
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
EXHIBIT 3 User’s Manual
EXHIBIT 10 Cover Letters (Agent Authorization Letter and Anti-Drug Statement)
American Telecommunications Certification Body Inc. 6731 Whittier Ave, McLean, VA 22101 July 20, 2001 RE: Spin-Cast Inc. FCC ID: OXHSCRC001 I have just a few brief comments on the Exhibits associated with this Application. 1.) The labeling for this device does not conform to the requirements of 15.19. If the device is smaller than the palm of the hand, the two-part statement of 15.19(a)(3) may appear in the manual. Please resubmit corrected Exhibits. 2.) The internal photographs are of insufficient detail. Please submit full sized photos of both sides of printed wiring board with all RF shielding removed. Submit just one to a page of sufficient quality to distinguish the individual components on the board. Orthographic views are preferred. 3.) Am not certain if additional information could be derived from better external photos, but clearer ones might be helpful. That’s it. Get me these updated Exhibits and your Grant will be issued. Bill William H. Graff Examining Engineer President and Director of Engineering mailto:[email protected] The items indicated above must be submitted before processing can continue on the above referenced application. Failure to provide the requested information may result in application termination. Correspondence should be considered part of the permanent submission and may be viewed from the Internet after a Grant of Equipment Authorization is issued. Please do not respond to this correspondence using the email reply button. In order for your response to be processed expeditiously, you must submit your documents through the AmericanTCB.com website. Also, please note that partial responses increase processing time and should not be submitted. Any questions about the content of this correspondence should be directed to the sender.
EXHIBIT 6 External Photographs Spin-Cast, Inc.
EXHIBIT 2 Label and Label Placement Spin-Cast, Inc. Remote Transmitter Label Spin-Cast, Inc. Remote Transmitter Label Placement
EXHIBIT 5 Internal Photographs SPIN-CAST, INC. SCRC001 - Internal
FCC ID#: OXHSCRC001 Page 1 EXHIBIT 7 Test Report FCC ID#: OXHSCRC001 Page 2 Table of Contents Table of Contents......................................................................................................................19 Certificate of Compliance.........................................................................................................20 1.0 EUT Description.................................................................................................................4 1.1 EUT Operation....................................................................................................................4 2.0 Electromagnetic Emissions Testing.....................................................................................4 2.1 Test Procedure.................................................................................................................5 2.2 Test Criteria...................................................................................................................5 2.3 Test Results.....................................................................................................................5 3.0 Occupied Bandwidth Measurements....................................................................................5 3.1 Test Procedure.................................................................................................................6 3.2 Test Criteria....................................................................................................................6 3.3 Test Results.....................................................................................................................6 4.0 Antenna Requirement..........................................................................................................6 4.1 Evaluation Procedure......................................................................................................6 4.2 Evaluation Criteria..........................................................................................................6 4.3 Evaluation Results...........................................................................................................7 5.0 Modifications to Equipment................................................................................................7 6.0 List of Test Equipment........................................................................................................7 Figures Figure 1: Radiated Emissions Test Setup...................................................................................23 Appendices Appendix A: Fundamental Emissions Test Data........................................................................24 THIS REPORT SHALL NOT BE REPRODUCED EXCEPT IN FULL, WITHOUT THE WRITTEN APPROVAL OF PROFESSIONAL TESTING (EMI), INC. FCC ID#: OXHSCRC001 Page 3 Applicant: SPIN-CAST, INC. Applicant’s Address: 5680 Randolph Blvd. San Antonio, Texas 78233 Model: SCRC001 Serial Number: 005 Project Number: 01415-10 Test Dates: April 19, 2001 I, Jeffrey A. Lenk, for Professional Testing (EMI), Inc., being familiar with the FCC rules and test procedures have reviewed the test setup, measured data and this report. I believe them to be true and accurate. The SPIN-CAST INC., SCRC001 was tested to and found to be in compliance with FCC Part 15 Subpart C for an Intentional Radiator. The highest emissions generated by the above equipment are listed below: Frequency (MHz) Level (dBμV/m) Limit (dBμV/m) Margin (dB) Fundamental 418 79.9 80.3 -0.4 Spurious 2090 49.2 63.5 -14.3 Occupied Bandwidth 190 KHz measured at –20 dBC. Fundamental frequency is 418 MHz. ______________________________ Jeffrey A. Lenk President Certificate of Compliance Page 4 1.0 EUT Description The Equipment Under Test (EUT) is a Spin-Cast, Inc. SCRC001. The SCRC001 is a low power hand-held wireless remote transmitter designed to activate a remote controlled feeder. The SCRC001 is powered by 2 AA batteries. The transmission continues until the button is released. Once the button is released, the transmission stops instantly as power is removed from the entire circuit. The EUT operates at 418 MHz and is designed fro compliance with 47 CFR 15.231 of the FCC rules. Specific test requirements for this device include the following: 47 CFR 15.231 Fundamental Transmit Power 47 CFR 15.231& 15.205 Spurious Radiated Power 47 CFR 15.231 Occupied Bandwidth (ANSI C63.4 used as Procedural Reference) 47 CFR 15.203 Antenna Requirement The system tested consisted of the following: Manufacturer & Model Serial # FCC ID # Description SPIN-CAST, INC., SCRC001 005 OXHSCSR001 SCRC001 1.1 EUT Operation The SCRC001 was tested with the transmit button continuously depressed, thus the SCRC001 was continuously transmitting. 2.0 Electromagnetic Emissions Testing Professional Testing (EMI), Inc. (PTI), follows the guidelines of NIST for all uncertainty calculations, estimates and expressions thereof for EMC testing. Radiated emission measurements were made of the Fundamental and Spurious Emission levels for the SCRC001. Measurements of the occupied bandwidth were also made for the equipment. Measurements of the maximum emission levels for the fundamental and the spurious/harmonic emissions of the SCRC001 were made at the Professional Testing "Open Field" Site #3, located in Round Rock, Texas to determine the radio noise radiated from the EUT. A “Description of Measurement Facilities” has been submitted to the FCC and approved pursuant to Section 2.948 of CFR 47 of the FCC rules. Tests of the fundamental emissions for the device were performed to determine the worst case polarization of the device. The fundamental emissions of the device were measured with the device in its position of use and the measurement antenna was changed to both vertical and horizontal polarity to record the signal of highest intensity. FCC ID#: OXHSCRC001 Page 5 2.1 Test Procedure The EUT was placed on a non-conductive table 0.8 me…
Text truncated - open the document above for the full version.
EXHIBIT 8 Test Set-Up Photographs Test Setup Photographs SPIN-CAST, INC. Radiated Emissions – Front View Micro Wave Radiated Emissions
1601 FM 1460 Suite B · Round Rocl, Texas · United States
| # | Rule Parts | Frequency Range | Power Output |
|---|---|---|---|
| 1 | 15C | 418 MHz - 418 MHz | 18.00 µW |

Remote Control Feeder Transmitter
Equipment Class
DXX - Part 15 Low Power Communication Device Transmitter