FSQ010412Wireless Keyboard

FK-720 Instruction Manual Introduction FK-720 RF wireless trackball keyboard has to be one of the best computer input devises on the market today. It combines the convenience of radio frequency(RF) wireless and the uniquely positioned and ergonomic trackball. Unlike IR(infra-red), RF technology has no angle of With no cables connected to the keyboard, you can put it away to save space whenever you finish using it. FK-720 also comes with 2 entirely separate channels to allow to switch interchangeably whenever you encounter interference. FK-720 also has 2 quick access keys for opening browser and e-mail software under Windows ME and Windows 2000. Please read carefully the information and instructions contained in this manual and you are sure to obtain a higher level of computing enjoyment. This package include the following : (RECEIVER)(1.5V BATTERIES 2xAAA) J F1 Esc F4 F5F6 F2 F3 S W @ A Q 1 ~ Caps Lock Alt Shift Z Ctrl & U H Y 7 ^ % G T F R 5 6 S # D E 3 4 NBVXC up Page Break Pause Page Down F10 F8F9F7 Print enScre SysRq F12 F11 Scroll Lock + = - - ] } [ { )( L O K I 90 P * 8 ? / Alt > < M Insert Delete space Back Enter Home End \ Shift Ctrl - 6 9 PgUp + / Lock Num 5 8 4 7 Home 3 PgDn Enter Del 2 0 1 End Ins Tab MMX e-mail WWW 2 (KEYBOARD) Features & specifications: --- 2 separate channels. --- 6ft range. --- 2 x AA batteries, approx. 2~3 months battery life(please only use alkali batteries) --- Compatible with Windows 95, Windows NT, Windows 98 and Windows 2000. --- Energy saving management. --- No. of keys: 107/108. --- Unique tactile key switches, 20 million key switch life. Installation 1.Turn off your computer. Plug the receiver of the keyboard into the PS/2 connectors of your computer. The purple connector is for keyboard port and the green connector is for the mouse port. 2.Open the battery compartment cover under the keyboard and place the enclosed batteries inside the compartment. Close the battery compartment cover. (keyboard )¹q¦À»\¹Ï 3.Open the channel adjustment compartment lids under the keyboard and the receiver. 4.Make sure they are adjusted at the same channel. Should you encounter interference, please adjust the channel. (keyboard & receiver channel ) 5.Turn on the computer to operate the keyboard. ½Õ¾ã¹Ï NOTE!! Once the keyboard is not used for over 1 minute, the keyboard will go into a sleep mode to minimize battery power consumption. To wake up the keyboard, please gently hit any keyboard keys. The Receiver 1. Caps lock LED. 2. Scroll lock LED. 3. Num. lock LED. 4. RF signal LED (flashes when the keyboard or the mouse is being used). Scroll lock LED RF signal LED Num. lock LED Caps lock LED Keyboard battery Low. (keyboard LED ) --- When this LED light brightens, it means the keyboard require a change of batteries. Please use the recommended Alkali batteries. ¹Ï Trouble shooting If you keyboard does not work, please try the following: 1.Make sure the cables are connected into the system correctly. 2.The keyboard has an optimal range of 2M of the receiver. Please keep at least 20cm of distance between the receiver and other electrical devices(such as speakers, monitors) 3.Make sure the channels underneath the keyboard, mouse and the receiver are adjusted to the same one(channel 1 for keyboard and receiver). 4.Working on metallic surfaces, please turn the receiver to its side to improve reception. 8-inches (20 cm) ¤À ̧Ñ¼Ò²Õ¹Ï Cleaning of the trackball unit ( trackball ) Turn the trackball ring anti-clock wise to unlock the ring and remove the trackball. Once the trackball is removed use a cotton bud to remove the dirt in the interior of the trackball unit. FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. INFORMATION TO USER: This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1.Reorient / Relocate the receiving antenna. 2.Increase the separation between the equipment and receiver. 3.Connect the equipment into an outlet on a circuit difference from that to which the receiver is connected. 4.Consult the dealer or an experienced radio/TV technician for help. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment

PROPOSED FCC ID LABEL AND LOCATION FOCUS ELECTRONICS CO., LTD This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID: FSQ010412 FCC ID LABEL

ELECTROMAGNETIC EMISSIONS COMPLIANCE REPORT CERTIFICATION TO FCC PART 15 REQUIREMENTS for INTENTIONAL RADIATOR 27 MHz RF KEYBOARD MODEL NO: FK720 FCC ID NO: FSQ010412 PROJECT NO: 01T0783 ISSUE DATE: JUNE 01, 2001 Prepared for FOCUS ELECTRONIC CO., LTD. 5F, 306, SEC 4, CHENGTEH ROAD TAIPEI, TAIWAN ROC Prepared by COMPLIANCE ENGINEERING SERVICES, INC. d.b.a. COMPLIANCE CERTIFICATION SERVICES 561F MONTEREY ROAD MORGAN HILL, CA 95037, USA TEL: (408) 463-0885 FAX: (408) 463-0888 PROJECT NO: 01T0783 DATE: JUNE 01, 2001 EUT: 27 MHz RF KEYBOARD COMPLIANCE CERTIFICATION SERVICES, INC. CCS DOCUMENT NO:CCSUP4022B 561F MONTEREY ROAD, MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 1. VERIFICATION OF COMPLIANCE...............................3 2. PRODUCT DESCRIPTION.....................................4 3. TEST FACILITY...........................................4 4. MEASUREMENT STANDARDS...................................4 5. TEST METHODOLOGY........................................4 6. MEASUREMENT EQUIPMENT USED...............................5 7. POWERLINE RFI LIMIT.....................................5 8. RADIATED EMISSION LIMITS................................5 9. SYSTEM TEST CONFIGURATION................................6 10. EQUIPMENT MODIFICATION..................................7 11. TEST PROCEDURE AND RESULT................................7 12. Appendix...............................................10 External & Internal Photos..............................10 Schematics.............................................13 Block Diagram..........................................13 User Manual............................................13 PROJECT NO: 01T0751-5 DATE: MAY 3, 2001 EUT: 27 MHz WIRELESS MOUSE TRANSMITTER PAGE NO: 3 OF 13 COMPLIANCE CERTIFICATION SERVICES, INC. CCS DOCUMENT NO:CCSUP4022B 561F MONTEREY ROAD, MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 1. VERIFICATION OF COMPLIANCE COMPANY NAME : FOCUS ELECTRONIC CO., LTD.. 5F, 306, SEC 4 TAIWAN, TAIPEI ROC CONTACT PERSON : HWA, CHIN-SHIU TELEPHONE NO. : (2) 2880-5512 EUT DESCRIPTION : 27 MHz RF KEYBOARD MODEL NAME/NUMBER : FK720 SERIAL NUMBER : 99714516 FCC ID : FSQ010412 DATE TESTED : JUNE 01, 2001 PROJECT NUMBER : 01T0783 TYPE OF EQUIPMENT REMOTE CONTROL EQUIPMENT TYPE 27 MHZ RF KEYBOARD MEASUREMENT PROCEDURE ANSI 63.4 / 1992 LIMIT TYPE CERTIFICATION FCC RULE CFR 47, PART 15.227 The above equipment was tested by Compliance Engineering Services, Inc. for compliance with the requirements set forth in CFR 47, PART 15. This said equipment in the configuration described in this report shows that maximum emission levels emanating from equipment are within the compliance requirements. Warning : This document reports conditions under which testing was conducted and results of tests performed. This document may not be altered or revised in any way unless done so by Compliance Certification Services and all revisions are duly noted in the revisions section. Any alteration of this document not carried out by Compliance Certification will constitute fraud and shall nullify the document. Reviewed By Approved By THU CHAN / EMC SENIOR ENGINEER STEVE CHENG / EMC ENGINEERING MANAGER COMPLIANCE CERTIFICATION SERVICES COMPLIANCE CERTIFICATION SERVICES PROJECT NO: 01T0751-5 DATE: MAY 3, 2001 EUT: 27 MHz WIRELESS MOUSE TRANSMITTER PAGE NO: 4 OF 13 COMPLIANCE CERTIFICATION SERVICES, INC. CCS DOCUMENT NO:CCSUP4022B 561F MONTEREY ROAD, MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 2. PRODUCT DESCRIPTION CHASSIS TYPE PLASTIC Fundamental Frequency 27.0975 or 27.1875MHz Power Source 3 VOLT BATTERY Transmitting Time CONTINUOUS NO. OF LAYER 1 Local Oscillators N/A 3. TEST FACILITY The 3/10/30 meter open area test site and conducted measurement facility used to collect the radiated data is located at 561F Monterey Road, Morgan Hill, California, U.S.A. A detailed description of the test facility was submitted to the Commission on May 27,1994. 4. MEASUREMENT STANDARDS The site is constructed and calibrated in conformance with the requirements of ANSI C63.4/1992. 5. TEST METHODOLOGY For an intentional radiator, the spectrum shall be investigated from the lowest radio frequency signal generated in the device, without going below 9 KHz, up to at least the tenth harmonic of the highest fundamental frequency or to 40 GHz, whichever is lower. (CFR 47 Section 15.33) PROJECT NO: 01T0751-5 DATE: MAY 3, 2001 EUT: 27 MHz WIRELESS MOUSE TRANSMITTER PAGE NO: 5 OF 13 COMPLIANCE CERTIFICATION SERVICES, INC. CCS DOCUMENT NO:CCSUP4022B 561F MONTEREY ROAD, MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 6. MEASUREMENT EQUIPMENT USED 7. POWERLINE RFI LIMIT CONNECTED TO AC POWER LINE SECTION 15.207 CARRIER CURRENT SYSTEM IN THE FREQUENCY RANGE OF 450 KHz TO 30MHz SECTION 15.205 AND SECTION 15.209, 15.221, 15.223, 15.225 OR 15.227, AS APPROPRIATE. BATTERY POWER NOT REQUIRED. 8. RADIATED EMISSION LIMITS GENERAL REQUIREMENTS SECTION 15.209 RESTRICTED BANDS OF OPERATION SECTION 15.20…

Text truncated - open the document above for the full version.

PROJECT NO: 01T0751-5 DATE: MAY 3, 2001 EUT: 27 MHz WIRELESS MOUSE TRANSMITTER PAGE NO: 6 OF 13 COMPLIANCE CERTIFICATION SERVICES, INC. CCS DOCUMENT NO:CCSUP4022B 561F MONTEREY ROAD, MORGAN HILL, CA 95037, USA TEL:(408)463-0885 FAX:(408)463-0888 This report shall not be reproduced except in full, without the written approval of CCS. This document may be altered or revised by Compliance Certification Services personnel only, and shall be noted in the revision section of the document. 9. SYSTEM TEST CONFIGURATION The EUT was configured for testing in a typical fashion (as a customer would normally use it). Radiated Open Site Test Set-up