G95RS21002.4GHz Wireless Audio System, Main unit

RS2100 user manual It is important to read this instruction book prior to using your new product for the first time. Es importante leer este manual antes de usar por vez primera su euipo. FCC Information EN FCC Information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. In accordance with FCC requirements, changes or modifications not expressly approved by Thomson Inc. could void the user’s authority to operate this product. This device generates and uses radio frequency (RF) energy, and if not installed and used properly, this equipment may cause interference to radio and television reception. If this equipment does cause interference to radio or television reception (which you can determine by unplugging the unit), try to correct the interference by one or more of the following measures: • Re-orient the receiving antenna (that is, the antenna for the radio or television that is "receiving" the interference). • Move the unit away from the equipment that is receiving interference. • Plug the unit into a different wall outlet so that the unit and the equipment receiving interference are on different branch circuits. If these measures do not eliminate the interference, please consult your dealer or an experienced radio/television technician for additional suggestions. Also, the Federal Communications Commission has prepared a helpful booklet, "How To Identify and Resolve Radio TV Interference Problems." This booklet is available from the U.S. Government Printing Office, Washington, DC 20402. Please specify stock number 004-000-00345-4 when ordering copies. This product complies with DHHS Rules 21 CFR Subchapter J. Applicable at the date of manufacture. For Your Safety The AC power plug is polarized (one blade is wider than the other) and only fits into AC power outlets one way. If the plug won’t go into the outlet completely, turn the plug over and try to insert it the other way. If it still won’t fit, contact a qualified electrician to change the outlet, or use a different one. Do not attempt to bypass this safety feature. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. Main plug is used as the disconnect device, it shall remain readily operable and should not be obstructed during intended used.To be completely disconnected the apparatus from supply mains,the main plug of the apparatus shall be disconnected from the mains socket outlet completely. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. For mp3 player only RECORD Have a Blast- Just Not in Your Eardrums Make sure you turn down the volume on the unit before you put on headphones. Increase the volume to the desired level only after headphones are in place. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la class B est conforme à la norme du NMB-003 du Canada RCA RD2100 Equipment tested for compliance as a complete unit FCC Information EN The descriptions and characteristics given in this document are given as a general indication and not as a guarantee. In order to provide the highest quality product possible, we reserve the right to make any improvement or modification without prior notice. The English version serves as the final reference on all products and operational details should any discrepancies arise in other languages. Technical specification Product: 5CD Audio System with mp3 Player Brand: RCA Model: RS2100(Audio System)/RD2100(mp3 player) Electrical Consumption: Power Supply: 120V~60Hz Power consumption: 150 Watts IMPORTER Comercializadora Thomson de México, S.A. de C.V. Álvaro Obregón No. 151. Piso 13. Col. Roma. Delegación Cuauhtémoc C.P. 06700. México, D.F. Telefono: 52-55-11-020360 RFC: CTM-980723-KS5 For Your Records In the event that service should be required, you may need both the model number and the serial number. In the space below, record the date and place of purchase, and the serial number: Model No. Remote Control No. Date of Purchase Place of Purchase Serial No. Service Information This product should be serviced only by those specially trained in appropriate servicing techniques. For instructions on how to obtain service, refer to the warranty included in this Guide. WARNING: TO PREVENT FIRE OR ELECTRICAL SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. SEE MARKING ON BOTTOM / BACK OF PRODUCT CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN THE EXCLAMATION POINT WITHIN THE TRIANGLE IS A WARNING SIGN ALERTING YOU OF IMPORTANT INSTRUCTIONS ACCOMPANYING THE PRODUCT. THE LIGHTNING FLASH AND ARROW- HEAD WITHIN THE TRIANGLE IS A W ARNING SIGN ALERTING YOU OF "DANGEROUS VOLTAGE" INSIDE THE PRODUCT. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER- SERVICEABLE PARTS IN- SIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. Portions based upon Microsoft Windows Media Technologies. Copyright © 1999 Microsoft Corporation. All Rights Reserved. Microsoft, Windows Media, and the Windows Logo are trademarks or registered trademarks of Microsoft Corporation in the United States and/or other countries. Main unit FCC ID:G95RS2100 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Remote controller FCC ID:G95RS2100A This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that m…

Text truncated - open the document above for the full version.

Sorry , we can’t provide the sample as there isn’t redundant product now and the time is urgent We have added section “5.3.3 Pseudorandom Hopping Algorithm” on RSS2100 and RSS2100A two reports. And the amendment reports uploaded to web site.

Photographs – Label FCC ID :G95RS2100 Photo #1: Location and Format of label 18.07mm Audio system with 2.4G wireless 59.23mm

SGS-CSTC EMC Lab (Shenzhen) t: +86 (0) 755 2601 2053 f: +86 (0) 755 2671 0594 Member of the SGS Group 通标标准技术服务有限公司 SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch EMC Lab No.1 Workshop, M-10, Middle Section, Science & Technology Park, Tel.: +86 (0) 755 2601 2053 Shenzhen, China P.C. 518057 Fax: +86 (0) 755 2671 0594 RF EXPOSURE (mobile unit) Standard Applicable This device is not fixed inside the host equipment, it is connected with host through wire. So it is easy to be re-located in the place where at least 20cm far away from the body of the user. Warning statement to the user for keeping at least 20cm or more separation distance with the antenna should be included in users manual. So this device is classified as Mobile Device. According to §1.1307(b)(1), systems operating under the provisions of this section shall be operated in a manner that ensure that the public is not exposed to radio frequency energy level in excess of the Commission’s guideline. Measurement Result: According to FCC 1.1310: The criteria shall be used to evaluate the environmental impact of human exposure to radio-frequency (RF) radiation as specified in 1.1307(b). Friis transmission formula : Pd = (Pout*G) / (4*pi*R) where Pd = power density in mW/cm2 Pout = output power to antenna in mW G = gain of antenna in linear scale Pi = 3.1416 SGS-CSTC EMC Lab (Shenzhen) t: +86 (0) 755 2601 2053 f: +86 (0) 755 2671 0594 Member of the SGS Group R = distance between observation point and center of the radiator in cm. Antenna Gain: Output Power Into Antenna & RF Exposure at distance 20cm: The max. Pd is: Pout=-5.08dBm=0.31mW G=2.1dB Pd=(0.31X2.1)/(4X3.1416X2.5)=0.02 mW/cm2 The SAR measurement is not necessary.

Report No.: SZEMO060400784AVF Page: 1 of 37 FCC ID: G95RS2100 Robinson Lo Laboratory Manager This report refers to the General Conditions for Inspection and Testing Services, printed overleaf. This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the SGS PRODUCT CERTIFICATION MARK. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. The report must not be used by the client to claim product certification, approval, or endorsement by NVLAP, NIST, or any agency of the federal government. All test results in this report can be traceable to National or International Standards. Member of the SGS Group (SGS SA) SGS-CSTC Standards Technical Services Ltd. No.198 Kezhu Road, Science Town Economic& Technology Development District Guangzhou, China 510663 Telephone: +86 (0) 20 8215 5555 Fax: +86 (0) 20 8207 5059 Email: [email protected] FEDERAL COMMUNICATIONS COMMISSION Registration number: 556682 FCC TEST REPORT Application No.: SZEMO060400784AV Applicant: Thomson Industry (Shenzhen) Co., Ltd. Fundamental Frequency : 2.404GHz to 2.478GHz FCC ID: G95RS2100 Equipment under Test (EUT): Name: audio system with 2.4G wireless* Model: RS2100 * This report is only about the main unit of the audio system with 2.4G wireless. Standards: FCC PART 15, SUBPART C : 2006 Date of Receipt: 25 April 2006 Date of Test: 26 April to 14 June 2006 Date of Issue: 15 June 2006 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEMO060400784AVE Page: 2 of 37 FCC ID: G95RS2100 2 Test Summary Test Test Requirement Stanadard Paragraph Result Conduct Emission FCC PART 15 2006 Section 15.207 PASS Number of hopping Frequency FCC PART 15 2006 Section 15.247 PASS Occupied Bandwidth FCC PART 15 2006 Section 15.247 (a2) PASS Channnel Separated FCC PART 15 2006 Section 15.247(a) PASS Occupied Time FCC PART 15 2006 Section 15.247(a1) PASS Band edge FCC PART 15 2006 Section 15.247 PASS Maximum Peak Output Power FCC PART 15 :2006 Section 15.247 (b) PASS Radiated Emission (30MHz to 25GHz) FCC PART 15 :2006 Section 15.209 PASS The test result is only about the main unit of the audio system with 2.4G wireless. SGS-CSTC Standards Technical Services Co., Ltd. Report No.: SZEMO060400784AVE Page: 3 of 37 FCC ID: G95RS2100 3 Contents Page 1 COVER PAGE ...........................................................................................................................................1 2 TEST SUMMARY.................................................................................................................................................2 3 CONTENTS...........................................................................................................................................................3 4 GENERAL INFORMATION................................................................................................................................4 4.1 CLIENT INFORMATION....................................................................................................................................4 4.2 DETAILS OF E.U.T.........................................................................................................................................4 4.3 DESCRIPTION OF SUPPORT UNITS................................................................................................................4 4.4 TEST LOCATION.............................................................................................................................................6 4.5 OTHER INFORMATION REQUESTED BY THE CUSTOMER...............................................................................6 4.6 TEST FACILITY................................................................................................................................................6 5 TEST RESULTS...................................................................................................................................................7 5.1 TEST INSTRUMENTS.......................................................................................................................................7 5.2 E.U.T. OPERATION........................................................................................................................................7 5.3 TEST PROCEDURE & MEASUREMENT DATA..................................................................................................8 5.3.1 Conducted Emissions............................................................................................................................8 5.3.2 Number of Hopping Frequency..........................................................................................................11 5.3.3 Pseudorandom Hopping Algorithm....................................................................................................13 5.3.4 Channel Separation..............................................................................................................................15 5.3.5 Occupied Bandwith..............................................................................................................................16 5.3.6 Occupancy Time..…

Text truncated - open the document above for the full version.