OVITRANSX ROCKER/GAMING CHAIR

2.1 Wireless Need Help? Email: [email protected] Phone: 866-969-2603 IMPORTANT: You must keep your original retail receipt as proof of purchase. 2 Thank you for purchasing this X Rocker gaming chair. You are now close to enhancing your favorite games with audio! To get started, please assemble the chair using get rocking! Table of contents 3 Box contents and control panel overview 4 5 6 Connect by controller (PS4 systems only) 7 8 Welcome to X Rocker! 3 + + ++ + + Control panel overview B1 - 3m RCA to RCA Audio cable B2 - 1m 3.5mm to 3.5mm Audio cable B3 - RCA female to female adapters B4 - 15cm RCA to 3.5mm audio cable B5 – 15cm 3.5mm to 3.5mm audio cable B6 – Power Supply Cable B B1 B3 B5B6 B4 B2 + B7 ON/OFF 4 B7) to your TV set using the 3.5mm to 3.5mm cable (B2/B5) Once connected, Set the control panel on the chair and the Wireless 1,2,3) To get the best sound, make sure that the volume on the TV is set to approximately 50% of the maximum. Depending on the TV you may need refer to TV manual for guidelines.) (All consoles) B5 TV/Mobile/Tablet ON/OFF 5 1. Connect B1 Cable to X Rocker control panel RCA INPUT sockets 2. Connect B3 RCA adapters to other end of B1 RCA cable 3. Connect B4 RCA cable to B3 Adapter. 4. Connect B4 3.5mm end into the headphone socket of your Television 5. Once connected to your TV, increase volume to 50% of the maximum for the best sound level.** * OTE: If your TV does not feature a headphone socket then you may need console for audio. Contact support for more details. **Depending on your TV you may need to Increase the headphone (All consoles) TV/Mobile/Tablet B4 ON/OFF 6 1. Connect the B2 headset socket. 2. Connect the other end of the B2 cable to the chair via the green port. 3. With the PS4 turned on, go to the main menu (or locate the main menu screen). Press and hold the quick menu appears on screen. 4. In this menu select [Adjust sound and devices] 5. Then select [output to headphones] 6. [Chat Only] to [All audio] 7. Make sure the volume in the previous menu is set to the maximum. 8. Set the control panel Wireless switch to the ‘OFF Connect by controller: (PS4 systems only) B2 7 • Make sure that the power cable is connected correctly. • Make sure that the power supply at the power source is working correctly. give the power cable a slight wiggle in the then please contact support (details below). • Make sure that the wireless channel (1,2,3 for wireless and AUX for wired • Please make sure that the volume of the source device is at a higher level to strengthen the audio signal. • Please contact X Rocker support ([email protected]) regarding this issue. • In this case, try another of the three wireless bands to isolate the signal. No power going to control panel Issue No sound The cables connected to my X Rocker have been broken accidentally 8 • Avoid immersing or allowing the X Rocker to come into contact with liquids. • Please consult X Rocker Support before unscrewing any of the electrical components on the chair. • Please be mindful of any cabling laid out between the X Rocker and power source/audio device. the X Rocker. • If the cables or electrical equipment are broken then this may present a choking risk, please contact Support for replacements and dispose of these parts safely. • Do not stand on the X Rocker or exceed the 250lbs weight limit via other means. • If your X Rocker comes with a pedestal,do not lean back on the chair to           • If your X Rocker comes with armrests,X Rocker armrests are designed for support and comfort during gameplay, please do not use these as support     • Playing audio for long periods at loud volumes may contribute to      • Please be considerate to others when playing audio through the X Rocker speakers at higher volumes. Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.               ! "#   $    % "&#     $   %    $    FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IC This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie …

Text truncated - open the document above for the full version.

SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 1 of 4 External Photos for SZEM2003001988CR FCC ID: OVITRANS SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 2 of 4 1 EUT Constructional Details SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 3 of 4 SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 4 of 4

>ĂďĞů ƐŝnjĞ͗ Ϯ͘ρΎϭ͘ρĐŵ >>>Kd/KE

SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 1 of 3 Internal Photos for SZEM2003001988CR FCC ID: OVITRANS SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 2 of 3 1 EUT Constructional Details SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 3 of 3

SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Report No.: SZEM200300198801 Page: 1 of 42 Keny Xu EMC Laboratory Manager TEST REPORT Application No.: SZEM2003001988CR Applicant: DAKANG HOLDING CO., LTD Address of Applicant: NO.695 kangshan road, Dipu Street, Anji county, Huzhou, Zhejiang Province, 313300 China Manufacturer: Dakang Holding Co., Ltd Address of Manufacturer: NO.695 Kangshan road, Dipu Street, Anji County, Zhejiang Province, China Factory: Dakang Holding Co., Ltd Address of Factory: NO.695 Kangshan Road, Dipu Street, Anji County, Zhejiang Province, China Equipment Under Test (EUT): EUT Name: X ROCKER/GAMING CHAIR Model No.: TRANS FCC ID: OVITRANS Standard(s) : 47 CFR Part 15, Subpart C 15.249 Date of Receipt: 2020-03-31 Date of Test: 2020-04-01 to 2020-04-11 Date of Issue: 2020-04-14 Test Result: Pass* * In the configuration tested, the EUT complied with the standards specified above. SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Report No.: SZEM200300198801 Page: 2 of 42 Revision Record Version Chapter Date Modifier Remark 01 2020-04-14 Original Authorized for issue by: Leo Li /Project Engineer Eric Fu /Reviewer SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Report No.: SZEM200300198801 Page: 3 of 42 2 Test Summary Radio Spectrum Technical Requirement Item Standard Method Requirement Result Antenna Requirement 47 CFR Part 15, Subpart C 15.249 N/A 47 CFR Part 15, Subpart C 15.203 Pass Radio Spectrum Matter Part Item Standard Method Requirement Result Conducted Emissions at AC Power Line (150kHz-30MHz) 47 CFR Part 15, Subpart C 15.249 ANSI C63.10 (2013) Section 6.2 47 CFR Part 15, Subpart C 15.207 Pass 20dB Bandwidth 47 CFR Part 15, Subpart C 15.249 ANSI C63.10 (2013) Section 6.9 47 CFR Part 15, Subpart C 15.215 Pass Duty Cycle 47 CFR Part 15, Subpart C 15.231 ANSI C63.10:2013 47 CFR Part 15C Section 15.35 (c) Pass Field Strength of the Fundamental Signal (15.249(a)) 47 CFR Part 15, Subpart C 15.249 ANSI C63.10 (2013) Section 6.5&6.6 47 CFR Part 15, Subpart C 15.249(a) Pass Restricted Band Around Fundamental Frequency 47 CFR Part 15, Subpart C 15.249 ANSI C63.10 (2013) Section 6.4&6.5&6.6 47 CFR Part 15, Subpart C 15.205 & 15.249(d) & 15.209 Pass Radiated Emissions 47 CFR Part 15, Subpart C 15.249 ANSI C63.10 (2013) Section 6.4&6.5&6.6 47 CFR Part 15, Subpart C 15.209 & 15.249 (a),(d) Pass SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Report No.: SZEM200300198801 Page: 4 of 42 3 Contents Page 1 COVER PAGE ..................................................................................................................................... 1 2 TEST SUMMARY ................................................................................................................................. 3 3 CONTENTS ......................................................................................................................................... 4 4 GENERAL INFORMATION .................................................................................................................. 6 4.1 DETAILS OF E.U.T. ......................................................................................................................... 6 4.2 DESCRIPTION OF SUPPORT UNITS .................................................................................................... 6 4.3 MEASUREMENT UNCERTAINTY ......................................................................................................... 6 4.4 TEST LOCATION ............................................................................................................................. 7 4.5 TEST FACILITY ............................................................................................................................... 7 4.6 DEVIATION FROM STANDARDS ......................................................................................................... 7 4.7 ABNORMALITIES FROM STANDARD CONDITIONS ................................................................................. 7 5 EQUIPMENT LIST ............................................................................................................................... 8 6 RADIO SPECTRUM TECHNICAL REQUIREMENT ............................................................................11 6.1 ANTENNA REQUIREMENT ................................................................................................................11 6.1.1 Test Requirement: ..................................................................................................................11 6.1.2 Conclusion ..............................................................................................................................11 7 RADIO SPECTRUM MATTER TEST RESULTS .................................................................................12 7.1 CONDUCTED EMISSIONS AT AC POWER LINE (150KHZ-30MHZ) ........................................................12 7.1.1 E.U.T. Operation .....................................................................................................................12 7.1.2 Measurement Procedure and Data .........................................................................................12 7.2 20DB BANDWIDTH .........................................................................................................................15 7.2.1 E.U.T. Operation .....................................................................................................................15 7.2.2 Test Setup Diagram ................................................................................................................15 7.2.3 Measurement Procedure and Data .........................................................................................15 7.3 DUTY CYCLE .................................................................................................................................18 7.4 FIELD STRENGTH …

Text truncated - open the document above for the full version.

SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 1 of 4 Setup Photos for SZEM2003001988CR FCC ID: OVITRANS SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 2 of 4 1 Photographs 1.1 Conducted Emissions at AC Power Line (150kHz-30MHz) Test Setup 1.2 Field Strength of the Fundamental Signal (15.249(a)) Test Setup SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 3 of 4 1.3 Restricted Band Around Fundamental Frequency Test Setup SGS-CSTC Standards Technical Services Co., Ltd. Shenzhen Branch Page: 4 of 4 1.4 Radiated Emissions Test Setup