NWA-MP180LRFID Reader

RFID Reader MP180L 1 Contents Block Diagram.................................................................................................................................. 2 System Update Guide ......................................... .............................................................................. 3 Test Method ...................................................................................................................................... 5 Warning............................................................................................................................................. 6 2 1. Block Diagram Processor • TI AM3325 CPU Clock Speed 1Ghz Memory • 256MB SDRAM Display • COG/FSTN LCD with white backlight • 128 × 64 pixel resolution Interface • 18 hard keys • LED indicators x 3 Card Reader • Capacity of card: 40,960 • Supports reader types: – EM, 125kHz – HID, 125kHz – Mifare, 13.56MHz Operating System • Linux 3.2 Data IO • Ethernet 10/100M • RS485 • Door Open • Security Trigger • Door Position Input • Anti-Thief Input • Relay x 2 I/O Expansion • Drive RS232 x 1 (secondary reader) • Audio Input/Output • Digital inputs x 3 • Digital outputs x 3 • USB Host 1.1 X 1 • USB Device 1.1 X1 3 • Micro SD Card Slot X1 2. System Update Guide 1. Install USB driver on Windows XP (FriendlyARM USB Download Driver Setup_20090421.exe). 2. Connect MP180L USB device port to USB host port on PC using an USB cable. 3. Connect MP180L J15 to Windows XP RS-232 port with console cable, and enable the hyper terminal or putty (115200,N,8,1) USB device USB Host USB Cable Console Cable 4 4. Remove J6 Jumper and turn on MP180L, it will then enter SOM BIOS setup menu. 5. Run download tool DNW.exe. 6. Select [ r ] Restore NAND Flash from HOST through USB in terminal or putty. 7. Access download tool DNW and select the latest system backup in USB Port -> 5 Transmit/Restore, plug-in J6 after transmit and restart to complete the system upgrade. 3. Test Method 1. There is no single-chip IC on MP180L main board, therefore testing must be done through SOM by writing the testing program on SOM. 2. Manufacture jigs to connect all SOM PIN to MP180L in order, and create connectors like the schematic shown below for plugging. 3. Connect Microphone, speaker, buzzer, micro SD Card, USB disk, Ethernet RJ-45. 4. SOM will run the testing program automatically after turn-on, main board can then be inspect through console and LED. 6 4. Warning Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: . Reorient or relocate the receiving antenna. . Increase the separation between the equipment and receiver. . Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. . Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must acceptany interference received, including interference that may cause undesired operation.

Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 2 of 27 External Photos Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 3 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 4 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 5 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 6 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 7 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 8 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 9 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 10 of 27

Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 11 of 27 Internal Photos Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 12 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 13 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 14 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 15 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 16 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 17 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 18 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 19 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 20 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 21 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 22 of 27 Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 23 of 27

of Applicant: Microprogram Information Co., Ltd. Address: 11F.-8, No.262, Sec. 2, Henan Rd., Xitun Dist., Taichung City 407, Taiwan (R.O.C.) Tested and Prepared by Worldwide Testing Services (Taiwan) Co., Ltd. FCC Registration No.: 930600 Industry Canada filed test laboratory Reg. No. IC 5679A-1, IC 5107A-1 A2LA Accredited No.: 2732.01 Report No.: W6M21504-14993-C-1 6F, NO. 58, LANE 188, RUEY-KUANG RD., NEIHU TAIPEI 114, TAIWAN, R.O.C. TEL: 886-2-66068877 FAX: 886-2-66068879 E-mail: [email protected] FCC PART 15 SUBPART C TEST REPORT for RFID Reader Model No.: MP180L FCC ID: NWA-MP180L Registration number: W6M21504-14993-C-1 FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Page 1 of 18 TABLE OF CONTENTS 1 GENERAL INFORMATION ..........................................................................................................2 1.1 NOTES..........................................................................................................................................2 1.2 TESTING LABORATORY................................................................................................................3 1.2.1 Location ..................................................................................................................................3 1.2.2 Details of accreditation status ................................................................................................3 1.3 D ETAILS OF APPROVAL HOLDER...................................................................................................4 1.4 APPLICATION DETAILS.................................................................................................................4 1.5 G ENERAL INFORMATION OF TEST ITEM........................................................................................4 1.6 T EST STANDARDS.........................................................................................................................4 2 TECHNICAL TEST .........................................................................................................................5 2.1 SUMMARY OF TEST RESULTS........................................................................................................5 2.2 TEST ENVIRONMENT....................................................................................................................5 2.3 TEST EQUIPMENT LIST.................................................................................................................6 2.4 G ENERAL TEST PROCEDURE........................................................................................................8 3 TEST RESULTS (ENCLOSURE) ................................................................................................10 3.1 OUTPUT POWER (FIELD STRENGTH) ..........................................................................................11 3.2 OUT OF BAND RADIATED EMISSIONS.........................................................................................12 3.3 OCCUPIED BANDWIDTH.............................................................................................................14 3.4 F REQUENCY TOLERANCE...........................................................................................................15 3.5 POWER LINE CONDUCTED EMISSION.........................................................................................16 A PPENDIX..............................................................................................................................................18 Registration number: W6M21504-14993-C-1 FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Page 2 of 18 1 General Information 1.1 Notes The purpose of conformity testing is to increase the probability of adherence to the essential requirements or conformity specifications, as appropriate. The complexity of the technical specifications, however, means that full and thorough testing is impractical for both technical and economic reasons. Furthermore, there is no guarantee that a test sample which has passed all the relevant tests conforms to a specification. Neither is there any guarantee that such a test sample will interwork with other genuinely open systems. The existence of the tests nevertheless provides the confidence that the test sample possesses the qualities as maintained and that is performance generally conforms to representative cases of communications equipment. The test results of this test report relate exclusively to the item tested as specified in 1.5. The test report may only be reproduced or published in full. Reproduction or publication of extracts from the report requires the prior written approval of the Worldwide Testing Services(Taiwan) Co., Ltd. Tester: May 27, 2015 Spencer Yang Date WTS-Lab. Name Signature Technical responsibility for area of testing: May 27, 2015 Kevin Wang Date WTS Name Signature Registration number: W6M21504-14993-C-1 FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Page 3 of 18 1.2 Testing laboratory 1.2.1 Location OATS No.5-1, Lishui, Shuang Sing Village, Wanli Dist., New Taipei City 207, Taiwan (R.O.C.) 3 meter semi-anechoic chamber No.35, Aly. 21, Ln. 228, Ankang Rd., Neihu Dist., Taipei City 114, Taiwan (R.O.C.) TEL:886-2-6613-0228 FAX:886-2-2791-5046 Company Worldwide Testing Services(Taiwan) Co., Ltd. 6F, NO. 58, LANE 188, RUEY-KUANG RD. NEIHU, TAIPEI 114, TAIWAN R.O.C. Tel : 886-2-66068877 Fax : 886-2-66068879 1.2.2 Details of accreditation status Accredited testing laboratory A2LA accredited number: 2732.01 FCC filed test laboratory Reg. No. 930600 Industry Canada filed test laboratory Reg. No. IC 5679A-1, IC 5107A-1 Test location, where different from Worldwide Testing Services (Taiwan) Co., Ltd. : Name: ./. Accredited number: ./. Street: ./. Town: ./. Country: ./. Telephone: ./. Fax: ./. Registration number: W6M21504-14993-C-1 FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Page 4 of 18 1…

Text truncated - open the document above for the full version.

Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 24 of 27 Set Up Photo of Radiated Emission EMI Below 1 GHz Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 25 of 27 RF Below 30 MHz Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 26 of 27 Above 30 MHz Registration number: W6M21504-14993-FCC FCC ID: NWA-MP180L Worldwide Testing Services(Taiwan) Co., Ltd. Appendix page 27 of 27 Set Up Photo of Conducted Emission