HV4STU-300LCD SIGNATURE TABLET

LCD Signature Tablet STU-300 User’s manual Benutzerhandbuch Manuel de l’utilisateur Manual del usuario 사용 설명서 1 CONTENTS INTRODUCTION AND OVERVIEW .................................................... 2 PRECAUTIONS ON USE AND HANDLING ........................................ 3 Connecting the tablet ........................................................................ 5 Software / Driver ................................................................................ 5 Service ............................................................................................... 5 Replacing the pen tip ......................................................................... 5 Caring for your LCD signature tablet ................................................. 6 Specifi cation ...................................................................................... 7 Reuse, recycling, and recovery .......................................................... 8 Radio and television interference ...................................................... 8 CE declaration ................................................................................... 8 Federal Communications Commission (FCC) notice ......................... 9 2 INTRODUCTION AND OVERVIEW The Wacom ® STU-300 LCD signature tablet combines the benefi ts of a liquid crystal display (LCD) with the control, comfort, and productivity of Wacom’s cordless, battery- free pen technology. This gives you a direct pen-on-screen interface that leads to a truer pen-on-paper writing experience. The basic components of the LCD signature tablet include a Wacom pen tablet internally mounted behind a FSTN monochrome LCD display, and a Wacom pen. The LCD signature tablet is equipped with a USB interface. 3 PRECAUTIONS ON USE AND HANDLING Be sure to follow all instructions, cautions, and warnings found within this guide. Failure to do so could cause the loss of data or damage to your computer. Failure to do so could also void your warranty, in which case Wacom shall have no responsibility to repair or replace the product. Usage WARNING Do not use the STU-300 LCD signature tablet in a facility control system that requires extremely high reliability; it may cause other electronic devices to malfunction, or other devices may cause the LCD signature tablet to malfunction. Where use is prohibited, power off the STU-300 to prevent the possibility of it causing other electronic devices to malfunction. Wacom does not accept any liability for direct or consequential damages. For details, please refer to your Warranty located at the end of this guide. Environment Temperature and humidity • Operating temperature and humidity: 5° to 35°C, 20 to 80% RH, non-condensing • Storage temperature and humidity: -10° to 60°C, 20 to 90% RH, non-condensing CAUTION Do not use or store the LCD signature tablet where: • Temperature changes are severe or exceed specifi cations (e.g., outdoors or inside a vehicle). • The LCD signature tablet and pen are exposed to direct sunlight or heat from an appliance, or are exposed to water or any other kind of liquid. Do not use the LCD signature tablet in a dusty environment; this may damage the unit. 4 Handling WARNING High Voltage. Do not open or disassemble the STU-300 LCD signature tablet. There is a risk of electrical shock when the casing is open. This will also void your warranty and Wacom shall have no responsibility to repair or replace the product. If the LCD screen has been damaged, DO NOT touch any liquid that may be leaking from it; this liquid is an irritant. In case of contact with skin, eyes, or mouth, rinse immediately with running water for at least 15 minutes or more. If contact is made with the eyes or mouth, also consult a physician. Prevent children from swallowing the pen tip. The pen tip may accidentally be pulled out if children are biting on them. CAUTION Do not disassemble the pen. This may cause the device to malfunction. In this case, Wacom shall have no responsibility to repair or replace the product. Do not scratch the display screen. Avoid placing sharp objects on the display screen surface. Avoid intensive shock or vibration to the STU-300 or the pen. Hitting or dropping the LCD signature tablet may damage the display screen or other components. Do not put heavy articles on the LCD signature tablet or push against it with a strong force; This may damage the display screen. Do not place heavy articles on the STU-300 cabling, repeatedly bend the cables sharply, or apply heavy stress to the cable connectors; this may damage the unit or cabling. If the pen tip becomes sharp or angular, it may damage the coating on the display screen. Please replace the pen tip if necessary. Do not use any organic solvent (e.g., alcohol) or even mild detergent to clean the display screen. Use of these cleaners can damage the coating on the screen. Please note that damage of this kind is not covered by the manufacturer's warranty. • To clean the display screen, use an anti-static cloth or a slightly damp cloth. When cleaning, apply only a light amount of pressure to the display screen and do not make the surface wet. • To clean the LCD signature tablet casing or pen, use a soft cloth with mild detergent (such as dish washing liquid) diluted with water. Do not expose the STU-300 to high voltage electrostatic discharges or to a build-up of an electrostatic charge on the LCD screen. This may result in a temporary blotching of the LCD monitor. If blotching occurs, leave the STU-300’s display on and the blotching should disappear within a few hours. Wacom LCD signature tablet products comply with the European Union RoHS Directive 2002/95/EC (RoHS Directive). 5 Connecting the tablet The STU-300 can be connected to a host computer via a USB cable. Consult your Wacom Signature Solution Partner for the STU-300 and host computer connection. Software / Driver Wacom does not provide any driver or application software for the STU-300. Any applicatio…

Text truncated - open the document above for the full version.

Page: 1 Page: 2

FCC ID: HV4STU-300 FCC LABEL LOCATION The label will be permanently affixed at a conspicuous location on the device. Label

Page: 1 Page: 2 Page: 3 Page: 4 Page: 5

Report No.: RF981111A04 1 Report Format Version 3.0.0 FCC TEST REPORT REPORT NO.: RF981111A04 MODEL NO.: STU-300 RECEIVED: Nov. 11, 2009 TESTED: Nov. 16 ~ 27, 2009 ISSUED: Nov. 30, 2009 APPLICANT: Wacom Co., Ltd. ADDRESS: 2-510-1 Toyonodai, Otone-cho Kitasaitama-gun, Saitama, 349-1148, Japan ISSUED BY: Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch LAB ADDRESS: No. 47, 14th Ling, Chia Pau Tsuen, Lin Kou Hsiang, Taipei Hsien 244, Taiwan This test report consists of 24 pages in total. It may be duplicated completely for legal use with the approval of the applicant. It should not be reproduced except in full, without the written approval of our laboratory. The client should not use it to claim product endorsement by TAF, or any government agencies. The test results in the report only apply to the tested sample. Report No.: RF981111A04 2 Report Format Version 3.0.0 Table of Contents 1 CERTIFICATION .........................................................................................3 2 SUMMARY OF TEST RESULTS ...................................................................4 2.1 MEASUREMENT UNCERTAINTY .................................................................4 3 GENERAL INFORMATION ............................................................................5 3.1 GENERAL DESCRIPTION OF EUT ..............................................................5 3.2 DESCRIPTION OF TEST MODES ................................................................6 3.2.1 CONFIGURATION OF SYSTEM UNDER TEST ...........................................6 3.2.2 TEST MODE APPLICABILITY AND TESTED CHANNEL DETAIL ................7 3.3 GENERAL DESCRIPTION OF APPLIED STANDARDS ...............................8 3.4 DESCRIPTION OF SUPPORT UNITS ..........................................................8 4 TEST PROCEDURE AND RESULT ..............................................................9 4.1 CONDUCTED EMISSION MEASUREMENT ................................................9 4.1.1 LIMITS OF CONDUCTED EMISSION MEASUREMENT ..............................9 4.1.2 TEST INSTRUMENTS ................................................................................10 4.1.3 TEST PROCEDURES ..................................................................................11 4.1.4 DEVIATION FROM TEST STANDARD ........................................................11 4.1.5 TEST SETUP ...............................................................................................11 4.1.6 EUT OPERATING CONDITIONS ................................................................12 4.1.7 TEST RESULTS ..........................................................................................13 4.2 RADIATED EMISSION MEASUREMENT ...................................................15 4.2.1 LIMITS OF RADIATED EMISSION MEASUREMENT .................................15 4.2.2 TEST INSTRUMENT ...................................................................................16 4.2.3 TEST PROCEDURE ...................................................................................17 4.2.4 DEVIATION FROM TEST STANDARD .......................................................17 4.2.5 TEST SETUP ..............................................................................................18 4.2.6 EUT OPERATING CONDITION ..................................................................18 4.2.7 TEST RESULT ............................................................................................19 4.2.8 TEST RESULTS (SPECTRUM BANDWIDTH) ............................................21 5 PHOTOGRAPHS OF THE TEST CONFIGURATION ..................................22 6 INFORMATION ON THE TESTING LABORATORIES ................................23 7 APPENDIX A – MODIFICATIONS RECORDERS FOR ENGINEERING CHANGES TO THE EUT BY THE LAB .......................................................24 Report No.: RF981111A04 3 Report Format Version 3.0.0 1 CERTIFICATION PRODUCT: LCD SIGNATURE TABLET BRAND NAME: Wacom MODEL NO.: STU-300 APPLICANT: Wacom Co., Ltd. TESTED: Nov. 16 ~ 27, 2009 TEST SAMPLE: ENGINEERING SAMPLE STANDARDS: FCC Part 15, Subpart C (Section 15.209), ANSI C63.4 -2003 The above equipment has been tested by Bureau Veritas Consumer Products Services (H.K.) Ltd., Taoyuan Branch, and found compliance with the requirement of the above standards. The test record, data evaluation & Equipment Under Test (EUT) configurations represented herein are true and accurate accounts of the measurements of the sample’s EMC characteristics under the conditions specified in this report. PREPARED BY : , DATE: Nov. 30, 2009 ( Kay Chen / Supervisor ) TECHNICAL ACCEPTANCE : , DATE: Nov. 30, 2009 Responsible for RF ( Jamison Chan / Supervisor ) APPROVED BY : , DATE: Nov. 30, 2009 ( Ken Liu / Assistant Manager ) Report No.: RF981111A04 4 Report Format Version 3.0.0 2 SUMMARY OF TEST RESULTS The EUT has been tested according to the following specifications: APPLIED STANDARD: FCC Part 15, Subpart C STANDARD PARAGRAPH TEST TYPE RESULT REMARK 15.207 Conducted Emission Test PASS Meet the requirement of limit. Minimum passing margin is –16.36 dB at 0.173MHz. 15.209 Radiated Emission Test PASS Meet the requirement of limit. Minimum passing margin is –5.2 dB at 109.28MHz & 110.83MHz. 2.1 MEASUREMENT UNCERTAINTY Where relevant, the following measurement uncertainty levels have been estimated for tests performed on the EUT as specified in CISPR 16-4-2: This uncertainty represents an expanded uncertainty expressed at approximately the 95% confidence level using a coverage factor of k=2. MEASUREMENT UNCERTAINTY Conducted emissions 2.44 dB Radiated emissions 3.75 dB Report No.: RF981111A04 5 Report Format Version 3.0.0 3 GENERAL INFORMATION 3.1 GENERAL DESCRIPTION OF EUT PRODUCT LCD SIGNATURE TABLET MODEL NO. STU-300 FCC ID HV4STU-300 POWER SUPPLY 5Vdc from PC CARRIER FREQUENCY OF EACH CHANNEL 531.25 kHz 562.50 kHz 593.75 kHz NUMBER OF CHANNEL 3 ANTENNA TYPE Loop antenna…

Text truncated - open the document above for the full version.

1 PHOTOGRAPHS OF THE TEST CONFIGURATION CONDUCTED EMISSION TEST 2 RADIATED EMISSION TEST