OXVSSG5Secure Services Gateway 5

Juniper Networks, Inc. 1194 North Mathilda Avenue Sunnyvale, CA 94089 USA 408-745-2000 www.juniper.net Part Number: 530-015647-01, Revision beta3 Security Products Secure Services Gateway 5 Hardware Installation and Configuration Guide - Beta3 ScreenOS Version 5.4.0 ii„ Copyright Notice Copyright © 2006 Juniper Networks, Inc. All rights reserved. Juniper Networks and the Juniper Networks logo are registered trademarks of Juniper Networks, Inc. in the United States and other countries. All other trademarks, service marks, registered trademarks, or registered service marks in this document are the property of Juniper Networks or their respective owners. All specifications are subject to change without notice. Juniper Networks assumes no responsibility for any inaccuracies in this document or for any obligation to update information in this document. Juniper Networks reserves the right to change, modify, transfer, or otherwise revise this publication without notice. FCC Statement The following information is for FCC compliance of Class A devices: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. The equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case users will be required to correct the interference at their own expense. The following information is for FCC compliance of Class B devices: The equipment described in this manual generates and may radiate radio-frequency energy. If it is not installed in accordance with Juniper Network’s installation instructions, it may cause interference with radio and television reception. This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in part 15 of the FCC rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: „Reorient or relocate the receiving antenna. „Increase the separation between the equipment and receiver. „Consult the dealer or an experienced radio/TV technician for help. „Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Caution: Changes or modifications to this product could void the user's warranty and authority to operate this device. Disclaimer THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY, CONTACT YOUR JUNIPER NETWORKS REPRESENTATIVE FOR A COPY. Writer: Carrie Nowocin Editor: Lisa Eldridge Table of Contents„iii Table of Contents About This Guidev Organization .................................................................................................... v WebUI Conventions ........................................................................................ vi CLI Conventions............................................................................................. vii Obtaining Documentation and Technical Support ......................................... viii Chapter 1 Hardware Overview1 Port and Power Connectors ............................................................................. 1 Front Panel ...................................................................................................... 2 System Status LEDs ................................................................................... 2 Port Descriptions ....................................................................................... 4 Ethernet Ports ..................................................................................... 4 Console Port ....................................................................................... 4 AUX Port ............................................................................................. 5 Back Panel ....................................................................................................... 5 Power Adapter........................................................................................... 5 Radio Transceiver...................................................................................... 5 Grounding Lug ........................................................................................... 6 Antennae Types......................................................................................... 6 Universal Serial Bus (USB) Host Module ..................................................... 6 Chapter 2 Installing and Connecting the Device9 Before You Begin ............................................................................................. 9 Equipment Rack Installation .......................................................................... 10 Equipment Desk Mount Installation ............................................................... 10 Connecting Interface Cables to the Device ..................................................... 11 Chassis Grounding ......................................................................................... 11 Connecting the Power .........................................................................…

Text truncated - open the document above for the full version.

Photo 1: External photo of EUT Ethernet SSG 5 Photo 2: External photo of EUT Ethernet SSG 5 Photo 3: External photo of EUT V.92 SSG 5 Photo 4: External photo of EUT V.92 SSG 5 Photo 5: External photo of Antenna Antenna 1 Photo 6: External photo of Antenna Antenna 2 Photo 7: External photo of Antenna Antenna 3 Photo 8: External photo of Adapter Photo 9: External photo of Adapter Photo 10: External photo of Adapter Photo 11: External photo of Adapter

FCC ID Label Location

Photo 1: Internal photo of EUT SSG 5 Photo 2: Internal photo of EUT SSG 5 Photo 3: Internal photo of EUT SSG 5 Photo 4: Internal photo of EUT SSG 5 Photo 5: Internal photo of EUT SSG 5 Photo 6: Internal photo of EUT SSG 5 Photo 7: Internal photo of EUT SSG 5 Photo 8: Internal photo of EUT SSG 5 Photo 9: Internal photo of EUT SSG 5 Photo 10: Internal photo of EUT SSG 5

FCC ID. : OXVSSG5 Report No.: EME-060774 Page 1 of 120 EMC TEST REPORT Report No. : EME-060774 Model No. : SSG 5 Issued Date : Jul. 3, 2006 Applicant : Juniper Networks Inc. 1194 North Mathilda Avenue, Sunnyvale, California 94089-1206 USA Test By : Intertek Testing Services Taiwan Ltd. No. 11, Lane 275, Ko-Nan 1 Street, Chia-Tung Li, Shiang-Shan District, Hsinchu City, Taiwan This test report consists of 118 pages in total. It may be duplicated completely for legal use with the allowance of the applicant. It shall not be reproduced except in full, without the written approval of Intertek Laboratory. The test result(s) in this report only applies to the tested sample(s). Marx Yang Project Engineer Reviewed By Jerry Liu FCC ID. : OXVSSG5 Report No.: EME-060774 Page 2 of 120 Table of Contents Summary of Tests ..............................................................................................................5 1. General information ......................................................................................................6 1.1 Identification of the EUT ........................................................................................6 1.2 Additional information about the EUT....................................................................6 1.3 Antenna description.................................................................................................7 1.4 Peripherals equipment .............................................................................................7 2. Test specifications .........................................................................................................8 2.1 Test standard............................................................................................................8 2.2 Operation mode .......................................................................................................8 2.3 Test equipment ........................................................................................................9 3. Minimum 6dB Bandwidth test (FCC 15.247) .............................................................10 3.1 Operating environment..........................................................................................10 3.2 Test setup & procedure ..........................................................................................10 3.3 Measured data of Minimum 6dB Bandwidth test results ......................................10 4. Maximum Output Power test (FCC 15.247) ...............................................................18 4.1 Operating environment..........................................................................................18 4.2 Test setup & procedure ..........................................................................................18 4.3 Measured data of Maximum Output Power test results ........................................18 5. RF Antenna Conducted Spurious test..........................................................................20 5.1 Operating environment..........................................................................................20 5.2 Test setup & procedure ..........................................................................................20 5.3 Measured data of the highest RF Antenna Conducted Spurious test result ..........20 6. Radiated Emission test (FCC 15.247) .........................................................................42 6.1 Operating environment..........................................................................................42 6.2 Test setup & procedure ..........................................................................................42 6.3 Emission limits ......................................................................................................43 6.4 Radiated spurious emission test data.....................................................................44 6.4.1 Measurement results: frequencies equal to or less than 1 GHz..........................44 6.4.2 Measurement results: frequency above 1GHz ...................................................46 7. Power Spectrum Density test (FCC 15.247) ...............................................................49 7.1 Operating environment..........................................................................................49 7.2 Test setup & procedure ..........................................................................................49 FCC ID. : OXVSSG5 Report No.: EME-060774 Page 3 of 120 7.3 Measured data of Power Spectrum Density test results ........................................49 8. Emission on the band edge (FCC 15.247)...................................................................57 8.1 Operating environment..........................................................................................57 8.2 Test setup & procedure ..........................................................................................57 8.3 Test Result .............................................................................................................58 8.3.1 Conducted Method .............................................................................................58 8.3.2 Radiated Method ................................................................................................66 9. Peak Output Power test (FCC 15.407) ........................................................................68 9.1 Operating environment..........................................................................................68 9.2 Test setup & procedure ..........................................................................................68 9.3 Limit ......................................................................................................................68 9.4 Measured data of Maximum Output Power test results ........................................68 10. Power Spectrum Density test (FCC 15.407) .....…

Text truncated - open the document above for the full version.

Photo 1: Conducted Emission Test Set-up photo Ethernet SSG 5 Photo 2: Conducted Emission Test Set-up photo Ethernet SSG 5 Photo 3: Conducted Emission Test Set-up photo V.92 SSG 5 Photo 4: Conducted Emission Test Set-up photo V.92 SSG 5

Photo 1: Radiated Emission Test set-up photo SSG 5 Photo 2: Radiated Emission Test set-up photo SSG 5