QEATX49MY FIRST RC

My First RC-Airplane 49MHZ / Racing Car 49MHZ / Dump Truck 49MHZ (5500 / 5501) Encode Q1 & Q2 Amplifier Q3 Power Supply 9V battery Oscillator Q4 & X1

Operation Description of the My First RC ñAirplane 49MHZ / Racing Car 49MHZ / Dump Truck 49MHZ The transmitter for My First RC ñAirplane 49MHZ / Racing Car 49MHZ / Dump Truck 49MHZ operating at 49.860 MHz which is controlled by a crystal. It is powered a 9 V battery. There are two buttons in the center of the EUT. When the Forward button is pressed once, it transmits a radio frequency for receiver going forward. When the Spin button is pressed, it transmits a radio frequency for receiver spin. Refer to the circuit design, the circuit description is listed as follows : - Q1, Q2 and associated circuit act as encoder - X1, Q4 and associated circuit act as oscillator - Q3 and associated circuit act as amplifier

TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 Applicant : Kid Galaxy Sample Description : One(1) submitted sample stated to be : Item Name Model No. My First RC – Airplane 5500 My First RC – Racing Car 5501 My First RC – Dump Truck 5502 Rating : 1 x 9 V battery No. of sample(s) : Four(4) pieces *** Date Received : 2002 June 13. 2003 May 02. Test Period : 2003 May 02 – 2003 May 09. Test Requested : FCC Part 15 Certification Test Method : FCC Rules and Regulations Part 15 – May 2002 ANSI C63.4 – 1992 Test Result : See attached sheet(s) from page 2 to 10. Conclusion : The submitted sample was found to comply with requirement of FCC Part 15 Subpart C. Remark : All three models are the same in circuitry and components and construction, and therefore model 5500 was chosen to be the representative of the test sample. For and on behalf of CMA Testing and Certification Laboratories Authorized Signature : Page 1 of 10 Danny Chui EMC Engineer - EL. Division FCC ID : QEATX49 TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 Table of Contents 1 General Information........................................................................................................................ 3 1.1 General Description.................................................................................................................. 3 1.2 Related Submittal Grants.......................................................................................................... 3 1.3 Location of the test site............................................................................................................. 4 1.4 List of measuring equipment..................................................................................................... 5 2 Description of the radiated emission test.......................................................................................... 6 2.1 Test Procedure......................................................................................................................... 6 2.2 Test Result............................................................................................................................... 6 2.3 Radiated Emission Measurement Data....................................................................................... 7 3 Description of the Line-conducted Test............................................................................................ 8 3.1 Test Procedure......................................................................................................................... 8 3.2 Test Result............................................................................................................................... 8 3.3 Graph and Table of Conducted Emission Measurement Data...................................................... 8 4 Photograph..................................................................................................................................... 9 4.1 Photographs of the Test Setup for Radiated Emission and Conduction Emission.......................... 9 4.2 Photographs of the External and Internal Configurations of the EUT........................................... 9 5 Supplementary document................................................................................................................. 9 5.1 Bandwidth............................................................................................................................... 9 6 Appendices............................................................................................................................... 10 Page 2 of 10 FCC ID : QEATX49 TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 1 General Information 1.1 General Description The equipment under test (EUT) is a transmitter for My First RC – Airplane operating at 49.860 MHz which is controlled by a crystal. The EUT is powered 9 V battery. There are two buttons in the center of the EUT. When the Forward button is pressed once, it transmit a radio frequency for receiver going forward. When the Spin button is pressed, it transmit a radio frequency for receiver spin. The brief circuit description is listed as follows : - Q1, Q2 and associated circuit act as encoder - X1, Q4 and associated circuit act as oscillator - Q3 and associated circuit act as amplifier The model(s) 5501 and 5502 are the same as model 5500 in hardware aspect. The difference in model numbers serves as marketing strategy. 1.2 Related Submittal Grants This is a single application for certification of a transmitter. Page 3 of 10 FCC ID : QEATX49 TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 1.3 Location of the te…

Text truncated - open the document above for the full version.

TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 Applicant : Kid Galaxy Sample Description : One(1) submitted sample stated to be : Item Name Model No. My First RC – Airplane 5500 My First RC – Racing Car 5501 My First RC – Dump Truck 5502 Rating : 1 x 9 V battery No. of sample(s) : Four(4) pieces *** Date Received : 2002 June 13. 2003 May 02. Test Period : 2003 May 02 – 2003 May 09. Test Requested : FCC Part 15 Certification Test Method : FCC Rules and Regulations Part 15 – May 2002 ANSI C63.4 – 1992 Test Result : See attached sheet(s) from page 2 to 10. Conclusion : The submitted sample was found to comply with requirement of FCC Part 15 Subpart C. Remark : All three models are the same in circuitry and components and construction, and therefore model 5500 was chosen to be the representative of the test sample. For and on behalf of CMA Testing and Certification Laboratories Authorized Signature : Page 1 of 10 Danny Chui EMC Engineer - EL. Division FCC ID : QEATX49 TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 Table of Contents 1 General Information........................................................................................................................ 3 1.1 General Description.................................................................................................................. 3 1.2 Related Submittal Grants.......................................................................................................... 3 1.3 Location of the test site............................................................................................................. 4 1.4 List of measuring equipment..................................................................................................... 5 2 Description of the radiated emission test.......................................................................................... 6 2.1 Test Procedure......................................................................................................................... 6 2.2 Test Result............................................................................................................................... 6 2.3 Radiated Emission Measurement Data....................................................................................... 7 3 Description of the Line-conducted Test............................................................................................ 8 3.1 Test Procedure......................................................................................................................... 8 3.2 Test Result............................................................................................................................... 8 3.3 Graph and Table of Conducted Emission Measurement Data...................................................... 8 4 Photograph..................................................................................................................................... 9 4.1 Photographs of the Test Setup for Radiated Emission and Conduction Emission.......................... 9 4.2 Photographs of the External and Internal Configurations of the EUT........................................... 9 5 Supplementary document................................................................................................................. 9 5.1 Bandwidth............................................................................................................................... 9 6 Appendices............................................................................................................................... 10 Page 2 of 10 FCC ID : QEATX49 TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 1 General Information 1.1 General Description The equipment under test (EUT) is a transmitter for My First RC – Airplane operating at 49.860 MHz which is controlled by a crystal. The EUT is powered 9 V battery. There are two buttons in the center of the EUT. When the Forward button is pressed once, it transmit a radio frequency for receiver going forward. When the Spin button is pressed, it transmit a radio frequency for receiver spin. The brief circuit description is listed as follows : - Q1, Q2 and associated circuit act as encoder - X1, Q4 and associated circuit act as oscillator - Q3 and associated circuit act as amplifier The model(s) 5501 and 5502 are the same as model 5500 in hardware aspect. The difference in model numbers serves as marketing strategy. 1.2 Related Submittal Grants This is a single application for certification of a transmitter. Page 3 of 10 FCC ID : QEATX49 TEST REPORT This document shall not be reproduced either in full or in part except with written approval by the Authorized Representative of CMA Testing. Room 1401-3, Yan Hing Centre, 9-13 Wong Chuk Yeung St.., Fo Tan, Shatin, Hong Kong. Tel: (852) 2698 8198 Fax: (852) 2695 4177 E-mail: [email protected] Web Site: http://www.cmatcl.com Report No. : AC009320-1 Date : 2003 June 03 1.3 Location of the te…

Text truncated - open the document above for the full version.