HBWOVX1Radio activated locking device

For Technical Support Please Call: 1-888-528-7826 www.chamberlainaccess.com ACCESSMASTER OL10 1 0 OVERLOCK INSTALLATION MANUAL Warning: Changes or modi fi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the • receiver is connected.Consult the dealer or an experienced radio TV technician for help. • This Class B digital apparatus complies with Canadian ICES-003.Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.To comply with FCC/IC RF exposure limits for general population/uncontrolled exposure, the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.RF Exposure To comply with FCC/IC RF exposure requirements for mobile transmitting devices, this transmitter should only be used or installed at locations where there is at least 20cm separation distance between the antenna and all persons.© 2008, The Chamberlain Group, Inc.All Rights Reserved 114A3885 Overlock Serial Number Unit Number Transceiver Serial Number Overlock Serial Number Unit Number Transceiver Serial Number CARTON INVENTORYOverlock deviceBattery cover(4) Lithium batteries (4) Screws (5) Pop RivetsSpacersInstallation Kit (?) CONTENTS Overview................................................................................................... 1Speci fi cations ........................................................................................... 1 Battery Power .......................................................................................... 2Tools Required.......................................................................................... 2Assembly ................................................................................................. 2Mounting the Overlock.............................................................................. 2OL1000 Operation .................................................................................. 6Troubleshooting ........................................................................................ 6Warranty & Disclaimer ............................................................................. 7 iv OverviewThe Overlock device is a battery-powered, radio-actuated, locking device that provides a positive stop to control unit access. An actuator is extended until it sits against a closed door hasp, providing a positive lock that effectively prevents the door from being opened. The Overlock provides additional access and security control that integrates with a Falcon XT access control system. This additional control helps to protect vacant units from unauthorized use or vandalism and assists in preventing access to units by delinquent users.The overlock device provides automated overlocking of commercial doors. The device offers two modes of operation: Delinquent payment: Allows manager to overlock the customer’s ● unit until the delinquent amount has been paid. Vacant unit: Allows manager to secure a vacant unit to help prevent ● vandalism and unauthorized use. An opt-out function is included that allows the site manager to turn off any or all of these options. Please refer to the Overlock Software Manual for information on setting up each function.Specif cations Battery: 4 AA lithium, 1.5V Temperature: -40° C to +85° C Range: 500 ft Open Range maximum Frequency: 903 to 928 Mhz ISM Door and Hasp Types Supported: (For Beta) Door Types: Janus 650 DBCI 2000 US Door 501/502 Hasp Types: Chateau C-DL-1 and C-DL2 four bolt door latch The overlock can be installed on both right-hand and left-hand door hasps. 9 Chamberlain Access Solutions shall have no liability for any death, injury, or damage, however incurred, based on a claim that Chamberlain Access Solutions Products failed to function. However, if Chamberlain Access Solutions is held liable, directly or indirectly, for any loss or damage arising under this limited warranty or otherwise, Chamberlain Access Solutions’s maximum liability will not in any case exceed the purchase price of the Product, which will be fi xed as liquidated damages and not as a penalty, and will be the complete and exclusive remedy against Chamberlain Access SolutionsWarning: The User should follow all installation, operation, and maintenance instructions. The User is strongly advised to conduct Product and systems test at least once each week. Changes in environmental conditions, electric or electronic disruptions, and tampering may cause the Product to not perform as expected.Warning: Chamberlain Access Solutions warrants its Product to the User. The User is responsible for exercising all due prudence and taking necessary precautions for the safety and protection of lives and property wherever Chamberlain Access Solutions Products are installed. Chamberlain Access Solutions does not authorize the use of its Produc…

Text truncated - open the document above for the full version.

845 Larch Ave. Elmhurst, IL 60126 Phone 630.993.6306 Fax 630.516.6863 Email: [email protected] December 8, 2009 Federal Communication Commission Equipment Authorization Division Application Processing Branch 7435 Oakland Mills Road Columbia, Maryland 21046 FCC ID:HBWOVX1 Request for Confidentiality In accordance with 47 C.F.R. Section 0.457 and 0.459, we, Chamberlain Group, Inc., hereby request confidentiality for the block diagram, schematic and product description presented for certification. In support of the Request for Confidentiality, the following is stated: Enclosed within this application is technical information which we deem to be trade secrets and proprietary. If made public, the information might be used to our disadvantage. To assist in assuring that we receive the full value of our product and protect its competitive posture, we respectfully request this grant of confidentiality. I would appreciate your prompt attention to the submittal. If there are any questions, please call me at 630-993-6306 or send a fax to 630-516- 6863. Sincerely, Barbara Kelkhoff Regulatory Project Manager II Chamberlain Group, Inc. 845 Larch Ave. Elmhurst, IL. 60126

FCC ID HBWOVX1 Page | 1 of 2 FCC ID HBWOVX1 Page | 2 of 2

132B2683-1 - Use 4 Lithium AA Batteries - This product is covered by one or more of the following patents 7,071,850, 7,561,075. Other patents pending. The Chamberlain Group, Inc. USA Assembled in USA FCC ID: HBWOVX1 IC: 2666A-OVX1 Overlock OL1010 132LA2683-10-A Shown at 100% ECN: 01611 6-Nov-2009

FCC ID: HBWOVX1

FCC ID: HBWOVX1 Page 1 of 1

FCC ID: HBWOVX1 UL Project Number: 09NK15075 RF Exposure / SAR statement Applicant: Chamberlain Group Inc. Model: OL1010, Radio Activated Locking Device Calculations: The following information provides the minimum separation distance for the highest gain antenna provided with the “OL1010” as calculated from FCC OET Bulleting 65 Appendix A, Table (B) Limits for General Population / Uncontrolled Exposure. This calculation is based on the highest EIRP possible from the system, considering maximum power and antenna gain, and considering a f/1500mW/cm 2 (0.601mW/cm 2 ) uncontrolled exposure limit. The Friis formula used was: 2 **4 * r GP S π = Where P = 48.98mW (Maximum Peak Output Power) G = 3.27 (Numerical Antenna Gain, 5.14dBi) R = 20.0cm For OL1010 the S = 0.0319mW/cm 2

Underwriters Laboratories Inc. A not-for-profit organization dedicated 333 Pfingsten Rd. to public safety and committed to Northbrook, IL 60062 quality service for over 100 years Tel: (847) 272-8800 Underwriters Laboratories Inc. 333 Pfingsten Rd. Northbrook, IL 60062 www.ul.com/emc (847) 272-8800 Job Number: 1001173150 Project Number: 09NK15075 File Number: MC3181 Date: 04 November 2009 Model: OL1010 Electromagnetic Compatibility Test Report For Chamberlain Group Inc. Copyright  2007 Underwriters Laboratories Inc. Underwriters Laboratories Inc. authorizes the above-named company to reproduce this Report provided it is reproduced in its entirety. Job : 1101173150 Project #: 09NK15075 File #: MC3181 Page 2 of 57 Model Number: OL1010 Client Name: Chamberlain Group Inc. FCC ID: HBWOVX1 Underwriters Laboratories Inc. 333 Pfingsten Rd. Northbrook, IL 60062 USA Tel.: 847 272-8800 Rev. No 1.0 EMC Report 2007 Test Report Details Tests Performed By: Underwriters Laboratories Inc. 333 Pfingsten Rd. Northbrook, IL 60062 Tests Performed For: Chamberlain Group Inc. 845 Larch Av Elmhurst, IL 60126 Applicant Contact: Hank Sieradzki Phone: (630) 993-6564 E-mail: [email protected] Test Report Date: 25 September 2009 Product Type: Short Range Wireless Device Product standards FCC Part 15, Subpart C, 15.247, RSS-Gen, RSS-210 Model Number: OL1010 Sample Serial Number: NA EUT Category: Frequency Hopping Spread Spectrum Transceiver Testing Start Date: October 15, 2009 Date Testing Complete: October 26, 2009 Overall Results: Compliant Underwriters Laboratories Inc. reports apply only to the specific samples tested under stated test conditions. All samples tested were in good operating condition throughout the entire test program. It is the manufacturer's responsibility to assure that additional production units of this model are manufactured with identical electrical and mechanical components. Underwriters Laboratories Inc. shall have no liability for any deductions, inferences or generalizations drawn by the client or others from Underwriters Laboratories Inc. issued reports. This report shall not be used to claim, constitute or imply product certification, approval, or endorsement by NVLAP, NIST, A2LA, or any agency of the US government. This report may contain test results that are not covered by the NVLAP or A2LA accreditation. The scope of accreditation is limited to the specific tests that are listed on the NVLAP and/or A2LA websites referenced at the end of this report. Job : 1101173150 Project #: 09NK15075 File #: MC3181 Page 3 of 57 Model Number: OL1010 Client Name: Chamberlain Group Inc. FCC ID: HBWOVX1 Underwriters Laboratories Inc. 333 Pfingsten Rd. Northbrook, IL 60062 USA Tel.: 847 272-8800 Rev. No 1.0 EMC Report 2007 Report Directory 1 G E N E R A L - Product Description ......................................................................................................................4 1.1 Equipment Description ...................................................................................................................................4 1.2 Device Configuration During Test ..................................................................................................................4 1.2.1 Equipment Used During Test: ....................................................................................................................4 1.2.2 Input/Output Ports: .....................................................................................................................................4 1.2.3 Power Interface: .........................................................................................................................................5 1.3 EUT Configurations ........................................................................................................................................5 1.4 EUT Operation Modes ....................................................................................................................................5 2 Summary .................................................................................................................................................................5 2.1 Deviations from standard test methods ..........................................................................................................5 2.2 Device Modifications Necessary for Compliance ...........................................................................................5 2.3 Reference Standards .....................................................................................................................................5 2.4 Results Summary ...........................................................................................................................................6 3 Calibration of Equipment Used for Measurement ...................................................................................................7 4 EMISSIONS TEST RESULTS ................................................................................................................................7 4.1 Test Conditions and Results – RADIATED EMISSIONS ...............................................................................8 4.2 Test Conditions and Results – SPURIOUS EMISSIONS (Antenna Conducted and Radiated) ................. 12 4.3 Test Conditions and Results – BAND EDGE COMPLIANCE ..................................................................... 31 4.4 Test Conditions and Results – Carrier Frequency Separation .................................................................... 36 4.5 Test Conditions and Results – NUMBER OF HOPPING FREQUENCIES ................................................. 39 4.6 Test Conditions and Results – Dwell Time and Duty Cycle Correction ...................................................... 42 4.7 Test Conditions and Results – 20DB BANDWIDTH ....................................................…

Text truncated - open the document above for the full version.

FCC ID: HWBOVX1 Page 1 of 1 Radiated Emissions Test Setup Antenna Conducted Test Setup