LSQ-TRXS-860Wrist Tag

Wrist Tag TRXS-860 USER MANUAL October 2011 ElmoTech Ltd. TRXS-860 - User Manual 1 Table of Contents 1. Foreword ....................................................................................2 2. Installing the Wrist Tag. .............................................................3 3. General Rules for the Client ......................................................6 4. Maintenance Instructions ...........................................................7 4.1. Cleaning the Wrist Tag ..............................................................7 4.2. Wrist Tag Straps Replacement ...................................................8 5. FCC Notices .............................................................................10 ElmoTech Ltd. TRXS-860 - User Manual 2 1. Foreword The Wrist Tag (TXRS-860) is a transmitter, used in home arrest systems. The Wrist Tag (TXRS-860 / TRXS-860-2) is transmitting on an American FCC tested and approved frequency; whereas the European version (TXRS-860-2) is transmitting on a European tested and approved frequency. From a user interface and function point of view the two models are identical; therefore this user manual serves both versions. ElmoTech Ltd. TRXS-860 - User Manual 3 2. Installing the Wrist Tag. Hold the transmitter in your hand with the metal pins (along the strap) pointing forward. Hold the Electronic Key in your other hand, with the black button pointing toward the open or free end of the strap. Press the Electronic Key over the metal pins with the two touch points on the Electronic Key matching the metal pins on the Transmitter strap. Hold the Electronic key in this position while you do the next step. Hold the Electronic key in this position while you do the next step. Press the red button on the Electronic Key down for one second; the red light turns steadily on for two (2) seconds. If the transmitter successfully receives the reset command, the red light, on the Electronic Key, will flash for two (2) seconds. Note that if the Tag has failed to receive the startup command the red light will turn off after the initial two (2) seconds ON. If the Electronic Key battery is low the red light will immediately flash for two (2) seconds, once the red button is pressed. (No command is sent to the transmitter). ElmoTech Ltd. TRXS-860 - User Manual 4 Place the Tag on its side, on a non-metal surface, for 30 seconds. Attaching the Transmitter Place a strap holder over the short strap (strap with pin side) of the Transmitter. Attach the female Clip to the underside of the Transmitter’s short strap (to lie against the Offenders skin). Check that the closed end of the clip fits with the edge of the strap. Wrap the Transmitter around the Offender’s wrist/ankle at its narrowest point ensuring that, with the ankle Transmitter the protruding side of the Transmitter body is directed upwards. Lay the long strap over the female clip ensuring that all pins on the short strap are protruding through the long strap. Slide the strap holder over the end of the long strap in order to hold it in place. It is important to note that the Transmitter must fit tightly around the Offender’s wrist/ankle, but not squeezing. ElmoTech Ltd. TRXS-860 - User Manual 5 Cover the female clip with the male clip ensuring that the pins on the male clip fit correctly into the female clip (the grooves on the side of each clip must match). Ask the Offender to stand up and move around to insure that the Tag is comfortable. Fasten the two Clips with the locking tool. Be sure to fasten all the four pins well. An audible clicking sound should be heard, indicating that the Clips are closed properly. Don’t install the Tag over a thick sock, since the Tag will get too loose once the sock is removed. If the Tag is installed without a sock, instruct the offender that he should not put on a very thick sock, and then try to pull it under the Tag. The Offender may wear a thin sock underneath and a thick sock over the Tag. ElmoTech Ltd. TRXS-860 - User Manual 6 3. General Rules for the Client The Transmitter is a waterproof wristwatch and there is no need to remove it when taking a bath or a shower. You can even wear it when swimming and diving in a swimming pool or taking a sauna bath. Turn the Transmitter’s transmission off when admitting to a hospital, either for a visit or for hospitalization, since the transmitted signal may affect other medical instrumentation. Turn the Transmitter’s transmission off when boarding a flight, since the transmitted signal may affect the aircraft’s avionics thus impairing flight safety. Turning the Transmitter’s transmission off should be done by an authorized personnel, as follows: • Press the electronic key’s BLACK button down for one second, the red light turns steadily ON for two (2) seconds. • If the shut down command has been successfully received, the red light on the Electronic Key will flash for two (2) seconds. Note that if the transmitter has failed to receive the shut down command the red light will turn off after the initial two (2) seconds ON. If the Electronic Key battery is low the red light will immediately flash for two (2) seconds, once the black button is pressed. (No command is sent to the transmitter). ElmoTech Ltd. TRXS-860 - User Manual 7 4. Maintenance Instructions 4.1. Cleaning the Wrist Tag A soft brush and any cleaning solution are all that is needed to clean the Wrist Tag TXRS-860. Alcohol based solutions; Soapy water or Lysol can be used to clean the Tag. For additional safety and user comfort it is Recommended that after cleaning with any of the above the Tag be washed with clear water before it is reused. Holding it at the end of the long strap, spray the Tag with cleaning solution of choice (see above). Alternatively you can simply drop the Tag in the cleaning solution. Using a piece of cloth or a paper towel, dry the outer side of the Tag. Lay the Tag on the towel with its inner side facing up. Using a soft brush or another …

Text truncated - open the document above for the full version.

CPU STM32L152RBT6TR RF Transceiver CC1101 S P I 2 Body sensor Light sensor Volatge regulator Digital Accelerometer Strap Power BAT A/D ADC MRD Debug & Programming Configuration resistors ADC EEPROM 8KByte SPI 1 CSn1 SPI 1 HW Block DIagram CSn2 INT Tilt Sensor 26MHz Crystal Loop Antenna 32.768KHz Crystal

FCC Confidentiality Form 31.10.11 Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Gentlemen, This letter is to comply with Section 0.457(d)(2)(i) and 0.459 pertaining to confidential material. Elmo Tech would like the following documents regarding this submission for FCC ID: LSQ-TRXS-860 to be kept confidential. • Permanent Confidentiality: Schematics • Short-term Confidentiality (180 days): Installation Manual The above material contains trade secrets or technical data, which would customarily be guarded from competitors. We do not want this document to be accessible to the general public. Sincerely, Shai Avigdori Quality Assurance Manager

TRXS-860 external photograph

Laser print location. (lable)

TRXS-860 internal photograph

TRXS-860 Bracelet Transceiver Operational Description The TRXS-860 is a small ankle worn device designed for offender monitoring applications. The device comprises a printed circuit board (PCB) that includes RF transceiver module with an integral antenna and microcontroller that controls its operation. The TRXS-860 has one 318MHz RF channel over which it communicates with its allocated home unit and/or GPS tracking device The unit is powered by an internal 3.6V Lithium Thionyl Chloride battery. The TRXS-860 is attached to the ankle of the offender by means of a metal conductive strap. When attached to the offender, the 2 stripes are connected to one another through a conductive rubber. When activated, the TRXS-860 transmits signals separated by a pseudorandom interval of between 20 to 22 seconds. All signals transmitted are encrypted with a special key that is created between the TRXS-860 and its home unit. After each transmission, the TRXS-860 listens for an acknowledge signal in order to ascertain whether its home unit/tracking device is within range. If a defined timeout has expired without receiving an acknowledge signal, the TRXS-860 sends encrypted signal with general key, known by all home units. As per section 15.231(a)(3), being a security and safety of life equipment this device transmits supervision transmissions, including data (e.g. battery ok, strap not cut, etc), to determine the device integrity. The total duration of transmissions does not exceed more than two seconds per hour: 60 minutes X 3 transmissions per minute X 6 mSec (max.) = 1.08 seconds.

Test Report E109460.01 ElmoTech Ltd Page 1 of 38 FCC ACC M Ver 1.1 05Mayl 2000 DATE: 13 November 2011 I.T.L. (PRODUCT TESTING) LTD. FCC Radio Test Report for ElmoTech Ltd Equipment under test: Ankle Tag TRXS-860 Written by: _____________________________ D. Shidlowsky, Documentation Approved by: _____________________________ A. Sharabi, Test Engineer Approved by: _____________________________ I. Raz, EMC Laboratory Manager This report must not be reproduced, except in full, without the written permission of I.T.L. (Product Testing) Ltd. This report relates only to items tested. Test Report E109460.00 ElmoTech Ltd Page 2 of 38 FCC ACC M Ver 1.1 05Mayl 2000 Measurement/Technical Report for ElmoTech Ltd Ankle Tag TRXS-860 FCC ID: LSQ-TRXS-860 This report concerns: Original Grant: x Class I change: Class II change: Equipment type: Part 15 Security/Remote Control Transceiver 47CFR15 Section 15231 (a-d) Measurement procedure used is ANSI C63.4-2003. Application for Certification: prepared by: Shai Avigdori Elmo Tech Ltd. 2 Habarzel St. Tel-Aviv, 61131 Israel Tel: +972-3- 767-1700 Fax: +972-3- 767-1701 e-mail: [email protected] Test Report E109460.00 ElmoTech Ltd Page 3 of 38 FCC ACC M Ver 1.1 05Mayl 2000 TABLE OF CONTENTS 1. GENERAL INFORMATION ------------------------------------------------------------------------------- 4 1.1 Administrative Information ................................................................................. 4 1.2 List of Accreditations ......................................................................................... 5 1.3 Product Description ........................................................................................... 6 1.4 Test Methodology .............................................................................................. 6 1.5 Test Facility ....................................................................................................... 6 1.6 Measurement Uncertainty ................................................................................. 6 2. SYSTEM TEST CONFIGURATION --------------------------------------------------------------------- 7 2.1 Justification ........................................................................................................ 7 2.2 Special Accessories .......................................................................................... 7 2.3 Equipment Modifications ................................................................................... 7 2.4 Configuration of Tested System ........................................................................ 7 3. RADIATED MEASUREMENT TEST SET-UP PHOTOS------------------------------------------- 8 4. AVERAGE FACTOR CALCULATION ----------------------------------------------------------------- 10 4.1 Test Instrumentation Used .............................................................................. 12 5. PERIODIC OPERATION ---------------------------------------------------------------------------------- 13 5.1 Specification .................................................................................................... 13 5.2 Requirements .................................................................................................. 13 5.3 Results ............................................................................................................. 13 6. FIELD STRENGTH OF FUNDAMENTAL ------------------------------------------------------------ 18 6.1 Test Specification ............................................................................................ 18 6.2 Test Procedure ................................................................................................ 18 6.3 Measured Data ................................................................................................ 18 6.4 Test Instrumentation Used, Field Strength of Fundamental ............................ 22 7. RADIATED EMISSION, 9 KHZ – 30 MHZ ------------------------------------------------------------ 23 7.1 Test Specification ............................................................................................ 23 7.2 Test Procedure ................................................................................................ 23 7.3 Measured Data ................................................................................................ 23 7.4 Test Instrumentation Used, Radiated Measurements ..................................... 24 7.5 Field Strength Calculation ............................................................................... 24 8. SPURIOUS RADIATED EMISSION-------------------------------------------------------------------- 25 8.1 Test Specification ............................................................................................ 25 8.2 Test Procedure ................................................................................................ 25 8.3 Test Data ......................................................................................................... 26 8.4 Test Instrumentation Used, Radiated Measurements ..................................... 28 9. BANDWIDTH ------------------------------------------------------------------------------------------------ 29 9.1 Test procedure ................................................................................................ 29 9.2 Results table .................................................................................................... 30 9.3 Test Equipment Used. ..................................................................................... 31 10. APPENDIX A - CORRECTION FACTORS ----------------------------------------------------------- 32 10.1 Correction factors for CABLE ......................................................................... 32 10.2 Correction factors for CABLE ......................................................................... 33 10.3 Correction factors for CABLE ...................…

Text truncated - open the document above for the full version.

TRXS-860 Test Setup Photographs