L5C0781TX-HWeather Station

DIGITAL THERMO SENSOR OWNER'S MANUAL Thank you for purchasing the new generation electronic thermo sensor. Designed and engineered with the state-of-art technology and components, this instrument will provide accurate and reliable measurement of outdoor temperature and humidity, and a 433MHz RF communication with your weather station. Read this manual carefully to full explore the features and functions of the new product. Name and Functions of Switch and Buttons: CH Select Channel 1,2,3 TX Force transmission of RF signal MODE Change display between temperature, humidity or auto scroll C/F Select the reading between C and F BATTERY INSTALLATION Lift off the bracket stand, loose the 4 screws with a small screwdriver, insert 2 pcs AAA batteries according to the polarity indicated. Replace the cover and tighten the 4 screws. SETTING UP THE WIRELESS THERMOMETER: • For the first installation, always insert batteries to the home unit and then the remote sensor. • Set Channel 1 for the first remote sensor. Set channel 2 and channel 3 for the additional 2nd and 3rd sensors. • Press the Tx button on the back of remote sensor to verify the RF reception. C/ F SELECTION Press “C/F“ to select degree C/ degree F on the LCD display. LOW BATTERY INDICATION Low battery indication is available for the remote sensors. Replace the batteries and follow the setup procedure as mentioned in this instruction manual. BATERY DISPOSAL Replace only with the same or equivalent type recommended by the manufacturer. Please disposal of old, defective batteries in an environmentally friendly manner in accordance with the relevant legislation. FCC DISCLAIMER FCC ID: L5C0781TX-H This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. SPECIFICATIONS Range of temperature measurement: Remote sensor : -20 C to +60 C (-4 F to +140 F) Channel : 3 Transmission : up to 30M (100 ft.) open area, RF434 MHz Resolution : 0.1 degree for temperature, 1% for humidity Batteries : AAA x 2 pcs Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase he separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Modifications not authorized by the manufacturer may void users authority to operate this device.

+ 7[E ORFNG LDJUDP 0&8 +XPLGLW\6HQVRU7KHUPLVWRU)XQFWLRQ.H\V /&'GLVSOD\5)WUDQVPLVVLRQFLUFXLW

PHOTOGRAPH OF THE PRODUCT FRONT VIEW OF THE PRODUCT REAR VIEW OF THE PRODUCT

FCC ID: L5C0781TX-H MADE IN CHINA This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operations. FCC ID: L5C0781TX-H MADE IN CHINA 0781-H

PHOTOGRAPH OF THE PRODUCT INNER CIRCUIT TOP VIEW INNER CIRCUIT BOTTOM VIEW

FCC ID: L5C0781TX-H Circuit Description The 433MHz crystal oscillator drives the base of Q2 the final/buffer amplifier. The modulation provided by U1. The output of Q2 has the matching network consisting of L6 and C10 that limit the harmonic content and effect the proper coupling of the antenna to the output stage. Antenna, Ground and Power Source There is no external antenna. There is no external ground connection. The ground is only that of the printed circuit board. Electric current is supplied by a 3Volt (“AAA” size battery x 2) primary battery

香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 1 of 22 No. : HM151561 This report shall not be reproduced unless with prior written approval from the Hong Kong Standards and Testing Centre. 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of STC: www.hkstc.org (the section “Application and Quotation”). Applicant: Ansen Electronics Company Room 73-78, 2/F, Sino, Industrial Plaza, 9 KAI Cheung Road, Kowloon Bay, Kowloon, Hong Kong Description of Samples: Model name: 433.92MHz Weather Station Transmitter Model no.: 0781-H Brand name: Ansen FCC ID: L5C0781TX-H Date Samples Received: 2004-06-18 Date Tested: 2004-07-28 Investigation Requested: FCC Part 15 Subpart C Conclusions: The submitted product COMPLIED with the requirements of Federal Communications Commission [FCC] Rules and Regulations Part 15. The tests were performed in accordance with the standards described above and on Section 2.2 in this Test Report. Remarks: ---- K C Lee, EMC for Chief Executive 香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 2 of 22 No. : HM151561 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of STC: www.hkstc.org (the section “Application and Quotation”). CONTENT: Cover Page 1 of 22 Content Page 2-3 of 22 1.0 General Details 1.1 Test Laboratory Page 5 of 22 1.2 Applicant Details Page 5 of 22 Applicant HKSTC Code Number for Applicant Manufacturer 1.3 Equipment Under Test [EUT] Page 6 of 22 Description of EUT operation 1.4 Date of Order Page 6 of 22 1.5 Submitted Sample Page 6 of 22 1.6 Test Duration Page 6 of 22 1.7 Country of Origin Page 6 of 22 1.8 Additional Information of EUT Page 7 of 22 2.0 Technical Details 2.1 Investigations Requested Page 8 of 22 2.2 Test Standards and Results Summary Page 8 of 22 3.0 Test Results 3.1 Emission Page 9-12 of 22 3.2 Bandwidth Measurement Page 13-14 of 22 香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 3 of 22 No. : HM151561 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of STC: www.hkstc.org (the section “Application and Quotation”). Appendix A List of Measurement Equipment Page 15 of 22 Appendix B Duty Cycle Correction During 100 msec Page 16-17 of 22 Appendix C Periodic Operation Page 18-20 of 22 Appendix D Photographs Page 21-22 of 22 香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 4 of 22 No. : HM151561 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of STC: www.hkstc.org (the section “Application and Quotation”). 1.0 General Details 1.1 Test Laboratory The Hong Kong Standards and Testing Centre Ltd. EMC Laboratory 10 Dai Wang Street, Taipo Industrial Estate New Territories, Hong Kong Telephone: 852 2666 1888 Fax: 852 2664 4353 1.2 Applicant Details Applicant Ansen Electronics Company Room 73-78, 2/F, Sino, Industrial Plaza, 9 KAI Cheung Road, Kowloon Bay, Kowloon, Hong Kong HKSTC Code Number for Applicant ANE001 Manufacturer Ansen Electronics Company Chen Tung Industrial Zone, Ning Tau Administrative District, Qiao Tau Zhen, Dongguan, Guangdong, China. 香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 5 of 22 No. : HM151561 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of STC: www.hkstc.org (the section “Application and Quotation”). 1.3 Equipment Under Test [EUT] Description of Sample Product: 433.92MHz Weather Station Transmitter Manufacturer: Ansen Electronics Company Brand Name: Ansen Model Number: 0781-H Input Voltage: 3Vd.c (“AAA” size battery x 2) 1.3.1 Description of EUT Operation The Equipment Under Test (EUT) is an Ansen Electronics Company., 433.92MHz Weather Station Transmitter. The transmitter is an automatic transmitter. The EUT is to transmit RF signal while temperature measurement is changed. The EUT is for data transmission, Modulation by Data Code. Tape is pulses modulation. 1.4 Date of Order 2004-06-18 1.5 Submitted Sample(s): 3 Samples per model 1.6 Test Duration 2004-07-28 1.7 Country of Origin China 香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 6 of 22 No. : HM151561 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) 2664 4353 Homepage: www.hkstc.org E-mail: [email protected] For full text of “Conditions of Issuance of Test Report”, please refer to overleaf or refer to the website of STC: www.hkstc.org (the section “Application and Quotation”). 1.8 Additional Information of EUT Submitted Not Available User Manual Part List Circuit Diagram Printed Circuit Board [PCB] Layout Block diagram FCC ID Label 香 港 標 準 及 檢 定 中 心 Hong Kong Standards and Testing Centre Date : 2004-08-01 TEST REPORT Page 7 of 22 No. : HM151561 香港新界大埔工業村大宏街10號 10 Dai Wang Street, Taipo Industrial Estate, N.T., Hong Kong Tel: (852) 2666 1888 Fax: (852) …

Text truncated - open the document above for the full version.

TEST SET UP PHOTOGRAPH OF THE PRODUCT MEASUREMENT OF RADIATED EMISSION TEST SET UP