P5A-BL0002WIRELESS MOUSE

MCU CR81P200 Battery AAA*2 DC-DC 3V Regulator 3V Sensor IC PAN3601 M I S O S C L K EEPROM 93CC46 RF Transmit Circuit (double the carrier wave to 27.045MHz) R F - D A T A R F - P W R ANT Load oscillator 13.5225MHz 12M MOSI 4M PDF created with pdfFactory trial version www.pdffactory.com

EUT - Front View EUT - Back View

FCC ID Label Sample for Model: L122 FCC ID: P5A-BL0002 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC ID Label This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The Label must not be a stick-on paper. The Label on these products must be permanently affixed to the product and readily visible at the time of purchase and must last the expected lifetime of the equipment not be readily detachable. Proposed Label Location on EUT EUT Bottom View/proposed FCC Mark Location FCC ID: P5A-BL0002

PCB- Front View PCB- Back View

1. Two batteries supply the power of the circuit ‘s working . 2. DC-DC regulator rised the voltage to 3V. 3. The oscillator ,give clock frequency of the IC.. 4. When press any key, the MCU can catch the action by the voltage level’s change. 5. The optical sensor scan the interface, estimate brightness changes, and transform the information to the digital signal, then send to MCU. 6. When the MCU received the signals, it will code them and then transmit them to the antenna network 7. Channel and address information store in the EEPROM. 8. The center frequency of the RF transmission is 27.045MHz. PDF created with pdfFactory trial version www.pdffactory.com

123456 A B C D 6 54321 D C B A RTCC 1 VDD 2 PB5 3 VSS 4 PB4 5 PB0 6 PB1 7 PB2 8 PB3 9 PA0 10 PA1 11 PA2 12 PA3 13 PA4 14 PA5 15 PA6 16 PA7 17 PC0 18 PC1 19 PC2 20 PC3 21 PC4 22 PC5 23 PC6 24 PC7 25 OSC2 26 OSC1 27 RESET 28 RF DATA NCS MISO SCLK LB RB MB B4 B5 MOSI SEL PD SSS E2_CS LED2 LED3 LED4 RF_PWR EN_Z Z1 Z2 27M U2 AP16CMP57AD CS 1 SK 2 DI 3 DO 4 GND 5 ORG 6 NC 7 VCC 8 U3 93C46 VDD 1 1 2 2 C6 0.1uF C4 0.1uF R2 470K C3 0.1uF VDD R1 22K Y1 4M C9 20p C10 20p SENSOR -90 VDD SENSOR 180 GND SENSOR 90 VDD SENSOR 0 GND SW1 LB SW2 RB SW3 MB SW6 ID R7 470K R8 470K R9 470K R5 470K R10 470K R6 470K D4 4148 D3 4148 R3 470K R4 470K R27 330 SCLK MISO VDD RF-DATA RF-PWR R16 20K VCC R11 470K R13 470K VDD VDD L1 22-200uH C1 0.1uF C7 47-100uF C2 0.1uF C8 47-100uF POWER VDDVCC dc+ 2 dc- 1 k 3 DC DC-3 S1 SCLK MISO SENSOR 123 C O M 1 ZA 2 ZB 3 K3 ENCODE RF-DATA RF-PWR VDD 27M-RF R12 470K VDD Q7 2SC5226 Q6 2SC5226 Q5 2SC5226 C27 100p C15 104 C26 50P C24 150P C22 68p C21 102 C28 200p C25 150p R35 82k R26 10 R25 10 R34 1.5k R24 10k R33 27k R32 4.7k R31 4.7k y3 13.5225MHz L2 0.33uH D6 BB149 RF PWR VDD C29 220p Q4 3906 R23 2K C23 15p C16 104 C13 CAP 1 2 3 4 5 6 7 8 9 1011 12 13 14 15 16 17 18 19 20 U4 PIN3601 y2 Y D5LED R19 51 C19 10uF C15 104 C20 1uF C18 104 R18 100 VDD D1 NPN1 1 1 2 2 3 3 U1 AM3.0 R17 100 PD PD R37 10K VCC R36 470K D2 LED 核准：審核： 制圖：韋志勇 PDF created with pdfFactory trial version www.pdffactory.com

FCC TEST REPORT Page 1 of 22 FCC ID : P5A-BL0002 Applicant : Areson Technology Corporation 12F, No.111-6, Hsing-De Rd. SanChung, Taipei Hsien, Taiwan Equipment Under Test (EUT) : Product description : Wireless Mouse Model No. : L122 Standards : FCC 15 Subpart C Paragraph 15.227 Date of Test : March 7, 2007 Test Engineer : Tiger Su Reviewed By : PERPARED BY: Waltek Services (Shenzhen) Co., Ltd. 8C,West Tower, Aidi Building, No.5003 Binhe Rd, Futian District, Shenzhen518045, Guangdong, China. Tel: 86-755-83551033 Fax: 86-755-83552400 Areson Technology Corporation FCC ID: P5A-BL0002 Page 2 of 22 2 Contents Page 1 COVER PAGE..........................................................................................................................................................1 2 CONTENTS ..............................................................................................................................................................2 3 TEST SUMMARY....................................................................................................................................................5 4 GENERAL INFORMATION..................................................................................................................................6 4.1 CLIENT INFORMATION............................................................................................................................................6 4.2 GENERAL DESCRIPTION OF E.U.T...........................................................................................................................6 4.3 DETAILS OF E.U.T. .................................................................................................................................................6 4.4 DESCRIPTION OF SUPPORT UNITS...........................................................................................................................6 4.5 STANDARDS APPLICABLE FOR TESTING..................................................................................................................6 4.6 TEST FACILITY........................................................................................................................................................7 4.7 TEST LOCATION......................................................................................................................................................7 5 EQUIPMENT USED DURING TEST ...................................................................................................................8 6 CONDUCTED EMISSION TEST ..........................................................................................................................9 6.1 TEST EQUIPMENT....................................................................................................................................................9 6.2 TEST PROCEDURE...................................................................................................................................................9 6.3 CONDUCTED TEST SETUP.....................................................................................................................................10 6.4 EUT OPERATING CONDITION...............................................................................................................................10 6.5 CONDUCTED EMISSION LIMITS.............................................................................................................................11 6.6 CONDUCTED EMISSION TEST RESULT...................................................................................................................11 7 RADIATION EMISSION TEST...........................................................................................................................12 7.1 TEST EQUIPMENT..................................................................................................................................................12 7.2 MEASUREMENT UNCERTAINTY.............................................................................................................................12 7.3 TEST PROCEDURE.................................................................................................................................................12 7.4 RADIATED TEST SETUP.........................................................................................................................................13 7.5 SPECTRUM ANALYZER SETUP...............................................................................................................................14 7.6 CORRECTED AMPLITUDE & MARGIN CALCULATION............................................................................................14 7.7 SUMMARY OF TEST RESULTS................................................................................................................................14 7.8 EUT OPERATING CONDITION...............................................................................................................................15 7.9 RADIATED EMISSIONS LIMIT.................................................................................................................................15 7.10 RADIATED EMISSIONS TEST RESULT................................................................................................................16 7.11 RADIATED EMISSION TEST DATA.....................................................................................................................16 8 OCCUPIED BANDWIDTH ..................................................................................................................................17 8.1 TEST PROCEDURE.................................................................................................................................................17 9 PHOTOGRAPHS OF TESTING.................................................................................................................…

Text truncated - open the document above for the full version.

Radiation Emission Test View