QC4-VSMARTAHICLASV-Smart, A, H

© Copyright 2002, Bioscrypt Inc. All rights reserved. V-Prox / V-Flex / V-PASS / V-Smart OOPERATIONS PERATIONS MMANUALANUAL © 2000 Bioscrypt, Inc. Trademark Disclosures Bioscrypt has made every effort to provide disclosures when using trademarks owned by other companies. Trademarked designations appear throughout this publication. The publisher states that it is using the designations only for editorial purposes, and to the benefit of the trademark owner with no intent to infringe upon that trademark. The following trademarks are found in this manual: • Microsoft™, and Windows 95™, Windows 98™, Windows NT™, Windows ME™, Windows 2000™, and Windows XP™ are trademarks of the Microsoft Corporation. • V-Prox ®, V-Flex ®, V-PASS ®, V-Smart ®, MV1100 ®, MV1200 ® are registered trademarks of Bioscrypt, Inc. • HID™ is a trademark of the HID Corporation. • Motorola™ Indala™ are trademarks of the Motorola Corporation. • MIFARE® is a registered trademark of Philips Electronics N.V. • iCLASS™ is a trademark of HID Corporation. © 2000 Bioscrypt, Inc. Disclaimer The instructions in this document have been carefully checked for accuracy and are presumed to be reliable. Bioscrypt, Inc. and its writers assume no responsibility for inaccuracies and reserve the right to modify and revise this document without notice. It is always our goal at Bioscrypt, Inc. to supply accurate and reliable documentation. If you discover a discrepancy in this document, please e- mail your comments to [email protected], or contact Bioscrypt Technical Support at the telephone number listed below. No part of this publication may be placed in a retrieval system, transmitted, or reproduced in any way, including, but not limited to, photograph, photocopy, computer disk or other record, without prior agreement and written permission from: Bioscrypt Inc. 5000 Van Nuys Blvd., Suite 300 Sherman Oaks, CA 91403 Phone 818.304.7150 Toll Free 888.982.4643 http://www.bioscrypt.com © 2000 Bioscrypt, Inc. Bioscrypt One Year Limited Warranty Policy Bioscrypt warrants to the original consumer purchaser (“Customer”) that new Bioscrypt products will be free from defects in material and workmanship for one year from the date the product was shipped from Bioscrypt. For replacement products the warranty on the replacement unit is the remainder of the warranty on the original product or ninety (90) days, whichever is longer. The Customer is responsible for making any claims for shipment damage (evident or concealed) with the freight carrier. Bioscrypt must be notified within thirty days of shipment of incorrect materials. If a defect is discovered, Bioscrypt's sole obligation shall be to repair or replace the Bioscrypt product(s) at its sole discretion at no charge, provided it is returned to Bioscrypt during the warranty period and is shipped freight and insurance prepaid. Merchandise must be properly packaged to prevent damage during shipping. Before returning a Bioscrypt product, contact Bioscrypt Technical Service to obtain a Return Material Authorization (RMA) number. No product may be returned whether in warranty or out of warranty without first obtaining approval from Bioscrypt. The model number, invoice number, and serial number may be required for warranty service. This warranty shall not apply to any product or any part of a product, which in the judgment of Bioscrypt, has been subjected to misuse, negligence, alteration, accident, improper maintenance, or damage by excessive physical or electrical stresses. Tampering, such as opening the housing of a biometric reader or replacing parts will void this warranty. The warranty is void if the serial number of the Bioscrypt product has been defaced, altered, or removed or if the product has been modified. Repair and replacement parts will be furnished on an exchange basis and may be either reconditioned or new. All replaced parts or products become the property of Bioscrypt. This warranty may also be voided for failure to comply with Bioscrypt’s return policy. The warranty is not applicable to: • Abnormal wear and tear © 2000 Bioscrypt, Inc. • Damage caused during installation • Damage caused by the equipment or system with which the biometric reader is used • Damage caused by modification or repairs not made or authorized by Bioscrypt • Damage caused by improper packaging • Damage caused by lack of ESD protection • Merchandise that is determined to be stolen The newest Bioscrypt Veri-Series products are designed to be weather resistant but no sensor technology exists today that can work in all weather environments. If a Bioscrypt Veri-Series product is not used in a completely indoor environment, then a protective cover is required to shield the sensor from moisture, dust, and other contaminants that will degrade sensor operation and void the product warranty. This warranty is exclusive and in lieu of all others, whether oral or written, expressed or implied. Bioscrypt specifically disclaims any and all implied warranties, including without limitation, warranties of merchantability and fitness for any particular purpose. No Bioscrypt dealer, agent, or employee is authorized to make any modification, extension or addition to this warranty. © 2000 Bioscrypt, Inc. Notices The Veri-Series line of products has been tested for compliance with all applicable international standards. The resulting approvals are listed below, and are additionally printed on the labeling located on the rear panel of the product. The power supply offered by Bioscrypt is CE and CSA approved and UL listed. V-Flex FCC, UL, ULC, CE V-Prox FCC, UL, ULC, CE V-Pass FCC, UL, ULC, CE V-Smart FCC, UL, ULC, CE FCC Information to Users This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment ge…

Text truncated - open the document above for the full version.

www.HIDCorp.com 9292 Jeronimo Road • Irvine, CA 92618-1905 • Phone (949) 598-1600 Fax (949) 598-1680 (Administration) • Fax (949) 598-1690 (Customer Service) • Fax (949) 598-1692 (Manufacturing & Purchasing) An ASSA ABLOY Group company August 13, 2002 Timco Engineering, Inc. Telecommunications Certified Body 849 N.W. State Road 45 Newberry, FL 32669 0.459 Request that submitted material be withheld from Public Inspection Products: 31xxA (609x-301) iCLASS OEM Module Family It is requested that the following material be withheld from public inspection: Description of the iCLASS OEM Module, Circuit Functions, how the device operates, Ground System, and Antenna Block Diagram Schematic These materials are considered HID Corporation Proprietary and Confidential. Revealing the fundamental design for the product to the public, the OEM, and our competition would put us at a competitive disadvantage. We feel we have a product cost/design advantage over our competition with our iCLASS OEM Module family and therefore ask that the above-specified materials be withheld from public and OEM inspection. Frank de Vall Manager of Compliance Engineering HID Corporation Assa Abloy ITG Research Center 11674 N. Huron Street Denver, CO 80234

ANNEX 2 - EXTERNAL PHOTOGRAPHS OF EUTPhoto # 1 V-SMART, Model V-SMART, A, HFCC ID: QC4VSMARTAHICLA IC: 4308B-VSMARTAH ANNEX 2 - EXTERNAL PHOTOGRAPHS OF EUTPhoto # 2 V-SMART, Model V-SMART, A, HFCC ID: QC4VSMARTAHICLA IC: 4308B-VSMARTAH

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. V-Smart, A, H Input 12VDC, 200 mA P/N: 871-05212-13 S/N: NNNNNNNNNN FCC ID: QC4-VSMARTAHICLAS UL-MARK BAR CODE IC: 4308BVSMARTAH Label 1, for the biometric engine This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. V-Smart, A, H Input 12 VDC, 200 mA P/N:871-09212-11 S/N: NNNNNNNNNN FCC ID: QC4-VSMARTAHICLAS UL-MARK BAR CODE IC: 4308BVSMARTAH Label 2, for the card reader DSP BoxBox with Smart Card Reader Rear View Cable Sensor Label 1 Top of the Unit Back of the DSP Unit Bottom of the Unit DB-15 Label 2 Top of the Unit Back of the Card Reader Unit Bottom of the Unit

DSP BoxBox with Smart Card Reader Rear View Cable Sensor Label 1 Top of the Unit Back of the DSP Unit Bottom of the Unit DB-15 Label 2 Top of the Unit Back of the Card Reader Unit Bottom of the Unit

Aug. 06, 2002 BIOSCRYPT INC. 5000 Van Nuys Blvd., Suite 300 Sherman Oaks, CA USA, 91403 Attn.:Mr. Curt Harkless Subject:FCC Certification Application Testing under FCC PART 15, Subpart C - Unlicensed Low Power Transmitter operating in the frequency band 13.553-13.567 MHz. Product:V-SMART Model No.:V-SMART, A FCC ID:QC4VSMARTAHICLAS Dear Mr. Harkless, The product sample, as provided by you, has been tested and found to comply with FCC PART 15, Subpart C - Unlicensed Low Power Transmitter operating in the frequency band 13.553-13.567 MHz. Enclosed you will find copies of the engineering report. If you have any queries, please do not hesitate to contact us. Yours truly, Tri Minh Luu, P. Eng., V.P., Engineering Encl UltraTech Group of Labs 31040/SIT C-1376 46390-2049 200093-0 2 00-034 3000 Bristol Circle, Oakville, Ontario, Canada L6H 6G4 Tel.: (905) 829-1570 Fax.: (905) 829-8050 Website: www.ultratech-labs.com Email: [email protected] V-SMART Model No.: VSMART, A, H FCC ID: QC4VSMARTAHICLAS Applicant: BIOSCRYPT INC. 5000 Van Nuys Blvd., Suite 300 Sherman Oaks, CA USA, 91403 In Accordance With FEDERAL COMMUNICATIONS COMMISSION (FCC) PART 15, SUBPART C Unlicensed Low Power Transmitter operating in the band 13.553-13.567 MHz UltraTech's File No.: MYT-026F15.225 This Test report is Issued under the Authority of Tri M. Luu, Professional Engineer, Vice President of Engineering UltraTech Group of Labs Date: Aug. 06, 2002 Report Prepared by: Tri LuuTested by: Hung Trinh, RFI Technician Issued Date: Aug. 06, 2002Test Dates: July 31 & Aug. 01, 2002 ß The results in this Test Report apply only to the sample(s) tested, and the sample tested is randomly selected. ß This report must not be used by the client to claim product endorsement by NVLAP or any agency of the US Government. UltraTech 3000 Bristol Circle, Oakville, Ontario, Canada, L6H 6G4 Tel.: (905) 829-1570 Fax.: (905) 829-8050 Website: www.ultratech-labs.com Email: [email protected], Email: [email protected] 2 31040/SITC-137646390-2049200093-000-034 FCC PART 15, SUBPART C - UNLICENSED LOW POWER TRANSMITTER Page 2 V-SMART, Model V-SMART, A, HFCC ID: QC4VSMARTAHICLAS ULTRATECH GROUP OF LABSFile #: MYT-026F15.225 3000 Bristol Circle, Oakville, Ontario, Canada L6H 6G4Aug. 06, 2002 Tel. #: 905-829-1570, Fax. #: 905-829-8050, Email: [email protected], Website: http://www.ultratech-labs.com All test results contained in this engineering test report are traceable to National Institute of Standards and Technology (NIST) 2 31040/SITC-137646390-2049200093-000-034 TABLE OF CONTENTS EXHIBIT 1.SUBMITTAL CHECK LIST........................................................................................................................................4 EXHIBIT 2.INTRODUCTION..........................................................................................................................................................5 2.1.SCOPE.......................................................................................................................................................................................5 2.2.RELATED SUBMITAL(S)/GRANT(S)........................................................................................................................................5 2.3.NORMATIVE REFERENCES.................................................................................................................................................5 EXHIBIT 3.PERFORMANCE ASSESSMENT..............................................................................................................................6 3.1.CLIENT INFORMATION........................................................................................................................................................6 3.2.EQUIPMENT UNDER TEST (EUT) INFORMATION...........................................................................................................6 3.3.DESCRIPTION OF V-SMART, A, H OPERATION..................................................................................................................7 3.3.1.Overall Operation.........................................................................................................................................................7 3.3.2.Biometric Engine..........................................................................................................................................................7 3.3.3.HID iClass Model R10.................................................................................................................................................7 3.4.EUT’S TECHNICAL SPECIFICATIONS..............................................................................................................................8 3.5.LIST OF EUT’S PORTS..............................................................................................................................................................9 3.6.ANCILLARY EQUIPMENT.......................................................................................................................................................9 3.7.BLOCK DIAGRAM OF TEST SETUP..................................................................................................................................9 EXHIBIT 4.EUT OPERATING CONDITIONS AND CONFIGURATIONS DURING TESTS............................................10 4.1.CLIMATE TEST CONDITIONS...............................................................................................................................................10 4.2.OPERATIONAL TEST CONDITIONS & ARRANGEMENT FOR TESTS...............................................................................10 EXHIBIT 5.SUMMARY OF TEST RESULTS.............................................................................................................................11 5.1.LOCATION OF TESTS...............................................................................…

Text truncated - open the document above for the full version.

ANNEX 1 - TEST SETUP FOR RADIATEDPhoto # 1 EMISSIONS MEASUREMENTS (EUT WAS PLACED IN 3 DIFFERENT ORTHOGONAL DIRECTIONS) V-SMART, Model V-SMART, A, HFCC ID: QC4VSMARTAHICLAS IC: 4308B-VSMARTAH ANNEX 1 - TEST SETUP FOR RADIATEDPhoto # 2 EMISSIONS MEASUREMENTS (EUT WAS PLACED IN 3 DIFFERENT ORTHOGONAL DIRECTIONS) V-SMART, Model V-SMART, A, HFCC ID: QC4VSMARTAHICLAS IC: 4308B-VSMARTAH ANNEX 1 - TEST SETUP FOR RADIATEDPhoto # 3 EMISSIONS MEASUREMENTS (EUT WAS PLACED IN 3 DIFFERENT ORTHOGONAL DIRECTIONS) V-SMART, Model V-SMART, A, HFCC ID: QC4VSMARTAHICLAS IC: 4308B-VSMARTAH