OXC-204Car Alarm Transmitter, 204

USER GUIDE FOR REMOTE CONTROL TYPE 204 AND 225 This is a multi function remote controlled transmitter intended for the remote operation of a vehicle security system. The function of each button is described fully in the operating manual of the security system in question and the user should consult this manual for the detailed functions controlled by the transmitter. The transmitter operates using two lithium batteries type CR1220. The life of these batteries is 2 – 3 years with typical usage. When the batteries are nearing the end of their life the LED light on the remote will begin to flash when pushed and the user will begin to notice the range deteriorating. When this occurs the battery should be replaced within a few weeks to avoid any inconvenience. FCC STATEMENT – FCC APPROVAL NUMBERS OXC-204 AND OXC-225 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates, uses, and can radiate radio frequency energy and, if installed and used in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, the user in encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the computer and receiver. -Connect the computer into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications not expressly approved by the guarantee of this device cold void the user’s authority to operate the equipment.

Page 1 of 23 Report No: FC00-013 CERTIFICATION TEST REPORT FOR THE CAR ALARM SYSTEM TRANSMITTER, 204301/8 FCC PART 15.231 COMPLIANCE DATE OF ISSUE: MARCH 2, 2000 PREPARED FOR: PKF Electronics (PTY) LTD. P.O. Box 3660 Durban 4000 KWA Zulu, Natal, South Africa W.O. No: 73326 PREPARED BY: Joyce Walker CKC Laboratories, Inc. 5473A Clouds Rest Mariposa, CA 95338 Date of test: January 31, 2000 Report No: FC00-013 DOCUMENTATION CONTROL: _____________________________ Tracy Phillips Documentation Control Supervisor CKC Laboratories, Inc. APPROVED BY: _____________________________ Dennis Ward Director of Laboratories CKC Laboratories, Inc. This report contains a total of 23 pages and may be reproduced in full only. Partial reproduction may only be done with the written consent of CKC Laboratories, Inc. Page 2 of 23 Report No: FC00-013 TABLE OF CONTENTS Administrative Information ............................................................................................. 3 Summary Of Results........................................................................................................ 4 Equipment Under Test (EUT) Description...................................................................... 4 Measurement Uncertainty................................................................................................ 4 EUT Operating Frequency............................................................................................... 4 Peripheral Devices ........................................................................................................... 4 Report Of Measurements................................................................................................. 5 Table 1: Fundamental Radiated Emission Levels .............................................. 5 Table 2: Six Highest Radiated Emission Levels ................................................ 6 Table A : List Of Test Equipment ................................................................................... 7 EUT Setup .......................................................................................................................8 Test Instrumentation And Analyzer Settings................................................................... 8 Table B : Analyzer Bandwidth Settings Per Frequency Range........................... 8 Spectrum Analyzer Detector Functions............................................................... 9 Peak ......................................................................................................... 9 Quasi-Peak............................................................................................... 9 Average.................................................................................................... 9 Test Methods ................................................................................................................... 10 Radiated Emissions Testing................................................................................. 10 Occupied Bandwidth ........................................................................................... 11 Sample Calculations ........................................................................................................ 11 Appendix A : Information About The Equipment Under Test........................................ 12 I/O Ports............................................................................................................... 13 Crystal Oscillators ............................................................................................... 13 Printed Circuit Boards ......................................................................................... 13 Photograph Showing Radiated Emissions ........................................................... 14 Photograph Showing Radiated Emissions ........................................................... 15 Photograph Showing Radiated Emissions ........................................................... 16 Photograph Showing Radiated Emissions ........................................................... 17 Appendix B : Measurement Data Sheets ......................................................................... 18 Occupied Bandwidth Plot.................................................................................... 19 Duty Cycle Plot ................................................................................................... 20 Page 3 of 23 Report No: FC00-013 CKC Laboratories, Inc. has Certificates of Accreditation from the following agencies: DATech (Germany); A2LA (USA); FCC (USA); VCCI (Japan); BSMI (Taiwan); HOKLAS (Hong Kong). CKC Laboratories, Inc. has Letters of Acceptance through an MRA for the following agencies: ACA/NATA (Australia); SABS (South Africa); SWEDAC (Sweden); TUV Rheinland-Germany; TUV Rheinland- Korea; TUV Rheinland-Russia; Radio Communications Agency (RA); NEMKO (Norway). ADMINISTRATIVE INFORMATION DATE OF TEST: January 31, 2000 PURPOSE OF TEST: To demonstrate the compliance of the Car Alarm System Transmitter, 204301/8, with the requirements for FCC Part 15.231 devices. MANUFACTURER: PKF Electronics (PTY) LTD. P.O. Box 3660 Durban 4000 KWA Zulu, Natal, South Africa REPRESENTATIVE: MBParnaby TEST LOCATION: CKC Laboratories, Inc. 22105 Wilson River Hwy Tillamook, OR 97141 TEST PERSONNEL: Mike Wilkinson TEST METHOD: ANSI C63.4 1992 FREQUENCY RANGE TESTED: 9 kHz - 5000 MHz EQUIPMENT UNDER TEST:Car Alarm System Transmitter Manuf:PKF Electronics (PTY) LTD. Model:204301/8 Serial:None FCC ID:Pending Page 4 of 23 Report No: FC00-013 SUMMARY OF RESULTS The PKF Electronics (PTY) LTD. Car Alarm System Transmitter, 204301/8, was tested in accordance with ANSI C63.4 1992 for compliance with FCC Part 15.231. As received, the above equipment was found to be fully compliant with the limits of FCC Part 15.231. The results in this report apply only to the items tested, as identified herein. EQUIPMENT UNDER TEST (EUT) D…

Text truncated - open the document above for the full version.