JRMTX6813transmitter

TX-D4A235 User Guide Model No. : TX-D4A235 Frequency : 433.92MHz Operate Voltage : 12V( GP-27A*1 ) Operate Current : 6mA Button VS. data table Button Data code * D3 D2 D1 D0 Put off Put off Put off Put off No transmission Push Put off Put off Put off 0 0 0 1 Put off Push Put off Put off 0 0 1 0 Put off Put off Push Put off 0 1 0 0 Put off Put off Put off Push 1 0 0 0 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. To comply with the FCC RF exposure compliance requirements, this device and its antenna must not be co-located or operating to conjunction with any other antenna or transmitter. Luck Unluck Alarm TRUNK

FCC ID: JRMTX6813 Sheet A1 of A1 Sheets ETC Report No. : 11-06-MAS-216 ANNEX A: EXTERNAL CONSTRUCTION PHOTOS OF EUT 1. Outside view 1 of EUT 2. Outside view 2 of EUT

FCC ID: JRMTX6813 Sheet B1 of B2 Sheets ETC Report No. : 11-06-MAS-216 ANNEX B: INTERNAL CONSTRUCTION PHOTOS OF EUT 1. Inside View 1 of EUT 2. Inside View 2 of EUT FCC ID: JRMTX6813 Sheet B2 of B2 Sheets ETC Report No. : 11-06-MAS-216 3. Front view of PCB 4. Rear view of PCB

FCC ID: JRMTX6813 Sheet 2 of 21 Sheets ETC Report No.: 11-06-MAS-216 Rev. No 1.0 Client : Micro Alarm System Inc Address : 4825 South Soto street Vernon, CA 90058 Manufacturer : Micro Alarm System Inc Address : 4825 South Soto street Vernon, CA 90058 EUT : transmitter Trade name : MICRO Model No. : TX-D4A235 Power Source : DC 6V（Lithium Battery） Regulations applied : FCC 47 CFR, Part 15 Subpart C The testing described in this report has been carried out to the best of our knowledge and ability, and our responsibility is limited to the exercise of reasonable care. This certification is not intended to believe the sellers from their legal and/or contractual obligations. The compliance test is only certified for the test equipment and the results of the testing report relate only to the item tested. The compliance test of this report was conducted in accordance with the appropriate standards. It’s not intention to assure the quality and performance of the product. This report shall not be reproduced except in full, without the approval of ETC. This report must not be used by the client to claim product endorsement by NVLAP or any agency of the U.S. Government. Laboratory Introduction: Electronics Testing Center, Taiwan is recognized, filed and mutual recognition arrangement as following: 1 ISO9001: TüV Product Service 2 ISO/IEC 17025: BSMI, CNLA, NCC, NVLAP, CCIBLAC, UL, Compliance 3 Filing: FCC, Industry Canada, VCCI 4 MRA: Australia, Hong Kong, New Zealand, Singapore, USA, Japan, Korea, China, APLAC through TAF 5 FCC Registration Number: 90588, 91094, 91095 h Industry Canada Site Regisitation number: IC 2949A NVLAP Lab Code 200133-0 FCC ID: JRMTX6813 Sheet 3 of 21 Sheets ETC Report No.: 11-06-MAS-216 Rev. No 1.0 Table of Contents Page 1. GENERAL INFORMATION ...................................................................................................................................... 4 1.1 PRODUCT DESCRIPTION.................................................................................................................................................. 4 1.2 CHARACTERISTICS OF DEVICE:....................................................................................................................................... 4 1.3 TEST METHODOLOGY..................................................................................................................................................... 4 1.4 TEST FACILITY............................................................................................................................................................... 4 2. DEFINITION AND LIMITS ....................................................................................................................................... 5 2.1 DEFINITION.................................................................................................................................................................... 5 2.2 RESTRICTED BANDS OF OPERATION...............................................................................................................................5 2.3 LIMITATION.................................................................................................................................................................... 6 2.4 LABELING REQUIREMENT............................................................................................................................................... 7 2.5 USER INFORMATION....................................................................................................................................................... 7 3. RADIATED EMISSION MEASUREMENT ............................................................................................................. 8 3.1 APPLICABLE STANDARD................................................................................................................................................. 8 3.2 MEASUREMENT PROCEDURE.......................................................................................................................................... 8 3.3 TEST DATA................................................................................................................................................................... 10 3.4 FIELD STRENGTH CALCULATION.................................................................................................................................. 12 3.5 RADIATED TEST EQUIPMENT........................................................................................................................................ 12 3.6 MEASURING INSTRUMENT SETUP................................................................................................................................. 16 4. BANDWIDTH OF EMISSION.................................................................................................................................. 17 4.1 APPLICABLE STANDARD PLOT GRAPHIC OF BANDWIDTH............................................................................................ 17 4.2 TEST EQUIPMENT......................................................................................................................................................... 17 4.3 TEST RESULT............................................................................................................................................................... 17 5. CONDUCTED EMISSION MEASUREMENT ........................................................................................................ 19 6. LIMIT OF TRANSMISSION TIME ......................................................................................................................... 20 6.1 APPLICABLE STANDARD............................................................................................................................................... 20 6.2 TEST EQUIPMENT.........................................................…

Text truncated - open the document above for the full version.

FCC ID: JRMTX6813 Sheet 1 of 2 Sheets ETC Report No. : 11-06-MAS-216 Photos of Radiation Measuring Setup x-axis FCC ID: JRMTX6813 Sheet 2 of 2 Sheets ETC Report No. : 11-06-MAS-216 y-axis z-axis