P2BAPX-ACWireless Audio Call HandFree

USER MANUAL INSTRUCTIONS FOR USE: 1. CLIP ON TO LISTENING AREA OF PHONE. 2. PRESS SWITCH BUTTON AND ILLUMINATED LED INDICATOR (SWITCH OFF FOR ENDING). 3. TUNE CAR RADIO TO FM 88.7 MHz AND STORE IT INTO MEMORY PRE-SET STATION FOR HANDSFREE USING. 4. HANDSFREE FUNCTION THROUGH YOUR CAR STEREO. 5. USER SHALL CAUTION THAT THE CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSILE FOR COMPLIANCE COULD VOID THE USER`S AUTHORITY TO OPERATE THE EQUIPMENT. ***Caution*** The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Test Report ----------------------------------------------------------------------------------------------------------10/23 Report Number: RE-U02-FC-279 Test Date: Aug. 24, 2001 Wireless Audiocall Handsfree Best Laboratory Co., Ltd. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 4. Modification List for EMC Complying Test

From: Mike Kuo Sent: Wednesday, December 19, 2001 2:43 PM To: 'Jeff Chiu' Subject: RE: Application File Dear Jeff: Question #1:Answer: if this signal generator and the probe or antenna is used to generate the audio modulation, you can place these equipment on top of turn table near the EUT. Question #2: Answer:Attached please find TCB invoice. I have checked with accounting department, we have not received any payment from Apices communications. Best Regards Mike Kuo -----Original Message----- From: Jeff Chiu [mailto:[email protected]] Sent: Wednesday, December 19, 2001 3:28 AM To: Mike Kuo Subject: Application File Importance: High Dear Mike: There are two questions as below: (1) Is the signal generator and the probe or antenna must be placed on the table? Or it can be placed in far-end? Because my co-workers put them in far- end. If them must be placed on the table, I need to tell them. (2) Do you have invoice to let me show to my client that you do receive the applicant fee? If you don't have that, can I give you one , then you sign back to me? Thank you very much!!! Best Regards! ----- Original Message ----- From: Mike Kuo To: 'Jeff Chiu' Sent: Wednesday, December 12, 2001 9:22 AM Subject: FW: Application File -----Original Message----- From: Mike Kuo Sent: Tuesday, December 11, 2001 5:22 PM To: Mike Kuo Subject: RE: Application File Dear Jeff: I have reviewed the PDF file that you sent to me on 12/04/2001. Some of questions are still not acceptable. Question #1: O.K. Question #2: O.K. Question #3: If you are using the information provided in Page 31 of your PDF file. You can not copy the FCC rule part to be used as operational description.Operational Description should include but not limit to : the design theory of this RF device, how to prevent this device tune to outside the designed fundamental frequency, the antenna specification, DC power and grounding consideration etc.. Question #4: Please take a look Page 35 of PDF file. The schematic diagram is not readable. If you can not read it, so do I. Question #5: Setup Photos: EUT is placed on the center of turn table. O.K. Question #6: Page 15 of test report. O.K. Question #7: Verified. O.K. Question #8: O.K. Question #9: O.K. Question #10:O.K. Question #11:As I indicated in my previous e-mail. You can not use background noise to provide the max. audio input signal. From the test setup photos as well as test configuration diagram. There is no external audio source was used to enable max. audio input signal. This is not acceptable. You must test this device with max. audio input signal. This test condition has been mentioned by FCC to caution all TCBs to watch out the test condition. Question #12: Page 10 of test report. O.K. Question #13: This is my mistake. The required information to be included in the user manual should be 15.21 of FCC rules. Please provide revised user manual. Question #14: O.K. Best Regards Mike Kuo -----Original Message----- From: Mike Kuo Sent: Thursday, November 08, 2001 4:13 PM To: 'Jeff Chiu' Subject: RE: Application File Dear Jeff: The Grantee code is P2B. The Microsoft Word file has not information in it. Please check it again. Question #1: O.K. Grantee code is P2B. Question #2: Can not verify Question #3: Awaiting technical information. Question #4: Awaiting technical information. Question #5: Can not verify Question #6: Awaiting modification report signed by the applicant. Question #7: Based upon your statement, this device does not comply with FCC rules and regulation. You can not measure any fundamental and harmonic emission but you can measured out spurious emissions. Since the fundamental emission field strength is not measurable but spurious emissions are measurable. This means spurious emissions are higher than fundamental field strengths. In accordance to 15.209(c) requirements, spurious emissions from intentional radiator can not higher than fundamental emission field strength. Question #8: Can not verify Question #9: Can not verify Question #10:I do not understand the spectrum plot labeled Marker 1 and Delta 1. If you are trying to demonstrate compliance to 15.239(a) requirement by submitting Marker 1, then this plot does not comply with requirement. You can not use RBW of 200kHz and span 2MHZ for this requirements. You should use the span of 200kHz and RBW =1 % of span for the measurement. All emission has be within the 200kHz band. Delta 1 : what are you trying to show ? Question #11:The test condition is max. input signal. You can not just use background noise to test condition, you should use external audio signal to generate max. input signal. Question #12:Can not verify Question #13:Can not verify Question #14: User manual also indicates two frequencies. If only one fundamental frequency, user manual needs to be modified as well. Best Regards Mike Kuo / TCB Certifier -----Original Message----- From: Jeff Chiu [mailto:[email protected]] Sent: Thursday, November 08, 2001 7:36 AM To: Mike Kuo Subject: Re: Application File Importance: High Dear Mike: The following questions have to be addressed in order for the review process to be continued: Question #1: In order for us to apply the grantee code for your customer, please provide the following information: Answer #1: Company name : Apices Communication Co., Ltd. Address: 3F, No. 115, Ming De Road, Hsintien, Taipei, Taiwan Contact person's name and title: Geoff Lai / Director Telephone number: 886-2-29136881 Fax number: 886-2-29137641 E-mail address of contact person: [email protected] Question #2: This device is subject to 15.239 technical requirements. It is a Part 15 subpart C intentional radiator. It is not a Class B device. Please modify your test report. Answer #2: Please refer to the attachment Question #3: Please provide operational description as outlined in section 2.1033(b)(4) of FCC rules. Answer #3: The applicant is tring to do this. Question #4: The schematic diagram can not be read. Please provide a clear copy of sche…

Text truncated - open the document above for the full version.

Size of Label Long x Wide = 2.0 cm x 0.75 cm Position of Label This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC ID : P2BAPX-AC Model No.: APX-AC

OPERATIONAL DESCRIPTION 1. TO USE OF THE THEORY OF SHORT-DISTANCE RF MICROPHONE TO TRANSMIT SOUND.THE FUCTION IS SIMILAR TO HAND-FREE CAR KIT. 2. THIS FREQUENCY IS ONLY BE USED IN THE CAR AND THE DISTANCE IS UNDER ONE METER. 3. USE THE RETRACTABLE ROD ANTENNA. 4. THIS PRODUCT IS ONLY BE USED IN THE CAR AND USE THE POWER OF THE CAR.

Applicant : Apices Communication Co., Ltd. Equipment : Wireless Audiocall Handsfree Model : APX-AC Exhibit B Test Report FCC Test Report ----------------------------------------------------------------------------------------------------------1/23 Report Number: RE-U02-FC-279 Test Date: Aug. 24, 2001 Wireless Audiocall Handsfree Best Laboratory Co., Ltd. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 Test Report Certification Best Laboratory Co., Ltd. No. 336, Ba Lian Rd., Sec. 1, Hsi Chih City, Taipei Hsien, Taiwan, R.O.C. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 Applicant : Apices Communication Co., Ltd. Address : 3F, NO. 115, Ming De Road., Hsintien, Taipei , Taiwan, R.O.C. Equipment : Wireless Audiocall Handsfree FCC ID : P2BAPX-AC Model : APX-AC Device’s Class : Intentional Radiator Measurement Standard : FCC Part 15.239 Measurement Procedure : ANSI C63.4-1992 Operating Voltage : 1.5 VDC Test Result : Compliance (Detail showed in the test report) Sample Received : May 11, 2001 Test Date : Aug. 24, 2001 Report Number : RE-U02-FC-279 Test Firm : No. 336, Ba Lian Rd., Sec. 1, Hsi Chih City, Taipei Hsien, Taiwan, R.O.C. Remark: (1) The test report is only relating to the sample tested (2) The test report shall not be reproduced except in full, without the written approval of Best Laboratory Co., Ltd. (3) The test report must not be used by the client to claim product endorsement by NVLAP or any agency of the US Government. (4) The test result of this report are traceable to the national or international standards. Prepared : __________________________ JACKY WU Approved : __________________________ ( Title: Quality Department Manager ) JEFF CHIU Date Issued : FCC Test Report ----------------------------------------------------------------------------------------------------------2/23 Report Number: RE-U02-FC-279 Test Date: Aug. 24, 2001 Wireless Audiocall Handsfree Best Laboratory Co., Ltd. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 Contain 1 General Information 1.1 EUT Description....................................................................................................................3 1.2 Test System Detail ................................................................................................................. 4 1.3 Tested Configuration.............................................................................................................4 1.4 EUT Exercise Software.........................................................................................................5 1.5 Test Performed ....................................................................................................................... 5 2 Conducted Emission Measurement 2.1 Test Equipment List...............................................................................................................6 2.2 Test Set-Up.............................................................................................................................6 2.3 Limit ...................................................................................................................................... 6 2.4 Test Procedure........................................................................................................................7 2.5 Test Specification...................................................................................................................7 2.6 Test Result .............................................................................................................................. 7 3 Radiated Emission Measurement 3.1 Test Equipment List...............................................................................................................8 3.2 Test Set-Up............................................................................................................................8 3.3 Limit ...................................................................................................................................... 9 3.4 Test Procedure.......................................................................................................................9 3.5 Test Specification..................................................................................................................9 3.6 Test Result ............................................................................................................................. 9 4 Modification List 5 Appendix Appendix A: Summary of Test Result.........................................................................12 Appendix B: The Photograph of measurement............................................................21 FCC Test Report ----------------------------------------------------------------------------------------------------------3/23 Report Number: RE-U02-FC-279 Test Date: Aug. 24, 2001 Wireless Audiocall Handsfree Best Laboratory Co., Ltd. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 1. General Information 1.1 EUT Description Applicant : Apices Communication Co., Ltd. Address : 3F, NO. 115, Ming De Road., Hsintien, Taipei , Taiwan, R.O.C. Equipment : Wireless Audiocall Handsfree Model No. : APX-AC Kind of Product : Engineer Sample Condition of EUT : Good Device’s Class : Intentional Radiator Operation Voltage : 1.5VDC Output Ports : Battery Cell: There is one battery, 1.5VDC, size AAA, putted in the battery cell of EUT. FCC Test Report ----------------------------------------------------------------------------------------------------------4/23 Report Number: RE-U02-FC-279 Test Date: Aug. 24, 2001 Wireless Audiocall Handsfree Best Laboratory Co., Ltd. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 1.2 Test System Detail N / A 1.3 EUT Configuration (1) Put the battery into the battery cell. (2) Press one button to let EUT continuously transmit. (***PS: Please refers to the Photograph***) Drawing of Configuration EUT EUT Battery set. FCC Test Report ----------------------------------------------------------------…

Text truncated - open the document above for the full version.

FCC Test Report ----------------------------------------------------------------------------------------------------------23/23 Report Number: RE-U02-FC-279 Test Date: Aug. 24, 2001 Wireless Audiocall Handsfree Best Laboratory Co., Ltd. Tel: 886-2-2646-2899 Fax: 886-2-2646-2870 The Photograph of Radiated Emission Test