2 SAR SYSTEM VERIFICATION SETUP AND PROCEDURE .................................................................................. 11 5.3 LIQUID AND SYSTEM VALIDATION ................................................................................................................ 12 6 EUT TEST STRATEGY AND METHODOLOGY ......................................................................................... 13 6.1 TEST POSITIONS FOR DEVICE OPERATING NEXT TO A PERSON’S EAR ........................................................... 13 6.2 CHEEK/TOUCH POSITION .............................................................................................................................. 14 6.3 EAR/TILT POSITION....................................................................................................................................... 14 6.4 TEST POSITIONS FOR BODY-WORN AND OTHER CONFIGURATIONS ................................................................. 15 6.5 SAR EVALUATION PROCEDURE .................................................................................................................... 16 6.6 TEST METHODOLOGY ................................................................................................................................... 16 7 DASY4 SAR EVALUATION PROCEDURE .................................................................................................. 17 7.1 POWER REFERENCE MEASUREMENT ............................................................................................................. 17 7.2 AREA SCAN ................................................................................................................................................... 17 7.3 ZOOM SCAN .................................................................................................................................................. 18 7.4 POWER DRIFT MEASUREMENT ....................................................................................................................... 18 7.5 Z-SCAN ......................................................................................................................................................... 18 8 DESCRIPTION OF TEST SYSTEM ................................................................................................................ 19 8.1 IEEE SCC-34/SC-2 P1528 RECOMMENDED TISSUE DIELECTRIC PARAMETERS ........................................... 20 8.2 MEASUREMENT SYSTEM DIAGRAM .............................................................................................................. 20 9 SAR MEASUREMENT REDUCTION ............................................................................................................ 29 10 SA…

Text truncated - open the document above for the full version.

Note: This test report is prepared for the customer shown above and for the device described herein. It may not be duplicated or used in part without prior written consent from Bay Area Compliance Laboratories Corp. This report must not be used by the customer to claim product certification, approval, or endorsement by A2LA* or any agency of the Federal Government. * This report may contain data that are not covered by the A2LA accreditation and are marked with an asterisk “*” (Rev.3) FCC PART 74 SUBPART H IC RSS-210 ISSUE 8, AMENDMENT 1 TEST AND MEASUREMENT REPORT For Lectrosonics, Inc. 581 Laser Road, Rio Rancho, NM 87124, USA FCC ID: DBZSSMC1 IC: 8024A-SSMC1 Report Type: Original Report Product Type: Wireless Microphone Transmitter Prepared By: Chen Ge Test Engineer Report Number: R1502273-74 Report Date: 2015-04-07 Reviewed By: Simon Ma Lead Engineer Bay Area Compliance Laboratories Corp. 1274 Anvilwood Avenue, Sunnyvale, CA 94089, USA Tel: (408) 732-9162 Fax: (408) 732 9164 Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 2 of 38 FCC Part 74/ IC RSS-210 Test Report TABLE OF CONTENTS 1 GENERAL INFORMATION ............................................................................................................................... 5 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST (EUT) ........................................................................... 5 1.2 MECHANICAL DESCRIPTION OF EUT ................................................................................................................. 5 1.3 OBJECTIVE ......................................................................................................................................................... 5 1.4 RELATED SUBMITTAL(S)/GRANT(S) ................................................................................................................... 5 1.5 TEST METHODOLOGY ........................................................................................................................................ 5 1.6 MEASUREMENT UNCERTAINTY .......................................................................................................................... 6 1.7 TEST FACILITY ................................................................................................................................................... 6 2 SYSTEM TEST CONFIGURATION .................................................................................................................. 8 2.1 JUSTIFICATION ................................................................................................................................................... 8 2.2 EUT EXERCISE SOFTWARE ................................................................................................................................ 8 2.3 EQUIPMENT MODIFICATIONS ............................................................................................................................. 8 2.4 SPECIAL EQUIPMENT ......................................................................................................................................... 8 2.5 LOCAL SUPPORT EQUIPMENT............................................................................................................................. 8 2.6 EUT INTERNAL CONFIGURATION DETAILS ........................................................................................................ 8 2.7 POWER SUPPLY LIST AND DETAILS.................................................................................................................... 8 2.8 INTERFACE PORTS AND CABLES ........................................................................................................................ 8 3 SUMMARY OF TEST RESULTS ........................................................................................................................ 9 4 FCC §74.861 & IC RSS-210 AMEND 1 §6.1 – RF OUTPUT POWER ........................................................... 10 4.1 APPLICABLE STANDARDS ................................................................................................................................ 10 4.2 TEST PROCEDURE ............................................................................................................................................ 10 4.3 TEST EQUIPMENT LIST AND DETAILS .............................................................................................................. 10 4.4 TEST ENVIRONMENTAL CONDITIONS ............................................................................................................... 11 4.5 TEST RESULTS ................................................................................................................................................. 11 5 FCC §74.861(E)(3) & IC RSS-210 AMEND 1 §6.6.2 – MODULATION CHARACTERISTICS ................. 15 5.1 APPLICABLE STANDARDS ................................................................................................................................ 15 5.2 TEST PROCEDURE ............................................................................................................................................ 15 5.3 TEST EQUIPMENT LIST AND DETAILS .............................................................................................................. 15 5.4 TEST ENVIRONMENTAL CONDITIONS ............................................................................................................... 16 5.5 TEST RESULTS ................................................................................................................................................. 16 6 FCC §74.861(E) (5) (6) & IC RSS-210 AMEND 1 §6.2 – EMISSION BANDWIDTH & EMISSION MASK18 6.1 APPLICABLE STANDARDS ................................................................................................................................ 18 6.2 TEST PROCEDURE ......................…

Text truncated - open the document above for the full version.

Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 33 of 38 FCC Part 74/ IC RSS-210 Test Report 11 Exhibit B - Test Setup Photographs 11.1 Radiated Emission below 1 GHz Front View 11.2 Radiated Emission below 1 GHz Rear View Lectrosonics, Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-74 Page 34 of 38 FCC Part 74/ IC RSS-210 Test Report 11.3 Radiated Emission above 1 GHz Front View 11.4 Radiated Emission above 1 GHz Rear View

Lectrosonics Inc. FCC ID: DBZSSMC1, IC: 8024A-SSMC1 Report Number: R1502273-SAR SAR Evaluation Report Page 59 of 62 17 Appendix G – Test Setup Photos 17.1 Back Side Touch to the Flat Phantom Setup Photo