HBW2555Transceiver

RATING: 120 Vac, 60Hz, 35mA 5. Within 30 seconds press and hold the programmed HomeLink ® button in your vehicle. 6. Release the HomeLink ® button when the garage door opener light blinks. If light bulbs are not installed in the garage door opener, two clicks will be heard. Programming is complete. 7. To ensure the garage door opener operates from the HomeLink ® button, press the programmed HomeLink ® button in the vehicle. If it does not operate the garage door opener, repeat the steps. INSTALL AND PROGRAM THE HOMELINK ® REPEATER To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door: • ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote control transmitters. • Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel. • ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door. INTRODUCTION The HomeLink ® Repeater Kit is designed to allow compatibility between a new Chamberlain, Sears Craftsman, or LiftMaster* garage door opener and the HomeLink ® system in your vehicle. Refer to the your vehicle owner’s manual for specific instructions on programming the HomeLink ® system. Your model may look different than illustrated in this programming guide. * Chamberlain and LiftMaster are Trademarks of Chamberlain Group. Sears is a Trademark of Sears Roebuck. HOMELINK ® REPEATER KIT NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. © 2010 The Chamberlain Group, Inc. 114A4226 All Rights Reserved 1-800-355-3515 www.homelink.com AntennaIndicator Light Remote Control HomeLink ® Repeater 1. Program the new remote control included with the HomeLink ® Repeater Kit. Refer to the owner’s manual for your vehicle for programming steps. Be sure that your vehicle is parked outside of the garage before programming the HomeLink ® Repeater Kit. Two people may be needed to program the HomeLink ® system. 2. Plug the HomeLink ® Repeater into a 120 Vac polarized outlet, located as close as possible to your garage door opener. 3. Straighten the antenna. 4. Press and release the YELLOW Learn button on the garage door opener. The Learn LED will glow steadily.

845 Larch Ave. Elmhurst, IL 60126 Phone 630.993.6306 Fax 630.530.6140 Email: [email protected] January 25, 2011 Federal Communications Commission EQUIPMENT APPROVAL SERVICES PO Box 358315 Pittsburgh, PA 15251-5315 Re: FCC ID: HBW2555 Request for Confidentiality In accordance with 47 C.F.R. Section 0.459, we, The Chamberlain Group, Inc., hereby request confidentiality for the block diagram, schematic and product description presented for certification. In support of the Request for Confidentiality, the following is stated: Enclosed within this application is technical information which we deem to be trade secrets and proprietary. If made public, the information might be used to our disadvantage. To assist in assuring that we receive the full value of our product and protect its competitive posture, we respectfully request this grant of confidentiality. Sincerely, THE CHAMBERLAIN GROUP, INC. Barbara Kelkhoff Manager, Regulatory Affairs

Eli 151 Do Tel Fax ww ite Electronic E 16 Centre Circl owners Grove, I l : (630) 495-97 x: (630) 495-978 ww.elitetest.co Engineering, Inc le IL 60515 70 85 om F P D T T T A c. Meas 1A6801 For P.O. Number Date Tested Test Personne Test Specifica Test Report By Approved By: suremen Freque The C 845 La Elmhu 8675 9 Augus el Richa ation FCC " Part15 Indust Indust y: Richa EMC E Raym Regis t Engine Engineer nt of RF E ncy Con Transm Chamberlain G arch Ave urst, IL 60128 90 st 30 through rd King "Code of Fede 5, Subpart C try Canada R try Canada R rd King Engineer ond J. Kloud a tered Profess eer of Illinois ing Test Re p Emission nverter G itter Group 8 September 3 eral Regulatio RSS-GEN RSS-210 a sional - 44894 port No. 100 ns from a Garage D 3, 2010 ons” Title 47 2656-01 a Door Engineering Test Report No. 1002656-01 TABLE OF CONTENTS PARAGRAPH DESCRIPTION OF CONTENTS PAGE NO. THIS REPORT SHALL NOT BE REPRODUCED, EXCEPT IN FULL, WITHOUT THE WRITTEN APPROVAL OF ELITE ELECTRONIC ENGINEERING INCORPORATED. Page 2 of 52 1. Introduction ................................................................................................................................................... 5 1.1. Scope of Tests ..................................................................................................................................... 5 1.2. Purpose ............................................................................................................................................... 5 1.3. Deviations, Additions and Exclusions .................................................................................................. 5 1.4. EMC Laboratory Identification ............................................................................................................. 5 1.5. Laboratory Conditions.......................................................................................................................... 5 2. Applicable Documents .................................................................................................................................. 5 3. EUT Setup and Operation ............................................................................................................................ 6 3.1. General Description ............................................................................................................................. 6 3.1.1. Power Input ................................................................................................................................. 6 3.1.2. Peripheral Equipment ................................................................................................................. 6 3.1.3. Signal Input/Output Leads .......................................................................................................... 6 3.1.4. Grounding ................................................................................................................................... 6 3.1.5. Frequency of EUT ....................................................................................................................... 6 3.2. Operational Mode ................................................................................................................................ 6 3.3. EUT Modifications ................................................................................................................................ 6 4. Test Facility and Test Instrumentation ......................................................................................................... 6 4.1. Shielded Enclosure .............................................................................................................................. 6 4.2. Test Instrumentation ............................................................................................................................ 7 4.3. Calibration Traceability ........................................................................................................................ 7 4.4. Measurement Uncertainty ................................................................................................................... 7 5. Test Procedures ........................................................................................................................................... 7 5.1. Powerline Conducted Emissions ......................................................................................................... 7 5.1.1. Requirements .............................................................................................................................. 7 5.1.2. Procedures .................................................................................................................................. 8 5.1.3. Results ........................................................................................................................................ 8 5.2. Periodic Operation Measurements ...................................................................................................... 8 5.2.1. Requirements .............................................................................................................................. 8 5.2.2. Procedures .................................................................................................................................. 8 5.2.3. Results ........................................................................................................................................ 9 5.3. Duty Cycle Factor Measurements ....................................................................................................... 9 5.3.1. Procedures .................................................................................................................................. 9 5.3.2. Results ................................................................................................................................…

Text truncated - open the document above for the full version.

T Pa Test Setup for age 16 of 52 Figure 2 r Conducted E Engineer Emissions ing Test Repport No. 1002656-01 Test Set Test Se tup for Radiat etup for Radia Pa ted Emissions ated Emission age 17 of 52 Figure 3 s, 30MHz to 1 ns, 30MHz to Engineer 1GHz – Horiz 1GHz – Ver t ing Test Rep zontal Polariza tical Polarizat port No. 100 ation tion 2656-01 Test S Test S etup for Radi Setup for Rad Pa ated Emissio diated Emissi age 18 of 52 Figure 4 ns, Above 1 G ons, Above 1 Engineer GHz – Horizon GHz – Vertic ing Test Rep ntal Polarizati cal Polarizatio port No. 100 ion on 2656-01