IJELR778CRT MONITOR

Page 24 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Page 25 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Page 26 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Page 27 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Page 28 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Page 29 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help.

Page 17 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Block Diagram

Page 6 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Photographs Figure 1 General Appearance Figure 2 General Appearance Label Location Page 7 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 3 General Appearance Figure 4 General Appearance Page 8 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 5 General Appearance Figure 6 General Appearance Page 9 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 7 General Appearance Figure 8 General Appearance

Page 6 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Photographs Figure 1 General Appearance Figure 2 General Appearance Label Location

Page 4 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Label Drawing Please refer Exhibit 2 Figure 2 for Label Placement Location

Page 10 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 9 Main Board, Component Side Figure 10 Main Board, Component Side Page 11 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 11 Main Board, Component Side Figure 12 Main Board, Component Side Page 12 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 13 Main Board, Component Side Figure 14 Main Board, Component Side Page 13 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 15 Main Board, Component Side Figure 16 Main Board, Component Side Page 14 Proview Electronics Co., Ltd. CRT Monitor FCC ID : IJELR778 Figure 17 Main Board, Component Side

FCC ID:IJELR778 p age 1-1 Proview Electronics Co., Ltd. CRT Monitor Brand Name Model No. Brand Name Model No. Proview 778 Vobis 778 EMC 778 MOTOROLA 778 MAG 778 acer AF7X0*(X=0-9, *=A-Z or Blank) XEROX 778 Lenovo LXH-WG769F2 eMachine 778 Lenovo LXB-HF769A Prepared for : Proview Electronics Co., Ltd. 6F, No. 1, Pau-Sheng Rd., Yung-Ho City, Taipei, Taiwan Prepared By : Audix Technology (Shenzhen) Co., Ltd. No. 6, Ke Feng Rd., 52 Block, Shenzhen Science & Industrial Park, Nantou, Shenzhen, Guangdong, China Tel: (0755) 26639496 Report Number ： ACS-F04125 Date of Test ： Apr.18~20, 2004 Date of Report ： May.17, 2004 FCC ID:IJELR778 p age 1-2 TABLE OF CONTENTS Description Page FCC Test Report for Declaration of Conformity 1. GENERAL INFORMATION .................................................................................................... 1-4 1.1. Description of Device (EUT) .............................................................................................................1-4 1.2. Tested Supporting System Details .....................................................................................................1-5 1.3. Test Facility........................................................................................................................................1-7 1.4. Test Uncertainty .................................................................................................................................1-7 2. POWER LINE CONDUCTED EMISSION TEST.................................................................. 2-1 2.1. Test Equipment ..................................................................................................................................2-1 2.2. Block Diagram of Test Setup .............................................................................................................2-1 2.3. Power Line Conducted Emission Test Limits....................................................................................2-2 2.4. Configuration of EUT on Test ...........................................................................................................2-2 2.5. Operating Condition of EUT..............................................................................................................2-2 2.6. Test Procedure....................................................................................................................................2-2 2.7. Power Line Conducted Emission Test Results ..................................................................................2-3 3. RADIATED EMISSION TEST ................................................................................................. 3-1 3.1. Test Equipment ..................................................................................................................................3-1 3.2. Block Diagram of Test Setup .............................................................................................................3-1 3.3. Radiated Emission Limit ....................................................................................................................3-2 3.4. EUT Configuration on Test................................................................................................................3-2 3.5. Operating Condition of EUT..............................................................................................................3-3 3.6. Test Procedure....................................................................................................................................3-3 3.7. Radiated Emission Test Result...........................................................................................................3-4 4. DEVIATION TO TEST SPECIFICATIONS .......................................................................... 4-1 5. PHOTOGRAPH.......................................................................................................................... 5-1 5.1. Photos of Power Line Conducted Emission Test ...............................................................................5-1 5.2. Photos of Radiated Emission Test (In 10m Anechoic Chamber).......................................................5-2 APPENDIX I (9 pages) APPENDIX II (9 pages) FCC ID:IJELR778 p age 1-3 TEST REPORT DECLARATION Applicant ： Proview Electronics Co., Ltd. Manufacturer ： Proview Technology (Shenzhen) Co., Ltd. EUT Description ： CRT Monitor (A) MODEL NO. & BRAND NAME : Proview 778 Vobis 778 EMC 778 MOTOROLA 778 MAG 778 acer AF7X0*(X=0-9, *=A-Z or Blank) XEROX 778 Lenovo LXH-WG769F2 eMachine 778 Lenovo LXB-HF769A (B) SERIAL NO. : F2004051701 (C) POWER SUPPLY : AC 120V/60Hz Test Procedure Used: FCC Rules and Regulations Part 15 Subpart B Class B Aug, 2003. The device described above is tested by AUDIX TECHNOLOGY (SHENZHEN) CO., LTD. to determine the maximum emission levels emanating from the device. The maximum emission levels are compared to the FCC Part 15 Subpart Class B limits both radiated and conducted emissions. The test results are contained in this test report and AUDIX TECHNOLOGY (SHENZHEN) CO., LTD. is assumed full responsibility for the accuracy and completeness of these tests. Also, this report shows that the Equipment Under Test (EUT) is to be technically compliant with the FCC requirements. This report applies to above tested sample only. This report shall not be reproduced in part without written approval of AUDIX TECHNOLOGY (SHENZHEN) CO., LTD. This report must not be used by the applicant to claim product endorsement by NVLAP or any agency of the U.S. Government. Date of Test : Apr.18~20, 2004 Prepared by : Reviewer : Approved & Authorized Signer : Name of the Representative of the Responsible Party : Signature : FCC ID:IJELR778 p age 1-4 1. GENERAL INFORMATION 1.1. Description of Device (EUT) Description : CRT Monitor Model Number & Brand Name : Proview 778 Vobis 778 EMC 778 MOTOROLA 778 MAG 778 acer AF7X0*(X=0-9, *=A-Z …

Text truncated - open the document above for the full version.

FCC ID:IJELR778 p age 5-1 5. PHOTOGRAPH 5.1. Photos of Power Line Conducted Emission Test FCC ID:IJELR778 p age 5-2 5.2. Photos of Radiated Emission Test (In 10m Anechoic Chamber) FCC ID:IJELR778 p age 5-3