Q8IM189MK2Maritime Broadband Radio

G210–56/3 December 2021 © Kongsberg Seatex AS MBR 189 Maritime Broadband Radio Instruction Manual Kongsberg Seatex AS www.kongsberg.com Document information • Product: MBR 189 • Hardware version: MK2 • Document: Instruction Manual • Document part number: G210–56 Copyright The information contained in this document remains the sole property of Kongsberg Seatex AS. No part of this document may be copied or reproduced in any form or by any means, and the information contained within it is not to be communicated to a third party, without the prior written consent of Kongsberg Seatex AS. Warning The equipment to which this manual applies must only be used for the purpose for which it was designed. Improper use or maintenance may cause damage to the equipment and/or injury to personnel. You must be familiar with the contents of the appropriate manuals before attempting to operate or work on the equipment. Kongsberg Seatex disclaims any responsibility for damage or injury caused by improper installation, use or maintenance of the equipment. Disclaimer Kongsberg Seatex AS endeavours to ensure that all information in this document is correct and fairly stated, but does not accept liability for any errors or omissions. Support information If you require maintenance or repair, contact Kongsberg Maritime’s support organisation. You can contact us using the following address:[email protected]. If you need information about our other products, visithttp: //www.kongsberg.com. G210–56/33 Table of contents ABOUT THIS MANUAL..............................................................7 MBR 189..................................................................................8 System description.............................................................................................................8 System diagram..................................................................................................................9 Scope of supply................................................................................................................10 Restrictions in guarantee..................................................................................................10 Radio frequency license...................................................................................................11 FCC compliance statement..............................................................................................11 Health and safety..............................................................................................................11 Network security..............................................................................................................12 Support information.........................................................................................................13 OPERATION...........................................................................14 Getting started..................................................................................................................14 Turning on the Radio Unit......................................................................................14 Enabling contact with the Radio Unit....................................................................15 De!ning the IP address on the computer's network adapter ..................................16 Operating procedures.......................................................................................................18 Setting up the radio site for operation....................................................................18 Joining a wireless network.....................................................................................22 Editing an existing radio network ..........................................................................23 Adding or removing equipment .............................................................................25 Enabling the embedded MBR link crypto..............................................................26 Checking the status of the MBR network ..............................................................27 User preference procedures..............................................................................................28 Selecting colour palette for display........................................................................28 User interface...................................................................................................................29 Operational principles............................................................................................29 Display organisation...............................................................................................29 Display views.........................................................................................................30 Functions and dialog boxes..............................................................................................35 Menu system...........................................................................................................36 MBR Con!guration Wizard...................................................................................37 Con!guration guide................................................................................................37 Create site...............................................................................................................38 Add radios to site....................................................................................................39 Con!gure site .........................................................................................................40 Local Host List.......................................................................................................42 Instruction Manual 4 G210–56/3 Status......................................................................................................................43 …

Text truncated - open the document above for the full version.

Nemko Canada Inc 303 River Road Ottawa, Ontario Canada K1V 1H2 Attn: Reviewing engineer Deres ref/Your ref Vår ref/Our ref Dato/Date David Møller Hagen 09/12/2022 MBR 189 MK2 FCC certification – Cover letter This is to request Nemko Canada Inc to provide the required service enabling us to achieve FCC certification for the MBR 189 MK2 equipment manufactured by Kongsberg Seatex AS. The Maritime Broadband Radio is a smart antenna designed for use in maritime applications where digital high- speed reliable communication and data transfer is crucial for efficient and safe operation. The MBR 189 MK2 version has a phased array consisting of 60 antennas and can in real-time adjust the signal phase in order to increase gain in the direction of the receiver. Yours faithfully _________________________________ David Møller Hagen

28/11/2022 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: Q8IM189MK2 Product Name: MBR 189 MK2 Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential: • Schematics/Circuit diagram • Block diagram • Part list/Bill of materials • Theory of operation/Operational description These items contain detailed system and equipment description and related information about the product which Kongsberg Seatex AS consider to be proprietary, confidential and a custom design which otherwise would not be released to the general public. The information are trade secrets. Since this design is a basis from which future technological products will evolve, Kongsberg Seatex AS also feel that this information would be of benefit to our competitors, and that the disclosure of the listed information would give our competitors unjustified benefits in the market. Dated this 28 Day of November 20 22 By: David Møller Hagen Signature Printed Title: Project Manager On behalf of : Kongsberg Seatex AS Telephone: +47 73545500

FCC Exhibit – External Photos - MBR 189 MK2 Front: Side: Rear:

FCC Exhibit – Product label - MBR 189 MK2 The marking plates are fixed with a self-adhesive tape on the aluminium parts of the product. The label is made from an industrial moulded material designed for unprotected outdoor use, corresponding to an ingress protection IP66. The marking plate has been tested with isopropyl alcohol and a mechanical test as specified in ExTAG/67/CD. The marking is highly durable. The label is located at the rear side of the product:

FCC Exhibit – Internal Photos - MBR 189 MK2 Internal Parts:

Exhibit – Tune-up tolerance statement The output power variation due to frequency and temperature is +1 to -3 dB from the stated nominal figures.

FCC ID: Q8IM189MK2 FCC 1.1307(b)(3)(i)(B) Determination of Exemption for Single RF Sources Average Output Power, Conducted 1000.00 mW Average Output Power, Radiated 1050.00 mW Separation Distance d (cm)(valid for d ≤ 40 cm) d (cm) 20.00 cm Frequency f (GHz) (valid for f ≥ 300MHz and f ≤ 6 GHz) f (GHz) 5.84 GHz ERP @20cm (mW) ERP 20cm 3060 value used in Threshold calculation x 2.09 Threshold value at Separation distance d (mW) P th (mW) 3060.00 mW Verdict: EXEMPTED Values above are valid for Single Source RF transmi tters Valid when available maximum time-averaged power or ERP is less than or equal to the Threshold Only valid for frequency ≥300MHz and ≤6GHz, not valid for other frequencies Valid for Separation Distance ≤40cm. Alternatively, use values in FCC 1.1307 Tabl e 1. Threshold Value is 1 mW for separation distance les s than 0.5cm

Report No. 466874-06-R00 Template version: C Nemko Group Nemko Scandinavia AS, Instituttveien 6, 2027 Kjeller, Norway TEL +47 22 96 03 30 EMAIL [email protected] nemko.com/no Test Report Product Maritime Broadband Radio Name and address of the applicant Kongsberg Seatex AS Havnegata 9 N-7010 Trondheim, Norway Name and address of the manufacturer Kongsberg Seatex AS Havnegata 9 N-7010 Trondheim, Norway Model MBR 189 MK2 Rating 300W (24-48 V DC ) Trademark Additional information Operates in U-NII-3 band Tested according to FCC Part 15.407 Unlicensed National Information Infrastructure Devices (U-NII) Industry Canada RSS-247, Issue 2 Licence-Exempt Local Area Network (LE-LAN) Devices Order number 466874 Tested in period 2022-06-29 to 2022-11-25 Issue date 2022-11-28 Name and address of the testing laboratory Instituttveien 6 Kjeller, Norway www.nemko.com CAB Number FCC: NO0001 ISED: NO0470 An accredited technical test executed under the Norwegian accreditation scheme Prepared by [Frode Sveinsen] Approved by [Jan G. Eriksen] This report shall not be reproduced except in full without the written approval of Nemko. Opinions and interpretations expressed within this report are not part of the current accreditation. This report was originally distributed electronically with digital signatures. For more information contact Nemko. TEST REPORT FCC Part 15.407 Report no.: 466874-06-R00 FCC ID: Q8IM189MK2 Nemko Scandinavia Page 2 (26) Revision history Revision Date Comment Sign 00 2022-11-28 First Edition FS THIS TEST REPORT APPLIES ONLY TO THE ITEM(S) AND CONFIGURATIONS TESTED. Deviations from, additions to, or exclusions from the test specifications are described in “Summary of Test Data”. Nemko Group authorizes the above-named entity to reproduce this report provided it is reproduced in its entirety and for use by the entity’s employees only. Any reproduction of parts of this report requires approval in writing from Nemko Group. Any use that a third party makes of this report, or any reliance on or decisions to be made based on it, are the responsibility of such third parties. Nemko Group accepts no responsibility for damages suffered by any third party caused by decisions made or actions based on this report. TEST REPORT FCC Part 15.407 Report no.: 466874-06-R00 FCC ID: Q8IM189MK2 Nemko Scandinavia Page 3 (26) CONTENTS 2 INFORMATION ......................................................................................................................... 4 2.1 Test Item ................................................................................................................................................... 4 2.3 Normal test conditions ............................................................................................................................... 5 2.4 Test Engineer(s) ........................................................................................................................................ 5 2.5 Antenna Requirement ................................................................................................................................ 5 2.6 EUT Operating Modes ............................................................................................................................... 5 2.7 Comments ................................................................................................................................................. 5 3 TEST REPORT SUMMARY ...................................................................................................... 6 3.1 General ..................................................................................................................................................... 6 3.2 Test Summary ........................................................................................................................................... 6 4 TEST RESULTS ........................................................................................................................ 7 4.1 Maximum Output Power, EIRP .................................................................................................................. 7 4.2 Emission Bandwidth / Occupied BW (99%)................................................................................................ 9 4.3 DTS Bandwidth ....................................................................................................................................... 11 4.4 Peak Power Spectral Density .................................................................................................................. 13 4.5 Unwanted Emissions ............................................................................................................................... 15 4.6 Restricted Bands of operation .................................................................................................................. 17 4.7 Radiated Emissions, 30 – 1000 MHz ....................................................................................................... 18 4.8 Radiated Emissions, 1 – 40 GHz ............................................................................................................. 20 5 Measurement Uncertainty ..................................................................................................... 23 6 LIST OF TEST EQUIPMENT................................................................................................... 24 7 BLOCK DIAGRAM .................................................................................................................. 25 7.1 Power Line Conducted Emission ............................................................................................................. 25 7.2 Conducted Tests ..................................................................................................................................... 25 7.3 Test Site Radiated Emission ...................................................…

Text truncated - open the document above for the full version.

MBR 189 MK2 Antenna details The MBR 189 MK2 antenna part consist of an integrated antenna array of helix antennas. The maximum antenna gain from the radio unit is stated to 24 dBi for 4725 to 4850 MHz. The beampattern is designed for a sector steerable antenna lobe within a 100x100 degrees sector. The antenna lobe is 9degrees (-3dB) both in elevation and Azimuth. The helix antenna array is made from a metal wire and integrated in the radio unit:

TEST SET-UP PHOTOS Project no.: 466874 FCC ID: Q8IM189MK2 Page 1 (1) Nemko Scandinavia Radiated Emissions 30 – 1000 MHz Radiated Emissions 1 – 18 GHz Pre-scan 18 – 40 GHz