H5OTR02Remote Control Transceiver for Car Alarm

Model RST760 REMOTE ENGINE STARTER WITH ALARM SYSTEM OWNER’S MANUAL

FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two condition.(1).this device may not cause harmful interference. (2).this device must accept any interference received, including interference that may cause undesired operation Warning: Note: This equipment has been tested and found to comply with the limits for digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, used and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference in to radiate communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: l Reorient or relocate the receiving antenna l Increase the separation between the equipment and receiver. l Connect the equipment into an outlet on a circuit different form that to which the receiver in connected. l Consult the dealer or an experienced radio/TV technician for help. THE MANUFACTURER IS NOT RESPONSIBKE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.SUCH ODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT. ’

From: snnydate [[email protected]] Sent: Sunday, January 20, 2002 9:30 PM To: [email protected] Subject: from : NEUTRON ENGINEERING INC. Subject : ADVANCE SECURITY INC. FCC ID : H5OTR02, Assessment No : AN02T1735 Question # 1. : FCC ID Label, I resent one file that you need for this application. (RST760)(ID Label PDF.File) Question # 2. About Operational Description, I provide the technical information. I resent one file that you need for this application. (RST760)(Operational Description PDF.File) THANK YOU VERY MUCH Sincerely, If you have any questions feel free to contact us [email protected] [email protected] -----Original Message----- > From: CERTADM > Sent: Friday, January 18, 2002 7:11 PM > To: '[email protected]' > Subject: ADVANCE SECURITY INC., FCC ID:H5OTR02, AN02T1735 > > > Notice_content > ------------- > Question #1: FCC ID label location: The proposed FCC ID label location was > proposed to be placed on the main control unit. This main control unit is a > receiver not the transmitter. As indicated in the test report, this main > control unit is subject to FCC DoC procedure and it should be labled in > accordance with FCC DoC labeling requirement. Please revise your FCC ID > label location by changing the location from main control unit to the > transmitter. > > Question #2: In the operational description, it does not address periodic > operation requirement. There is no information provided to justify that > this transmitter will automatically deactivate the transmitter within not > more than 5 seconds of being released or cease transmission within 5 seconds > after activation. Please provide the technical inforamton to comply this > requirement. > > Best Regards > > > > Mike Kuo / TCB Certifier > The items indicated above must be submitted before processing can continue > on the above referenced application. Failure to provide the requested > information within 60 days of the original e-mail date may result in > application dismissal and forfeiture of the filing fee. Also, please note > that partial responses increase processing time and should not be submitted. > Any questions about the content of this correspondence should be directed to > the e-mail address listed below the name of the sender. > >

Photo # 1. Front View 01E1779 Photo 2 Front View Rear View 01E1779 01E1779

NEUTRON EMC LAB. FCC ID: H5OTR02 5/25 2. Product Labeling 2-1. FCC ID Label The remained portion of label statement required by FCC is attached in the user’s manual. 2-2 Location of Label on EUT FCC ID : H5OTR02 3cm 1cm 01E1779

Photo 3 Unit partially Disassembled 01E1779 Photo 4 Unit partially Disassembled 01E1779 01E1779 Photo 5 Unit partially Disassembled 01E1779 Photo 6 Unit partially Disassembled 01E1779 01E1779 Photo 7 Unit partially Disassembled 01E1779 Photo 8 Unit partially Disassembled 01E1779 01E1779 Photo 9 Unit partially Disassembled 01E1779 Photo 10 Unit partially Disassembled 01E1779 01E1779 Photo 11 Unit partially Disassembled 01E1779 Photo 12 Unit partially Disassembled 01E1779 01E1779 Photo 13 Unit partially Disassembled 01E1779 Photo 14 Unit partially Disassembled 01E1779 01E1779 Photo 15 Unit partially Disassembled 01E1779 Photo 16 Unit partially Disassembled 01E1779 01E1779 Photo 17 Unit partially Disassembled 01E1779

(RST760) Operational Description The ADVANCE SECURITY INC. Model: RST760 (referred to as the EUT in this report) is a Transceiver of car alarm security system. It offers wireless remote control, ideal for use in vehicle security system to activate the function of center door lock control system and car searching except the alarm system. A major technical descriptions of EUT is described as following: A). Operation Frequency: 433.92 MHz B). Modulation : Pulse Modulation C). Antenna Designation: Non-User Replaceable (Fixed) D). Power Supply: 5V, Battery Operated. E). Receiver type : Superheterodyne Battery Operated ≤ The 2 way pager is a low-powered transmitter device used in monitoring the automobile security status as well as in remotely engine start system and other optional features. Its features and functions are described in the separate attached sheet. The transmission is powered by DC 5V and works on 433.92MHz single fixed frequency. Details of circuit diagram and its block diagram are shown on the attached sheets. The automobile’s sensor will trigger the digital control signals and modulate the carrier signal. The carrier signal is generated by a crystal oscillator /amplifier circuit of a 434MHz crystal and a npn transistor. The modulated output of the RF amplifier stage is coupled to the coil. All the tuning and verification are done by manufacturer during the production process and no adjustment is allowed by any consumer. No external ground is needed in such device. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received including interference that may cause undesired operation. Note: The manufacturer is not responsible for any radio of TV interference caused by unauthorized modification to this equipment. Such modification could void the user’s authority to operate the equipment.

NEUTRON EMC LAB. FCC ID: H5OTR02 1/25 MEASUREMENT/TECHNICAL REPORT APPLICTNT:ADVANCE SECURITY INC MODEL NO.:RST760 FCC ID:H5OTR02 This report concerns ( check one ) : Original Grant 3 Class II Change Equipment type: 433.92 MHz Remote Controller (Transceiver) Deferred grant requested per 47CFR 0.457(d)(1)(ii)? Yes No 3 If yes, defer until: (date) We, the undersigned, agree to notify the Commission by (date) / / of the intended date of announce meant of the product so that the grant can be issued on that date. Transition Rules Request per 15.37? Yes No 3 If no, assumed Part 15, Subpart B for unintentional radiator the new 47 CFR (10-1-90 Edition) provision. Report Prepared by Testing House Neutron Engineering Inc. for Company Name ADVANCE SECURITY INC. Address 3F., No. 48, TA AN ST., HIS CHIH CITY, TAIPEI, Taiwan, R.O.C. Applicant Signature Michael Chen / President NEUTRON EMC LAB. FCC ID: H5OTR02 2/25 CERTIFICATION We hereby certify that: The test data , data evaluation , test procedures, and equipment configurations shown in this report were made in accordance with the procedures given in ANSI C63.4 (1992) and the en- ergy emitted by the sample EUT tested as described in this report is in compliance with con- ducted and radiated emission limits of FCC Rules Part 15. Prepared by Carol Chen Reviewed by Vincent Su Approved by George Yao Issued Date Jan. 08, 2002 Report No. NEI-FCCB-01219 Company Stamp NEUTRON ENGINEERING INC. No. 132-1, Lane 329, Sec. 2, Palain Rd., Shijr Jen, Taipei, Taiwan TEL: (02) 2646-5426 FAX : (02) 2646-6815 NEUTRON EMC LAB. FCC ID: H5OTR02 3/25 Table of Contents 1.General Information...................................................................................................................... 1-1 Product Description................................................................................................................4 1-2 Related Submittal(s)/Grant(s)..................................................................................................4 1-3 Test Methodology.............................................................................................................4 1-4 Test Facility...................................................................................................................4 2.Product Labeling............................................................................................................................ Figure 2-1 FCC ID Label...............................................................................................................5 Figure 2-2 Location of Label on EUT............................................................................................5 3.System Test Configuration............................................................................................................. 3-1 EUT Configuration...................................................................................................................6 3-2 EUT Exercise............................................................................................................................6 3-3 Test Procedure..........................................................................................................................6 3-4 Limitation..................................................................................................................................7 3-5 Special Accessories...................................................................................................................7 3-6 Equipment Modifications...........................................................................................................7 3-7 Test Set-UP...............................................................................................................................8 3-8 Test Equipment........................................................................................................................9 4.Block Diagram(s)..............................................................................................................................10 5.Radiated Measurement Photos............................................................................ Figure 5-1. Radiated Emission Data...................................................................................11 6.Radiated Emission Data............................................................................................................ 6-1 Radiated Emission Data...........................................................................................................12 6-2 Field Strength Calculation.......................................................................................................18 6-3 Duty Cycle Correction Factor Calculated .............................................................................19 6-4 Correction Factor Table VS Frequency....................................................................................20 7.Supplementary Information for Section 15.231(C) Requirement .............................................21 8.Attachment...................................................................................................................................... A. Technical Information of Pulse Code Definition & Timing Chart ................................................22 B. Photos of Tested EUT...................................................................................................................24 C. User Manual..................................................................................................................................25 NEUTRON EMC LAB. FCC ID: H5OTR02 4/25 1. GENERAL INFORMATION 1-1. Product Description The ADVANCE SECURITY INC. Model: RST760 (referred to as the EUT in this report) is a Transceiver of car alarm security system. It offers wireless remote control, ideal for use in vehicle security system to activate the function of center door lock control system an…

Text truncated - open the document above for the full version.

NEUTRON EMC LAB. FCC ID: H5OTR02 11/25 5. Radiated Measurement Photos