IKQBTFMBluetooth FM Transmitter

FCC Statement -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Les changements ou modifications non expressément approuvés par la partie responsable de la conformité pourraient annuler l'autorité de l'utilisateur à utiliser l'équipement. Cet équipement a été testé et jugé conforme aux limites d'un dispositif numérique de classe B, conformément à la partie 15 des règles de la FCC. Ces limites sont con?ues pour fournir une protection raisonnable contre les interférences nuisibles dans une installation résidentielle. Cet équipement génère, utilise et peut émettre de l'énergie radiofréquence et, si non installé et utilisé conformément aux instructions, peut provoquer des interférences dans les communications radio. Cependant, il n'y a aucune garantie que des interférences ne se produiront pas dans une installation particulière. Si cet équipement provoque des interférences nuisibles à la réception radio ou de télévision, ce qui peut être déterminé en allumant et éteignant l'équipement, l'utilisateur est encouragé à essayer de corriger l'interférence par une ou plusieurs des mesures suivantes: - Réorienter ou déplacer l'antenne de réception. - Augmenter la distance entre l'équipement et le récepteur. - Connecter l'équipement à une sortie sur un circuit différent de celui sur lequel est branché le récepteur. - Consulter le revendeur ou un technicien radio / TV expérimenté pour de l'aide IC Statement This device complies with Industry Canada licence-exempt RSS standard(s): Operation is subject to the following Two conditions:(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. The term “IC: “ before the certification/registration number only signifies that the Industry Canada technical specifications were met. This product meets the applicable Industry Canada technical specifications. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement

Letter of Authorization June 18, 2015 To Whom It May Concern: We, the undersigned, hereby authorize: MiCOM Labs Inc. 575 Boulder Court Pleasanton CA 94566 USA., to act on our behalf in matters related to applying to the appropriate agencies for our part number BTFM. Any and all acts carried out by MiCOM Labs Inc. on our behalf shall have the same effect as acts of our own. This authorization expires on June 18, 2016. This shall include the following: • Testing • Approval applications (includes complete product documentation package, including Confidential information) and procedures • Payment of approval fees We declare that MiCOM Labs Inc. is allowed to forward all information related to the approval project to the applied notified body and to the notification entities and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Sincerely, Mark Larson Sr. Product Manager on behalf of: Scosche Industries 805/486-4450 ext. 127

June 18, 2015 Federal Communications Commission Office of Engineering Technology 7435 Oakland Mills Road Columbia, MD 21046 Confidentiality Request regarding application for certification of FCC ID: IKQBTFM Pursuant to Sections 0.457 and 0.459 of the Commission’s Rules (47CFR, 0.457, 0.459), we hereby request confidential treatment of information accompanying this application as outlined below: 1. Schematic Diagram 2. Block Diagram 3. Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Mark Larson Sr. Product Manager

Photographs of EUT Model: BTFM External Photos

LABEL ARTWORK AND LOCATION Product: Bluetooth FM Transmitter Model: BTFM Label size: L*W=25*20mm Scosche Industries, Inc. SCOSCHE MODEL NO.: BTFM IC: 6955A-BTFM FCC ID: IKQBTFM

Model: BTFM Internal Photos

Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com TEST REPORT FCC ID: IKQBTFM Product: Bluetooth FM Transmitter Model No.: BTFM Additional Model No.: N/A Trade Mark: SCOSCHE Report No.: TCT150514E003 Issued Date: Aug. 07, 2015 Issued for : Scosche Industries, Inc. 1550 Pacific Ave. Oxnard, CA 93033, USA Issued By: Shenzhen Tongce Testing Lab. 1F, Leinuo Watch Building, Fuyong Town, Baoan Dist, Shenzhen, China TEL: +86-755-27673339 FAX: +86-755-27673332 Note: This report shall not be reproduced except in full, without the written approval of Shenzhen Tongce Testing Lab. This document may be altered or revised by Shenzhen Tongce Testing Lab. personnel only, and shall be noted in the revision section of the document. The test results in the report only apply to the tested sample. Report No.: TCT150514E003 Page 2 of 28 Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com TABLE OF CONTENTS 1. Test Certification....................................................................................... 3 2. Test Result Summary ............................................................................... 4 3. EUT Description ........................................................................................ 5 4. Genera Information................................................................................... 6 4.1. Test environment and mode................................................................................. 6 4.2. Description of Support Units................................................................................ 6 5. Facilities and Accreditations ................................................................... 7 5.1. Facilities ................................................................................................................. 7 5.2. Location ................................................................................................................. 7 5.3. Measurement Uncertainty..................................................................................... 7 6. Test Results and Measurement Data ...................................................... 8 6.1. Antenna requirement ............................................................................................ 8 6.2. Conducted Emission ............................................................................................. 9 6.3. Conducted Output Power ................................................................................... 10 6.4. Emission Bandwidth ........................................................................................... 13 6.5. Power Spectral Density....................................................................................... 16 6.6. Test Specification................................................................................................ 16 6.7. Conducted Band Edge and Spurious Emission Measurement ....................... 19 6.8. Radiated Spurious Emission Measurement...................................................... 22 Appendix A: Photographs of Test Setup Appendix B: Photographs of EUT Report No.: TCT150514E003 Page 3 of 28 Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com 1. Test Certification Product: Bluetooth FM Transmitter Model No.: BTFM Additional Model No.: N/A Applicant: Scosche Industries, Inc. Address: 1550 Pacific Ave. Oxnard, CA 93033, USA Manufacturer: Shenzhen James Audio Technology Co., Ttd. Address: 4F, Building A, Rongli Industrial Park, Miaoxi Industrial Zone, Xinghua Community, Guanlan Street, Longhua New District, Shenzhen, China Date of Test: May 14 – Jun. 04, 2015 Applicable Standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 KDB 558074 D01 DTS Meas Guidance v03r02 The above equipment has been tested by Shenzhen Tongce Testing Lab. and found compliance with the requirements set forth in the technical standards mentioned above. The results of testing in this report apply only to the product/system, which was tested. Other similar equipment will not necessarily produce the same results due to production tolerance and measurement uncertainties. Tested By: Date:Jun. 04, 2015 SKY Reviewed By: Date:Aug. 07, 2015 Joe Zhou Approved By: Date:Aug. 07, 2015 Tomsin Report No.: TCT150514E003 Page 4 of 28 Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com 2. Test Result Summary Requirement CFR 47 Section Result Antenna requirement §15.203/§15.247 (c) PASS AC Power Line Conducted Emission §15.207 N/A Conducted Peak Output Power §15.247 (b)(3) PASS 6dB Emission Bandwidth §15.247 (a)(2) PASS Power Spectral Density §15.247 (e) PASS Band Edge §15.247(d) PASS Spurious Emission §15.205/§15.209 PASS Note: 1. PASS: Test item meets the requirement. 2. Fail: Test item does not meet the requirement. 3. N/A: Test case does not apply to the test object. 4. The test result judgment is decided by the limit of test standard. Report No.: TCT150514E003 Page 5 of 28 Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com 3. EUT Description Product Name: Bluetooth FM Transmitter Model : BTFM Additional Model: N/A Trade Mark: SCOSCHE Operation Frequency: 2402MHz~2480MHz Channel Separation: 2MHz Number of Channel: 40 Modulation Technology: GFSK Antenna Type: PCB Antenna Antenna Gain: 0dBi Power Supply: DC 12V Operation Frequency each of channel Channel FrequencyChannel FrequencyChannelFrequencyChannel Frequency 0 2402MHz10 2422MHz20 2442MHz30 2462MHz 1 2404MHz11 2424MHz21 2444MHz31 2464MHz ... ... ... ... ... ... ... ... 8 2418MHz18 2438MHz28 2458MHz38 2478MHz 9 2420MHz19 2440MHz29 2460MHz39 2480MHz Remark: Channel 0, 19 & 39 have been tested. Report No.: TCT150514E003 Page 6 of 28 Hotline: 400-6611-140 Tel: 86-755-27673339 Fax: 86-755-27673332 http://www.tct-lab.com 4. Genera Information 4.1. Test environment and mode Operating Environment: Temperature: 2…

Text truncated - open the document above for the full version.

Test Setup Model: BTFM Radiated For BT TX For FM TX