OUCG8D-380H-BAutomotive Security Receiver

≥ ! CAUTION The remote control switch is a precision electronic device. Therefore, pay attention to the following: ε Do not impose shock on the remote control switch. ε Keep the remote control switch dry. ε Do not disassemble the remote control switch.  Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Your keyless entry system operates on a radio frequency subject to Federal Communications Commission (FCC) rules and Industry Canada rules. This device complies with Part 15 of the FCC Rules. Operation is subject to the following tow conditions. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation of the device. (3) “ Complies with RSS-210 of Industry Canada. ” NOTICE This equipment has been tested and found to comply with the limits for a Class B device, pursuant to part 15 of the FCC Rules, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communications However there is no guarantee that interference will not occur in particular installation. If this equipment dose cause harmful interference to radio or radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help. FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

From: [email protected] Sent: Thursday, February 14, 2002 4:42 PM To: Mike Kuo; [email protected] Subject: RE: Omron Corporation, FCC ID:OUCG8D-380H-B Assessment No:AN02T1777 Dear Mr. Kuo Please reply whether JQA opinion is accepted or not. JQA says : 15.33(b)(1) is applied to Digital equipment except the equipment mentioned in 15.33(b)(2) and (3). OMRON's reciver employing superheterodyne techniques. So 15.33(b)(3) should be applied. According to 15.33(b)(3), the frequency range shall be investigated up to the higher of the second harmonic of the highest local oscillator frequency generated in the device . The highest local oscillator frequency generated in OMRON's receiver is 324.55MHZ. So the higher of the second harmonic of the highest local oscillator frequency is 649.1MHZ. JQA tested up to 1000MHZ above 649.1MHZ. Best regards Yasuhide Yomo > -----Original Message----- > From: Mike Kuo [mailto:[email protected]] > Sent: Thursday, February 14, 2002 5:27 AM > To: '?? ??'; '[email protected]' > Subject: Omron Corporation, FCC ID:OUCG8D-380H-B Assessment No:AN02T1777 > > > Dear Yasuhide: > Question #1: The frequency range investigated for above subject > receiver is > from 30 - 1000MHz. In accordance with Section 15.33(b)(1) Table, > the upper > frequency should be investigated up to 2000MHz. Please provide additional > test data from 1000 - 2000MHz. > > Best Regards > > ========================= > Mike Kuo > Compliance Certification Services > 561F Monterey Road > Morgan Hill CA 95037 > Telephone number:408-463-0885 EXT:105 > Fax number :408-463-0888 > E-Mail:[email protected] > >

‚r‚ d‚ q‚ h‚ `‚ k@‚ m‚ nD ‚s‚ `‚ h‚ v‚ `‚ m@‚ m‚ nD FCC IDF OUCG8D-380H-B CANADA:1884-G8D380HB OMRONG8D-380H-B TAIWAN LOGO