HHV20020606Emergency Communication Device

Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 TG100 PAGE 1 OF 11 TG100 Operating Instructions Draft Version 1.1 July 4, 2002 Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 TG100 PAGE 2 OF 11 SAFETY INFORMATION EXPOSURE TO RADIO FREQUENCY SIGNALS In August 1996, the Federal Communications Commission (FCC) adopted RF exposure guidelines with safety levels for mobile wireless phones. Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies. The design of this phone complies with the FCC guidelines and these international standards bodies; ANSI C95.1(1992)* NCRP Report 86(1986)* ICNIRP(1996)* * American National Standards Institute; National Council on Radiation Protection and Measurements; International Commission on Non-Ionizing Radiation Protection Those standards were based on comprehensive and periodic evaluations of the relevant scientific literature. Over 120 scientists, engineers, and physicians from universities, government health agencies, and industry reviewed the available body of research to develop the ANSI Standard (C95.1). The design of your phone complies with the FCC guidelines in addition to those standards. ANTENNA CARE Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could damage the phone and may violate FCC regulations. PHONE OPERATION Never violate any of the following Rules and Regulations of the FCC when using this device model. Such violations are punishable by fine, imprisonment or both. TIPS ON EFFICIENT OPERATION : • Do not touch the antenna unnecessarily when this device model is in use. Contact with the antenna affects call quality and may cause the device to operate at a higher power level than otherwise needed. • Never use your device to send false distress calls. DRIVING Check the laws and regulations on the use of wireless telephones in the areas where you drive. Always obey them. Also, if using the device while driving, please: • Give full attention to driving - - driving safely is your first responsibility. • Pull off the road and park before making or answering a call if driving conditions so require. Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 TG100 PAGE 3 OF 11 ELECTRONIC DEVICES Most modern electronic equipment is shielded from RF signals. However, certain electronic equipment may not be shielded against the RF signals from your device. Pacemakers The Health Industry Manufacturers Association recommends that a minimum separation of six (6") inches be maintained between a wireless phone device and a pacemaker to avoid potential interference with the pacemaker. These recommendations are consistent with the independent research by and recommendations of Wireless Technology Research. Persons with pacemakers: • Should ALWAYS keep the device more than six inches from their pacemaker when the device is turned ON. Other Medical Devices If you use any other personal medical device, consult the manufacturer of your device to determine if they are adequately shielded from external RF energy. Your physician may be able to assist you in obtaining this information. FOR VEHICLES EQUIPPED WITH AN AIR BAG An air bag inflates with great force. DO NOT place objects, including both installed or portable wireless equipment, in the area over the air bag or in the air bag deployment area. If in-vehicle wireless equipment is improperly installed and the air bag inflates, serious injury could result. OTHER RESTRICTIONS Your device model is designed for use at ambient temperatures between –20°C and +60°C. Please note that higher or lower temperatures can affect the proper functioning of the device. Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 TG100 PAGE 4 OF 11 TABLE OF CONTENTS 1. OVERVIEW.............................................................................................................................................. 5 1.1. F EATURES........................................................................................................................................... 5 1.2. C ONTROLS.......................................................................................................................................... 5 2. OPERATION ............................................................................................................................................ 7 2.1. P OWER DOWN MODE.......................................................................................................................... 7 2.2. E MERGENCY CALL MODE..................................................................................................................... 7 2.2.1. Initiating a Call ............................................................................................................................................7 2.2.2. Establishing Position...................................................................................................................................7 2.2.3. Voice Conversation.....................................................................................................................................8 2.2.3. Emergency Response Center (ERC)...........................................................................................................8 2.3. SELF TEST MODE................................................................................................................................9 2.3.1. Indication by using TEST LED (Flashing/Solid) ..........................................................................................9 2.3.1.1. GPS Module Test..................................................................................................................................9 2.3.1.2. AMPS RSSI Test.........................................................................................…

Text truncated - open the document above for the full version.

Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 PAGE 1 OF 2 EXTERNAL PHOTOS Top ViewBottom View Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 PAGE 2 OF 2 EXTERNAL PHOTOS (Continued) Side View

Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 LABEL / LOCATION INFORMATION FCC Identification Label Location

Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 PAGE 1 OF 2 INTERNAL PHOTOS Top ViewBottom View Applicant : Matsushita Electric Works, Ltd. Transmitter Type : HHV20020606 PAGE 2 OF 2 INTERNAL PHOTOS (Continued) Top View (Shields Removed) Bottom View (Shields Removed)

Applicant: Matsushita Electric Works, Ltd. Transmitter Type: HHV20020606 CFR 47 Part 2 and 22 Test Report Terminal device FCC ID: HHV20020606 Device Name: Emergency Communication Device Model Number: TG100 Date of Report: 8, July, 2002 Rev. 1.0 Applicant: Matsushita Electric Works, Ltd. Transmitter Type: HHV20020606 PAGE 2 OF 20 TABLE OF CONTENTS 1. GENERAL INFOMATION............................................................................................................................................................................... 3 1.1. L IST OF GENERAL INFORMATION REQUIRED FOR CERTIFICATION.............................................................................................................3 1.2. T EST SUMMARY...........................................................................................................................................................................................4 2. STANDARD TEST CONDITIONS................................................................................................................................................................ 5 3. TEST EQUIPMENT LIST................................................................................................................................................................................ 5 4. RF POWER OUTPUT(CONDUCTED) ....................................................................................................................................................... 6 4.1. S ETUP AND PROCEDURE.............................................................................................................................................................................6 4.2. P ASS/FAIL CRITERIA.....................................................................................................................................................................................6 4.3. T EST RESULTS..............................................................................................................................................................................................6 5. TRANSMITTER AUDIO FREQUENCY RESPONSE ............................................................................................................................. 7 5.1. S ETUP AND PROCEDURE.............................................................................................................................................................................7 5.2. P ASS/FAIL CRITERIA.....................................................................................................................................................................................7 5.3. T EST RESULTS..............................................................................................................................................................................................7 6. MODURATION LIMITING............................................................................................................................................................................... 9 6.1. S ETUP AND PROCEDURE.............................................................................................................................................................................9 6.2. P ASS/FAIL CRITERIA.....................................................................................................................................................................................9 6.3. T EST RESULTS..............................................................................................................................................................................................9 7. OCCUPIED BANDWITH ..............................................................................................................................................................................10 7.1. S ETUP AND PROCEDURE.......................................................................................................................................................................... 10 7.2. P ASS/FAIL CRITERIA.................................................................................................................................................................................. 10 7.3. T EST RESULTS........................................................................................................................................................................................... 10 8. SPURIOUS EMISSIONS AT ANTENNA TERMINAL............................................................................................................................14 8.1. S ETUP AND PROCEDURE.......................................................................................................................................................................... 14 8.2. P ASS/FAIL CRITERIA.................................................................................................................................................................................. 14 8.3. T EST RESULTS........................................................................................................................................................................................... 14 9. EMISSIONS IN RECEIVE BAND................................................................................................................................................................18 9.1. S ETUP AND PROCEDURE.......................................................................................................................................................................... 18 9.2. PASS/FAIL CRITERIA................................................................................................................................................................................... 18 9.3. T EST RESULTS........................................................................…

Text truncated - open the document above for the full version.

A-015-02-C Page 1 of 13 KEC Ikoma Testing Laboratory 12128 Takayama-cho Ikoma-city Nara 630-0101 Japan Designated by Ministry of international Trade and industry KANSAI ELECTRONIC INDUSTRY DEVELOPMENT CENTER HEAD OFFICE IKOMA TESTING LABORATORY 6-8-7 NISHITENMA 12128 TAKAYAMA-CHO KITA-KU OSAKA 530-0047 JAPAN IKOMA-CITY NARA 630-0101 JAPAN Corporate Juridical Person TEST REPORT Report No. A-015-02-C Date: 8 July 2002 This test report is to certify that the tested device properly complies with the requirements of: FCC Rules and Regulations Part 22 Subpart H ; a Public Mobile Service. The tests necessary to show compliance to the requirements were performed and these results met the specifications of requirement. The results of this report should not be construed to imply compliance of equipment other than that which was tested. Unless the laboratory permission, this report should not be copied in part. 1. Applicant Company Name : Matsushita Electric Works, Ltd. Mailing Address : 1048, Kadoma, Osaka 571-8686, Japan 2. Identification of Tested Device FCC ID : HHV20020606 Device Name : Emergency Communication Device Trade Name : NAIS Model Number : TG100 Serial Number : 17407802146 Date of Manufacture : June 2002 3. Test Items and Procedure (1) MEASUREMENT OF RADIATED SPURIOUS EMISSIONS (2) MEASUREMENT OF RF POWER OUTPUT( SUBSTITUTION METHOD ) Above all tests were performed under : FCC Part 2 Section 2.1046 and Section 2.1053 4. Date of Test Receipt of Test Sample : 1 July 2002 Test Completed on : 3 July 2002 CERTIFIED BY : Seiichi Izumi General Manager of Ikoma Testing Laboratory A-015-02-C Page 2 of 13 KEC Ikoma Testing Laboratory 12128 Takayama-cho Ikoma-city Nara 630-0101 Japan Table of Contents 1. GENERAL INFORMATION........................................................................................................... 3 1.1 Product Description................................................................................................................ 3 1.2 Description for Equipment Authorization................................................................................. 3 1.3 Test Facility........................................................................................................................... 3 2. TESTED SYSTEM......................................................................................................................... 4 2.1 Test Mode.............................................................................................................................. 4 2.2 Block Diagram of EUT System............................................................................................... 4 2.3 List of EUT System................................................................................................................ 5 2.4 List of Antenna and Cable...................................................................................................... 5 3.RF OUTPUT POWER AND RADIATED EMISSIONS..................................................................... 6 3.1 Reference Rule and Specification............................................................................................ 6 3.2 Test Procedure........................................................................................................................ 6 3.3 Test Configuration.................................................................................................................. 7 3.4 Photographs of EUT System Configuration.............................................................................. 9 3.5 Test Results........................................................................................................................... 10 5. LIST OF TEST INSTRUMENTS.................................................................................................. 13 A-015-02-C Page 3 of 13 KEC Ikoma Testing Laboratory 12128 Takayama-cho Ikoma-city Nara 630-0101 Japan 1. GENERAL INFORMATION 1.1 Product Description The NAIS Model No. TG100 (referred to as EUT in this report) is an ANALOG AMPS Emergency Communication Device. (1) Transmitting Frequency Range : 824.04 - 848.97 MHz (2) Receiving Frequency Range : 869.04 - 893.97 MHz (3) Emission Designator : F3E (4) Type of Circuit : Superheterodyne 1st IF : 83.16 MHz 2nd IF : 60 kHz (5) Type of Antenna : Internal Antenna (50Ω, unbalanced) (6) Rated Power Supply : DC 6.0 V (7) Contained Oscillator 1) SYSTEM CLOCK : 14.4 MHz 2) 2nd LOCAL OSC : 83.1 MHz 3) RX VCO : 952.2 - 977.13 MHz 4) TX VCO : 824.04 - 848.97 MHz 1.2 Description for Equipment Authorization (1) Rules Part(s) under which the equipment is operated FCC Rule Part 22, Subpart H ; a Public Mobile Service (2) Kind of Equipment Authorization Certification (3) Procedure of Application Original Equipment Modification 1.3 Test Facility Name : KANSAI ELECTRONIC INDUSTRY DEVELOPMENT CENTER ( KEC ) IKOMA TESTING LABORATORY Anechoic Chamber No.3 Address : 12128, Takayama-cho Ikoma-city, Nara, 630-0101 Japan This test facility has been filed in FCC under the criteria in ANSI C63.4-1992. The laboratory has been accredited by the NVLAP (Lab.Code:200207-0) based on ISO17025. A-015-02-C Page 4 of 13 KEC Ikoma Testing Laboratory 12128 Takayama-cho Ikoma-city Nara 630-0101 Japan 2. TESTED SYSTEM 2.1 Test Mode The carrier wave is transmitted continuously with the maximum power level. 2.2 Block Diagram of EUT System [ Note ] See 2.3 List of EUT System and 2.4 List of Antenna and Cable. A) EUT 1 2 DC 6V A-015-02-C Page 5 of 13 KEC Ikoma Testing Laboratory 12128 Takayama-cho Ikoma-city Nara 630-0101 Japan 2.3 List of EUT System No Device Name Model Number (Serial Number) FCC ID (Trade Name) Note A Emergency Communication Device TG100 (17407802146) HHV20020606 (NAIS) EUT 2.4 List of Antenna and Cable No Type Length ( m ) Note 1 Built-in Antenna (50Ω) 0.1 2 DC Cable 1.8 A-015-02-C Page 6 of 13 KEC Ikoma Testing Laboratory 12128 Takayama-cho Ikoma-city Nara 630-0101 Japan 3.RF O…

Text truncated - open the document above for the full version.