QXATC27MHZWRemote Control Toy Transmitter

CONTENTS, COLORS AND DECORATIONS MAY VARY FROM PHOTOS. Hummer H2, the H2 Emblem and distinctive vehicle model body and grille designs are General Motors Trademarks used under license to Tack Cheung Plastic Manufactory, Ltd. General Motors Trademarks used under license to Tack Cheung Plastic Manufactory, Ltd. MG OFFICIAL LICENSED PRODUCT 25-26101-41194 FORD, F-150 PICK UP trademarks are used under license from Ford Motor Company. FOR AGES ABOVE 3 COLLECT THEM ALL! FOR AGES ABOVE 3 FOR AGES ABOVE 3 27 MHz 27 MHz SCALE 1:24 FOR AGES ABOVE 3 • GOES FORWARD • TURNS IN REVERSE SCALE 1:24 27 MHz SCALE 1:24 FOR AGES ABOVE 3 • GOES FORWARD • TURNS IN REVERSE • GOES FORWARD • TURNS IN REVERSE • GOES FORWARD • TURNS IN REVERSE • GOES FORWARD • TURNS IN REVERSE 27 MHz SCALE 1:24 ITEM N0. 6697 MADE IN CHINA © 2003 TOY CENTURY INDUSTRIAL CO., LIMITED TSIM SHA TSUI EAST, KOWLOON, HONG KONG TM PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE PLAYING, AND RETAIN THIS INSTRUCTION FOR FUTURE REFERENCE. RADIO CONTROL FREQUENCY FOR INTERFERENCE-FREE RESULTS, DO NOT OPERATE THIS VEHICLE WITH OTHER RADIO-CONTROLLED TOYS NOT INCLUDED IN THIS SET WITHIN TRANSMISSION RANGE. TRANSMITTER AND RECEIVER SINCE RADIO WAVES CONTROL THIS VEHICLE AND IN ORDER TO AVOID INTERRUPTION, DO NOT OPERATE THIS VEHICLE NEAR ELECTRICAL OR TELEPHONE LINES, CB INTERFERENCE, CD PLAYERS, MOBILE PHONES, ELEVATORS, STEEL GIRDERS, OTHER ELECTRONIC DEVICES AND NEAR HIGHWAYS. INSTALLING THE BATTERIES • REMEMBER TO SET THE “ON-OFF” SWITCH AT BOTTOM OF THE VEHICLE TO “OFF” POSITION BEFORE INSERTING THE BATTERIES. • UNSCREW AND OPEN BATTERY COMPARTMENT COVER TO INSERT BATTERIES IN THE VEHICLE AS SHOWN IN FIGURE. MAKE SURE ALL BATTERIES ARE AT THE CORRECT POLARITY. • CLOSE THE COVER AND TIGHTEN THE SCREW. • TO INSERT BATTERY IN THE CONTROLLER, OPEN BATTERY COMPARTMENT COVER TO INSERT BATTERY AS SHOWN IN FIGURE. • CLOSE THE COVER. • DO NOT LEAVE BATTERIES IN THE VEHICLE AND TRANSMITTER WHEN THE TOY IS NOT IN USE. • DO NOT MIX OLD AND NEW BATTERIES TOGETHER. • DO NOT MIX ALKALINE, STANDARD (CARBON-ZINC) OR RECHARGEABLE (NICKEL-CADMIUM) BATTERIES. • DO NOT DISPOSE OF BATTERIES IN FIRE. BATTERIES MAY EXPLODE OR LEAK. • FOR BEST PERFORMANCE, ALKALINE BATTERIES ARE RECOMMENDED. OPERATING THE VEHICLE • FOR YOUR SAFETY, NEVER PLAY WITH THIS TOY ON THE STREET. • TURN THE "ON-OFF" SWITCH AT THE BOTTOM OF THE VEHICLE TO "ON" POSITION, THEN THE VEHICLE WILL GO BACKWARD IN CIRCULAR PATH. • PULL THE TRIGGER DOWNWARD ON THE TRANSMITTER, THE VEHICLE WILL RESPOND IN GOING FORWARD. OPERATION TIPS 1. OPERATE ONLY ON SMOOTH (BUT NOT SLIPPERY), DRY AND CLEAN SURFACE. 2. DO NOT PLAY WITH THIS TOY ON THE STREET, IN GRASS, SAND OR CARPET. 3. DO NOT DRIVE THE TOY THROUGH WATER. 4. ALWAYS POINT THE CONTROLLER ANTENNA UPWARD FOR BETTER TRANSMISSION. 5. DO NOT MAKE ANY PHYSICAL CONTACT WITH THE CONTROLLER ANTENNA WHILE OPERATING. 6. KEEP THE TOY IN A DRY AND COOL PLACE AFTER PLAYING. DO NOT LEAVE IT DIRECTLY UNDER SUNLIGHT. CONFORMS TO TOY SAFETY STANDARDS ASTM F963-96a. "MODIFICATIONS NOT AUTHORIZED BY THE MANUFACTURER MAY VOID USERS AUTHORITY TO OPERATE THIS DEVICE" NOTE: THIS EQUIPMENT HAS BEEN TESTED AND FOUND TO COMPLY WITH THE LIMITS FOR A CLASS B DIGITAL DEVICE, PURSUANT TO PART 15 OF THE FCC RULES. THESE LIMITS ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST HARMFUL INTERFERENCE IN A RESIDENTIAL INSTALLATION. THIS EQUIPMENT GENERATES, USES AND CAN RADIATE RADIO FREQUENCY ENERGY AND, IF NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTIONS, MAY CAUSE HARMFUL INTERFERENCE TO RADIO COMMUNICATIONS. HOWEVER, THERE IS NO GUARANTEE THAT INTERFERENCE WILL NOT OCCUR IN A PARTICULAR INSTALLATION. IF THIS EQUIPMENT DOES CAUSE HARMFUL INTERFERENCE TO RADIO OR TELEVISION RECEPTION, WHICH CAN BE DETERMINED BY TURNING THE EQUIPMENT OFF AND ON, THE USER IS ENCOURAGED TO TRY TO CORRECT THE INTERFERENCE BY ONE OR MORE OF THE FOLLOWING MEASURES : - REORIENT OR RELOCATE THE RECEIVING ANTENNA. - INCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER. - CONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM THAT TO WHICH THE RECEIVER IS CONNECTED. - CONSULT THE DEALER OR AN EXPERIENCED RADIO/TV TECHNICIAN FOR HELP. F-150 PICK UP CHEVY® SILVERADO ™ F-150 PICK UP BATTERY INSTRUCTION DIAGRAMS USES 4 X 1.5V "AA" SIZE BATTERIES (NOT INCLUDED) ™ ™ UNDERNEATH WATCH CONTROLLER. USES 3 BUTTON CELL BATTERIES (AG13 / LR44) FOR CONTROLLER (INCLUDED). + 1.5V AG13 /LR44 1.5V AG13 /LR44 1.5V AG13 /LR44 PRESS BUTTON TO GO FORWARD. RELEASE BUTTON TO GO BACKWARD. 12 : 00 PM PRESS HERE

PHOTOGRAPH OF THE PRODUCT FRONT VIEW OF THE PRODUCT REAR VIEW OF THE PRODUCT

PHOTOGRAPH OF THE PRODUCT INNER CIRCUIT TOP VIEW INNER CIRCUIT BOTTOM VIEW

FCC ID: QXATC27MHZW Circuit Description The 27.145MHz crystal oscillator drives the base of Q3 the final/buffer amplifier. The modulation provided by Q1 and Q2. The output of Q3 has the matching network consisting of L1 and C6 that limit the harmonic content and effect the proper coupling of the antenna to the output stage. Antenna, Ground and Power Source The antenna consists of a 26.5cm long metal antenna. There is no external ground connection. The ground is only that of the printed circuit board. Electric current is supplied by a 4.5 Volt (“AG13” size battery x 3) primary battery

Date: 2003-02-28 TEST REPORT Page 1 of 20 No.: HM109800 FCC PART 15 SUBPART C CERTIFICATION REPORT FOR LOW POWER TRANSMITTER TEST REPORT No.:HM109800 Equipment Under Test [EUT]:Radio Control Vehicle Model Number:TC27MHzW Applicant:Toy Century Industrial Co., Ltd. FCC ID :QXATC27MHZW Date: 2003-02-28 TEST REPORT Page 2 of 20 No.: HM109800 CONTENT: Cover Page 1 of 20 Content Page 2-3 of 20 Conclusion Page 4 of 20 1.0 General Details 1.1Test Laboratory Page 5 of 20 1.2Applicant Details Page 5 of 20 Applicant HKSTC Code Number for Applicant Manufacturer 1.3Equipment Under Test [EUT] Page 6 of 20 Description of EUT operation 1.4Date of Order Page 6 of 20 1.5Submitted Sample Page 6 of 20 1.6Test Duration Page 6 of 20 1.7Country of Origin Page 6 of 20 1.8 Additional Information of EUT Page 7 of 20 2.0 Technical Details 2.1Investigations Requested Page 8 of 20 2.2Test Standards and Results Summary Page 8 of 20 3.0Test Results 3.1Emission Page 9-13 of 20 3.2Bandwidth Measurement Page 14-15 of 20 Date: 2003-02-28 TEST REPORT Page 3 of 20 No.: HM109800 Appendix A List of Measurement Equipment Page 16 of 20 Appendix B Duty Cycle Correction During 100 msec Page 17-18 of 20 Appendix C Photographs Page 19 of 20 Date: 2003-02-28 TEST REPORT Page 4 of 20 No.: HM109800 CONCLUSION The submitted product was deemed to have COMPLIED with the requirements of Federal Communications Commission [FCC] Rules and Regulations Part 15. The tests were performed in accordance with the standards described above and on Section 2.2 in this Test Report. Verify byPatrick Wong for Chief Executive Date: 2003-02-28 TEST REPORT Page 5 of 20 No.: HM109800 1.0 General Details 1.1Test Laboratory The Hong Kong Standards and Testing Centre Ltd. EMC Laboratory 10 Dai Wang Street, Taipo Industrial Estate New Territories, Hong Kong Telephone:852 2666 1888 Fax:852 2664 4353 1.2Applicant Details Applicant TOY CENTURY INDUSTRIAL CO., LTD. Unit 1010-1015, 10/F., Tower B, New Mandarin Plaza, No. 14 Science Museum Road, Tsim Sha Tsui East, Kowloon, Hong Kong. Telephone:852 2790 3612 Fax:852 2304 1863 HKSTC Code Number for ApplicantBVP001 Manufacturer TOY CENTURY INDUSTRIAL CO., LTD. Unit 1010-1015, 10/F., Tower B, New Mandarin Plaza, No. 14 Science Museum Road, Tsim Sha Tsui East, Kowloon, Hong Kong. Telephone:852 2790 3612 Fax:852 2304 1863 Date: 2003-02-28 TEST REPORT Page 6 of 20 No.: HM109800 1.3Equipment Under Test [EUT] Description of Sample Product:Radio Control Vehicle Manufacturer:Toys Century Industrial Co., Ltd. Brand Name:N/A Model Number:TC27MHzW Input Voltage:4.5Vd.c (“AG13” size battery x 3) Additional Model: Number:K00001, 00040, 17448, 19511, 19522, 19523,19527, 19528, 19529, 19532, 19533, 19536, 19539, 207, 230, 6661, 6680, 6700, 6705, 6682, 6601, 6801, 6805, 6683, 6684, 6688, 66881, 6689, 6690, 6691, 6695, 6697, 6698, 66902, 66952, 66982, 66984, 66985, 66986, 66992, 7629, 85928, 9800 1.3.1Description of EUT Operation The Equipment Under Test (EUT) is an Toys Century Industrial Co., Ltd., Radio Control Vehicle (Watch Type Transmitter). The transmitter is a 2 button transmitter. The EUT continues to transmit while button is being pressed, Modulation by Q1 and Q2. and tape is pulse modulation. 1.4Date of Order 2002-12-11 1.5Submitted Sample(s): 3 Samples per model 1.6Test Duration 2003-02-12 1.7Country of Origin China Date: 2003-02-28 TEST REPORT Page 7 of 20 No.: HM109800 1.8Additional Information of EUT SubmittedNot Available User Manual Part List Circuit Diagram Printed Circuit Board [PCB] Layout Block diagram FCC ID Label Date: 2003-02-28 TEST REPORT Page 8 of 20 No.: HM109800 2.0Technical Details 2.1Investigations Requested Perform ElectroMagnetic Interference measurement in accordance with FCC 47CFR [Codes of Federal Regulations] Part 15 and ANSI C63.4:2000 for FCC Certification. 2.2Test Standards and Results Summary Tables EMISSION Results Summary Test ConditionTest RequirementTest MethodClass /Test Result SeverityPassFailedN/A Field Strength of Fundamental Emissions & Spurious Emissions FCC 47CFR 15.227ANSI C63.4:2000N/A Radiated Emissions, 30MHz to 1GHz FCC 47CFR 15.209ANSI C63.4:2000Class B Conducted Emissions on AC, 0.15MHz to 30MHz FCC 47CFR 15.207ANSI C63.4:2000Class B Note: N/A - Not Applicable Date: 2003-02-28 TEST REPORT Page 9 of 20 No.: HM109800 3.0 Test Results 3.1Emission 3.1.1Radiated Emissions Test Requirement:FCC 47CFR 15.227 Test Method:ANSI C63.4:2000 Test Date:2003-02-24 Mode of Operation:On mode Test Method: The sample was placed 0.8m above the ground plane on the OATS *. Measurements in both horizontal and vertical polarities were performed. During the test, each emission was maximized by: having the EUT continuously working, investigate all operating modes, rotated about all 3 axis (X, Y & Z) to obtain worst position, manipulating interconnecting cables, rotating turntable, varying antenna height from 1m to 4m in both horizontal and vertical polarizations. The emissions worst-case are shown in Test Results of the following pages. *:OATS [Open Area Test Site] located at HKSTC with a metal ground plane on filed with the FCC pursuant to section 2.948 of the FCC rules, with Registration Number: 90657. Test Setup: EUT distance = 3m Pre -Amplifier Receiver Turn Table Computer Ground plane Date: 2003-02-28 TEST REPORT Page 10 of 20 No.: HM109800 Limits for Field Strength of Fundamental Emissions [FCC 47CFR 15.227]: Frequency Range of Fundamental Field Strength of Fundamental Emission [Peak] Field Strength of Fundamental Emission [Average] [MHz] [μV/m][μV/m] 26.96-27.28100,00010,000 Results: FrequencyCorrectionLimit @3mAntenna FactorPolarity MHz dB μ V/m μ V/m 27.1523.8022.346.1201.8100,000Vertical Field Strength of Fundamental Emissions Peak Value Measured Level @3m Field Strength μ V/mdB μ V/m Field Strength dB μ V/m FrequencyCorrectionLimit @3mAntenna FactorPolarity MHz dB μ V/m μ V/m 27.1519.722.342.0125.9100,00Vertical μ V/mdB μ V/m Field Strength dB μ V/m Field Strength of Fundamental Emissions Avera…

Text truncated - open the document above for the full version.

TEST SET UP PHOTOGRAPH OF THE PRODUCT MEASUREMENT OF RADIATED EMISSION TEST SET UP