KE3TXPG1010Pet Containment System

FCC ID: KE3TXPG1010 SECTION 6 USER’S MANUAL FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010

FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010

FCC ID: KE3TC100 SECTION 5 PHOTOGRAPHS FCC ID: KE3TC100 PHOTOS OF THE TESTED EUT Photo 1.Front View of EUT w/Adapter Photo 2. Back View of EUT Photo 3.Top View of EUT Photo 4. Main Board of EUT, PCB Side Photo 5.Main Board of EUT, Solder Side FCC ID: KE3TC100 Photo 1.Front View of EUT FCC ID: KE3TC100 Photo 2. Back View of EUT FCC ID: KE3TC100 Photo 3.Top View of EUT

FCC ID: KE3TC100 SECTION 3 LABELING INFORMATION FCC ID: KE3TC100 FCC ID: KE3TC100

FCC ID: KE3TC100 Photo 4. Main Board of EUT, PCB Side FCC ID: KE3TC100 Photo 5.Main Board of EUT, Solder Side

FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010 FCC ID: KE3TXPG1010

FCC ID: KE3TXPG1010

Radio Systems Corporation FCC Part 15, Certification Application Model PG-1010 November 1, 2000 MEASUREMENT/TECHNICAL REPORT COMPANY NAME:Radio Systems Corporation MODEL:PG-1010 FCC ID:KE3TXPG1010 DATE:November 1, 2000 This report concerns (check one): Original grant X Class II change_ _ Equipment type: Low Frequency, Low Power Transmitter Deferred grant requested per 47 CFR 0.457(d)(1)(ii)? yes_____ No X If yes, defer until:_________________ date N.A. agrees to notify the Commission by NA date of the intended date of announcement of the product so that the grant can be issued on that date. Report prepared by: United States Technologies, Inc. 3505 Francis Circle Alpharetta, GA 30004 Phone Number: (770) 740-0717 Fax Number: (770) 740-1508 FCC ID: KE3TXPG1010 TABLE OF CONTENTS AGENCY AGREEMENT SECTION 1 GENERAL INFORMATION Product Description Related Submittal(s) Grant(s) SECTION 2 TESTS AND MEASUREMENTS Configuration of Tested Test Facility Test Equipment Modifications Field Strength of Fundamental Emission Field Strength of Spurious Emissions Radiated Emissions Power Line Conducted Emissions SECTION 3 LABELING INFORMATION SECTION 4 BLOCK DIAGRAM/SCHEMATICS SECTION 5 PHOTOGRAPHS SECTION 6 USER'S MANUAL FCC ID: KE3TXPG1010 LIST OF FIGURES AND TABLES FIGURES Test Configuration Photograph(s) for Spurious and Fundamental Emissions TABLES EUT And Peripherals Test Instruments Field Strength of Fundamental Emission Field Strength of Spurious Emissions Power Line Conducted Emissions FCC ID: KE3TXPG1010 SECTION 1 GENERAL INFORMATION FCC ID: KE3TXPG1010 GENERAL INFORMATION Product Description The Equipment Under Test (EUT) is a Radio Systems Corporation Low Frequency, Low Power Petsafe Guardian Transmitter, Model PG-1010. The EUT consists of a 10.65 kHz dog fence transmitter. This report covers only the transmitter (dog fence) portion of the device. Related Submittal(s) Grant(s) The EUT is subject to the following authorizations: a)Certification as a low power transmitter (10.65 kHz) The information contained in this report is presented for the Certification authorization for the transmitter portion of the EUT. FCC ID: KE3TXPG1010 SECTION 2 TESTS AND MEASUREMENTS FCC ID: KE3TXPG1010 TESTS AND MEASUREMENTS Configuration of Tested System The sample was tested per ANSI C63.4, Methods of Measurement from Low-Voltage Electrical and Electronic Equipment in the Range of 30 MHz -1 GHz (1992). Conducted and radiated emissions data were taken with the test receiver or spectrum analyzer's resolution bandwidth adjusted to 100 Hz (9 kHz – 150 kHz), 9kHz (150 kHz - 30 MHz), and 120 kHz (30 MHz - 1 GHz) respectively. All measurements are peak unless stated otherwise. The video filter associated with the spectrum analyzer was off throughout the evaluation process. Interconnecting cables were manipulated as necessary to maximize emissions. A block diagram of the tested system is shown in Figure 1. Test configuration photographs for spurious and fundamental emissions are shown in Figure 2. The EUT was set up with a 320' length of wire connected to it, to simulate a typical installation. The wire was not buried, as it would be in a typical installation (approximately 2 -3 inches). Measurements were taken at all three antenna polarities on each side of the rectangle and intervals in between, at a distance of 3 meters. The side with the worst case results was re-measured at a distance of 10 meters. Results between 100 kHz and 30 MHz were corrected to 30 meters by the following 40 log (300/10) = 59.1 dB. Those results below 100 kHz were corrected to 300 meters by the following 60 log (300/10) = 88.6 dB (which has been applied to other submittals and is allowed per previous discussions with Greg Czumak at the FCC). Test Facility Conducted and digital device testing was performed at US Tech's measurement facility as described to the FCC and acknowledged in their letter marked 31040/SIT/USTECH. Additional radiated testing was performed at a vacant area that would allow measurements to be made 10 meters away from the EUT with the 320' length of wire connected to it. Test Equipment Table 2 describes test equipment used to evaluate this product. Modifications No modifications were made to bring the EUT into compliance with FCC Part 15, Class B Requirements: FCC ID: KE3TXPG1010 FIGURE 1 TEST CONFIGURATION 120 VAC 60Hz Direct Plug In Dog Fence Transmitter (EUT) 6’U 320 ‘ U total Adapter 37‘ U on short side 123‘ U on long side FCC ID: KE3TXPG1010 EUT and Peripherals PERIPHERAL MANUFACTURER MODEL NUMBER SERIAL NUMBER FCC ID:CABLES P/D Dog Fence Transmitter Radio Systems Corporation (EUT) PG-1010NoneKE3PG1010 (pending) 320' U Adapter Radio Systems Corporation 41A-12-830 P/N: 300-006 NoneNone6' U FCC ID: KE3TXPG1010 TABLE 2 TEST INSTRUMENTS TYPEMANUFACTURERMODELSN. SPECTRUM ANALYZERHEWLETT-PACKARD8593E3205A00124 SPECTRUM ANALYZERHEWLETT-PACKARD8558B2332A09900 S A DISPLAYHEWLETT-PACKARD853A2404A02387 COMB GENERATORHEWLETT-PACKARD8406A1632A01519 RF PREAMPHEWLETT-PACKARD8447D1937A03355 RF PREAMPHEWLETT-PACKARD8449B3008A00480 HORN ANTENNAEMCO31153723 BICONICAL ANTENNAEMCO31109307-1431 LOOP ANTENNAAH SYSTEMSSAS200/562142 LOG PERIODIC ANTENNA EMCO31469110-3600 BILOGCHASECBL6112A2238 LISNSOLAR ELE.8028N/A THERMOMETERFLUKE525215250 MULTIMETERFLUKE8553710469 FUNCTION GENERATOR TEKTRONIXCFG250CFG250TW15059 PLOTTERHEWLETT-PACKARD7475A2325A65394 FCC ID: KE3TXPG1010 Field Strength of Fundamental Emission (47 CFR 15.209) Measurements were made using a peak detector. Field strength of the peak fundamental emission is shown in Tables 3 and 4. Duty Cycle Correction During 100 msec: The EUT has only one type of transmit cycle which consists of 20.5 ms of transmit time every 35.6 ms (57.6% Duty Cycle). Figure 3 shows the characteristics of the pulse train for this cycle. Duty Cycle Correction = 20 log (0.576) = - 4.8 dB FCC ID: KE3TXPG1010 FIGURE 3 FCC ID: KE3TXPG1010 TABLE 3a FIELD STRENGTH OF FUNDAMENTAL EMISSION Test Date:October 19, 2000 UST Proj…

Text truncated - open the document above for the full version.

FCC ID: KE3TXPG1010 FIGURE 2b Photograph(s) for Spurious and Fundamental Emissions (Photograph Shows 1 st portion of testing at 3 meters) FCC ID: KE3TXPG1010 FIGURE 2c Photograph(s) for Spurious and Fundamental Emissions (Photograph Shows 1 st portion of testing at 3 meters) FCC ID: KE3TXPG1010 FIGURE 2d Photograph(s) for Spurious and Fundamental Emissions (Photograph Shows 1 st portion of testing at 3 meters) FCC ID: KE3TXPG1010 FIGURE 2e Photograph(s) for Digital Device Emissions FCC ID: KE3TXPG1010 FIGURE 2f Photograph(s) for Digital Device Emissions FCC ID: KE3TXPG1010 FIGURE 2g Photograph(s) for Conducted Emissions