Q2RSA-908BLUETOOTH SPEAKER

FCC STATEMENT 1.This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: 1.This device may not cause harmful interference. 2.This device must accept any interference reveived,including interference that may cause undesired operation 2Changers or modifications not epressly approved by the party responsible for compliance could void the user's authority to operate the equipment NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules,These limits are designed to provide reasonable protection agaimst harmful interference in a residential installation This equipment generates uses and can radiate radio frequency energy and,if not installed and used in accordance with the nstructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a particular installation .If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures: Recorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outler on a circuit didderent from that to which the receiver is connected. Consult the dealer or an expeienced radio/TV technician for help. RF warning statement: The device has been evaluated to meet general RF exposure requirement.The device can be used in portable exposure condition without restriction 8 Safety Instructions This product is specially designed based on the full attention to safety, in order to make sure the accident-free operation, please abide the guidelines listed below: Always position the unit on a stable and level surface. Unstable surface can cause the unit to topple and fall, resulting in possible damage or injury. Do not drop, unpack, open, beat, curve, prink and burn the unit. Avoid using the unit nearby basins or sinks where it may come in contact with water. Do not place any ware with full water on the top of the unit, such as vase, glass, pot, and please avoid placing candle on the speaker surface as well. Protect the using of the unit from any overheating devices (such as radiator, heating installation, cooking stove or other heating devices) Regardless of what reasons cause the unit damage, please ask for the maintenance personnel to repair If you want to do the cleaning, please turn off the unit and unplug the power cable from the outlet first. Set the volume properly to prevent injury to the unit and your health. WARNING: The battery (battery or batteries or battery pack) shall not be exposed to excessive heat such as sunshine, fire or the like. Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. No naked flame sources, such as lighted candles, should be placed on the apparatus. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. If the unit will not be used for an extended period of time, unplug the power cord and place the unit with accessories into the package. Do not set the unit in a damp, high temperature or the sun point-blank place. 5

SCS-F18: Project and Product Certification Representative Authorization Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Project and Product Certification Representative Authorization Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Revised wording (obsolete) 1.0 2.0 Sept–25-2007 Updated company template (current) 2.0 3.0 Jan-31-2012 SCS-F18: Project and Product Certification Representative Authorization Letter Page 2 of 2 Rev 3.0 Dongguan Shengyu Electronic Technology CO.,LTD NO.180 Kang Yi Road, ChangShanTou Village, QingXi Town, DongGuan, GuangDong, China 523657 2012/9/25 To: SIEMIC, INC. 775 Montague Expressway, Milpitas, CA 95035 USA Dear Sir/Madam, Re: Project and Product Certification Representative Authorization Letter We, Dongguan Shengyu Electronic Technology CO.,LTD hereby authorize SIEMIC, INC. to act as a Certification Body for certifying for the following project(s): Product description: BLUETOOTH SPEAKER model name: SA-W908 FCC ID: Q2RSA-908 We affirm that between SIEMIC and Dongguan Shengyu Electronic Technology CO.,LTD , any difference in understanding, including test plan, measurement methods, applicable standards and relevant procedures and processes have been resolved prior to commencement of testing activities. Sincerely, Client’s signature : Client’s name / title : Andy.Liu/ Deputy General Manager Contact information / address: NO.180 Kang Yi Road, ChangShanTou Village, QingXi Town, DongGuan, GuangDong, China 523657

SCS-F19: Confidentiality Request Letter Page 1 of 2 Rev 3.0 775 Montague Expressway Milpitas, CA 95035 Tel: 408-526-1188 Fax: 408-526-1088 Email: [email protected] Confidentiality Request Letter Revision History Reason for Amendment (current / obsolete) From To Approved Date Initial Release (obsolete) 1.0 1.0 Nov-14-2006 Adding CFR 2.459 (obsolete) 1.0 2.0 August – 11 - 2008 Updated company template & Added text box (current) 2.0 3.0 Jan-31-2012 SCS-F19: Confidentiality Request Letter Page 2 of 2 Rev 3.0 Dongguan Shengyu Electronic Technology CO.,LTD NO.180 Kang Yi Road, ChangShanTou Village, QingXi Town, DongGuan, GuangDong, China 523657 2012/9/25 To: Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD Subject: Permanent Confidentiality Request for FCC ID: Q2RSA-908 We hereby request confidential treatment of information accompanying this application as outlined below: - Block Diagram - Schematics - Operational Description The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 & 0.459 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Client’s signature : Client’s name / title : Andy.Liu/ Deputy General Manager Contact information / address: NO.180 Kang Yi Road, ChangShanTou Village, QingXi Town, DongGuan, GuangDong, China 523657

External Photo External Photo External Photo

Label location

FCC ID: Q2RSA-908 EST Technology Co.,Ltd Report No.ESTE-R1209017 Page 85 of 86 Internal Photos M/N:SA-W908 FCC ID: Q2RSA-908 EST Technology Co.,Ltd Report No.ESTE-R1209017 Page 86 of 86 Internal Photos M/N:SA-W908

DONGGUAN ALLLIKE ELECTRONIC CO.,LTD Dongguan Shengyu Electronic Technology CO.,LTD BLUETOOTH SPEAKER Model Number: SA-W908 Additional Model: SA-W908II; SA-W908III e-Storm; e-StormII; SA-W901; SA-W903; SA-W905; SA-W906; SA-W909; SA-W910; SA-W912; SA-W913; SA-W915; SA-W916; SA-W918 FCC ID: Q2RSA-908 Prepared for : Dongguan Shengyu Electronic Technology CO.,LTD NO.180 Kang Yi Road, ChangShanTou Village, QingXi Town, DongGuan, GuangDong, China 523657 Prepared By : EST Technology Co., Ltd. Santun(guantai Road), Houjie Town, DongGuan City,GuangDong, China. Tel: 86-769-83081888-808 Report Number: ESTE-R1209018 Date of Test : Sep 5, 2012 ~ Sep 19, 2012 Date of Report : Sep 20,2012 FCC ID : Q2RSA-908 Portable device According to §15.247(e)(i) and §1.1307(b)(1), systems operating under the provisions of this section shall be operated in a manner that ensures that the public is not exposed to radio frequency energy level in excess of the Commission’s guidelines. According to KDB 447498 (2)(a)(i) Frequency Range Low Frequency (MHz) High Frequency(MHz) Center frequency (MHz) 60/f SAR Limitation (mw) 2402 2480 2441 25 Maximum measured transmitter power Bluetooth Basic Rate Freq (MHz) Conducted Power (mw) Max Antenna Gain (dBi) EIRP (mw) 2402 0.328 2 2.328 2441 0.235 2 2.235 2480 0.202 2 2.202 Maximum measured transmitter power Bluetooth Mode EDR 3Mbps Freq (MHz) Conducted Power (mw) Max Antenna Gain (dBi) EIRP (mw) 2402 0.217 2 2.217 2441 0.212 2 2.212 2480 0.208 2 2.208 Threshold at which no SAR required is 25 mw. Maximum Tx power is 2.328mw EIRP. Conclusion: No SAR is required. SIMULTANEOUS TRANSMISSION EVALUATION N/A

FCC ID: Q2RSA-908 EST Technology Co.,Ltd Report No.ESTE-R1209017 Page 1 of 86 FCC PART 15C TEST REPORT FOR CERTIFICATION On Behalf of Dongguan Shengyu Electronic Technology CO.,LTD BLUETOOTH SPEAKER Model Number: SA-W908 FCC ID: Q2RSA-908 Prepared for : Dongguan Shengyu Electronic Technology CO.,LTD NO.180 Kang Yi Road, ChangShanTou Village, QingXi Town, DongGuan, GuangDong, China 523657 Prepared By : EST Technology Co., Ltd. Santun(guantai Road), Houjie Town, DongGuan City,GuangDong, China. Tel: 86-769-83081888-808 Report Number: ESTE-R1209017 Date of Test : Sep 5, 2012 ~ Sep 19, 2012 Date of Report : Sep 20, 2012 FCC ID: Q2RSA-908 EST Technology Co.,Ltd Report No.ESTE-R1209017 Page 2 of 86 TABLE OF CONTENTS Description Page TEST REPORT VERIFICATION.........................................................................................................................3 1. GENERAL INFORMATION.................................................................................................................5 1.1. Description of Device (EUT) ........................................................................................................... 5 2. SUMMARY OF TEST.........................................................................................................................6 2.1. Summary of test result...................................................................................................................... 6 2.2. Test Facilities ................................................................................................................................... 7 2.3. Assistant equipment used for test ..................................................................................................... 8 2.4. Block Diagram ................................................................................................................................. 8 2.5. Test mode ......................................................................................................................................... 8 2.6. Test Equipment................................................................................................................................. 9 3. MAXIMUM PEAK OUTPUT POWER.................................................................................................10 3.1. Limit ............................................................................................................................................... 10 3.2. Test Procedure ................................................................................................................................ 10 3.3. Test Result ...................................................................................................................................... 10 3.4. Test Data ........................................................................................................................................ 11 4. 20 DB BANDWIDTH.......................................................................................................................15 4.1. Limit ............................................................................................................................................... 15 4.2. Test Procedure ................................................................................................................................ 15 4.3. Test Result ...................................................................................................................................... 15 4.4. Test Data ........................................................................................................................................ 16 5. CARRIER FREQUENCY SEPARATION..............................................................................................20 5.1. Limit ............................................................................................................................................... 20 5.2. Test Procedure ................................................................................................................................ 20 5.3. Test Result ...................................................................................................................................... 20 5.4. Test Data ........................................................................................................................................ 21 6. NUMBER OF HOPPING CHANNEL..................................................................................................25 6.1. Limit ............................................................................................................................................... 25 6.2. Test Procedure ................................................................................................................................ 25 6.3. Test Result ...................................................................................................................................... 25 6.4. Test Data ........................................................................................................................................ 26 7. DWELL TIME.................................................................................................................................28 7.1. Limit ............................................................................................................................................... 28 7.2. Test Result ...................................................................................................................................... 28 7.3. Test Data ........................................................................................................................................ 29 8. RADIATED EMISSIONS....................................................................................................................35 8.1. Limit ........................…

Text truncated - open the document above for the full version.

FCC ID: Q2RSA-908 EST Technology Co.,Ltd Report No.ESTE-R1209017 Page 83 of 86 11. TEST SETUP PHOTO Radiated Test (30-1000 MHz) Radiated Test (1000-25000 MHz)