O4GSLIMHRM1GHeart Rate Transmitter

NOTES: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is corrected. -- Consult the dealer or experienced radio / TV technician for help. Canada Statement This device complies with Industry Canada RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio RSS-210. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioé lectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. FCC ID: O4GSLIMHRM1G IC: 7666A-SLIMHRM1G MADE IN CHINA This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Neutron Engineering Inc. Project No.: 1107C213 Page 2 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 2 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 3 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 3 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 4 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 4 of 10 1107C213 1107C213

Neutron Engineering Inc. Project No.: 1107C213 Page 5 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 5 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 6 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 6 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 7 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 7 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 8 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 8 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 9 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 9 of 10 1107C213 1107C213 Neutron Engineering Inc. Project No.: 1107C213 Page 10 of 10 1107C213

Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 1 of 38 FCC/IC Radio Test Report FCC ID: O4GSLIMHRM1G IC: 7666A-SLIMHRM1G This report concerns (check one): Original Grant Class II Change Issued Date : Aug. 02, 2011 Project No. : 1107C213 Equipment : Heart Rate Transmitter Model Name : SLIMHRM Applicant : Dayton Industrial Co. Ltd. Address : 2-12 Kwai Fat Road, 11-A Kwai Chung, N.T. Hong Kong Manufacturer : Kendy Enterprise Ltd. Address : 2-12 Kwai Fat Road, 11-A Kwai Chung, N.T. Hong Kong Tested by: Neutron Engineering Inc. EMC Laboratory Date of Receipt: Jul. 28, 2011 Date of Test: Jul. 28, 2011 ~ Aug. 01, 2011 Testing Engineer : (Ivan Cao) Technical Manager : (Leo Hung) Authorized Signatory : (Steven Lu) Neutron Engineering Inc. No.3,Jinshagang 1st Road, ShiXia, Dalang Town, Dong Guan, China. TEL : (0769) 8318-3000 FAX : (0769) 8319-6000 Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 2 of 38 Declaration Neutron represents to the client that testing is done in accordance with standard procedures as applicable and that test instruments used has been calibrated with the standards traceable to National Measurement Laboratory (NML) of R.O.C., or National Institute of Standards and Technology (NIST) of U.S.A. Neutron's reports apply only to the specific samples tested under conditions. It is manufacture’s responsibility to ensure that additional production units of this model are manufactured with the identical electrical and mechanical components. Neutron shall have no liability for any declarations, inferences o r generalizations drawn by the client or others from Neutron issued reports. Neutron’s reports must not be used by the client to claim product endorsement by the authorities or any agency of the Government. This report is the confidential property of the client. As a mutual protection to the clients, the public and Neutron-self, extracts from the test report shall not be reproduced except in full with Neutron’s authorized written approval. Neutron’s laboratory quality assurance procedures are in compliance with the ISO Guide 17025 requirements, and accredited by the conformity assessment authorities listed in this test report. Limitation For the use of the authority's logo is limited unless the Test Standard(s)/Scope(s)/Item(s) mentioned in this test report is (are) included in the conformity assessment authorities acceptance respective. Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 3 of 38 Table of Contents Page 1 . CERTIFICATION 5 2 . SUMMARY OF TEST RESULTS 6 2.1 TEST FACILITY 7 2.2 MEASUREMENT UNCERTAINTY 7 3 . GENERAL INFORMATION 8 3.1 GENERAL DESCRIPTION OF EUT 8 3.2 DESCRIPTION OF TEST MODES 9 3.3 BLOCK DIGRAM SHOWING THE CONFIGURATION OF SYSTEM TESTED 10 3.4 DESCRIPTION OF SUPPORT UNITS 11 4 . EMC EMISSION TEST 12 4.1 CONDUCTED EMISSION MEASUREMENT 12 4.1.1 POWER LINE CONDUCTED EMISSION LIMITS 12 4.1.2 MEASUREMENT INSTRUMENTS LIST 12 4.1.3 TEST PROCEDURE 13 4.1.4 DEVIATION FROM TEST STANDARD 13 4.1.5 TEST SETUP 13 4.1.6 EUT OPERATING CONDITIONS 13 4.1.7 TEST RESULTS 14 4.2 RADIATED EMISSION MEASUREMENT 15 4.2.1 RADIATED EMISSION LIMITS 15 4.2.2 MEASUREMENT INSTRUMENTS LIST 16 4.2.3 TEST PROCEDURE 19 4.2.4 DEVIATION FROM TEST STANDARD 19 4.2.5 TEST SETUP 20 4.2.6 EUT OPERATING CONDITIONS 21 4.2.7 TEST RESULTS (BETWEEN 30 – 1000 MHz) 23 4.2.8 TEST RESULTS (ABOVE 1000 MHz) 25 4.2.9 TEST RESULTS (2400 – 2483.5 MHz) 29 5 . BANDWIDTH TEST 30 5.1 MEASUREMENT INSTRUMENTS LIST 30 5.2 TEST PROCEDURE 30 5.3 DEVIATION FROM STANDARD 30 5.4 TEST SETUP 30 5.5 EUT OPERATION CONDITIONS 30 5.6 TEST RESULTS 31 6 . ANTENNA CONDUCTED SPURIOUS EMISSION 32 Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 4 of 38 Table of Contents Page 6.1 APPLIED PROCEDURES / LIMIT 32 6.1.1 MEASUREMENT INSTRUMENTS LIST 32 6.1.2 TEST PROCEDURE 32 6.1.3 DEVIATION FROM STANDARD 32 6.1.4 TEST SETUP 32 6.1.5 EUT OPERATION CONDITIONS 32 6.1.6 TEST RESULTS 33 7 . EUT TEST PHOTO 36 Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 5 of 38 1. CERTIFICATION E q u i p m e n t : Heart Rate Transmitter Brand Name : N/A Model Name. : SLIMHRM A p p l i c a n t : Dayton Industrial Co. Ltd. Date of Test : Jul. 28, 2011 ~ Aug. 01, 2011 T e s t I t e m : ENGINEERING SAMPLE Standards : FCC Part15, Subpart C(15.249)/ ANSI C63.4 : 2003 The above equipment has been tested and found compliance with the requirement of the relative standards by Neutron Engineering Inc. EMC Laboratory. The test data, data evaluation, and equipment configuration contained in our test report (Ref No. NEI-FICP-1-1107C213) were obtained utilizing the test procedures, test instruments, test sites that has been accredited by the Authority of NVLAP and TAF according to the ISO-17025 quality assessment standard and technical standard(s). Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 6 of 38 2. SUMMARY OF TEST RESULTS Test procedures according to the technical standards: FCC Part15, Subpart C (15.249) Canada RSS-210:2010 StandardSection FCC RSS-210 Test Item Judgment Remark 15.207 Conducted Emission - Note(1) 15.209 Radiated Emission PASS 15.249 A2.9(a) Radiated Spurious Emission PASS NOTE: (1)” N/A” denotes test is not applicable in this Test Report Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 7 of 38 2.1 TEST FACILITY The test facilities used to collect the test data in this report is DG-C02/DG-CB03at the location of No.3,Jinshagang 1st Road, ShiXia, Dalang Town,Dong Guan, China.523792 Neutron's test firm number for FCC 319330 Neutron's test firm number for IC 4428B-1 2.2 MEASUREMENT UNCERTAINTY Where relevant, the following measurement uncertainty levels have been estimated for tests performed on the EUT as specified in CISPR 16-4-2: The reported uncertainty of measurement y ± U，where expended uncertainty U is based on a standard uncertainty multiplied by a coverage factor of k=2，providing a level of confidence of approximately 95 %。 A. Conducted Measurement : …

Text truncated - open the document above for the full version.

Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 36 of 38 7. EUT TEST PHOTO Radiated Measurement Photos 9K~30MHz Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 36 of 38 7. EUT TEST PHOTO Radiated Measurement Photos 9K~30MHz Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 37 of 38 Radiated Measurement Photos 30M~1000MHz Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 37 of 38 Radiated Measurement Photos 30M~1000MHz Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 38 of 38 Radiated Measurement Photos Above 1000MHz Neutron Engineering Inc. Report No.: NEI-FICP-1-1107C213 Page 38 of 38 Radiated Measurement Photos Above 1000MHz