KE3PROTX1Pet Containment System

FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1 FCC ID: KE3PROTX1

FCC ID: KE3PROTX1

FCC ID: KE3PROTX1

FCC ID: KE3PROTX1

FCC ID: KE3PROTX1 Photo 1.Front View of EUT FCC ID: KE3PROTX1 Photo 2. Back View of EUT FCC ID: KE3PROTX1 Photo 4. Side View of EUT FCC ID: KE3PROTX1 Photo 5. Side View of EUT

FCC ID: KE3PROTX1

FCC ID: KE3PROTX1 Photo 3.Top View of EUT FCC ID: KE3PROTX1 Photo 6. Main Board of EUT, PCB Side FCC ID: KE3PROTX1 Photo 7.Main Board of EUT, Solder Side

FCC ID: KE3PROTX1 FCC ID: KE3PROTX1

Radio Systems Corporation FCC Part 15, Certification Application Model PRO-TX1 August 15, 2002 MEASUREMENT/TECHNICAL REPORT COMPANY NAME:Radio Systems Corporation MODEL:PRO-TX1 FCC ID: KE3PROTX1 DATE: August 15, 2002 This report concerns (check one): Original grant X Class II change_ _ Equipment type: Low Frequency, Low Power Transmitter Deferred grant requested per 47 CFR 0.457(d)(1)(ii)? yes_____ No X If yes, defer until:_________________ date N.A. agrees to notify the Commission by NA date of the intended date of announcement of the product so that the grant can be issued on that date. Report prepared by: United States Technologies, Inc. 3505 Francis Circle Alpharetta, GA 30004 Phone Number: (770) 740-0717 Fax Number: (770) 740-1508 FCC ID: KE3PROTX1 TABLE OF CONTENTS AGENCY AGREEMENT CONFIDENTIALITY REQUEST SECTION 1 GENERAL INFORMATION Product Description Related Submittal(s) Grant(s) SECTION 2 TESTS AND MEASUREMENTS Configuration of Tested Test Facility Test Equipment Modifications Field Strength of Fundamental Emission Field Strength of Spurious Emissions Radiated Emissions Power Line Conducted Emissions SECTION 3 LABELING INFORMATION SECTION 4 BLOCK DIAGRAM/SCHEMATICS SECTION 5 PHOTOGRAPHS SECTION 6 USER'S MANUAL FCC ID: KE3PROTX1 LIST OF FIGURES AND TABLES FIGURES Test Configuration Photograph(s) for Spurious and Fundamental Emissions TABLES EUT And Peripherals Test Instruments Field Strength of Fundamental Emission Field Strength of Spurious Emissions Power Line Conducted Emissions FCC ID: KE3PROTX1 SECTION 1 GENERAL INFORMATION FCC ID: KE3PROTX1 GENERAL INFORMATION Product Description The Equipment Under Test (EUT) is a Radio Systems Corporation Low Frequency, Low Power Pet Containment System Model PRO-TX1. The EUT is a dog fence transmitter. The EUT has the capability of 2 different independent zones (each designed for different size areas) and also utilizes a user selectable frequency (7.37 kHz & 10.65 kHz). Related Submittal(s) Grant(s) The EUT is subject to the following authorizations: a) Certification as a low power transmitter (10.65 kHz) The information contained in this report is presented for the Certification authorization for the transmitter portion of the EUT. FCC ID: KE3PROTX1 SECTION 2 TESTS AND MEASUREMENTS FCC ID: KE3PROTX1 TESTS AND MEASUREMENTS Configuration of Tested System The sample was tested per ANSI C63.4, Methods of Measurement from Low-Voltage Electrical and Electronic Equipment in the Range of 30 MHz -1 GHz (1992). Conducted and radiated emissions data were taken with the test receiver or spectrum analyzer's resolution bandwidth adjusted to 100 Hz (9 kHz – 150 kHz), 9kHz (150 kHz - 30 MHz), and 120 kHz (30 MHz - 1 GHz) respectively. All measurements are peak unless stated otherwise. The video filter associated with the spectrum analyzer was off throughout the evaluation process. Interconnecting cables were manipulated as necessary to maximize emissions. A block diagram of the tested system is shown in Figure 1. Test configuration photographs for spurious and fundamental emissions are shown in Figure 2. Only one channel was selected for test since the unit operates on less than a 1 MHz band of channels. The 10.65 kHz was selected for test since the FCC does not approve transmitters below 9 kHz. The EUT was set up with a 300' length of wire connected to it, to simulate a typical installation. The wire was not buried, as it would be in a typical installation (approximately 2 -3 inches). Measurements were taken at all three antenna polarities along one of the long edges (111‘) of the rectangle at a distance of 3 meters to characterize the emissions. The worse case emissions were then tested at 10 meters. Results between 100 kHz and 30 MHz were corrected to 30 meters by the following 40 log (300/10) = 59.1 dB. Those results below 100 kHz were corrected to 300 meters by the following 60 log (300/10) = 88.6 dB (which has been applied to other submittals and is allowed per previous discussions with Greg Czumak at the FCC). Test Facility Conducted and digital device testing was performed at US Tech's measurement facility as described to the FCC and acknowledged in their letter marked 31040/SIT/USTECH. Additional radiated testing was performed at a vacant area that would allow measurements to be made 10 meters away from the EUT with the 300' length of wire connected to it. Test Equipment Table 2 describes test equipment used to evaluate this product. Modifications No modifications were made to bring the EUT into compliance with FCC Part 15, Class B Requirements: FCC ID: KE3PROTX1 FIGURE 1 TEST CONFIGURATION 120 VAC 60Hz Direct Plug In Dog Fence Transmitter only 1 zone tested at a time (EUT) 6’U 300 ‘ U total Adapter 39‘ U on short side 111‘ U on long side 6 ‘ U total FCC ID: KE3PROTX1 FIGURE 2a Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2b Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2c Photograph(s) for Spurious and Fundamental Emissions (Photograph Shows 1 st portion of testing at 3 meters) FCC ID: KE3PROTX1 FIGURE 2d Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2e Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2f Photograph(s) for Digital Device Emissions FCC ID: KE3PROTX1 FIGURE 2g Photograph(s) for Digital Device Emissions FCC ID: KE3PROTX1 FIGURE 2h Photograph(s) for Conducted Emissions FCC ID: KE3PROTX1 EUT and Peripherals PERIPHERAL MANUFACTURER MODEL NUMBER SERIAL NUMBER FCC ID:CABLES P/D Dog Fence Transmitter Radio Systems Corporation (EUT) PRO-TX1NoneKE3PROTX1 (pending) 300' U 6’ U Adapter Manufacturer Unknown 300-021NoneN/A6' U FCC ID: KE3PROTX1 TABLE 2 TEST INSTRUMENTS TYPEMANUFACTURERMODELSN. SPECTRUM ANALYZERHEWLETT-PACKARD8593E3205A00124 SPECTRUM ANALYZERHEWLETT-PACKARD8558B2332A09900 S A DISPLAYHEWLETT-PACKARD853A2404A02387 COMB GENERATORHEWLETT-PACKARD8406A1632A01519 RF PREAMPHEWLETT-PACKARD8447D1937A03355 BICON…

Text truncated - open the document above for the full version.

FCC ID: KE3PROTX1 FIGURE 2a Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2b Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2c Photograph(s) for Spurious and Fundamental Emissions (Photograph Shows 1 st portion of testing at 3 meters) FCC ID: KE3PROTX1 FIGURE 2d Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2e Photograph(s) for Spurious and Fundamental Emissions FCC ID: KE3PROTX1 FIGURE 2f Photograph(s) for Digital Device Emissions FCC ID: KE3PROTX1 FIGURE 2g Photograph(s) for Digital Device Emissions FCC ID: KE3PROTX1 FIGURE 2h Photograph(s) for Conducted Emissions