N6C-SXSDCAGWireless 802.11a/b/g SD Card Radio

SX-SDCAG 802.11a/b/g SDIO Module User Manual 140-00197-100 Rev A 140-00197-100 Revision A © 2010 Silex Technology America, Inc. All rights reserved. February 2010 Silex Technology America SPECIFICALLY DISCLAIMS THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS OF THIS PRODUCT FOR A PARTICULAR PURPOSE. Silex shall not be liable for any errors contained in this manual or for any damages resulting from loss of use, data, profits, or any incidental or consequential damages arising from the use of SILEX products or services. The information contained in this documentation is subject to change without notice. Information and descriptions contained herein are the property of Silex. Such information and descriptions may not be copied, disseminated, or distributed without the express written consent of Silex. This publication is subject to change without notice. Trademarks ExtendView is a trademark of Silex Technology America, Inc. All other company or product names referenced in this document may be trademarks or registered trademarks of their respective owners. Silex Technology America, Inc. www.silexamerica.com Contents Silex Page 1 140-00197-100 Revision A Contents About This User Manual ............................................................................................................................................ 2 Safety Precautions ................................................................................................................................................. 2 Emissions Disclaimer ............................................................................................................................................. 2 Chapter 1: Introduction .............................................................................................................................................. 3 Chapter 2 Hardware Specifications/Compliance ....................................................................................................... 4 FCC Information..................................................................................................................................................... 4 Information for Canadian Users (IC Notice)........................................................................................................... 5 Specifications ......................................................................................................................................................... 7 Chapter 3 Installation................................................................................................................................................. 8 Installation Requirements ...................................................................................................................................... 8 Installation Procedure ............................................................................................................................................ 8 Appendix A Antenna Information............................................................................................................................. 10 Antenna Specifications ........................................................................................................................................ 10 Appendix B Silex Contact Information ..................................................................................................................... 12 Page 2 Silex About This User Guide 140-00197-100 Revision A About This User Manual This user manual provides detailed specifications, diagrams and additional information required to install the SX- SDCAG 802.11a/b/g SDIO module into a product. The intended audiences are the developers and engineers responsible for the integration of the module in another product. Safety Precautions ƒ To prevent damage to the SX-SDCAG module’s electronic circuit components, follow established ESD practices and procedures for handling static-sensitive devices. All ESD-sensitive components must be stored and shipped in ESD-conductive bags or bubble-wrap and labeled as such using the standardized ESD adhesive warning label. ƒ Ethernet electrical wiring must be at least 6 feet from bare power wiring or lightning rods and associated wires, and at least 6 inches from other types of wire (antenna wires, doorbell wires, wires from transformers to neon signs), steam or hot water pipes, and heating devices. ƒ Protectors and grounding wire placed by the service provider must not be connected to, removed, or modified by the customer. Emissions Disclaimer Final emission certification per FCC, IC, CE and other agency requirements are the responsibility of the OEM (refer to chapter 2 for additional information). Introduction Silex Page 3 140-00197-100 Revision A Chapter 1: Introduction The SX-SDCAG is an 802.11a/b/g radio/baseband module in a standard SDIO form factor. Designed for wireless local area network (WLAN) applications that require low power consumption, the SX-SDCAG is ideal for battery-operated portable devices in the medical, weights and measures, transportation and other industries. SX-SDCAG features include: • Highly Integrated System for 802.11a/b/g WLAN • U.FL antenna connectors with diversity support • Wide operating temperature range • Integrated Atheros AR6002XZ Single Chip • Integrated high performance Dual-Band Front End Module (FEM), Band Pass Filter, 26MHz Crystal • 16Kbit EEPROM • Advanced power management to minimize standby and active power • WEP 64/128, WPA (TKIP), WPA2 (802.11i) security • Linux, Windows CE, and Windows Mobile drivers available from Silex (porting will be required in most cases) Figure 1 SX-SDCAG Dimensions (mm) 24.0 1.5 46.0 4.1 27.1 Introduction Silex Page 4 140-00197-100 Revision A Chapter 2 Hardware Specifications/Compliance FCC Information FCC ID: N6C-SXSDCAG NOTICE In accordance with FCC Part 15, the SX-SDCAG is listed as a Modular Transmitter device. End products th…

Text truncated - open the document above for the full version.

F I L E N o . 1 F E D 23 DWG No. C B A 1234 DESIGNED CHANGE OF CONTENTSREVISDATEDESIGN DATE MATERIAL APPROVEDCHECKED DWG No. TITLE MODEL FINISHSCALE F E D C B A Umegaki SX-SDCAG EMI Label HP11561XB HP11561XB 12 Printing Color : Black PET Film 50m White HP11561B .ai Feb. 05, 2010

FC Calculat Silex T e 15661 R Tustin C Model N Fundam Maximu Measure Maximu Power O CKC La Device a Transmi Test Pr o This equ CC 1.131 RSS133 tions prepared echnology Am Red Hill Ave. CA 92780 Number: mental Operati um Rated Out ed Output Pow um Antenna G Output and Op aboratories, T and Antenna itting continu ocedure: uipment is ev 10(b), Ma 3 Sub Cl d for: merica, Inc. Suite 120 SX-SDCA G ing Frequency tput Power: wer: Gain: perating Freq Test Report: 9 Operating C uously. Power aluated in acc aximum P ause 8 Ex Date of Re Repor t G y: quency Inform 0303-10 Configuration r measured co cordance with Page 1 of 2 Permissi xposure port: Februa r t No.: 90303‐ Calculati o Eddie Wo 110 N. Ol Brea, CA 5.15 - 5.25 0.0214 W 0.0214 W 4.2 dBi ( mation used fo n: onducted at th h the guidelin ible Expo of Huma ry 9, 2010 ‐10‐R ons prepared b ong linda Place 92823 5GHz, 5.725 - 5 W W 2.6 linear g a or these calcu he antenna por nes set forth in osure Cal ans to RF by: 5.825GHz ain) lations were f rt Max antenn n OET Guide lculation F Field from: na gain is 4.2 65. ns dBi. Page 2 of 2 MPE Limit in accordance with 1.1310(b): Limits for general population/uncontrolled exposure MPE Limit for 5150 – 5250MHz, 5725 – 5825MHz = 1 mW/cm 2 (10 W/m 2 ) (B) Limits for General Population/Uncontrolled Exposure Frequency density (mW/cm2) Averaging time (minute) 1500-100,000 1.0 30 Power Output (Watts) Power Density Limit (mW/cm 2 ) Minimum Distance (Meters) 0.0214 1 0.021 P t = Power Delivered to the Antenna G = Antenna Gain d = Distance in meters Zo = Impedance of Free Space Statement of Compliance: This device demonstrates compliance under the operating conditions specified in this document. Under normal operating conditions, the antenna is designed to be installed in accordance with the manufacturer’s instructions in such a manor to maintain the minimum separation distance. The MPE calculations shown above demonstrate compliance to the provisions of 1.1310 in accordance with the guidelines of OET 65. Under normal operation, the antennas to be used with the EUT a maintain a distance of 20 cm (0.2 meter) from the user. As can be seen from the MPE result, this device passes the limit specified in 1.1310 at a distance of 0.021 meter. Calculation: = 0.021m 377 x 10 6.2 0214.0 30xx d= 0 2 t 2 x Zd G x P x 30 )(W/m Density Power=

This report c o written conse TE S CERT #803 803.05 ontains a total of ent of CKC Laborat S W FCC STING 3.01, 803.02, 5, 803.06 189 pages and m tories, Inc. Silex Te ADD Wireless 80 Te C PART 15 S This test rep testing perfo of ISO/IEC 1 CKC Laborato We strive t o sound, adapt our custome processes, bu ay be reproduced echnol DENDUM TES 02.11a/b/ ested To The UBPART E S Report Date of iss port bears th ormed herein 17025 under ories, Inc. o create long‐t tive, customer ers’ unique EM ut rather as th d in full only. Parti logy Am ST REPORT T /g SD Card e Following S SECTION 15.4 No.: 90303‐1 sue: March 19, e accreditatio meets the tes the applicab term, trust ba r first testing MC challenges, e reason we a ial reproduction m merica TO 90303‐10 Radio, SX‐ Standards: 407 & RSS‐2 10A , 2010 on symbol ind st and reporti ble scope of sed relations h services. We , not as an int are in business may only be done , Inc. 0 ‐SDCAG 210 ISSUE 7 dicating that ing requireme EMC testing hips by provid embrace each terruption to . with the the ents for ding h of set Page 2 of 189 Report No.: 90303‐10A TABLE OF CONTENTS Administrative Information .......................................................................................................................... 3 Test Report Information ............................................................................................................................................ 3 Revision History ......................................................................................................................................................... 3 Report Authorization ................................................................................................................................................. 3 Test Facility Information ............................................................................................................................................ 4 Site Registration & Accreditation Information .......................................................................................................... 4 Summary of Results ................................................................................................................................................... 5 Conditions During Testing ......................................................................................................................................... 5 Equipment Under Test ............................................................................................................................................... 6 Peripheral Devices ..................................................................................................................................................... 6 FCC Part 15 Subpart E Section 15.407 .......................................................................................................... 7 Temperature And Humidity During Testing............................................................................................................... 7 15.31(e) Voltage Variation ......................................................................................................................................... 7 15.31(m) Number Of Channels .................................................................................................................................. 7 15.33(a) Frequency Ranges Tested ............................................................................................................................ 7 15.203 Antenna Requirements .................................................................................................................................. 7 EUT Operating Frequency .......................................................................................................................................... 7 15.407(a)(1) RF Output Power 5.15‐5.25GHz ............................................................................................................ 8 15.407(a)(3) RF Output Power 5.725‐5.825GHz ...................................................................................................... 11 15.407(a)(5) Peak Power Spectral Density .............................................................................................................. 14 15.407(a)(6) Peak Excursion .................................................................................................................................... 22 15.407(b)(1) Undesirable Emissions in 5.15‐5.25GHz ............................................................................................. 26 15.407(b)(4) Undesirable Emissions in 5.725‐5.825GHz ......................................................................................... 65 15.407(b)(6)/15.207 Undesireable Conducted Emissions ..................................................................................... 104 15.407(b)(6)/15.209 Undesirable Radiated Emissions .......................................................................................... 111 15.407(b)(7)/15.205 Undesirable Emissions Limits ............................................................................................... 121 15.407(g) Frequency Stability ................................................................................................................................ 159 Band Edge .............................................................................................................................................................. 162 26dB Bandwidth .................................................................................................................................................... 178 RSS‐210 99% Bandwidth ........................................................................................................................................ 183 Supplemental Information ...............................................................…

Text truncated - open the document above for the full version.