HV4PL550Computer Interactive Pen Display

CAUTION Be sure to ground the power adaptor cable at the receptacle when plugging in. Do not touch the liquid crystal if leaked; it is irritative. In case of contact, rinse immediately with running water for more than 15 minutes. If it went into the eye or mouth, consult physician. WARNING Turn off the power of the Cintiq 15X in the area where prohibited to use. It may cause other electronic devices to malfunction. Do not use the Cintiq 15X in a facility control system that requires extremely high reliability. It may cause other electronic devices to malfunction or, other device may cause the Cintiq 15X to malfunction. Do not open the Cintiq 15X It has the risk of electric shock. HIGH VOLTAGE If the Cintiq 15X is broken due to fall or hit, do not leave it connected to the power. It has the potential to result in fire. Only use the AC adaptor that came with your Interactive Pen Display. If a different type of AC adaptor is used, the Interactive Pen Display will not work properly or it may be damaged. Using a different type of AC adaptor also has the potential to result in fire. Prevent your children from swallowing the UltraPen nib or side switch. The pen nib or side switch may accidentally be pulled out if children are biting on them. 01.7.31, 9:27 PM1 Preface The Wacom ® Cintiq ™ 15X is an integrated LCD tablet designed for direct draw-on-screen interface with your computer. The Cintiq 15X Interactive Pen Display components include a Wacom tablet internally mounted behind a 15.0" diagonal TFT color LCD monitor, and Wacom’s UltraPen ® . This manual describes how to install the Cintiq 15X Interactive Pen Display hardware and software. It also describes how to use the Interactive Pen Display and UltraPen. Information on using the Wacom Tablet Control Panel for customizing your tablet and pen settings is available in the Interactive Pen Display online Help, located under the H ELP menu in the Wacom Tablet Control Panel. The following are not included with this product:
Information about your specific computer hardware.
Information about your operating system.
Information about application software. To use the pressure-sensitivity of the UltraPen with your favorite drawing application, refer to instructions in that application’s manuals. Please refer also to your computer hardware, operating system, or software application manuals. 01.7.31, 9:27 PM2 Precautions on handling the Cintiq 15X
For use with DVI, do not use any graphics card that Cintiq 15X can not be used with. It may damage the Cintiq 15X.
Do not disassemble the Cintiq 15X or pen. This may cause the device to malfunction. In this case, Wacom shall have no responsibility to repair or replace the product.
Do not use or store the Cintiq 15X where: - Temperature changes are severe (e.g., outdoors or inside a vehicle). - The Cintiq 15X and pen are exposed to direct sunlight or heat from an appliance. - The Cintiq 15X and pen are exposed to water or any other kind of liquid. - Temperature or humidity exceeds the specifications.
Do not block the ventilation holes in the rear panel. It may overheat and damage the Cintiq 15X.
Do not use the Cintiq 15X in a dusty environment. It may damage the Cintiq 15X.
Do not scratch the cover glass of the Cintiq 15X. Avoid placing sharp objects on the glass surface. If the pen tip becomes sharp or angular, it may damage the coating on the cover glass of the Interactive Pen Display. Please replace the pen nib as necessary.
Do not use detergent to clean the cover glass of the Cintiq 15X—this may alter the surface friction and deteriorate the handwriting feel.
Do not lift up the Cintiq 15X by holding the stand. It may damage the open-close mechanism of the stand. When you lift up the Cintiq 15X, be sure to hold the main unit casing.
Do not put heavy articles on the Interactive Pen Display; this may damage the cover glass or stand.
Do not place heavy article on the Cintiq 15X cables. Near the cable connectors, do not apply heavy stress on the cables or do not repeat bending the cables. It may damage the Cintiq 15X.
Do not connect or disconnect the DVI video cable or power cable while the Interactive Pen Display or your computer is turned on; it may damage the LCD display or computer video card. 01.7.31, 9:27 PM3 4 Table of Contents Checking Packed Components5 Installation6 LCD Monitor Installation Wacom Tablet Software Installation for Windows and Macintosh Calibrating the Tablet Cintiq 15X Component Functions10 Front View Rear View Mounting the Cintiq 15X onto a Mount Arm or Other Stand Caring For Your Cintiq 15X Using the UltraPen UltraPen Pen Type Settings in the Wacom Tablet Control Panel Replacing the Pen Tip Using the UltraPen13 UltraPen Using a Pen Adjusting the LCD Monitor15 Factory Presets, Auto Adjust and User Settings Functions and Uses of the MENU Window Adjusting Pitch and Phase Power Saving Caring For Your Cintiq 15X19 Cleaning Your Cintiq 15X Replacing the Pen Tip Troubleshooting for Display20 Specifications22 General Specifications LCD Display Tablet UltraPen 01.7.31, 9:27 PM4 5 Checking Packed Components In your package you will find the following items: USB Cable or RS-232C Cable DVI-DVI Cable or DVI-RGB Cable* 2 Cintiq 15X main unit UltraPen with Pen Holder User’s Manual Wacom Software CD Contains the Interactive Pen Display software and a Readme file (Windows/Macintosh) AC Adaptor and Cable Side Slit Fillers *1 * 1 * 2 For Cintiq 15X only. Do not use this for other devices. One either cable is included. *2 Please retain the package box for storage or transportation. 01.7.31, 9:27 PM5 6 Installation LCD Monitor Installation First install the Cintiq 15X as a monitor. Do not connect the USB cable or serial data cable until instructed for the tablet software installation. ➀ Turn off your computer. IMPORTANT: Never connect or disconnect the DVI video cable or power cable while your computer or Interactive Pen Display is powered on. This can damage the LCD display or video card. …

Text truncated - open the document above for the full version.

American Telecommunications Certification Body Inc. 6731 Whittier Ave, McLean, VA 22101 August 30, 2001 RE: Wacom Co., Ltd. FCC ID: HV4PL550 I am ready to issue the Grant, but I do have a couple of minor issues which need to be resolved.. 1.) Please note that internal photos cannot be held as Confidential. This request will be ignored during the upload to the FCC website. 2.) Please note that loop antennas have three positions which must be addressed during low frequency testing. These are: perpendicular with the EUT, aligned along the same axis as the EUT, and parallel with the ground. The description in Section 4.2.4 of your test report is not sufficient to cover this antenna. Please confirm these three antenna orientations were tested. Bill William H. Graff Examining Engineer President and Director of Engineering mailto:[email protected] The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information may result in application termination. Correspondence should be considered part of the permanent submission and may be viewed from the Internet after a Grant of Equipment Authorization is issued. Please do not respond to this correspondence using the email reply button. In order for your response to be processed expeditiously, you must submit your documents through the AmericanTCB.com website. Also, please note that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the sender.

Page 1 ANNEX PHOTOGRAPHS OF EUT Page 2 Page 3

Page 18

FCC LABEL LOCATION The label will be permanently affixed at a conspicuous location on the device. Label

Page 4 Page 5 Page 6

Page 7 Page 8 Page 9

Page 10 Page 11 Page 12

Page 13 Page 14 Page 15

Page 16 Page 17

FCC ID: HV4PL550 ADT No. 900716A03 Operational Description This display system includes LCD panel, tablet and also one specific pen, UltraPen. The tablet is installed on the back of the LCD panel, there are two groups of multiple loop coils in X and Y directions. Radio frequency energy is radiated from these coils. The user can use the specific pen to point the LCD panel. The radiated energy will be absorbed by this pen and then re-transmit it to the tablet. The sensor on the tablet can tell there on the LCD the user would like to point. The signal re-transmitted to the tablet includes the coordinate, switch and pressure data.

FCC ID: HV4PL550 Report No.: RF900716A03 1 Issued: July 23, 2001 FCC TEST REPORT REPORT NO.: RF900716A03 MODEL NO.: PL-550 RECEIVED: July 16, 2001 TESTED: July 21, 2001 APPLICANT:Wacom Co., Ltd. ADDRESS:2-510-1 Toyonodai, Otone-cho, Kitasaitama-gun, Saitama, Japan ISSUED BY:Advance Data Technology Corporation LAB LOCATION:47 14th Lin, Chiapau Tsun, Linko, Taipei, Taiwan, R.O.C. This test report consists of 21 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by CNLA, NVLAP or any government agencies. The test results in the report only apply to the tested sample. The test results in this report are traceable to the national or international standards. 0528 Lab Code: 200102-0 FCC ID: HV4PL550 Report No.: RF900716A03 2 Issued: July 23, 2001 Table of Contents 1CERTIFICATION............................................................................................. 3 2SUMMARY OF TEST RESULTS .................................................................... 4 3GENERAL INFORMATION............................................................................. 5 3.1GENERAL DESCRIPTION OF EUT ................................................................5 3.2DESCRIPTION OF TEST MODES ..................................................................6 3.3GENERAL DESCRIPTION OF APPLIED STANDARDS .................................6 3.4DESCRIPTION OF SUPPORT UNITS ............................................................7 4EMISSION TEST ............................................................................................ 8 4.1CONDUCTED EMISSION MEASUREMENT...................................................8 4.1.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT ................................8 4.1.2 TEST INSTRUMENTS.....................................................................................8 4.1.3 TEST PROCEDURE........................................................................................9 4.1.4 DEVIATION FROM TEST STANDARD............................................................9 4.1.5 TEST SETUP...................................................................................................9 4.1.6 EUT OPERATING CONDITIONS ..................................................................10 4.1.7 TEST RESULTS ............................................................................................ 11 4.2RADIATED EMISSION MEASUREMENT......................................................13 4.2.1 LIMITS OF RADIATED EMISSION MEASUREMENT ...................................13 4.2.2 LIMITS OF RADIATED EMISSION MEASUREMENT ...................................13 4.2.3 TEST INSTRUMENTS...................................................................................14 4.2.4 TEST PROCEDURE......................................................................................15 4.2.5 DEVIATION FROM TEST STANDARD..........................................................15 4.2.6 TEST SETUP.................................................................................................16 4.2.7 EUT OPERATING CONDITIONS ..................................................................16 4.2.8 TEST RESULTS ............................................................................................17 5PHOTOGRAPHS OF THE TEST CONFIGURATION ................................... 19 6APPENDIX - INFORMATION ON THE TESTING LABORATORIES ............ 21 FCC ID: HV4PL550 Report No.: RF900716A03 3 Issued: July 23, 2001 1 CERTIFICATION PRODUCT:15”LCD PenTablet System BRAND NAME:WACOM MODEL NO:PL-550 TEST ITEM:R&D SAMPLE APPLICANT: Wacom Co., Ltd. STANDARDS:FCC Part 15, Subpart C(15.209) ANSI C63.4-1992 We, Advance Data Technology Corporation, hereby certify that one sample (model: PL-550) of the designation has been tested in our facility on July 21, 2001. The test record, data evaluation and Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample's EMC characteristics under the conditions herein specified. FCC ID: HV4PL550 Report No.: RF900716A03 4 Issued: July 23, 2001 2 SUMMARY OF TEST RESULTS The EUT has been tested according to the following specifications: APPLIED STANDARD: 47 CFR Part 15, Subpart C STANDARD PARAGRAPH TEST TYPERESULTREMARK 15.207Conducted Emission Test PASS Meets Class B Limit Minimum passing margin is –13.05 dB at 23.642 MHz 15.209Radiated Emission Test PASS Meets Class B Limit Minimum passing margin is –2.0 dB at 47.17 MHz NOTE: For conducted emission test, the test limit used is according to FCC Part 15.107. In this part, conducted emission test for telecom port is not mentioned and therefore this item is not tested. FCC ID: HV4PL550 Report No.: RF900716A03 5 Issued: July 23, 2001 3 GENERAL INFORMATION 3.1 GENERAL DESCRIPTION OF EUT PRODUCT15”LCD PenTablet System MODEL NO. PL-550 POWER SUPPLY Switching power adapter Model: LE-9702B-01A Brand: LIEN Rating: Input: 100-240V, 60/50Hz, 1.5A Output: 18V, 3.33A Power Cord: Nonshielded, 3 pin, AC (1.8m) Nonshielded, DC (1.5m) with one core MODULATION TYPE FSK CARRIER FREQUENCY OF EACH CHANNEL 531.25kHz, 562.50kHz, 593.75kHz NUMBER OF CHANNEL3 ANTENNA TYPELoop coils antenna DATA CABLE VGA shielded (1.9 m) – analog to digital RJ11 shielded (1.9m) – digital to digital USB cable (1.9m) RS232 cable (1.9m) ASSOCIATED DEVICESNA NOTE: The EUT is an input / output integrated device for a computer, using Wacom’s seneor, an erasing UltraPen and a 15.0 inch TFT color LCD monitor. The tablet continuously transmits data to and from a UltraPen. For a more detailed features description, please refer to the manufacturer's specifications or the User's Manual. FCC ID: HV4PL550 Report No.: RF900716A03 6 Issued: July 23, 2001 3.2 DESCRIPTION OF TEST MODES Three channels are provided in th…

Text truncated - open the document above for the full version.

FCC ID: HV4PL550 Report No.: RF900716A03 19 Issued: July 23, 2001 5 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST FCC ID: HV4PL550 Report No.: RF900716A03 20 Issued: July 23, 2001 RADIATED EMISSION TEST