ON5-HR12HEART RATE SENSOR

FCCIC 066601185 2 Legal NoticesInformations légales Before using the computer, read the manual thoroughly and keep it for future reference.Avant d'utiliser l'ordinateur, veuillez lire attentivement le manuel d'utilisation, et le conserver pour consultation ultérieure Changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: – Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver. – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. – Consult the dealer or an experienced radio/TV technician for help. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p) is not more than that necessary for successful communication.Conformément á la réglementation d’ lndustrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’ un type d’ un gain maximal (ou inférieur) approuvé pour l’ émetteur par lndustrie Canada. Dans le but de réduire les risques de brouillage radioélectrique á l’ intention des autres utilisateurs, il faut choisir le type d’ antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e) ne dépasse pas l’ intensité nécessaire á l’ établissement d’ une communication satisfaisante.This device complies with Part 15 of the FCC Rules and Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:(1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device. L’ appareil est conforme à la réglementation FCC, section 15 et Industrie Canada RSS standard exempts de licence (s). L’ exploitation est autorisée aux deux conditions suivantes:(1) l’ appareil ne doit pas produire de brouillage, et(2) l’ utilisateur de l’ appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’ en compromettre le fonctionnement. CAN ICES-3 (B) / NMB-3 (B)

FOR CALIFORNIA USA ONLY Perchlorate material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate 2-8-25, KUWAZU, HIGASHI SUMIYOSHI-KU, OSAKA, JAPAN 546-0041 CO.,LTD. Before using, please thoroughly read the manual of the product that you mount on this bracket. Avant l’ utilisation, veuillez lire attentivement le manuel du produit que vous montez sur le support. Vor gebrauch die Bedienungsanleitung der Lampe sorgfältig durchlesen. Above refers to proper CR Coin Lithium battery disposal. Please make sure to dispose of the batteries according to local laws. http://www.cateye.com/ Please visit our website for the current applicable models. N’hésitez pas à visitez notre site internet pour trouver les différents modèles applicables. Auf unserer Homepage finden Sie alle aktuell prassenden Lampenmodelle. Electrode pad Ceinture thoracique Elektrodenpolster Back Derrière Herzfre- quenzriemen Heart rate sensor Capteur de fréquence cardiaque Herzfrequenzsensor HR strap Ceinture thoracique Herzfrequenzriemen Warning: Pace maker users should never use this device. • Stop using the unit if you have skin irritation with the HR strap or electrode pad. • Do not twist or pull strongly the HR strap. • The HR strap may deteriorate due to long-term use. Replace the HR strap if it has frequent measurement errors. • Wear the heart rate sensor so that the top of the sensor faces up. Avertissements: Les utilisateurs de pace maker ne doivent jamais utiliser cet appareil. • Arrêtez d’ utiliser l’ appareil si vous avez une irritation cutanée avec l’ attache HR ou le coussinet de l’ électrode. • Ne pas tordre ou tirer fortement l’ attache HR. • L’ attache HR peut se détériorer après une utilisation prolongée. Remplacez l’ attache HR si elle a des fréquentes erreurs de mesure. • Portez le capteur de fréquence cardiaque de manière à ce que le haut du capteur soit en haut. 066532520 V1 Pair the sensor ID according to the manual. Jumeler l’identification du capteur selon le mode d'emploi. Koppeln Sie die Sensor-ID entsprechend des Gebrauchsanleitung. http://www.cateye.com/manual /CC-RD500B/ 4 990173 026104 725012 026106

FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products RF Exposure Statement: 50004841 002 Page 1 of 1 Client: CATEYE Co., Ltd. 2-8-25, Kuwazu, Higashi-Sumiyoshi-Ku, Osaka, 546-0041 Japan Test item: HEART RATE SENSOR Identification: HR-12 FCC Requirement According to KDB 447498 D01 v05r02, SAR evaluation specified in FCC 2.1093 is not required for portable equipment if the transmitter power is below the following threshold for 100MHz to 6GHz: Highest Frequency of Transmitter Tunable Range F [GHz] Min. Test Separation Distance D [mm] 1-g SAR Test Exclusion Threshold (3.0 · D / √ F) + X [mW] 10-g SAR Test Exclusion Threshold (7.5 · D / √ F) + X [mW] 2.480 59.52523.813 Note: X = 0 for D (in mm) ≤ 50mm: X = (D – 50mm) · (1000 · F / 150) for D (in mm) > 50mm and F (in GHz) ≤ 1.5GHz X = (D – 50mm) · 10 for D (in mm) > 50mm and F (in GHz) > 1.5GHz IC Requirement According to RSS-102 (Issue 4), clause 2.5.1, no SAR evaluation is required if the transmitter has a minimum separation distance to the user less than or equal to 20cm and has an output power (both conducted and e.i.r.p.) below the following threshold: Equipment Use Frequency Range SAR Evaluation Threshold [mW] General Public Use 2.2 – 3GHz 20 Measurement Result The maximum measured transmitter power is given in the following table: Conducted Output Power [mW] Maximum Antenna Gain [dBi] EIRP Output Power [mW] 0.927 -9.16 0.113 Conclusion SAR evaluation is not required since the maximum transmitter output power (both conducted and e.i.r.p.) is below the FCC and IC thresholds. Refer to test report 50004841 001 for more details. TÜV Rheinland Japan Ltd. – Global Technology Assessment Center 4-25-2 Kita-Yamata, Tsuzuki-ku, Yokohama 224-0021, Japan

FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 2 von 39 Page 2 of 39 TEST SUMMARY 5.1.1 SUPPLY VOLTAGE REQUIREMENTS RESULT: PASS 5.1.2 ANTENNA REQUIREMENTS RESULT: PASS 5.1.3 RESTRICTED BANDS OF OPERATION RESULT: PASS 5.2.1 CONDUCTED OUTPUT POWER 5.3.1 DUTY CYCLE 5.3.2 20DB BANDWIDTH RESULT: PASS 5.3.3 99% BANDWIDTH 5.3.4 FIELD STRENGTH OF FUNDAMENTAL RESULT: Pass 5.3.5 RADIATED SPURIOUS EMISSIONS OF TRANSMITTER RESULT: PASS 5.4.1 AC POWER LINE CONDUCTED EMISSION OF TRANSMITTER RESULT: N/A FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 3 von 39 Page 3 of 39 Contents 1. GENERAL REMARKS ................................................................................................. 5 1.1 COMPLEMENTARY MATERIALS .................................................................................. 5 2. TEST SITES .............................................................................................................. 5 2.1 TEST FACILITIES ....................................................................................................... 5 2.2 LIST OF TEST AND MEASUREMENT INSTRUMENTS ....................................................... 6 2.3 MEASUREMENT UNCERTAINTY ................................................................................... 7 3. GENERAL PRODUCT INFORMATION ............................................................................ 8 3.1 PRODUCT FUNCTION AND INTENDED USE ................................................................... 8 3.2 SYSTEM DETAILS ...................................................................................................... 8 3.3 CLOCK FREQUENCIES ............................................................................................... 8 3.4 NOISE SUPPRESSING PARTS ..................................................................................... 8 4. TEST SET-UP AND OPERATION MODES ...................................................................... 9 4.1 TEST METHODOLOGY ................................................................................................ 9 4.2 OPERATION MODES .................................................................................................. 9 4.3 PHYSICAL CONFIGURATION FOR TESTING .................................................................. 9 4.4 TEST SOFTWARE .................................................................................................... 11 4.5 SPECIAL ACCESSORIES AND AUXILIARY EQUIPMENT ................................................ 12 4.6 COUNTERMEASURES TO ACHIEVE EMC COMPLIANCE ............................................... 12 5. TEST RESULTS R AD I O ......................................................................................... 13 5.1 TECHNICAL REQUIREMENTS .................................................................................... 13 5.1.1 Supply Voltage Requirements ................................................................................................. 13 5.1.2 Antenna Requirements ............................................................................................................ 13 5.1.3 Restricted Bands of Operation ................................................................................................. 14 5.2 CONDUCTED MEASUREMENTS AT ANTENNA PORT .................................................... 15 5.2.1 Conducted Output Power ......................................................................................................... 15 5.3 RADIATED MEASUREMENTS..................................................................................... 16 5.3.1 Duty Cycle ............................................................................................................................... 16 5.3.2 20dB Bandwidth ....................................................................................................................... 18 5.3.3 99% Bandwidth ........................................................................................................................ 21 5.3.4 Field Strength of Fundamental ................................................................................................. 24 5.3.5 Radiated Spurious Emissions of Transmitter ........................................................................... 27 5.4 AC POWER LINE CONDUCTED MEASUREMENTS ....................................................... 33 5.4.1 AC Power Line Conducted Emission of Transmitter ................................................................ 33 6. PHOTOGRAPHS OF THE TEST SETUP ........................................................................ 34 FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 4 von 39 Page 4 of 39 7. LIST OF TABLES ...................................................................................................... 38 8. LIST OF FIGURES .................................................................................................... 38 9. LIST OF PHOTOGRAPHS .......................................................................................... 39 FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 5 von 39 Page 5 of 39 1. General Remarks 1.1 Complementary Materials There is no attachment to this test report. 2. Test Sites 2.1 Test Facilities TÜV Rheinland Japan Ltd. – Global Technology Assessment Center 4-25-2 Kita-Yamata, Tsuzuki-ku, Yokohama 224-0021, Japan The used test equipment is in accordance with CISPR 16 for measurement of radio interference. The Federal Communications Commission has reviewed the technical characteristics of the radiated and conducted emission facilities and has found these test sites to be in compliance with the requirements of section 2.948 of the FCC rules. The description of the test faci…

Text truncated - open the document above for the full version.

FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 34 von 39 Page 34 of 39 6. Photographs of the Test Setup Photograph 1: Set-up for RF Conducted Power at Antenna Port FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 35 von 39 Page 35 of 39 Photograph 2: Set-up for Radiated Test of Transmitter, Front View Photograph 3: Set-up for Radiated Test of Transmitter, Rear View FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 36 von 39 Page 36 of 39 Photograph 4: Set-up for Radiated Emission, EUT Configuration X-Axis Photograph 5: Set-up for Radiated Emission, EUT Configuration Y-Axis FCC ID: ON5-HR12 IC: 5672A-HR12 Produkte Products Prüfbericht - Nr.: Test Report No.: 50004841 001 Seite 37 von 39 Page 37 of 39 Photograph 6: Set-up for Radiated Emission, EUT Configuration Z-Axis