HAP91251T4949 MHz Radio Transmitter

PRINTED IN CHINA #91251 SCALE:1:20 OPERATING INSTRUCTIONS Please read through this instruction manual carefully before starting to operate. It is recommended to operate the Jet Ski under adult supervision. FEATURES 7 functions (goes forward, backward turns left and right, stops) Note: The Jet Ski is not designed to be used in oceans, rivers, lakes or streams. It is ideal for bath tub and pool play. BATTERY REQUIREMENT ~ One "9V" battery for transmitter. ~ 6V battery pack for Jet Ski. Note: For the best performance and longer play time, alkaline batteries are recommended. Batteries are not included in this package. BATTERY INSTALLATION (I) Transmitter 1. Press and pull the battery compartment cover in the direction of the arrow to remove it. 2. Put the "9V" battery in the compartment according to the polarity symbols (+ and - ) marked inside. 3. Replace the battery compartment cover. (II) Jet Ski 1. Press the ON/OFF switch on the Jet Ski to "OFF". 2. Use a Philip screwdriver (not included) to unscrew the battery door and remove the door to open. 3. Install the batteries in the compartment as indicated by the polarity symbols (+ and -) marked inside. 4. Replace the battery door and screw the battery door to close. HOW TO OPERATE 1. Press the ON/OFF switch on the Jet Ski to "ON". 2. Use the transmitter's levers to control the movement and direction of the Jet Ski. Left Control Lever ~ Push forward to turn left. ~ Push backward to turn right. ~ Release to stop. Right Control Lever ~ Push forward to turn right. ~ Push backward to turn left. ~ Release to stop. Left Control Lever and Right Control Lever ~ Push left and right lever forward to move forward. ~ Push left and right lever backward to move backward. ~ Release to stop. HELPFUL HINTS ~ 2 Jet Skis can run together or race only in different frequencies. ~ If your Jet Ski moves slowly or does not move at all, replace the batteries with fresh ones. ~ For better performance, hold transmitter antenna upright and pointing at the Jet Ski. ~ If the motor runs but the Jet Ski does not respond to the controller, replace the controller's 9V battery. ~ After use, take the Jet Ski out of water and press the ON/OFF switch to "OFF". ~ Dry the Jet Ski thoroughly before storing it. Leave the Jet Ski's battery compartment cover open while it is in storage to allow moisture to evaporate. ~ If you're not planning to play with the Jet Ski for a few days, remove the batteries. Never leave weak or dead batteries in the boat or/and controller, as they may leak damaging chemicals. ~ If a CB transceiver is being operated nearby, it may interfere with your control of the Jet Ski. If this happens, move your Jet Ski to a new location or wait until the CB unit stops transmitting. THE FCC WANTS YOU TO KNOW NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the User's authority to operate the equipment. (II) (I) STOP forward backward left turn right turn left back turn right back turn TM 6V battery pack battery cover

Report No.: 02.11.1254E-1 Page: 1 of 9 FCC ID: HAP91251T49 Authorized Signature: Kent Hsu Laboratory Manager SGS-CSTC Co.,Ltd. This report refers to the General Conditions for Inspection and Testing Services, printed overleaf This report details the results of the testing carried out on one sample. The results contained in this test report do not relate to other samples of the same product and does not permit the use of the SGS PRODUCT CERTIFICATION MARK.. The manufacturer should ensure that all products in series production are in conformity with the product sample detailed in this report. This report may only be reproduced and distributed in full. If the product in this report is used in any configuration other than that detailed in the report, the manufacturer must ensure the new system complies with all relevant standards. Any mention of SGS International Electrical Approvals or testing done by SGS International Electrical Approvals in connection with, distribution or use of the product described in this report must be approved by SGS International Electrical Approvals in writing. Member of the SGS Group (Société Générale de Surveillance) SGS-CSTC Standards Technical Services Ltd. 1/F., Building No. 1 Building, Agriculture Machinery Materials Co. Wushan Road, Shipai, Tianhe District,Guangzhou, China Telephone: +86 (0) 20 3848 1001 Fax: +86 (0) 20 3848 1006 [email protected] FEDERAL COMMUNICATIONS COMMISSION Laboratory Division 7435 Oakland Mills Road Columiba,MD 21046 May 31,2002 Registration number:282399  FCC TEST REPORT Application No. : 02.11.1254E-1 Applicant : Echo Toys Ltd FCC ID : HAP91251T49 Fundamental Frequency : 49.860MHz Equipment under Test (EUT): Name : JET SKI / WAVE POUDER ♣ ♣ Please refer to section 3.1 of this report which indicates which model was actually tested and which models are electrically identical Model : 91251 Standards : FCC PART 15, SUBPART C : 2002 Date of Receipt : 29 October 2002 Date of Test : 30 October 2002 Date of Issue : 05 November 2002 Test Result : PASS * * In the configuration tested, the EUT complied with the standards specified above. FCC ID No.: HAP91251T49  Report No.: 02.11.1254E-1 Page: 2 of 9 SGS-CSTC Standards Technical Services Ltd. 2 Contents Page 1 COVER PAGE........................................................................................................................................................ 1 2 CONTENTS ............................................................................................................................................................ 2 3 GENERAL INFORMATION................................................................................................................................ 3 3.1 C LIENT INFORMATION.......................................................................................................................................... 3 3.2 D ETAILS OF E.U.T. ............................................................................................................................................... 3 3.3 D ESCRIPTION OF SUPPORT UNITS......................................................................................................................... 3 3.4 T EST LOCATION.................................................................................................................................................... 3 3.5 O THER INFORMATION REQUESTED BY THE CUSTOMER........................................................................................ 3 4 TEST RESULTS..................................................................................................................................................... 4 4.1 T EST INSTRUMENTS.............................................................................................................................................. 4 4.2 E.U.T. O PERATION............................................................................................................................................... 4 4.3 T EST PROCEDURE & MEASUREMENT DATA......................................................................................................... 5 4.3.1 Radiated Emissions .................................................................................................................................... 5 4.3.2 Occupied Bandwidth .................................................................................................................................. 6 4.4 P HOTOGRAPHS - RADIATED EMISSION TEST SETUP IN CHAMBER......................................................................... 7 PHOTOGRAPHS - EUT CONSTRUCTIONAL DETAILS.....................................................................................8-9 FCC ID No.: HAP91251T49  Report No.: 02.11.1254E-1 Page: 3 of 9 SGS-CSTC Standards Technical Services Ltd. 3 General Information 3.1 Client Information Applicant: Echo Toys Ltd Address of Applicant: Room 1108, Peninsula Centre 67 Mody Road, Tism Sha Tusi East,Kowloon, Hong Kong. 3.2 Details of E.U.T. Product Name: JET SKI / WAVE POUDER ♣ (Transmitter Part) ♣ Only one item was tested since the above 2 Items were electrically identical. They are the same samples with different product names only. Please refer to the e-mail from Haison Xu of Echo Toys Ltd., dated 05 Nov. 2002 for further details Model: 91251 Power Supply: 9V DC (1 x ‘6F22’ Battery) Power Cord: N/A- 3.3 Description of Support Units The EUT was tested as an independent unit: a radio transmitter. 3.4 Test Location All tests were performed at:- SGS-CSTC Standards Technical Services Ltd., Guangzhou Safety & EMC Laboratory, 1/F, Building No. 1, Agriculture Machinery Materials Company Warehouse Ltd., Wushan Road Shipai, Tianhe District, Guangzhou, China. P.C. 510630. Tel: +86 20 3848 1001 Fax: +86 20 3848 1006 SGS UK Certificate No.: L32 Frederal Communications Commission laboratory division Registration number: 282399 3.5 Other Information Requeste…

Text truncated - open the document above for the full version.