OMC1220pulse monitor

Date: June 23, 2000 FEDERAL COMMUNICATIONS COMMISSION Equipment Approval Services P.O. Box 358315 Pittsburgh, PA 15251-5315 Attn: New Applications Subject: FCC ID # OMC1220 Re: Icon Health & Fitness Application for Equipment Authorization-Certification. Model: 1220 To Whom It May Concern, We are acting on behalf of Icon Health & Fitness to test and certify their 122 kHz Cardio Sport Chest Pulse, Model number 1220. We are also filing the FCC application for Icon Health & Fitness Should any questions arise regarding this matter, kindly contact the undersigned. Sincerely, DNB Engineering, Inc. Jeff Williams Documentation Supervisor JW:jw

FCC ID: OMC1220 DATE: 21-JUN REPORT #06077-1F 1 DNB ENGINEERING, INC. CERTIFICATION FOR INTENTIONAL RADIATOR Per Part 15 Subpart C (CFR 47, 15,203 & 15.209) EUT: 122 kHz Cardio Sport Chest Pulse Model No. 1220 FCC ID: OMC1220 PREPARED FOR APPLICANT: ICON 1500 S.1000 W. Logan,, UT 84321 REPORT # 06077-1F Test Date: June 21, 2000 Prepared By: DNB ENGINEERING, INC. 1100 East Chalk Creek Rd. Coalville, Utah 84017 Tel: 1(435) 336-4433 A2LA # 0844-1 ELA #116 FCC ID: OMC1220 DATE: 21-JUN REPORT #06077-1F 2 Revision Letter Number of Pages Page No. of Rev. DescriptionDate A35Document Release6/23/2000 FCC ID: OMC1220 DATE: 21-JUN REPORT #06077-1F 3 TRANSMITTAL SUMMARY Unit tested:122 kHz Cardio Sport Chest Pulse Model #:1220 FCC ID: OMC1220 Specifications: ANSI C63.4 1992 and CFR 47 FCC part 15 Subpart C Purpose of Report:This report was prepared to document the status of the 122 kHz Cardio Sport Chest Pulse with requirements of the standards listed above. Requirements not applicable to EUT Part 15.37 - Not applicable Emergency Broadcast System - Not applicable Spread Spectrum Exhibit - Not applicable Scanning Receiver - Not applicable Test Summary The EUT’s compliance status according to the tests performed is as follows. Refer to Section 1.3 FCC ID: OMC1220 DATE: 21-JUN REPORT #06077-1F 4 CERTIFICATION OF TEST DATA - per 2.911(d) This report, containing emissions test data and evaluations, has been prepared by an independent electromagnetic compatibility laboratory, DNB ENGINEERING, in accordance with the applicable specifications and instructions required per the Introduction. DNB Engineering has been evaluated to do these tests by the American Association for Laboratory Accreditation, A2LA. The data evaluation and equipment configuration presented herein are a true and accurate representation of the measurements of the test emissions characteristics as of the dates and at the times of the test under the conditions herein specified. Equipment Tested:122 kHz Cardio Sport Chest Pulse Model #:1220 FCC ID#: OMC1220 Dates of Test:June 21, 2000 Test Performed: ____________________________________________ Yancey StaplesDate Test Engineer Test Report Reviewed: ____________________________________________ Jeff WilliamsDate Documentation Supervisor FCC ID: OMC1220 DATE: 21-JUN REPORT #06077-1F 5 TABLE OF CONTENTS 1.INTRODUCTION.............................................................................................................................6 1.1ADMINISTRATIVE DATA PER 2.1033(A) AND 2.911(C).........................................................................6 1.1.1REQUEST FOR CERTIFICATION Per 2.1033(b)1:.............................................................6 1.2RELATED SUBMITTALS/GRANTS.......................................................................................................6 1.3PURPOSE OF TESTS........................................................................................................................6 2.TEST DESCRIPTION......................................................................................................................7 2.1TEST CONFIGURATION....................................................................................................................7 2.2EQUIPMENT DESCRIPTION...............................................................................................................7 2.2.1Mode of Operation................................................................................................................7 2.3ANTENNA REQUIREMENT - PER 15.203.............................................................................................7 2.4CIRCUIT DESCRIPTION - PER 2.1033(B)4..........................................................................................7 2.5SCHEMATICS..................................................................................................................................9 2.6SCHEMATICS................................................................................................................................10 2.7TEST BLOCK DIAGRAM..................................................................................................................11 2.8PHOTOGRAPH OF EUT - PER 2.1033(B)(7).....................................................................................12 2.9PHOTOGRAPH OF EUT - PER 2.1033(B)(7).....................................................................................13 3.EMISSIONS FCC PART 15...........................................................................................................14 3.1RADIATED EMISSIONS TEST SETUP AND PROCEDURE - PER 2.1033(B)(6) PER 2.947(A).....................14 3.1.1Spurious Radiation Test Site Per 2.1033(b)6....................................................................14 3.1.2Example Of Typical Calculation Per 2.1033(b)6...............................................................16 3.1.3Field Strength of Intentional Radiator Inside of Band..........................................................17 3.1.4Emissions Radiated Outside of Band..................................................................................18 3.1.5Occupied Bandwidth...........................................................................................................19 3.1.6Photograph of Radiated Test Setup - per 2.1033(b)(7).......................................................20 4.LABELING REQUIREMENTS - PER 2.1033(B)(7)........................................................................21 4.1ADDITIONAL LABEL REQUIRED........................................................................................................21 4.2LABEL PLACEMENT AND CONTENTS...............................................................................................22 5.OWNERS MANUAL.......................................................................................................................23 5.1.1Owners Manual.........................…

Text truncated - open the document above for the full version.