FSQ-FK760RF Keyboard

1 Helen Zhao Subject:FW: FOCUS ELECTRONIC CO., LTD., FCC ID: FSQ-FK760, Assessment NO.: AN05T5265, Notice#1 Exhibit-K-O_D_rev. pdf Exhibit-C-Test_Rep ort_rev.pdf Exhibit-A-Block_Dia gram_rev.pd... Exhibit-D-ID_Label_ rev.pdf Dear Helen, Ans#1: I had revised the device uses 4AAAbatteries for Block and Operation Description. Ans#2: Pls find the attached revised test report. Ans#3: Pls find the attached revised ID Label. Best Regards, Iris Lin -----Original Message----- From: Compliance Certification Services [mailto:[email protected]] Sent: Thursday, November 03, 2005 4:24 PM Subject: FOCUS ELECTRONIC CO., LTD., FCC ID: FSQ-FK760, Assessment NO.: AN05T5265, Notice#1 Question #1: The test report and user manual indicate that the device uses 4xAAA batteries, but the block diagram and operational description indicate 2xAAA batteries, please clarify. Question #2: The test report Section 4.4 Radiated Emission Data - Please check channel number again, CH2 or CH3? CH4 or CH7? Question #3: The FCC ID label format shows FCC DoC logo. Please note wireless keyboard is not considered as PC or PC peripheral as it does not connect PC with wire or cable. Please remove FCC DoC logo from the proposed label format. Best Regards, Helen Zhao The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information within 30 days of the original e-mail date may result in application dismissal and forfeiture of the filing fee. Also, please note 2 that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the e-mail address listed below the name of the sender.

ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Top View of EUT Front View of EUT ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Side View of EUT Side View of EUT ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Rear View of EUT Bottom View of EUT

50mm 27mm

ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Internal View of EUT ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Component View of PCB Solder View of PCB ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Component View of PCB Solder View of PCB ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Component View of PCB Solder View of PCB ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT Component View of PCB Solder View of PCB ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 CONSTRUCTED PHOTOS of EUT 1. Component View of PCB 2. Solder View of PCB

Rev. No 1.0 FCC Part 15 EMI TEST REPORT of E.U.T. RF KEYBOARD FCC ID FSQ-FK760 MODEL FK760 for APPLICANT : FOCUS ELECTRONIC CO., LTD. ADDRESS : 3F., NO.6, Lane 315, Sec 2, Chung Shan Rd., Chung Ho City, Taipei County, Taiwan R.O.C. Test Performed by ELECTRONICS TESTING CENTER, TAIWAN NO. 34, LIN 5 , DING FU TSUN, LINKOU HSIANG, TAIPEI HSIEN, TAIWA, R.O.C. Tel:(02)26023052 Fax:(02)26010910 http://www.etc.org.tw ; e-mail : [email protected] Report Number : ET94R-09-056-03 ETC Report No. : ET94R-09-056-03 FCC ID. : FSQ-FK760 Rev. No 1.0 TEST REPORT CERTIFICATION Applicant : FOCUS ELECTRONIC CO., LTD. 3F., NO.6, Lane 315, Sec 2, Chung Shan Rd., Chung Ho City, Taipei County, Taiwan R.O.C. Manufacturer : FOCUS ELECTRONIC (CHINA) LTD. Building D3&D4, 35 TH Zone, Bao An Shen Zhen City, Guang Dong, China Description of EUT : a) Type of EUT : RF KEYBOARD b) Trade Name : FOCUS c) Model No. : FK760 d) Power Supply : TX: DC 6V e) Frequency Range : 2407~2469 MHz Regulation Applied : FCC Rules and Regulations Part 15 Subpart C (2005) I HEREBY CERTIFY THAT: The data shown in this report were made in accordance with the procedures given in ANSI C63.4 (2001), and the energy emitted by the device was founded to be within the limits applicable. I assume full responsibility for accuracy and completeness of these data. Note: 1. The result of the testing report relate only to the item tested. 2. The testing report shall not be reproduced expect in full, without the written approval of ETC. Issued Date : Oct. 27, 2005 Test Engineer : ( Kevin Lee ) Approve & Authorized Signer : Will Yauo, Manager EMC Dept. II of ELECTRONICS TESTING CENTER, TAIWAN ETC Report No. : ET94R-09-056-03 FCC ID. : FSQ-FK760 Rev. No 1.0 Table of Contents Page 1 GENERAL INFORMATION.......................................................................................................1 1.1 Product Description........................................................................................................................1 1.2 Characteristics of Device................................................................................................................1 1.3 Test Methodology..........................................................................................................................1 1.4 Test Facility....................................................................................................................................1 2 PROVISIONS APPLICABLE.......................................................................................................2 2.1 Definition........................................................................................................................................2 2.2 Requirement for Compliance...........................................................................................................3 2.3 Restricted Bands of Operation........................................................................................................5 2.4 Labeling Requirement.....................................................................................................................5 2.5 User Information............................................................................................................................6 3 SYSTEM TEST CONFIGURATION...........................................................................................7 3.1 Justification.....................................................................................................................................7 3.2 Devices for Tested System.............................................................................................................7 4 RADIATED EMISSION MEASUREMENT..............................................................................8 4.1 Applicable Standard.......................................................................................................................8 4.2 Measurement Procedure.................................................................................................................8 4.3 Measuring Instrument...................................................................................................................10 4.4 Radiated Emission Data................................................................................................................11 4.4.1 Tx Portion................................................................................................................................11 4.4.2 Other Emissions.......................................................................................................................14 4.5 Field Strength Calculation.............................................................................................................14 4.6 Photos of Radiation Measuring Setup............................................................................................15 5 CONDUCTED EMISSION MEASUREMENT........................................................................16 5.1 Description...................................................................................................................................16 6 ANTENNA REQUIREMENT....................................................................................................17 6.1 Standard Applicable.....................................................................................................................17 6.2 Antenna Construction...................................................................................................................17 7 BAND EDGES MEASUREMENT............................................................................................18 7.1 Standard Applicable.....................................................................................................................18 7.2 Measurement Procedure.....................................................................................................…

Text truncated - open the document above for the full version.

ETC Report No. : ET94R-09-056-03 FCC ID.: FSQ-FK760 Rev. No 1.0 Photos of Radiation Measuring Setup