PI3-CARRIER-F-20MRFID Patrol Data Carrier

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help. CAUTION: Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment.

MCU Oscillator 4M HZ LCM Display Real Time Clock & SRAM Power Supply 1.5V x 2 Key Board & Buzzer RFID Transceiver Oscillator 4M Hz UART Interface

Report No.: 01CH018FI Page: 1 of 1 Version:1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo

SUMMIT AUTOMATION CO., LTD. 2F, NO. 68, CHUNGKUANG 1 ST RD., TAICHUNG CITY, TAIWAN, R.O.C. TEL: 886-4-2350-9197 FAX: 886-4-2358-6825 FCC ID.: PI3-CARRIER-F-20M FCC ID Label Sample RFID Patrol Data Carrier Model No.: F-20M, F-18M, F-20, F-18 F F C C C C I I D D : : P P I I 3 3 - - C C A A R R R R I I E E R R - - F F - - 2 2 0 0 M M This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. S/N: Made in Taiwan

SUMMIT AUTOMATION CO., LTD. 2F, NO. 68, CHUNGKUANG 1 ST RD., TAICHUNG CITY, TAIWAN, R.O.C. TEL: 886-4-2350-9197 FAX: 886-4-2358-6825 FCC ID.: PI3-CARRIER-F-20M LabelLoc The FCC ID and DoC Label will be placed on the equipment as shown in the photograph below.

Report No.: 01CH018FI Page: 1 of 4 Version:1.0 Attachment 2 : EUT Detailed Photographs (1) EUT Photo (2) EUT Photo Report No.: 01CH018FI Page: 2 of 4 Version:1.0 (3) EUT Photo (4) EUT Photo Report No.: 01CH018FI Page: 3 of 4 Version:1.0 (5) EUT Photo Report No.: 01CH018FI Page: 4 of 4 Version:1.0 (6) EUT Photo

1.1. EUT Description The EUT is a DC operated lock with 134.2kHz transmitter and its associated key with passive tag reflector for code confirmation. The IC TMS3705A from TI was used as the transponder device by 4MHz clock. A 2cm *1cm multi-turn inductive loop was connected to the device as the transmitter antenna. The passive tag will reflect the matched energy to the EUT.

Report No. 01CH018FI Page : 1 of 19 Version:1.0 Test Report Product Name : RFID Patrol Data Carrier Model No. : F-20M, F-18M, F-20, F-18 FCC ID.: PI3-CARRIER-F-20M Report No. 01CH018FI Page : 3 of 19 Version:1.0 TABLE OF CONTENTS Description Page 1. GENERAL INFORMATION .....................................................................................................4 1.1. EUT Description ..........................................................................................................................................4 1.2. EUT Description ..........................................................................................................................................4 1.3. Tested System Details..................................................................................................................................5 1.4. Configuration of tested System ....................................................................................................................6 1.5. EUT Exercise Software................................................................................................................................6 1.6. Test Facility..................................................................................................................................................7 2. Conducted Emission....................................................................................................................8 2.1. Test Equipment List .....................................................................................................................................8 2.2. Test Setup .....................................................................................................................................................8 2.3. Limits ...........................................................................................................................................................9 2.4. Test Procedure..............................................................................................................................................9 2.5. Test Result....................................................................................................................................................9 3. Radiated Emission .....................................................................................................................10 3.1. Test Equipment ..........................................................................................................................................10 3.2. Test Setup ...................................................................................................................................................10 3.3. Limits .........................................................................................................................................................11 3.4. Test Procedure............................................................................................................................................11 3.5. Test Result..................................................................................................................................................11 4. EMI Reduction Method During Compliance Testing ............................................................12 5. Summary of Test Datas .............................................................................................................13 5.1. Test Data of Conducted Emission ..............................................................................................................14 5.2. Test Data of Radiated Emission .................................................................................................................15 Attachment 1: EUT Test Photographs Attachment 2: EUT Detailed Photographs Reference : Laboratory of License Report No. 01CH018FI Page : 4 of 19 Version:1.0 1. GENERAL INFORMATION 1.1. EUT Description Product Name : RFID Patrol Data Carrier Trade Name : SUMMIT FCC ID. : PI3-CARRIER-F-20M Model No. : F-20M, F-18M, F-20, F-18 RS232 Cable : Shielded, 1.8m Note: 1. This EUT is a RFID Patrol Data Carrier. 2. This device is a composite device in accordance with Part 15 regulations. The function for the receiver was, measured and made a test report that the report number is 01CH018F, certified under verification. 3. QuieTek has verified all construction and function in typical operation. All the test modes were carried out with the EUT in normal operation, which was shown in this test report and defined as: Test Mode: Mode 1: Transmit 1.2. EUT Description The EUT is a DC operated lock with 134.2kHz transmitter and its associated key with passive tag reflector for code confirmation. The IC TMS3705A from TI was used as the transponder device by 4MHz clock. A 2cm *1cm multi-turn inductive loop was connected to the device as the transmitter antenna. The passive tag will reflect the matched energy to the EUT. Report No. 01CH018FI Page : 5 of 19 Version:1.0 1.3. Tested System Details The types for all equipment, plus descriptions of all cables used in the tested system (including inserted cards ) are: Product Manufacturer Model No. Serial No. Power Cord FCC ID (1) Notebook DELL PP01L 2724903568 Non-shielded, 1.8m DoC (2) Monitor HITACHI CM752ET-311 T8D003312 Shielded, 1.8m DoC (3) Mouse Logitech M-S34 LZA82474119 -- DZL211029 (4) USB Mouse Logitech M-UE55 LTC93813273 -- DoC (5) Printer HP C2642A MY75L1D2XN Non-Shielded, 0.7m B94C2642X (6) Speaker JS J-008 99-D-235399-D -- -- (7) Microphone AIWA CD-8000 N/A -- DoC Signal Cable Type Signal cable Description A. VGA Cable Shielded, 1.8m, two ferrite cores bonded B. Mouse Cable Shielded, 1.8m C. USB Mouse Cable Shielded, 1.0m D. Printer Cable Shielded, 1.2m E. RS232 Cable Shielded, 1.8m F. Microphone Cable Non-shielded, 1.8m G. Speaker Cable Non-shielded, 1.8m Report No. 01CH018FI Page : 6 of 19 Version:1.0 1.4. Configurat…

Text truncated - open the document above for the full version.

Report No.: 01CH018FI Page: 1 of 2 Version:1.0 Attachment 1: EUT Test Setup Photographs Front View of Radiated Test-Loop (Mode 1) Back View of Radiated Test- Loop (Mode 1) Report No.: 01CH018FI Page: 2 of 2 Version:1.0 Front View of Radiated Test (Mode 1) Back View of Radiated Test (Mode 1)