QV2-SMD-53200RXRadio Receiver Module 433 MHz AM

TST SFFE2-C 2-channel radio receiver module 433 MHz AM Remote-controlled opening and closing of industrial doors and barriers Special features: • plug-in module for control boards of FEIG ELECTRONIC • frequency range AM 433 MHz • teach in of max. 32 transmitters possible • signal evaluation with microprocessor • operation with cable antenna or 50 Ohm technique • receiving display via LED Technical data Dimensions: wxh 100,65x49,21 mm Mains voltage: 12-24 V DC Current consumption: approx. 8 mA without RF module Settings: 53200 mode 35 - 110 ms Connections: 2x 5pin Molex type for supply and command 1x 3pol. screw terminal for antenna Displays: 1x LED red for function check Control elements. 2x learning press button 2x DIP-switch for latch function (optional) Construction: Learning and delete process: For the operation of this receiver a transmitter has to be teached in. Firstly the transmitter has to checked by pressing the transmission key and regarding the transmission LED. Now, the learn button of the receiver must be pressed and within 5 sec. after this the button of the transmission channel which should be teached in. If the LED flashes and the connected motor is running the learning process was successful. According to this a second transmitter can by teached in with the key for the second channel. In order to delete the entire store the learn button must be pressed on the receiver until red LED is on. (LED is on for the whole deleting process). After LED is off the store is empty and new transmitter(s) can be learned in again. The factory setting of the receiver is in the codification 1, 2, 3, 8, 9, 10 =ON . This codification should be changed always after the start up as following: Press the learn button for approx. 10 seconds; as a result, the processor is deleted completely. He signals this by short flashing of receiver LED. The codification in the manual transmitter must now be changed. Now, the learn button must be pressed on the receiver and within 5 sec. after this the button of the transmission channel which should be learned in. If the relay switches and the LED flashes on the learning process was successful. According to this principle it is possible to learn in 64 different transmitters. In order to delete the entire store the learn button must be pressed on the receiver again approx. 10 seconds (flashing of LED). After this new transmitter(s) can be learned in again. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could avoid the user's authority to operate the equipment. jb/vk 07/03 errors and technical changes remain reserved Distributed by FEIG ELECTRONIC GmbH key2 key1 SW2 SW1 S T 1 LED cable antenna 50 Ohm antenna GND G N D + V i n 1.chan. 2.chan. FCC ID: QV2-SMD-53200RX

FCC-ID: QV2-SMD-53200RX Test Report #EMCC-980069VC Page 2 of 13 Issue Date: 2003-MAY-29 TEST OF SMD-FUNK GMBH TYPE LW 433 A M TO 47 CFR PART 15B - UNINTENTIONAL RADIATORS REPORT_VC.DOC CONTENTS Page 1 GENERAL INFORMATION ...................................................................................................................................................................3 1.1 Purpose..................................................................................................................................................................................3 1.2 Limits and Reservations ......................................................................................................................................................3 1.3 Test Location.........................................................................................................................................................................3 1.4 Manufacturer .........................................................................................................................................................................3 1.5 Dates ......................................................................................................................................................................................3 2 Product Description.............................................................................................................................................................................4 2.1 Equipment Under Test (EUT)...............................................................................................................................................4 2.2 EUT Peripherals ....................................................................................................................................................................4 2.3 Mode of Operation During Testing .....................................................................................................................................4 2.4 Modifications Required for Compliance ............................................................................................................................4 3 Test Results Summary ........................................................................................................................................................................5 4 Conducted Emissions Tests ...............................................................................................................................................................6 4.1 Regulation .............................................................................................................................................................................6 4.2 Test Equipment .....................................................................................................................................................................6 4.3 Test Procedures....................................................................................................................................................................6 4.4 Test Results...........................................................................................................................................................................8 5 Radiated Emissions TEST...................................................................................................................................................................9 5.1 Regulation .............................................................................................................................................................................9 5.2 Test Equipment ...................................................................................................................................................................10 5.3 Test Procedures..................................................................................................................................................................11 5.4 Field Strength Calculation .................................................................................................................................................11 5.5 Test Results.........................................................................................................................................................................12 6 Miscellaneous Comments and Notes .............................................................................................................................................13 7 List of ANNEXES................................................................................................................................................................................13 FCC-ID: QV2-SMD-53200RX Test Report #EMCC-980069VC Page 3 of 13 Issue Date: 2003-MAY-29 TEST OF SMD-FUNK GMBH TYPE LW 433 A M TO 47 CFR PART 15B - UNINTENTIONAL RADIATORS REPORT_VC.DOC 1 GENERAL INFORMATION 1.1 Purpose The purpose of this report is to show compliance to the FCC regulations for unintentional radiators operating under section 15.101 ff. of the Code of Federal Regulations title 47. 1.2 Limits and Reservations The test results in this report apply only to the particular Equipment Under Test (EUT) as declared in this report. This test report shall not be reproduced except in full without the written permission of EMCC DR. RAŠEK. 1.3 Test Location Company Name: EMCC DR. RAŠEK Street: Moggast 72-74 City: 91320 Ebermannstadt Country: Germany Laboratory: Test Laboratory of EMCC DR. RAŠEK FCC Registration Number: 90566 This site has been fully described in a report submitted to the FCC, and accepted in the letter dated February 04, 2003 Registration Number 90566. Phone: +49-9194-9016 Fax: +49-9194-8125 E-Mail: [email protected] Web: www.emcc.de 1.4 Manufacturer Company Name: SMD-Funk GmbH Street: Hans-Boeckler-Strasse 5 City: 631…

Text truncated - open the document above for the full version.

FCC-ID: QV2-SMD-53200RX RADIO LABORATORIES EMC LABORATORIES TTI-P-G 094/94 TTI-P-G 074/95 EMCC DR. RAŠEK Moggast 72-74 91320 Ebermannstadt Germany FCC Registration # 90566 Annex1_VC.doc Telephone: +49-9194-9016 Telefax: +49-9194-8125 Mail: [email protected] Web: http://www.emcc.de PAGE 1 of 3 ANNEX 1 TO TEST REPORT # EMCC-980069VC, 2003-MAY-29 PHOTOGRAPHS OF TEST SETUPS EQUIPMENT UNDER TEST: Type: LW 433 AM Serial No: None Equipment Category: Receiver (module) Manufacturer: SMD-Funk GmbH Address: Hans-Boeckler-Strasse 5 63110 Rodgau Germany Phone: ++49-6106-6008-0 Fax: ++49-6106-6008-33 RELEVANT STANDARD: 47 CFR Part 15C - Intentional Radiators CONTENTS Page 1 CONDUCTED EMISSIONS TEST ......................................................................................................................... 2 1.1 Photograph: EUT LW 433 AM.................................................................................................................... 2 2 RADIATED EMISSIONS TEST ............................................................................................................................. 3 2.1 Photograph: EUT LW 433 AM on non conductive stand ........................................................................... 3 FCC-ID: QV2-SMD-53200RX Annex 1 to Test Report #EMCC-980069VC Page 2 of 3 Issue Date: 2003-MAY-29 TEST OF SMD-FUNK GMBH TYPE L W 433 AM TO 47 CFR PART 15C - INTENTIONAL RADIATORS ANNEX1_VC.DOC 1 CONDUCTED EMISSIONS TEST 1.1 Photograph: EUT LW 433 AM FCC-ID: QV2-SMD-53200RX Annex 1 to Test Report #EMCC-980069VC Page 3 of 3 Issue Date: 2003-MAY-29 TEST OF SMD-FUNK GMBH TYPE L W 433 AM TO 47 CFR PART 15C - INTENTIONAL RADIATORS ANNEX1_VC.DOC 2 RADIATED EMISSIONS TEST 2.1 Photograph: EUT LW 433 AM on non conductive stand