Q2I20152IWireless Door Chime

Receiver unit (Fig.1) (Fig.2) (Fig.3) (Fig.4) Pairing Method Press the button one time in the receiver, to replay the current sound Hold the button for 5 seconds,the receiver will have “Ding-Ding” sounds.then turn on the sensor until the receiver has “Ding” means pairing between sensor and receiver is completed. It will have another “Ding-Ding” to exit pairing status.   Item No.:I - 228P The sensor can be mounted on wall or put on the table. The chime can be put on table or put to the strap. Installation S Power on the item elect Sound Plug in the receiver Receiver uses 120V main power. Sensor uses 3x1.5V AAA Batteries Sounds electionS There are 32 sounds selectable for user. The desired tune can be selected by pressing the button inside the sensor . Sensor Unit (Sounds ) e d i s n I t c e l e S O N O F F Sound Selection/Pairing Button The desired sound can be selected by pressing this Button.(32 sounds) Shunde Advante Electron LTD. Wireless Door Chime Installation Instructions AC 120V This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment.

Shunde Advante Electron Ltd. North Second XinXi Road, LunJiao Industrial Avenue LunJiao, Shunde, Foshan, Guangdong, China 2015-12-25 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Confidentiality Request regarding application for certification of FCC ID: Q2I20152I We hereby request confidential treatment of information accompanying this application as outlined below: - schematics - Block diagram - operational description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Steven Zou Technical Manager Tel: 86-757-29995218-333 Fax: 86-757-25663105 E-mail: [email protected]

Shunde Advante Electron Ltd. North Second XinXi Road, LunJiao Industrial Avenue LunJiao, Shunde, Foshan, Guangdong, China Letter of Agency 2015-12-25 To whom it may concern, I, an officer of Shunde Advante Electron Ltd. do hereby authorize Dongguan NTC Co., Ltd. (Mr. Jees Hong) to act on our behalf in front of the Federal Communications Commission with respect to all matters relating to certification of equipment under Part 15 and/or Part 74 of the FCC Rules until further notice. I further certify that no party (as defined in §1.2002(b) of CFR 47.2007) to this application, including myself, is subject to a denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988. 21 U.S.C., 862. Sincerely, Steven Zou Technical Manager Tel: 86-757-29995218-333 Fax: 86-757-25663105 E-mail: [email protected]

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I External photo Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I

43mm x 24mm Label Volta gge: DC 4.5V MODEL: I FCC ID: Q2I20152I Label Location

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Internal photo Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I RF ANT

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Page 2 of 19 Table of Contents 1. GENERAL INFORMATION ................................................................................................ 3 1.1 PRODUCT DESCRIPTION FOR EQUIPMENT UNDER TEST.................................................................... 3 1.2 RELATED SUBMITTAL(S) / GRANT (S) ................................................................................................ 4 1.3 TEST METHODOLOGY....................................................................................................................... 4 1.4 EQUIPMENT MODIFICATIONS............................................................................................................ 4 1.5 SUPPORT DEVICE............................................................................................................................ 4 1.6 TEST FACILITY AND LOCATION.......................................................................................................... 4 1.7 SUMMARY OF TEST RESULTS........................................................................................................... 5 2. RADIATED EMISSION TEST............................................................................................. 6 2.1 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)..................................................................... 6 2.2 MEASUREMENT PROCEDURE........................................................................................................... 7 2.3 LIMIT................................................................................................................................................ 7 2.4 MEASUREMENT RESULTS ..................................................................................................... 10 3. OCCUPIED BANDWIDTH ................................................................................................ 14 3.1 MEASUREMENT PROCEDURE......................................................................................................... 14 3.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 14 3.3 LIMIT.............................................................................................................................................. 14 3.4 MEASUREMENT RESULTS............................................................................................................... 14 4 TRANSMISSION TIME...................................................................................................... 16 4.1 MEASUREMENT PROCEDURE......................................................................................................... 16 4.2 TEST SET-UP (BLOCK DIAGRAM OF CONFIGURATION)................................................................... 16 4.3 LIMIT.............................................................................................................................................. 16 4.4 MEASUREMENT RESULTS............................................................................................................... 16 5. ANTENNA APPLICATION ............................................................................................... 18 5.1 ANTENNA REQUIREMENT................................................................................................................ 18 5.2 MEASUREMENT RESULTS............................................................................................................... 18 6. TEST EQUIPMENT LIST.................................................................................................. 19 Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Page 3 of 19 1. GENERAL INFORMATION 1.1 Product Description for Equipment under Test This device is a WIRELESS DOOR CHIME which is powered by 3*1.5V AAA batteries. For more details features, please refer to User’s Manual. Manufacturer/ Factory : Shunde Advante Electron Ltd. Address : North Second XinXi Road, LunJiao Industrial Avenue LunJiao, Shunde, Foshan, Guangdong, China Frequency: : 433.92MHz Modulation : ASK Antenna Type : PCB Antenna Gain : 0dBi Number of Channels : 1 Power supply : DC 3*1.5V AAA Battery Model name : I, IP (We prepare model I for EMC test.) Model difference Description : Both of models have the same circuitry, PCB layout, electrical mechanical and physical construction. Their difference in model number for trading purpose. Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Page 4 of 19 1.2 Related Submittal(s) / Grant (s) This submittal(s) (test report) is intended for FCC ID: Q2I20152I filing to comply with Section 15.231 of the FCC Part 15 (2014), Subpart C Rule. 1.3 Test Methodology The radiated emission measurement was performed according to the procedures in ANSI C63.10 (2013). Radiated emission measurement was performed in semi-anechoic chamber. For radiated emission measurement, preliminary scans were performed in the semi-anechoic chamber only to determine the worst case modes. All radiated tests were performed at an antenna to EUT distance of 3 meters. 1.4 Equipment Modifications Not available for this EUT intended for grant. 1.5 Support Device None 1.6 Test Facility and Location Listed by FCC, July 03, 2014 The Certificate Registration Number is 665078. Listed by Industry Canada, June 18, 2014 The Certificate Registration Number is 9743A. Dongguan NTC Co., Ltd. (Full Name: Dongguan Nore Testing Center Co., Ltd.) Building D, Gaosheng Science and Technology Park, Hongtu Road, Nancheng District, Dongguan City, Guangdong, China (Full Name: Building D, Gaosheng Science & Technology Park, Zhouxi Longxi Road, Nancheng District, Dongguan, Guangdong, China. Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Page 5 of 19 1.7 Summary of Test Results FCC Rules Description Of Test Result …

Text truncated - open the document above for the full version.

Dongguan Nore Testing Center Co., Ltd. Report No.: NTC1512004F FCC ID: Q2I20152I Test photo Radiated emission