
Text extracted from the exhibit documents filed with the FCC. Open a document above to read the original.
RadioRouter ® Base Station Installation Guide Issue Date: 08-04-2003 Version 0.5 Flarion Technologies, Inc. Bedminster One 135 Route 202/206 South Bedminster, NJ 07921 Tel (908) 947 7000 Fax (908) 947 2050 Web: [email protected] Intentionally blank page RadioRouter ® BaseStation Installation Guide — Draft Version 0.5 - © 2003 i COPYRIGHT STATEMENT Copyright© 2003 Flarion Technologies, Inc. All rights reserved. Flarion™, flash-OFDM™, RadioRouter ® , Vector-LDPC™ and FlashView™ are trademarks of Flarion Technologies, Inc. All other trademarks contained herein are the property of their respective owners. Data subject to change without notice. Printed in USA. FTDS-200 013003 NOTICE: Regulatory Compliance Information The Flarion RadioRouter complies with the following regulatory compliance requirements: •Safety - UL 60950 — Underwriters Laboratories, Inc. - CAN/CSA -C22.2 No. 60950 — Canadian Standards Association - EN 60950 — European Norm - IEC 60950 — International Electrotechnical Commission •EMC — Electromagnetic Compatibility - FCC Part 15 (CFR 47) Class A — Federal Communications Commission, Code of Federal Regulations - ICES-003 Class A — Interference-Causing Equipment Standard - EN55022 Class A - CISPR22 Class A •Telecom - FCC Part 24 •Industry/Environmental - GR-63-CORE NEBS Level 3 — Network Equipment Building System - GR-1089-CORE NEBS Level 3 - ETSI EN 300 019-2-3 V2.1.2 — European Telecommunications Standards Institute FCCClassAStatement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio freque ncy energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. (CFR reference 15.105) RadioRouter ® BaseStation Installation Guide — Draft Version 0.5 - © 2003 i ii Modifying the equipment with out Flarion’s authorization may result in the equipment no longer complying with FCC requirements for Class A digital device. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense. (CFR reference 15.21) Canadian Class A Statement This Class ‘A’ digital apparatus complies with Canadian ICES-003. Cet appareil numerique de la classe ‘A’ est conforme á la norme NMB-003 de Canada. RadioRouter ® BaseStation Installation Guide — Draft Version 0.5 - © 2003 ii iii HOWTOUSETHISMANUAL This manual is intended for use by qualified engineering personnel only. The RadioRouter Base Station Installation Guide covers all of the necessary information required to install the RadioRouter Base Station. It contains the following sections: •Overview • Verifying the Site Preparation • Installing the Cabinet • Connecting the Power System • Connecting the Core Network Cables • Connecting the Antennas Cables • Installing the Alarm Connections • Powering Up the RadioRouter • Powering Down the RadioRouter • Verifying the Installation A list of abbreviations used in this manual can be found at the beginning of the document in the LIST OF ABBREVIATIONSsection. There is certain critical information contained within this manual that MUST be adhered to. Failure to observe this information can result in death or serious injury. Such information is marked as follows: WARNING: WARNINGS ARE ALWAYS IN UPPER CASE. WARNINGS RELATE TO POTENTIALLOSSOFLIFEORSERIOUSINJURY.YOUMUSTOBEY ALL WARNINGS. CAUTION: Normal Cautions are in bold type. Cautions relate to potential damage to equipment. You must obey all cautions. ESD CAUTION: This is an ESD caution. This is signified by the electrostatic symbol which appears to the left of the caution information. RadioRouter ® BaseStation Installation Guide — Draft Version 0.5 - © 2003 iii iv Note: Notes are displayed in italic. Notes contain certain information that may be valuable to the reader. RadioRouter ® BaseStation Installation Guide — Draft Version 0.5 - © 2003 iv v TABLE OF CONTENTS 1. Overview.....................................................................................Page 1 2. Verifying the Site Preparation ............................................................Page 3 2.1. Site Preparation Checklist — Indoor BaseStation ...............................Page 3 2.2. Preparing the Floor...................................................................Page 4 3. Installing the Cabinet ......................................................................Page 6 4. Connecting the Power System.........................................................Page 11 4.1. Routing the Cables.................................................................Page 11 4.2. Connecting to Power and Ground................................................Page 16 5. Connecting the Core Network Cables.................................................Page 21 6. Connecting the Antennas Cables......................................................Page 26 7. Installing the Alarm Connections......................................................Page 30 8. Powering Up the Cabinet................................................................Page 32 9. Powering Down the Cabinet ...........................................................Page 36 10. Verifying the Installation ...............................................................Page 37 10.1. Verifying the Physical Installation...............................................Page 37 10.2. Verifying the Base Station Operation ..........................................Page 37 LIST OF PROCEDURES Procedure …
Text truncated - open the document above for the full version.
QZXBS100019
NTS File: 40375-04-1.FTI, Revision 0 FCC Compliance Report Part 24 Certification For Flarion Technologies, Inc. RadioRouter Indoor Base Station Prepared By: National Technical Systems 36 Gilbert Street South Tinton Falls, NJ 07724 Phone: 732 936 0800 Fax: 732 936 0700 E-mail: [email protected] MJO #: 40375-04 National Technical Systems Page 1 of 39 NTS File: 40375-04-1.FTI, Revision 0 FCC Compliance Report Part 24 Certification For Flarion Technologies, Inc. RadioRouter Indoor Base Station Date : 8/25/03 MJO # : 40375-04 File : 40375-04-1.FTI Revision # : None Product : RadioRouter Indoor Base Station Manufacturer : Flarion Technologies, Inc. P.O. # : NR0164 This report shall not be reproduced, except in full, without the written approval of NTS, Inc. The test results relate only to the items tested. MJO #: 40375-04 National Technical Systems Page 2 of 39 NTS File: 40375-04-1.FTI, Revision 0 Richard C. Gaynor Manager) Product : RadioRouter Indoor Base Station Model : 97-0134-001 Rev. B Serial Number : 0317000012 Manufacturer : Flarion Technologies, Inc. Address : 135 Route 202/206 South Bedminster, NJ 07921 USA Phone : 908 947 7052 Fax : 908 997 2050 Date Received : 7/9/03 Contact : Bill Clark Test Laboratory : National Technical Systems 36 Gilbert Street South Tinton Falls, NJ 07724 USA Phone: 732 936 0800 Fax: 732 936 0700 E-mail: [email protected] Prepared By : Mark S. Betts Date: 8/25/03 (Senior EMC Test Engineer) Reviewed By : Mark S. Betts Date: 8/25/03 (Program Manager) Approved By : Date: 8/25/03 (Facility MJO #: 40375-04 National Technical Systems Page 3 of 39 NTS File: 40375-04-1.FTI, Revision 0 Table of Contents 1. General Description:..............................................................................................................................................5 2. Classification and Environment:............................................................................................................................5 3. Test Summary:.......................................................................................................................................................5 4. Test Report Summary:...........................................................................................................................................5 4.1. Test Sample Description:.......................................................................................................................6 4.1.1. Block Diagram: ......................................................................................................................................6 4.1.2. EUT Equipment List:.............................................................................................................................6 4.1.3. EUT Cabling:.........................................................................................................................................7 4.2. Test Configuration:.................................................................................................................................7 4.2.1. EUT Electrical Mode of Operation:.......................................................................................................7 4.2.2. Software/Firmware:................................................................................................................................7 4.3. Test Procedure:.......................................................................................................................................7 4.4. Test Results and Data:............................................................................................................................8 4.4.1. Transmitter Conducted Power Output:...................................................................................................8 Transmitter Conducted Power Output Report........................................................................................9 4.4.2. Transmitter Occupied Bandwidth:........................................................................................................13 Transmitter Occupied Bandwidth Laboratory Report..........................................................................14 4.4.3. Frequency vs. Temperature..................................................................................................................17 Frequency vs. Temperature Laboratory Report....................................................................................18 4.4.4. Frequency vs. Voltage..........................................................................................................................21 Frequency vs. Voltage Laboratory Report...........................................................................................22 4.4.5. Transmitter Conducted Spurs:..............................................................................................................25 Transmitter Conducted Spurs Report...................................................................................................26 4.4.6. Transmitter Radiated Spurs:.................................................................................................................29 Transmitter Radiated Spurs Report......................................................................................................30 4.4.7. Transmitter Band/Block Edge: .............................................................................................................33 Transmitter Band/Block Edge Laboratory Report................................................................................34 5. Test Equipment:...................................................................................................................................................37 6. References:..........................................................................................................................................................37 Attachm…
Text truncated - open the document above for the full version.
NTS File: 40375-04-1.FTI, Revision 0 Attachment 1, Photographs EUT Test Setup MJO #: 40375-04 National Technical Systems Page 38 of 39 NTS File: 40375-04-1.FTI, Revision 0 EUT Test Setup MJO #: 40375-04 National Technical Systems Page 39 of 39
6660-B Dobbin Road · Columbia, Maryland · United States
| # | Rule Parts | Frequency Range | Power Output | Emission | Tolerance |
|---|---|---|---|---|---|
| 1 | 24E | 1.97 GHz - 1.97 GHz | 19.7 W | 1M25F9W | 1.0000000000 Hz |

PCMCIA Wireless Network Card
Equipment Class
TNB - Licensed Non-Broadcast Station Transmitter
Radio Router Outdoor Base Station
Equipment Class
TNB - Licensed Non-Broadcast Station TransmitterRadio Router Indoor Base Station
Equipment Class
TNB - Licensed Non-Broadcast Station Transmitter
Wireless Broadband Modem
Equipment Class
PCB - PCS Licensed Transmitter
Radio Router Outdoor Base Station
Equipment Class
PCB - PCS Licensed Transmitter